remove rear light NISSAN PULSAR 2016 Owners Manual


> (GLW   0RGHO &$@
2-20
Instrument sand controls
GUID-F6B82 05F-DF3D-4522-92F0-97 114EEC2749
WARNING:
In freezing temperatures, thewasher fluidmay
freeze onthe windshield andobscure your
vision. Warmthewindshield withthedefogger
before youwash thewindshield.
CAUTION:
. Donot operate thewasher continuously for
longer than30seconds.
. Donot operate thewasher ifthe window
washer fluidreservoir isempty.
. Ifthe wiper operation isinterrupted bysnow
or ice, thewiper maystop moving toprotect
its motor. Ifthis occurs, turnthewiper switch
to the ªOFFº position andremove thesnow
or ice onand around thewiper arms.In
approximately 1minute, turntheswitch on
again tooperate thewiper.
WINDSHIELD WIPERANDWASHER
SWIT CH
GUID-B5 02F95A-B0 41-40B6-93BF-96CD 4CBD3C3C
SIC4022
T ype A
JVI0271X
T ype B
The windshield wiperandwasher operate whenthe
ignition switchisin the ªONº position.
Wiper operation
GUID-09 A5032E-B4FF -4FFF-AC03-6433AEEED 0C7
The lever position ªINTºor ª
º
*
1
operates the
wiper intermittently .
. The intermittent operationcanbeadjusted by
turning theadjustment controlknob,(longer)
*
A
or (shorter)
*
B
.
. The intermittent operationspeedvariesinaccor-
dance withthevehicle speed.(Forexample, when
the vehicle speedishigh, theintermittent opera-
tion speed willbefaster.)
The lever position ªLOº or
ª
º
*
2
operates the
wiper atlow speed.
The lever position ªHIºor
ª
º
*
3
operates the
wiper athigh speed.
T o stop thewiper operation, movethelever uptothe
ªOFFº position.
The lever position ªMISTºor
ª
º
*
4
operates the
wiper onesweep. Thelever automatically returnstoits
original position. Pulling
upthe wiper arm:
GUID-9E14C2 E6-2E9C-4731-980B-C45B899B9 77B
The wiper armshould beinthe upposition when
replacing thewiper.
T o pull upthe wiper arm,pullthelever
*
5
when the
ignition switchisin the ªOFFº position within1minute.
The wiper operation stopsinmid-operation andthe
wiper armcanbepulled up.
T o replace thewiper arm,place thewiper arminthe
down position andthen push thelever
*
4
up once
when theignition switchisin the ªONº position.
W asher operation
GUID-FCA4 580E-6687-43A6-B1FF-1 07489CBCCA 6
T o operate thewasher, pullthelever toward theback
of the vehicle
*
5
until thedesired amountofwasher
fluid isspread onthe windshield. Thewiper will
automatically operateseveraltimes.
Wiper dripwipe system:
GUID-9E14C2 E6-2E9C-4731-980B-C45B899B9 77B
The wiper willalso operate onceabout 3seconds after
the washer andwiper areoperated. Thisoperation isto
wipe washer fluidthathasdripped onthe windshield.
Headlight cleaner(ifequipped)
GUID-30A3 22AB-83A8-4BD5-9E9 6-B1C0CD1C922B
Pull thelever toward therear ofthe vehicle
*
5
.
The headlight cleanerwilloperate withoperation ofthe
windshield washer.
. The headlight cleaneroperates withthewind-
shield washer operation. Thisoperation activates
once eachtimeeither theignition switchorthe
headlight switchisturned offand on.
. After thefirst operation, theheadlight cleaner
operates onceforevery fewoperations ofthe
windshield washer.
WIPER ANDWASHER SWITCH
&RQGLWLRQ


> (GLW   0RGHO &$@
CUP HOLDERS
GUID-F1 D72A33-91A5 -4902-86FC-7439878ED485
WARNING:
The driver mustnotremove orinsert cupsinto
the cup holder whiledriving sothat fullattention
may begiven tovehicle operation.
CAUTION:
Avoid abrupt starting andbraking especially
when thecup holder isbeing usedtoprevent
spilling thecontents. Ifthe contents arehot, they
could scaldyouoryour passengers.
Front
GUID-E80F27 16-7269-4828-8FA8-097AFEB 8510C
JVI0465X
T o open thecup holder, slidethelid
*
1
.
T o close thecup holder, slidethelid
*
2
.
Rear (ifequipped)
GUID-A 5BBE5CB-2 BA4-4E2B-8 CED-7AA1E2 8D4F66
SIC4593
Soft bottle holders
GUID-0E67 B8D3-6652-4 674-BA6D-22 BE03283C F0
JVI0290X
Soft bottle holders arelocated onthe front andrear
doors.
CAUTION:
. Do not use bottle holder forany other
objects thatcould bethrown aboutinthe
vehicle andpossibly injurepeople during
sudden braking oran accident. .
Do not use bottle holder foropen liquid
containers.
SUNGLASSES HOLDER
GUID-1F6E4D 74-A08A-472D-98C4-D 401E33CD2 F9
JVI0291X
CAUTION:
. Do not use foranything otherthansun-
glasses.
. Donot leave sunglasses inthe sunglasses
holder whileparking indirect sunlight. The
heat maydamage thesunglasses.
T o open thesunglasses holder,pushthebutton
*
A
.
T o close, pushtheholder upuntil thelock latches.
Instrume ntsand controls
2-27
&RQGLWLRQ


> (GLW   0RGHO &$@
3-4
Pre-d riving checks andadjustments
L OCKING WITHINSIDE LOCK KNOB
GUID-629 A6066-531D -4132-A558-183B789AC 274
JVP0057X
CAUTION:
When locking thedoors usingtheinside lock
knob, besure nottoleave thekey inthe vehicle.
T o lock thefront doors, pushtheinside lockknob to
the lock position
*
1
, and then close thedoor while
pulling thedoor handle.
T o lock therear doors, pushtheinside lockknob tothe
lock position
*
1
and then close thedoor.
T o unlock, pulltheinside lockknob tothe unlock
position
*
2
.
L OCKING WITHPOWER DOORLOCK
SWIT CH
GUID-C7EADB 00-4DE8-4897-9B93-C F6FBD217 578
SP A2803
CAUTION:
When locking thedoors usingthepower door
lock switch, besure nottoleave thekey inthe
vehicle.
T o lock thedoors, pushthepower doorlockswitch to
the lock position
*
1
with thedriver's dooropen, then
close thedoor while pulling thedoor handle. Alldoors
including theback doorwilllock.
T o unlock, pushthepower doorlockswitch tothe
unlock position
*
2
.
Lockout protection
GUID-ED 56D328-80 4D-4737-9FE 3-5F8AAC166E06
The power doorlockswitch willnotlock thedoors
under thefollowing conditions:
Model without Intelligent Keysystem:
GUID-9E14C2 E6-2E9C-4731-980B-C45B899B9 77B
. When thekey isin the ignition switchandthe
driver's doorisopen.
. When anydoor except forthe driver's dooris
open. Model
withIntelligent Keysystem:
GUID-9E14C2 E6-2E9C-4731-980B-C45B899B9 77B
. When theIntelligent Key isleft inside ofthe vehicle
and driver's doorisopen.
VEHICLE SPEEDSENSING DOORLOCK
MECHANISM (ifequipped)
GUID-04 EA80D0-B8C 2-4DA2-8099 -FC1B6CCEFF93
All doors willbelocked automatically whenthevehicle
speed reaches 10km/h (6MPH) .Once thelock has
been unlocked, whiledriving, thevehicle speed
sensing doorlockmechanism willnot lock thedoor
again unless oneofthe following isperformed.
. Opening anydoors.
. Placing theignition switchinthe ªLOCKº position.
T o activate ordeactivate vehiclespeed
sensing doorlockmechanism
GUID-A6B B9DC0-42C7 -4550-8916-039A519AD243
T o activate ordeactivate thedoor lockmechanism,
perform thefollowing procedures.
1. Place theignition switchinthe ªONº position.
2. Within 20seconds, pushandhold thepower door
lock switch tothe ªLOCKº position for5seconds.
3. Thehazard indicator lightwillflash asfollows ifthe
switching operationissuccessful:
. Twice Ðactivated
. Once Ðdeactivated
AUT ODOOR LOCK RELEASING ME-
CHANISM (ifequipped)
GUID-27 B58B1A-D2 30-4263-AC30 -2995F5696A5B
All doors willbeunlocked automatically whenthe
following conditions:
. When theignition switchismoved fromªONº to
ªOFFº position (ModelwithInteligent Key system) .
. When thekey isremoved fromtheignition switch
(Model without Inteligent Key system) .
&RQGLWLRQ


> (GLW   0RGHO &$@
Extended storagefuseswitch (ifequipped)
GUID-5C0 0252D-3068-4605-8AA0 -2F3EB6F6A1 1D
SDI2705
If any electrical equipment doesnotoperate, remove
the extended storagefuseswitch andcheck foran
open fuse.
NO TE:
If the extended storagefuseswitch malfunc-
tions, orifthe fuse isopen, itis not necessary to
replace theswitch. Inthis case, remove the
extended storagefuseswitch andreplace itwith
a new fuse ofthe same rating.
How toremove theextended storagefuse
switch:
GUID-9E14C2 E6-2E9C-4731-980B-C45B899B9 77B
1. To remove theextended storagefuseswitch, be
sure theignition switchisin the ªOFFº orªLOCKº
position.
2. Besure theheadlight switchisin the ªOFFº
position.
3. Remove thefuse boxcover.
4. Pinch thestorage fuseswitch andpullitin the
direction illustrated.
GUID-0CA4 CBD7-552D -4275-8986-132CF6D FB30B
HEADLIGHTS
GUID-2A2B 2E01-3752-481E-ADE 0-0FB5E738 13F7
Fog may temporarily forminside thelens ofthe exterior
lights inthe rain orinacar wash. Atemperature
difference betweentheinside andtheoutside ofthe
lens causes thefog. This isnot amalfunction. Iflarge
drops ofwater collect insidethelens, contact a
NISSAN dealer.
X enon headlight model
GUID-A 9B63013- 3258-4FA3-B5A7 -51CE4118ED 89
If replacement isrequired, contactaNISSAN dealer.
WARNING:
HIGH VOLTAGE
When xenon headlights areon,they produce a
high voltage. To prevent anelectric shock,never
attempt tomodify ordisassemble. Alwayshave
your xenon headlights replacedataNISSAN
dealer.
Use thesame number andwattage asoriginally
installed:
High/Low beams(Xenon)
Wattage: 35
Bulb no.:D2S
Halogen headlight model
GUID-211 3779C-896 9-4483-818 E-EFB621042A37
The halogen headlight isasemi-sealed beamtype
which usesreplaceable headlight(halogen) bulbs.
They canbereplaced frominside theengine compart-
ment without removing theheadlight assembly.
CAUTION:
High-pressure halogengasissealed insidethe
bulb. Thebulb maybreak ifthe glass envelope is
scratched orthe bulb is
dropped.
JVM0070X
1. Disconnect thebattery negative cable.
2. Disconnect theelectrical connector
*
A
from the
rear endofthe bulb.
3. Pulloffthe rubber cap
*
B
.
4. Push andturn theretaining pin
*
C
to loosen it.
5. Remove theheadlight bulb.Donot shake orrotate
the bulb when removing it.
6. Install thenew bulb inthe reverse orderof
removal.
Maintenance anddo-it-yours elf
8-23
LIGHTS
&RQGLWLRQ


> (GLW   0RGHO &$@
JVM0072X
Front foglight (if equipped)
SDI2445
Side turnsignal light(fender type)
JVM0071X
Rear combination light
T o replace therear combination lightbulbs:
1. Remove thenuts
*
A
and move therear
combination light
*
B
rearward tomake a
clearance, thencarefully prythe light using a
suitable tool.
2. Replace thebulbs. (Stop/tail light
*
3
, Turn signal
light
*
2
, Reverse light
*
1
)
3. Install thecombination lightinthe reverse orderof
removal.
Maintenance anddo-it-yours elf
8-27
&RQGLWLRQ