clock reset NISSAN QUEST 2013 RE52 / 4.G Quick Reference Guide
Page 7 of 36
TIre Pre SSure MONITOr ING SYSTeM (TPMS) 
wITH eaSY FILL TI re aLerT
  A  CHe CK TIre P reSSure warning message will 
    appear in the dot matrix liquid crystal display
 
01  
   and the low tire pressure warning light
 02 will 
 
    illuminate when one or more tires are low on   
    pressure and air is needed.
    • The tire pressures should be checked when the 
      tires are cold. The tires are considered cold after 
      the vehicle has been parked for 3 hours or more or 
      driven less than 1 mile (1.6km) at moderate speeds.
 
  When adding air to an under-inflated tire, the TPMS with 
    easy fill Tire Alert provides visual and audible signals 
    outside the vehicle to help you inflate the tires to the 
    recommended c OLd tire pressure.  
 
  To use the easy fill Tire Alert system:  
    1.  Move the shift lever to the P (P arK) position and apply the parking brake.  
    2.  Place the ignition switch in the ON position. do not start the engine.  
    3.  Add air to the under-inflated tire and within a few seconds, the hazar\
d warning lights will   
      start flashing.  
    4.  When the designated tire pressure is reached, the horn will beep once and the hazard   
      warning flashers will stop flashing.  
    5.  Repeat this procedure for any additional under-inflated tires.
01
02
5To view detailed in\fstructional videos\f regarding these a\fnd other features\f \fplease go to www.nissanownersin\Ifo.mobi
LOOS e Fue L CaP
  A  LOOS e Fue L CaP warning message will appear
    in the dot matrix liquid crystal display
 
01 when the 
    fuel-filler cap is not tightened correctly. 
 
  To tighten, turn the cap clockwise until a single click 
    is heard.
 
  The warning message will disappear when the vehicle 
    detects the fuel-filler cap is properly tightened and the 
    reset button
 
02 is pressed for about 1 second.
   if the cap is not properly tightened, the Malfunction 
    indicator Light  
 may illuminate.f
or more information, refer to the “Instruments and controls (section 2)” 
and the “Pre-driving checks and adjustments (section 3)” of your 
Owner’s Manual.
01
02
essential information