mirror OLDSMOBILE AURORA 1999 Owners Manual

yellowblue
1-3 Power Lumbar Control
The power lumbar controls are located on the driver's
and passenger's door panels.
The rear lumbar control adjusts upper lumbar support,
and the front control adjusts lower lumbar support.
Press the front of the switch to increase support. Press
the back of the switch to decrease support.
Memory Seat and Mirrors
The memory function
controls both the driver's
seat cushion and outside
mirror positions. It does
not store the lumbar or
recline positions.
To set your memory seat cushion and mirrors:
1. Position the driver's seat and both outside mirrors
where you want them. See ªMirrorsº in the Index.
2. Press the SET button. You will hear one beep.
3. Within five seconds, press either the 1 or 2 button.
You will hear two beeps.
ProCarManuals.com

yellowblue
1-4
The seat cushion and mirror positions will be stored for
the number pressed. Repeat the procedure to store
another position with the other number if desired. To
adjust the seat and mirrors to the stored position, press
the number corresponding to the position. The memory
function will only work with the gearshift in PARK (P).
To stop the automatic movement, move the seat switch
in any direction. For easier exiting, press the 1 and
2 buttons at the same time to move the seat completely
down and back.Memory Seat and Mirror
Personalization Feature
The transmitters can also be programmed to move the
driver's seat and outside mirrors to a set memory
position when the transmitter's UNLOCK button
is pressed.
To program the system:
1. Adjust the driver's seat to a comfortable position.
Adjust both outside mirrors to suit you.
See ªMirrorsº in the Index.
2. Press the SET button on the driver's door panel.
You will hear one beep.
3. Within five seconds, press one of the two memory
buttons on the door panel. You will hear two beeps to
confirm that the mirror and the seat cushion
positions are entered into memory.
4. Press the UNLOCK button on the appropriate
transmitter within five seconds. You will hear
two beeps.
The second transmitter can be programmed to record
a different seat and mirror position by following the
same steps.
ProCarManuals.com

yellowblue
1-5
If you prefer to program the transmitter to the exit seat
position, which moves the seat completely down and
back, follow these steps:
1. Press the SET button on the driver's door panel.
You will hear one beep.
2. Press one of the memory buttons on the driver's door
panel. You will hear one beep, but the seat will not
move at this time.
3. Press the UNLOCK button on the appropriate
transmitter within five seconds. You will hear
two beeps.
This personalization feature will work only when the
vehicle is in PARK (P). A beep will sound inside the
vehicle when the UNLOCK button on the transmitter is
pressed to move the seat and mirrors.
To turn this feature off, press SET and then UNLOCK
within five seconds.Heated Front Seat (Option)
This feature will quickly heat the lower cushions and
lower back of the driver and front passenger seats for
added comfort.
Press the button once to turn the heater on high. The HI
indicator light below the button will glow. Press it again
to turn the heater on low. The LO indicator light below
the button will glow. Press it a third time to turn the
heater off. The heater will turn off automatically when
the ignition is turned to OFF.
ProCarManuals.com

2-
yellowblue
2-1
Section 2 Features and Controls
Here you can learn about the many standard and optional features on your vehicle, and information on starting,
shifting and braking. Also explained are the instrument panel and the warning systems that tell you if everything is
working properly
-- and what to do if you have a problem.
2
-2 Keys
2
-4 Door Locks
2
-9 Remote Lock Control
2
-14 Trunk
2
-15 Theft
2
-16 Universal Theft-Deterrent
2
-18 PASS-Key
II
2
-19 New Vehicle ªBreak-Inº
2
-20 Ignition Positions
2
-21 Starting Your Engine
2
-23 Engine Coolant Heater (Option)
2
-24 Automatic Transaxle Operation
2
-27 Parking Brake
2
-28 Shifting Into PARK (P)
2
-30 Shifting Out of PARK (P)
2
-31 Parking Over Things That Burn2
-31 Engine Exhaust
2
-33 Windows
2
-34 Tilt Wheel
2
-34 Turn Signal/Multifunction Lever
2
-42 Exterior Lamps
2
-44 Interior Lamps
2
-47 Mirrors
2
-51 Storage Compartments
2
-54 Accessory Power Outlet
2
-54 OnStar
System (Option)
2
-55 Sunroof (Option)
2
-56 Universal Transmitter
2
-60 The Instrument Panel - Your
Information System
2
-64 Warning Lights, Gages and Indicators
2
-75 Driver Information Center
ProCarManuals.com

yellowblue
2-11
Personalization Features
The following list of features that are available on your
vehicle can be programmed to the driver's preference
for each transmitter.

Memory Door Locks: This feature programs your
door locks to automatically lock or unlock when
shifting in and out of PARK (P).

Security Feedback: This feature provides feedback
to the driver when the vehicle receives a command
from the remote lock control transmitter.

Delayed Locking: This feature lets the driver delay
the actual locking of the vehicle. When all doors
have been closed, the doors will lock automatically
after five seconds.

Perimeter Lighting: When the UNLOCK button on
the transmitter is pressed, the headlamps, parking
lamps, back
-up lamps and cornering lamps will turn
on in dark conditions.

Memory Seat and Mirrors: This feature programs
your driver's seat and outside mirrors to a set
memory position when the UNLOCK button on the
transmitter is pressed.
For more detailed information and programming
instructions, refer to the Index for each individual
feature listed above.Security Feedback
This personalization feature provides feedback to the
driver when the vehicle receives a command from the
remote lock control transmitter. The following modes
may be selected:
Mode 0: No transmitter response when locking or
unlocking the vehicle.
Mode 1: No transmitter response when locking;
headlamps, parking lamps, and cornering lamps flash
when unlocking the vehicle.
Mode 2: Headlamps, parking lamps, and cornering
lamps flash when locking; no response when unlocking
the vehicle.
Mode 3: Headlamps, parking lamps, and
cornering lamps flash when locking and when
unlocking the vehicle.
Mode 4: Headlamps, parking lamps, and cornering
lamps flash and horn chirps when locking; no response
when unlocking the vehicle.
Mode 5: Headlamps, parking lamps, and cornering
lamps flash and horn chirps when locking; exterior
lamps flash when unlocking the vehicle.
ProCarManuals.com

yellowblue
2-47 Rear Reading Lamps
These lamps go on when you open the doors. You can
also turn them on by pressing the button to the side of
the lamp. Press it again to turn them off.
Trunk Lamp
When you open the trunk to its full open position, a
lamp will come on inside the trunk. This lamp will
automatically turn off when the trunk is closed.
Inadvertent Load Protection
This feature automatically shuts off the interior lamps
if any are left on for more than 10 minutes when the
ignition is off or a door is left open. This will keep
your battery from running down.
Mirrors
Electrochromic Day/Night Rearview Mirror
with Compass
Your vehicle may have an electrochromic inside
rearview mirror with a compass.
When set in the MIRROR position, this mirror
automatically changes to reduce glare from headlamps
behind you. A time delay feature prevents rapid
changing from the day to night positions while driving
under lights and through traffic.
The mirror also includes an eight
-point compass display in
the upper right corner of the mirror face. When on, the
compass automatically calibrates as the vehicle is driven.
ProCarManuals.com

yellowblue
2-48
When cleaning the mirror, use a paper towel or similar
material dampened with glass cleaner. Do not spray
glass cleaner directly on the mirror as that may cause
the liquid cleaner to enter the mirror housing. Use a
cotton swab and glass cleaner to clean the photocells
when necessary.
Mirror Operation
The right side of the button located at the bottom of the
mirror turns the electrochromic mirror on and off. To
turn on the automatic dimming feature, press MIRROR.
To turn off automatic dimming, press MIRROR again.
The green indicator light will be illuminated when this
feature is active.Compass Operation
Press the COMPASS button once to turn the compass
on or off.
When the ignition and the compass feature are on, the
compass will show two character boxes for
approximately two seconds. After two seconds, the
mirror will display the compass heading.
If, after two seconds, the display does not show a
compass heading (ªNº for North, for example), there
may be a strong magnetic field interfering with the
compass. Such interference may be caused by a
magnetic antenna mount, magnetic note pad holder or a
similar magnetic item.
Compass Calibration
If the letter ªCº should ever appear in the compass
window, the compass may need calibration.
The mirror can be calibrated in one of two ways:

Drive the vehicle in circles at five mph (8 km/h) or
less until the display reads a direction, or

Drive the vehicle on your everyday routine.
ProCarManuals.com

yellowblue
2-49
Compass Variance
The mirror is set in zone eight upon leaving the factory.
It will be necessary to adjust the compass to compensate
for compass variance if you live outside zone eight.
Under certain circumstances, as during a long distance
cross
-country trip, it will be necessary to adjust for
compass variance. Compass variance is the difference
between earth's magnetic north and true geographic
north. If not adjusted to account for compass variance,
your compass could give false readings.
To adjust for compass variance:
1. Press and hold the COMPASS button located at the
bottom of the mirror until a zone number appears in
the display.
2. Find your current location and variance zone number
on the following zone map.
3. Press the COMPASS button on the bottom of the
mirror until the new zone number appears in the
display. After you stop pressing the button, the
compass will need to be calibrated. (This is the
automatic calibration mode. Drive in a circle to
calibrate the mirror. See ªCompass Calibrationº
explained previously.)
ProCarManuals.com

yellowblue
2-50 Power Remote Control Mirror
The controls on the far left
of the instrument panel
control both outside
rearview mirrors. Move the
center switch to the left (L)
to select the driver's side
rearview mirror, or to the
right (R) to select the
passenger's side
rearview mirror.
Then press the arrows to adjust each mirror so that you
can just see the side of your vehicle when you are sitting
in a comfortable driving position.
To lock the controls, leave the selector switch in the
middle position.
Your vehicle is equipped with the memory function. The
mirror positions, along with the driver's set position, can
be stored into memory. See ªMemory Seat and Mirrorsº
in the Index.
Parallel Park Assist Mirror
The passenger's outside rearview mirror also includes a
tilt
-down feature that operates when the shift lever is in
REVERSE (R). This feature assists the driver with
improved rear obstacle detection.
Move the power remote control mirror switch to the
left (L) or center position to enable this feature. Move
the switch to the right (R) to turn this feature off.
Convex Outside Mirror
Your passenger's side mirror is convex. A convex
mirror's surface is curved so you can see more from the
driver's seat.
CAUTION:
A convex mirror can make things (like other
vehicles) look farther away than they really are.
If you cut too sharply into the right lane, you
could hit a vehicle on your right. Check your
inside mirror or glance over your shoulder before
changing lanes.
ProCarManuals.com

yellowblue
2-51 Heated Outside Rearview Mirror
When you operate the rear window defogger, a defogger
also warms the heated driver's and passenger's outside
rearview mirrors to help clear them of ice and snow. See
ªRear Window Defoggerº in the Index.
Storage Compartments
Glove Box
Use the door key to lock and unlock the glove box. To open,
pull the latch release on the left side of the glove box door.
Front Storage Armrest
The front armrest opens into a storage area. To open it,
lift the front edge. Inside you will find storage for
cassettes, compact discs and coins.
In front of the storage area is a cupholder. Press and
release the cupholder cover to open. Do not try to pull it
out. Push the cupholder forward to lock it when in use.
Press the cupholder back to its recessed position when
not in use.
Rear Storage Armrest
Your vehicle has a rear storage armrest with a
pass
-through feature.
Pull down the bolster in the back seat to use the armrest
and two cupholders. Lift the top of the armrest for
storage space.
Pull down the interior door to access the trunk.
ProCarManuals.com