engine Oldsmobile Cutlass Supreme 1993 s Repair Manual
Page 272 of 340
Service & Appearance Care
270
Fuses & Circuit Breakers
The wiring circuits in your vehicle are
protected from short circuits by
a
combination of fuses, circuit breakers,
and fusible thermal links in the wiring
itself. This greatly reduces the chance of
fires caused by electrical problems.
Some fuses are located in a fuse block
in the glove box as shown above.
To
locate the fuse block, lift out the storage
bin inside the glove box. See the
diagram later in this section.
Another set of fuses is located in the
component center, under the
instrument panel.
Additional fuses are located in the
underhood electrical centers on the
right and left sides of the engine
compartment. Spare fuses
and a fuse puller are located
in the glove box lid. To remove the
cover, press in on both ends
of the
cover and pull it
off.
Place the wide end of the fuse puller
over the plastic end of the fuse. Squeeze
the ends over the fuse and pull it out.
To identify and check fuses, refer to the
charts on the following pages. Look
at the silver-colored band inside
the fuse. If the band is broken or
melted, replace the fuse. Be sure you
replace a bad fuse with a new one of the
identical size and rating.
Page 278 of 340
Service & Appearance Care
Capacities & Specifications
Engine Crankcase
3.1L V6 .......................... .r-.~r.ir.iii+ir.riC.~.r..l .... f...-.T...Ti' .................................. 4 quarts
Twin Dual Cam
(DOHC) 3.4L V6 ................................................ 5 quarts
When changing filter, up to 1 quart (1 L) more oil may be needed.
When draininglreplacing converter, more fluid may be needed.
Automatic Transaxle
Pan Removal and Replacement ................................................... 4 quarts
After Complete Overhaul
............................................................. 7 quarts
Automatic Transaxle with Overdrive
When drainingheplacing converter, more fluid may be needed.
Pan Removal and Replacement ................................................... 6 quarts
After Complete Overhaul
............................................................. 8 quarts
(or more, as needed for converter and auxiliary coolers)
3.8 L
4.8 L
3.8 L
6.6 L
5.8 L
7.5 L
Page 280 of 340
Service & Appearance Care
278
-
Fluids & Lubricants
ITEM APPLICATION
Antifreeze Coolant.. .................................
Chassis Lubricant ....................................
(Ethylene Glycol Base)
(Grease Gun Insert)
Delco Supreme
11@ Brake Fluid ..............
DEXRONB-IIE Automatic ......................
Engine Oil ................................................
GM Engine Oil Supplement ....................
Transmission Fluid
(E.O.S.) Year-round
antifreeze for
...........................
General chassis lube, etc. ...........................
coolant mixtures
Brake System
..............................................
Automatic Transaxle ..................................
Engine lubrication ......................................
See your dealer for advice ..........................
GM PART NUMBER
1052753
1052497
SIZE
1 gal. (3.8 L)
14
oz. (397 g)
1052535 16 oz. (0.5 L)
12345881 32 oz.
(1 .O L)
12345880
1 gal. (3.8 L)
See the Index under Engine Oil.
1052367 16 oz. (0.5 L)
Page 281 of 340
ITEM APPLICATION
Engine Oil ................................................ Hood, trunk and door hinges
GM PART NUMBER
Windshield Washer Solvent .................... Windshield washer fluid
Power Steering Fluid
............................... Power Steering System .............................. 1050017
1052884
Silicone Grease ........................................ Weatherstrips .............................................. 1245579
SIZE
32 oz. (1.0 L)
16
oz. (0.5 L)
1 oz. (28 g)
Spray-A-Squea1c Silicone Lubricant ....... General purpose silicone lubricant, ........... 1052276 (aerosol) 4.5 OZ. (127 g)
weatherstrips 1052277 12 oz. (0.35 L)
279
Page 285 of 340
Normal Maintenance Replacement Parts
Air Cleaner Element
Engine
Oil Filter
PCV Valve
All Engines ........................................................................\
.............
All Engines ........................................................................\
.............
3.1L V6 ........................................................................\
..................
Twin Dual Cam (DOHC) 3.4L V6 ...............................................
3.1L V6 ........................................................................\
..................
Spark Plugs
Twin Dual Cam (DOHC) 3.4L V6 ...............................................
Batteries
Remote Lock Control Transmitter ...............................................
AC Type A-1 129C
AC Type
PF-5 1
AC Type CV-892C
AC Type CV-881C
AC Type oR44LTSM Gap: 0.045 inch (1.14mm)
AC Type eR42LTSM Gap: 0.045 inch (1.14mm)
2016 (2)
283
~~
Page 293 of 340
Schedule I
Is any of these true for your vehicle?
Most trips are less than 4 miles (6 km).
Most trips are less than 10 miles (16 km) when outside
temperatures are below freezing.
The engine is at low speed most of the time (as in door-to-
door delivery, or in stop-and-go traffic).
You operate your vehicle in dusty areas.
You tow a trailer. (With some models, you shouldn’t ever
If
any one (or more) of these is true for your driving, follow
Schedule
I.
tow a trailer. See the Index under Towing a Trailer.)
Schedule I1
Follow Schedule I1 only if none of the above conditions is
true.
291
Page 294 of 340
Maintenance Schedule
Section A: Scheduled Maintenance Services (cant.)
292
Schedule I
Follow Schedule I if your vehicle is
MAINLY driven under one or more of
the following conditions:
When most trips are less than 4 miles
When most trips are less than 10
(6 km) -
miles (1 6 ltm) and outside
temperatures remain below freezing.
When most trips include extended
idling and/or frequent low-speed
operation, as in stop-and-go traffic.
When towing a trailer.**
When operating in dusty areas.
Schedule I should also be followed if
the vehicle is used for delivery service,
police, taxi or other commercial
applications.
+k An Emission Control Service.
12 The U.S. Environmental Protection Agency has
determined that the failure to perform this
maintenance item will not nullify the emission
warranty
or limit recall liability prior to the
completion of vehicle useful life. General
Motors, however, urges that all recommended
maintenance services be performed at the
indicated intervals and the maintenance be
recorded in Section
E: Maintenance Record.
TO BE SERVICED
See Explanation of Scheduled Maintenance
Services
following Schedules I and II.
WHEN TO PERFORM
Miles (kilometers) or Months
(whichever occurs jirst).
I 2 1 Chassis Lubrication I Every other oil change. I
Tire and Wheel Rotation and Inspection At 6,000 Miles (10 000 h) and every l5,OOO Miles
(25 000 km) or as necessary. I
Camshaft Tiig Belt Inspection
(3.4L Engine, VIN Code X)* l5,OOO Miles (25 000 km). I I
At 60,OOO Miles (100 000 km) and then every
1 8 I Transaxle Service see ,!%ph&m of Scheduled Maintenance Services
following Schedules I and II.
I 10 I Spark Plug Wxe Inspection** I Every 30,000 Miles (50 OOO h). I
Exhaust Gas Recirculation (EGR) System I Every 30,000 Miles (50 000 km).
Inspection (3.4L Code X engine only)**
14 Fuel Tank, Cap & Lines Inspection** Every 30,000 Miles (50 OOO km). I
Page 296 of 340
,. .
Maintenance Schedule
Section A: Scheduled Maintenance Services (cant.)
* An Emission Control Service.
TO BE SERWCED WHEN TO PERFO'RM ITEM
Nom See J&plm.#ion of Scheduled Maintenance Miles (kiomtm) or Mmth
Sewices hllowing !khedules I and II. (whichaver occurs first).
At 7,500 Mks (E 500 kin) and then every l5,oOa
Miles (25 Oao km) or as necessary. I
Camshaft Timing Belt Insptim ~t 6U,OOO Miles (lo0 OOO h) and rherrewy
(3.4L Engine, VIN Code X)* ls,~ Miles (25 OOO km).
I 8 I Transaxle Service
10 I SDarkPlnpl Wm Inspection*a I Every 30,000 Miles (50 OOO km). I
I 14 I Fuel Ti&, Cap and Lines Jnsption*a I Every 30,000 Miles (SO OOO lan). I
Page 298 of 340
Maintenance Schedule
Section A: Scheduled Maintenance Services (Cant.)
Explanation of Scheduled Maintenance Services
Below are explanations of the services listed in Schedule I
and Schedule 11.
The proper fluids and lubricants to use are listed in Section
D. Make sure whoever services your vehicle uses these. All
parts should be replaced and all necessary repairs done
before you or anyone else drives the vehicle.
ITEM
NO. SERVICE
1 Engine Oil and Filter Change”-Always use SG
296
2
Energy Conserving I1 oils for proper viscosity. The
“SG” designation may be shown alone or in
combination with others, such as “SG/CC,”
“SG/CD” or “SF, SG, CC,” etc.
To determine the
preferred viscosity for your vehicle’s engine (e.g.,
SAE 5W-30 or SAE 1OW-30) see the Index under
Engine Oil.
Chassis Lubrication-Lubricate the transaxle shift
linkage, parking brake cable guides, underbody
contact points and linkage. Lubricate the front and
rear suspension and steering linkage.
ITEM
NO. SERVICE
3 Throttle Body Mounting Bolt Torque (3.1L
Code T or M engines only)*-Check the torque of
the mounting bolts and/or nuts.
4 Tire and Wheel Rotation and Inspection-For
proper wear and maximum tire life, rotate your
tires following the instructions in this manual. See
the
Index under Tires, Inspection G Rotation.
Check the tires for uneven wear or damage. If you
see irregular or premature wear, check the wheel
alignment. Check for damaged wheels also.
NOTE: To determine your engine’s displacement and code, see the Index under Engine Identification
* An Emission Control Service.
0 The U.S. Environmental Protection Agency has determined that the failure to perform this maintenance item will not nullify the emission warranty QY
limit recall liability prior to the completion of vehicle useful life. General Motors, however, urges that all re\
commended maintenance services be
performed
at the indicated intervals and the maintenance be recorded in Section E: Maintenance Record.
Page 299 of 340
ITEM
NO. SERVICE
5
6
7
Engine Accessory Drive Belt (s) Inspection
(California
3.1L Code T engine”)-Inspect the
belt for cracks, fraying, wear and proper tension.
Replace as needed.
Camshaft Timing Belt Inspection
(3.4L Code X
engine only)*-Inspect for cracks, wear or oiliness.
Check tensioner for proper operation. See the
service manual. (To purchase a service manual,
see the
Index under Publications.) Replace parts
as needed.
Cooling System Service*-Drain, flush, and refill
the system with new or approved recycled coolant
conforming to
GM Specification 1825M. Keep
coolant at the proper mixture as specified. See the
Index under Coolant. This provides proper freeze
protection, corrosion inhibitor level, and engine
operating temperature.
Inspect hoses and replace if they are cracked,
swollen or deteriorated. Tighten screw-type hose
clamps. Clean the outside of the radiator and air
conditioning condenser. Wash the pressure cap
and neck.
To help ensure proper operation, we recommend a
pressure test of both the cooling system and the
pressure cap.
ITEM
NO. SERVICE
8 Transaxle Service-Change both the fluid and
filter every 15,000 miles (25 000 ltm) if the vehicle
is mainly driven under one or more of these
conditions:
In heavy city traffic where the outside
temperature regularly reaches
90°F (32°C) or
higher.
In hilly or mountainous terrain.
When doing frequent trailer towing. (With some
models, you shouldn’t ever tow a trailer. See the
Index under Towing a Trailer.)
Uses such as found in taxi, police car, or delivery
service.
If you do not use your vehicle under any
of these
conditions, change both the fluid and filter every
100,000 miles (160 000 lun) .
Spark Plug Replacement*-Replace spark plugs
with the proper type. See the
Index under
Replacement Parts.
burns, cracks or other damage. Check the boot fit
at the coils and at the spark plugs. Replace wires
as needed.
10 Spark Plug Wire Inspection**-Inspect for
9
297