heating OPEL AGILA 2009 Owners Manual

Page 24 of 153

2-9 Keys, doors and windows
Folding mirrors
For the safety of pedestrians, the
exterior mirrors will swing out of their
normal mounting position in the event
of an accident-like impact.
Reposition the mirror by applying
slight pressure to the mirror housing.
Heated mirrors 3
The heating operates in conjunction
with the heated rear window using
button Ü.
Heated rear window, heated exterior
mirrors 3 8-5.
Interior mirror
Manual mirror
To adjust interior mirror, swivel mirror
housing.
Swivel lever on underside of mirror
housing to reduce dazzle at night.
Take care when driving with interior
mirror adjusted for night vision. Rear
view may be slightly distorted in this
position.

Page 55 of 153

5-5Instruments and controls
Cigarette lighter ) 3
With ignition switch in positions ACC
or ON, push the cigarette lighter in all
the way and release it.
Heating up ceases once element is
glowing; cigarette lighter pops up
automatically. Withdraw lighter.
Ashtrays 3
Portable ashtrayThe portable ashtray can be fitted in
the front or rear cup holder in the
centre console.
Warning lights, gauges
and indicators
Speedometer
Indicates the vehicle speed.
9 Warning
To be used only for ash and not
for combustible rubbish.

Page 61 of 153

5-11Instruments and controls
If it stays lit or illuminates during
driving, there is a fault with ESP®.
The vehicle’s brake system remains
operational without ESP
® regulation.
Seek the assistance of a workshop to
have the cause of the fault remedied.
Further information 3 9-10.
W Engine coolant
temperature
Will illuminate briefly in red when
ignition is switched on.
If it illuminates or flashes when the
engine is running: stop vehicle and
switch off engine. Coolant
temperature is too high; danger of
engine damage. Check coolant level.
Further information 3 10-4.
N Preheating for diesel
engines 3
Will illuminate during engine
preheating.
Preheating system switches on only if
outside temperature is low.
If it illuminates during driving or if the
engine cannot be started, seek the
assistance of a workshop as soon as
possible.
Starting the engine 3 9-2.
Z Exhaust emissions
Will illuminate in yellow when ignition
is switched on. Extinguishes after
engine is started.
If it illuminates when the engine is
running: fault in emission control
system. The permitted emission
limits may be exceeded. Fuel
economy and vehicle driveability may
be impaired. Seek the assistance of a
workshop immediately.Diesel engines: The engine stops and
control indicator Z illuminates if the
fuel level is too low. If the tank has
been run dry, bleed the fuel system 3
10-7.
Vehicles with electric throttle body
system 3: If the battery has been
disconnected, the system must be
recalibrated upon reconnection of the
battery. Hold ignition key in ON
position for 5 seconds without
running the engine. Control indicator
Z remains illuminated after the
engine is started if the procedure is
not successful.
I Engine oil pressure
Will illuminate in red when ignition is
switched on. Extinguishes after
engine is started.
If it illuminates during driving; engine
oil pressure may be dangerously low,
interrupting engine lubrication and
resulting in damage to the engine
and/or locking of the drive wheels:
„Move out of the flow of traffic as
quickly as possible without
impeding other vehicles,
9 Warning
Allow engine to cool down before
removing coolant filler cap.

Page 82 of 153

8-1 Climate controls
Climate controlsClimate control system
Ventilation, heating and cooling 3 are
combined into one unit that is
designed to provide comfort
regardless of the season, weather or
outside temperature.
Button for cooling n (or A/C) is only
present in version with air
conditioning system3.
Heating and ventilation
controls
TemperatureHeating and ventilation
controls............................... 8-1
Air vents ............................... 8-4
Heated rear window,
heated exterior mirrors 3 .... 8-5
Air intake .............................. 8-6
Pollen filter............................ 8-6
To red = Warm
To blue = Cold

Page 84 of 153

8-3 Climate controls
For simultaneous warming of the
footwell, set air distribution rotary
knob to J.
Switch on air conditioning 3 to
improve defrosting efficiency when
position J or V is selected.
Air recirculation mode 3
During ’normal’ operation, the
heating, ventilation and air
conditioning system 3 uses outside
air. To prevent fumes or unpleasant
odours from entering the vehicle
when in stationary traffic and when
rapid heating or cooling of the
passenger compartment is required, press button 4; control indicator in
the button illuminates and air is
recirculated.
Press button 4 again to turn air
recirculation mode off; control
indicator in the button extinguishes
and outside air is drawn into the
vehicle.
Air conditioning system 3
Operational only with engine running
and with the fan switched on:
Control indicator in the button
illuminates when air conditioning is
enabled and extinguishes when the
system is switched off.
Cooling switches off automatically at
low outside temperatures.
Switch off cooling when not required,
in order to save fuel.
9 Warning
Air recirculation mode should only
be used for brief periods, due to
gradual deterioration in air quality
and an increase in humidity,
causing windows to mist up.
Driving with air recirculation mode
on for extended periods may
cause vehicle occupants to feel
drowsy.
Press button n (or A/C) = On
Press button again = Off

Page 86 of 153

8-5 Climate controls
Side air vents
To open and close side air vents, turn
horizontal knurled wheel to the left or
right.
Open side air vents when air
distribution rotary knob is set to
position M or L.
The air flow can be directed up and
down by tilting the slats up and down
using the central adjuster. Air flow is
directed sideways by turning the
horizontal knurled wheel to the left or
right.Depending upon the position of the
temperature rotary knob, cold or
heated air will be directed into the
vehicle via these air vents.
The air supply is increased by
switching on the fan.
Door window defroster vents
Air distribution rotary knob set to
lorV; cooled or heated air will be
directed onto the windscreen and
onto the door windows (mainly in the
area of the exterior mirrors).
Heated rear window,
heated exterior mirrors3
Operational only with engine running.
Control indicator in the button
illuminates when heating is
operational and extinguishes when
heating is switched off.
Turn off heating as soon as vision is
clear.
Rear window and exterior mirror
heating is switched off automatically
after approx. 15 minutes.
To avoid discharging the battery, do
not operate when you are just starting
the vehicle, or if there is a build up of
snow or ice.
Do not use sharp instruments or
abrasive cleaners on rear window or
exterior mirrors, and avoid scratching
or damaging their heating elements.
Press button Ü=On
Press button Ü again = Off

Page 88 of 153

9-1 Driving and operating
Driving and
operatingStarting the vehicle
Driving hints
During the first 1000 km (600 miles),
drive your vehicle at various speeds.
Do not use full throttle. Never allow
the engine to labour at low revs.
Make good use of all gears. Depress
the accelerator pedal a maximum of
around three quarters of the available
pedal travel in all gears and drive
ranges.
Do not brake unnecessarily hard for
the first 200 km (125 miles).
When the vehicle is driven for the first
time, wax and oil on the exhaust
system may evaporate, producing
smoke-like emissions which should
not be inhaled. Allow wax and oil to
evaporate while the vehicle is in the
open air.
Never coast with engine not running
as many units may then not function
(e.g. brake servo unit, power
steering, airbag system). Driving in
this manner is a danger to yourself
and others.Pedals
To ensure the pedal travel is
uninhibited, there must be no mats in
the area of the pedals.
Ignition positionsStarting the vehicle ............... 9-1
Transmission ........................ 9-3
Engine exhaust..................... 9-7
Brakes .................................. 9-9
Ride control systems ............ 9-10
Fuel ...................................... 9-12
LOCK = Ignition off
ACC = Steering unlocked,
ignition off
ON = Ignition on, with
diesel engine:
preheating
START = Start (transmission in
neutral)

Page 89 of 153

9-2Driving and operating
To release the steering column lock,
turn ignition key to position ACC and
rotate steering wheel slightly.
Before starting-off, check:
„Tyre pressures and condition.
„Engine oil level and fluid levels in
engine compartment 3 10-3.
„All windows, mirrors, exterior
lighting and license plates are free
from dirt, snow and ice and are
operational.
„Objects are securely located and
will not be thrown forward in the
event of sudden braking.
„Seats, seat belts and mirrors are
correctly adjusted.
„All gauges and control indicators.
„Brake operation.
Starting the engine
With manual transmission in neutral,
depress clutch and foot brake,
(automatic transmission 3 in P or N),
do not accelerate.
Petrol engines: Turn key to START
and release it.
Diesel engines: Turn key to ON,
when preheating control indicator N
extinguishes, turn key to START and
release it.
Preheating system switches on only if
outside temperature is low.
Key returns automatically to ON
position when released.Start attempts should not last longer
than 15 seconds. If engine does not
start, wait 15 seconds before
repeating starting procedure. If
necessary, depress accelerator
before repeating starting procedure.
Parking the vehicle
„Apply the parking brake firmly
without actuating the release
button. On a downhill or uphill
slope, apply as firmly as possible.
Depress foot brake at the same
time to reduce operating forces.
„Push key into ignition switch before
turning to LOCK position and
removing (vehicles with automatic
transmission3: depress foot brake
and shift into P). Turn steering
wheel until lock is felt to engage
(anti-theft protection).
„If the vehicle is parked on a level
surface or a hill, select 1st gear
before switching the ignition off,
(vehicles with automatic
transmission 3: shift into P). Also
turn front wheels away from kerb if
parked on an uphill slope.

Page 95 of 153

9-8Driving and operating
Catalytic converter
Controlling exhaust emission
The catalytic converter reduces to a
minimum the proportion of noxious
materials in the exhaust, such as
carbon monoxide (CO),
hydrocarbons (CH) and nitrogen
oxides (NO
x).
Leaded fuel will damage the catalytic
converter and parts of the electronic
system, thereby rendering them
inoperative.„If the engine misfires or runs
roughly after a cold start, the
engine power has reduced
significantly or other unusual
operating problems occur that
indicate a fault in the ignition
system, seek the assistance of a
workshop as quickly as possible.
Drive at a slower speed and with
less engine revs for a short time, if
necessary.
„If unburned fuel enters the catalytic
converter, this may result in
overheating and irreparable
damage to the catalytic converter.
You should therefore avoid
frequent cold starts, unnecessarily
long use of the starter when setting
off, running the tank dry (an
irregular fuel supply leads to
overheating) and starting the
engine by pushing or towing.„If the control indicator for exhaust
emissions Z illuminates whilst
driving, seek the assistance of a
workshop immediately. Control
indicatorZ for exhaust emissions
35-11.
Exhaust gases
Caution
Damage to the catalytic converter or
the vehicle may result if the following
points are not observed.
9 Danger
Engine exhaust gases contain
poisonous carbon monoxide,
which has no colour or odour and
can be lethal if inhaled.
If exhaust fumes penetrate the
vehicle interior, open the windows
and seek the assistance of a
workshop immediately.

Page 99 of 153

9-12Driving and operating
Fuel
Petrol engine fuel
Use only unleaded fuels meeting the
specifications of DIN EN 228.
Refuel using the correct octane
number 3 12-3.
If the RON 95 label is attached to the
tank flap, unleaded fuel with an
octane rating of 95 or higher must be
used.
Diesel engine fuel
Use only diesel engine fuel meeting
the specifications of DIN EN 590.
Marine diesel fuel, fuel oils, diesel
fuels, which are entirely or partially
plant based such as rape seed oil or
bio-diesel, Aquazole and similar
diesel-water emulsions must not be
used.The flow and filterability of diesel
fuels are temperature-dependent.
Fuel filler cap
If replacing the fuel filler cap, be sure
to use the original fuel filler cap for
your model, to ensure full
functionality.
Refuelling
Caution
A fuel of too low an octane can lead
to engine damage.
9 Warning
Before refuelling, switch off the
engine and any heating systems
with combustion chambers.
Switch off mobile phones.
Fuel is inflammable and
explosive, therefore avoid dealing
with fuel near naked flames and
doing anything that would
generate sparks. No smoking!
This also applies where the smell
of fuel is noticeable. If the smell of
fuel vapour occurs in the vehicle
itself, have the cause remedied
immediately by a workshop.
Observe the operating and safety
instructions of the petrol station
when refuelling.

Page:   1-10 11-20 next >