warning PEUGEOT 1007 2008 User Guide

Page 30 of 189

2
33
General menu
Press the "MENU" button to gain
access to the general menu, then
press the "  " or "  " buttons to scroll
through the following items:
- radio-CD,
- vehicle confi guration,
- options,
- display settings,
- languages,
- units.
Press the "OK" button to select the
menu required. Vehicle confi guration
Once the "Vehicle confi guration"
menu has been selected, you can
activate or deactivate the following
equipment:
- rear wiper linked with reverse
gear,
- "follow-me-home" lighting.
Presentation
This displays the following informa-
tion, via the RD4 audio equipment
control keypad:
- the time,
- the date,
- the outside temperature (this fl ashes if there is a risk of ice),
- the audio source displays (radio, CD, ...),
- the status of the accesses (doors, boot, ...),
- the warning messages (e.g.: "Anti- pollution system faulty") or infor-
mation messages (e.g.: "Auto
lights on"), displayed temporarily,
can be cleared by pressing the

"ESC" button,
- the trip computer (see corre- sponding section).
MONOCHROME DISPLAY A
Options
Once the "Options" menu has been
selected, you can start diagnostics of
the status of the equipment (active,
not active, faulty).
Radio-CD
With the RD4 audio equipment
switched on, once the "Radio-CD"
menu has been selected, you can
activate or deactivate the functions
linked with the use of the radio (RDS
following, REG mode), the CD or the
CD changer (introscan, random play,
CD repeat).

Page 32 of 189

2
35
MONOCHROME DISPLAY C (without RD4 audio equipment)
General menu
Press the "MENU" button to access
the general menu:
- trip computer (see corresponding section),
- personalisation-confi guration.
Turn the navigator to select the menu
required, then confi rm by pressing
the navigator.
Presentation
It displays the following information:
- the time,
- the date,
- the exterior temperature (this fl ashes if there is a risk of ice),
-
the accesses check (doors, boot, ...),
- the warning messages (e.g.: "Antipollution system faulty")
or information messages (e.g.:
"Automatic headlamp lighting
activated"), displayed tempora-
rily, can be cleared by pressing
the "ESC" button,
- the trip computer (see corre- sponding section), Parameter configuration
There are three buttons and a navi-
gator to enable you to control the
screen:
-
"MENU" to display the general
menu,
- "MODE" to change the perma-
nent application (trip computer,
date, ...),
- "ESC" to abandon the operation
in progress,
- Rotation of the navigator:
movement on the display or
changing of a setting,
- Press on the navigator: confi r-
mation of the selection. "Personalisation-
Configuration" menu
Once this menu has been selected, you
can access the following functions:
- defi ne the vehicle parameters,
- display confi guration,
- selection of the language.

Page 34 of 189

2
37
MONOCHROME SCREEN C
"Audio functions" menu
With the RD4 audio equipment
switched on, once this menu has
been selected, you can activate
or deactivate the functions linked
with the use of the radio (RDS,
REG, RadioText), the CD or the CD
changer (introscan, random play, CD
repeat).
Presentation
This displays the following informa-
tion, via the RD4 audio equipment
control keypad:
- the time,
- the date,
- the outside temperature (this fl ashes if there is a risk of ice),
- the audio source displays (radio, CD, ...),
- the status of the accesses (doors, boot, ...),
- the warning messages (e.g.: "Antipollution system faulty")
or information messages (e.g.:
"Automatic headlamp lighting
activated"), displayed temporar-
ily, can be cleared by pressing
the "ESC" button,
- the trip computer (see corre- sponding section). General menu
Press the
"MENU" button to gain
access to the general menu:
- audio functions,
- trip computer (see corresponding section),
- personalisation-confi guration,
- telephone (hands-free kit).
Press the "  " or "  " buttons to select
the menu required, then confi rm by
pressing the "OK" button.
"Personalisation-
Configuration" menu
Once this menu has been selected,
you can gain access to the following
functions:
- defi ne the vehicle parameters,
- display confi guration,
- selection of the language.

Page 36 of 189

2
39
COLOUR SCREEN
Displays on the screen
When the ignition is switched on, this
displays the following information
automatically and directly:
- the time,
- the date,
- the outside temperature (if there is a risk of ice, you are warned
by a message).
Warning messages (e.g.: "Fuel level
low") and vehicle function status
messages (e.g.: "Automatic switching
on of the headlamps activated")
may appear temporarily. These can
be cleared by pressing the "ESC"
button. General menu
When the RT4 GPS audio/telephone
is switched on, select the menu
which corresponds to the following
applications:
- the satellite navigation system,
- the guidance on the map,
- the traffi c information,
- the audio sources (radio, CD,
Jukebox, ...),
- the telephone directories and functions,
- the confi guration of the screen and the setting of the parameters
of the vehicle’s equipment,
- the displaying of a video.
- the vehicle diagnostics (warnings log and status of the functions). Controls
From the RT4 GPS audio/telephone
control panel, to select one of the
applications:

 press the "MENU" button to gain
access to the general menu ,

 turn the dial to move the selection,

 press the dial to confi rm the
selection,
or

 press the "ESC" button to aban-
don the operation in progress and
return to the previous display.
For further details concerning these
applications, refer to the RT4 part of
the "Audio and Telematics" section.

Page 68 of 189

3
71
REAR INTERIOR LAYOUT
5. Retaining straps
These secure the warning triangle,
the tool kit, oil cans...
1. Rear parcel shelf
To remove the shelf:
- tilt and slightly raise the shelf,
- pull upwards on each side to
detach it from its fasteners.
There are several options for storing
the shelf:
- either behind the rear seats,
- or fl at in the boot.
2. Retaining hooks
3. Stowing rings
4. Luggage retaining net
Hooked onto the stowing rings, this
enables your luggage to be secured. 6. Storage trays in the fl oor
The right storage tray houses the
subwoofer of the JBL audio system.
7. Armrests/Side storage trays
These have recesses for storing a
can and a bottle.
8. Grab handles with coat hook

Page 71 of 189

4
74
ELECTRONIC ENGINE IMMOBILISER
This locks the engine control system
a few moments after the ignition has
been switched off and therefore pre-
vents starting of the vehicle by any-
one who does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code is
recognised and starting is possible.

If the system does not function
correctly, the service warning light
comes on, accompanied by an
audible signal and a message on the
multifunction display.
In this case, your vehicle will not
start. Contact a PEUGEOT dealer as
soon as possible.

Lost keys
Visit a PEUGEOT dealer with the
vehicle’s V5 registration certifi cate
and your personal identifi cation docu-
ments.
A PEUGEOT dealer will be able to
retrieve the key code and the trans-
ponder code required to order a
replacement key.
Programming the remote
control
Following changing of the remote
control battery or disconnection of
the vehicle battery, the remote control
must be reprogrammed.

 Wait at least one minute before
using the remote control.

 Switch on the ignition.

 Press button B or C for at least
fi ve seconds within the next ten
seconds.

 Switch off the ignition.

 Wait at least one minute before
using the remote control.
The remote control is now working
again.
Changing the remote control
battery
Battery ref.: CR1620/3 volts.
The information "battery fl at" is given
by displaying of the service warning
light, accompanied by an audible
signal and a message on the multi-
function display.
To replace the battery, unclip the
casing using a coin at the notch.
If the remote control does not work
after the battery has been changed,
re-programme the remote control.

Page 73 of 189

4
74
ELECTRONIC ENGINE IMMOBILISER
This locks the engine control system
a few moments after the ignition has
been switched off and therefore pre-
vents starting of the vehicle by any-
one who does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code is
recognised and starting is possible.

If the system does not function
correctly, the service warning light
comes on, accompanied by an
audible signal and a message on the
multifunction display.
In this case, your vehicle will not
start. Contact a PEUGEOT dealer as
soon as possible.

Lost keys
Visit a PEUGEOT dealer with the
vehicle’s V5 registration certifi cate
and your personal identifi cation docu-
ments.
A PEUGEOT dealer will be able to
retrieve the key code and the trans-
ponder code required to order a
replacement key.
Programming the remote
control
Following changing of the remote
control battery or disconnection of
the vehicle battery, the remote control
must be reprogrammed.

 Wait at least one minute before
using the remote control.

 Switch on the ignition.

 Press button B or C for at least
fi ve seconds within the next ten
seconds.

 Switch off the ignition.

 Wait at least one minute before
using the remote control.
The remote control is now working
again.
Changing the remote control
battery
Battery ref.: CR1620/3 volts.
The information "battery fl at" is given
by displaying of the service warning
light, accompanied by an audible
signal and a message on the multi-
function display.
To replace the battery, unclip the
casing using a coin at the notch.
If the remote control does not work
after the battery has been changed,
re-programme the remote control.

Page 76 of 189

4
77
Selection of the type of
protection Remote control failure
Unlock the doors using the key.
Open the door.
The alarm is triggered.
Switch on the ignition.
The electronic engine immobiliser
system recognises the key.
The siren stops and the alarm is
disarmed.
Do not make any modi-
fi cations to the alarm
system, this could result in
malfunctions.
To de-activate external protection
only
Press the unlocking button on the
remote control.
The direction indicators fl ash for two
seconds.
The red indicator light on the switch

1 goes out. Work on the battery
The alarm must not be set when the
battery is disconnected. Otherwise,
the siren will sound.
After reconnecting the battery:
- lock or deadlock, then unlock
the vehicle using the remote
control,
- the alarm will be operational again the next time the vehicle
is locked or deadlocked.
To set the alarm to external
protection only
If you want to leave a window partially
open, or a pet inside the vehicle, you
need to select external protection
only:
- switch off the ignition,
- within the next ten seconds,
press the control button 1 until
the warning light comes on
continuously,
- get out of the vehicle,
- lock or deadlock the vehicle,
- the direction indicators light for two seconds,
- the red indicator light on the switch 1 fl ashes once a second.

Page 78 of 189

4
79
"SESAME" DOORS
The exterior and interior handles
only permit triggering of the electric
movement of the door when it is fully
closed or fully open.
Opening and closing of the doors is
accompanied by an audible signal.
Closing from outside
Give a fi rm, fast push forwards on the
handle, without guiding the door, to
trigger the electric movement of the
door.
Opening from outside
Using your hand, tilt the handle
towards the rear of the vehicle and
remove your hand from the handle
when the electric movement of the
door begins.
Locking/Unlocking from inside
Press button
A , the red warning light
comes on when the vehicle is locked
and switches off when it is unlocked.
This locks/unlocks the doors and the
tailgate.
If the vehicle is locked or dead-
locked from outside, the red warning
light fl ashes and button A does not
function. In this case, use the key or
the remote control for unlocking.
Opening/Closing from inside
The opening and closing operates in
the same way as from outside.
None of the door opening switches
function when the vehicle is dead-
locked.
To open using the interior
handle: tilt the handle, with
the palm of your hand to-
wards the door.

Page 79 of 189

4
80
Automatic central locking
The doors can lock automatically
when you are driving (at a speed of
more than 6 mph (10 km/h).
You can activate or deactivate this
function. Driving with the doors locked
may make access to the
passenger compartment by
the emergency services more
diffi cult in an emergency.
Activation
With the ignition on, press and hold
button A .
Activation of the function is accom-
panied by an audible signal and a
message on the multifunction display.
Deactivation
With the ignition on, press and hold
button A .
Deactivation of the function is
accompanied by an audible signal
and a message on the multifunction
display.
"Door open" alert -
when the vehicle is moving,
by lighting of the "door open"
warning light, accompanied by
an audible signal and a message
on the multifunction display for a
few seconds.
Opening/Closing using the
remote control
Press button C or D to open or close
the left or right door.
The opening and closing of the
door is accompanied by an audible
signal.
2nd press on button C or D during
opening/closing  interruption of the
movement.
3rd press on button C or D  move-
ment of the door in the opposite
direction.
You are advised to use the
remote control or the con-
trols as much as possible.
Opening/Closing from the front
Press switch
B to open or close the
corresponding door.
Choosing the movement of the door
using the controls:
- pull  opens the door,
- push  closes,
- second press  stops the
movement,
- the controls do not function above 3 mph (5 km/h).
If a door or the boot is not
closed properly, you are
warned:
- when the engine is running,
by lighting of the "door open"
warning light, accompanied by
a message on the multifunction
display for a few seconds.

Page:   < prev 1-10 11-20 21-30 31-40 41-50 50 next >