reset PEUGEOT 1007 DAG 2008 Owners Manual

Page 15 of 194

1
18
PETROL MANUAL GEARBOX AND "2 TRONIC" GEARBOX INSTRUMENT PANELS

1. Trip distance recorder zero
reset and total/trip distance
recorder display button.

2. Emission control system
warning light.

3. Service warning light.

4. Anti-lock braking system (ABS)
warning light.

5. Electronic stability control
(ESP/ASR) warning light.

6. Handbrake, brake fl uid level
and electronic brake force
distribution warning light.
7. Maximum coolant temperature
warning light.

8. Engine oil pressure warning
light.

9. Punctured wheel warning light.

10. Battery charge warning light.

11. Left direction indicator.

12. Fuel gauge.

13. Low fuel level warning light.

14. Central STOP warning light.

15. Speedometer.
16. Speed limiter/cruise control
indicator light.

17. Service indicator, engine oil
level gauge and total/trip
distance recorder.

18. "2 Tronic" gearbox indicator.

19. Foot on brake warning light
("2 Tronic" gearbox).

20. Rev counter.

21. Right direction indicator.

22. Dipped headlamps indicator
light.

23. Main beam headlamps indicator
light.

24. Front fog lamps indicator light.

25. Rear fog lamp indicator light.

26. Door open warning light.

27. Seat belt not fastened warning
light.

28. Passenger air bag disarmed
warning light.

29. Front, steering column, side and
curtain air bags warning light.

30. Lighting rheostat button.

Page 16 of 194

1
19
DIESEL MANUAL GEARBOX INSTRUMENT PANEL

1. Trip distance recorder zero
reset and total/trip distance
recorder display button.

2. Emission control system
warning light.

3. Service warning light.

4. Anti-lock braking system (ABS)
warning light.

5. Electronic stability control
(ESP/ASR) warning light.

6. Handbrake, brake fl uid level
and electronic brake force
distribution warning light.
7. Maximum coolant temperature
warning light.

8. Engine oil pressure warning
light.

9. Punctured wheel warning light.

10. Battery charge warning light.

11. Left direction indicator.

12. Fuel gauge.

13. Low fuel level warning light.

14. Central STOP warning light.

15. Speedometer.
16. Diesel engine pre-heat warning
light.

17. Water in diesel fi lter warning
light.

18. Speed limiter/cruise control
indicator light.

19. Service indicator, engine oil
level gauge and total/trip
distance recorder.

20. Rev counter.

21. Right direction indicator.

22. Dipped headlamps indicator
light.

23. Main beam headlamps indicator
light.

24. Front fog lamps indicator light.

25. Rear fog lamp indicator light.

26. Door open warning light.

27. Seat belt not fastened warning
light.

28. Passenger air bag disarmed
warning light.

29. Front, steering column, side and
curtain air bags warning light.

30. Lighting rheostat button.

Page 21 of 194

1
24
Service indicator
This indicates when the next service
is due in accordance with the manu-
facturer's servicing schedule.
The point at which the next service
is due is calculated from the last indi-
cator zero reset. It is determined by
two parameters:
- the distance travelled,
- the time which has elapsed since the last service.
Operation
When the ignition is switched on, the
spanner symbolising the servicing
operations comes on; the distance
recorder display indicates the number
of miles [kilometres] (rounded off)
remaining until the next service.

Example: 4,800 miles/km remain before
the next service. For fi ve seconds after
the ignition is switched on, the display
indicates: 10 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and
the display indicates the total or trip
distance.
10 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and the
spanner remains lit.
It indicates that a service must be
carried out soon. The display indi-
cates the total or trip distance. The service is overdue.
The spanner fl ashes for 5 seconds
each time the ignition is switched on.
10 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and the
spanner remains lit.
The display indicates the total or trip
distance.
The distance remaining before the
next service may be weighted by the
time factor, depending on the user's
driving habits.
The spanner may also come on if
more than two years have elapsed
since the last service.
The distance remaining to
the next service is less than
500 miles/1,000 km.

Example: 400 miles/900 km remain
before the next service.
For 5 seconds after the ignition is
switched on, the display indicates:
Example: the service is overdue by
300 miles/km, your vehicle must be
serviced as soon as possible.
For 5 seconds after the ignition is
switched on, the display indicates:

Page 22 of 194

1
25
Service indicator zero re-set
Your PEUGEOT dealer carries out
this operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:

 Switch off the ignition,

 Press and hold the trip recorder
re-set button,

 Switch on the ignition.
The display begins a countdown.
When the display shows "=0" , release
the button; the spanner disappears. Total/trip distance recorder
Briefl y pressing the button alternates
between the total and trip distance
displays.
To reset the trip distance recorder to
zero, when it is displayed press the
button until zeros appear.
Lighting rheostat
With the lights on, press the button to
vary the intensity of the lighting of the
instruments and controls. When the
lighting reaches the required bright-
ness, release the button.
After this operation, if you
wish to disconnect the bat-
tery, lock the vehicle and
wait for at least fi ve minutes,
otherwise the zero re-set will not be
registered.

Page 24 of 194

1
27
TRIP COMPUTER

 Press the button, located at the
end of the wipers stalk , to dis-
play the various items of trip
computer data in succession. The trip computer data is the
following:
System which provides current infor-
mation concerning the route travelled
(range, consumption, ...).

 Press the control for more than two
seconds to reset the distance trav-
elled, the average consumption
and the average speed to zero.
Monochrome display A
Zero reset
Data displays - the range,
- the current consumption,
- the distance travelled,
- the average consumption,
- the average speed.

 The next press then returns you
to the normal display.

Page 26 of 194

1
29
Distance remaining to be travelled
(km or miles)
This is the distance remaining to be travelled to the fi nal destination. It is either calculated instantly by the navigation system if guidance is acti-vated, or entered by the user.
If the distance is not entered, dashes are displayed in place of the digits.
Average speed
(km/h or mph)
This is the average speed cal-culated since the last trip com-puter zero reset (ignition on).
Range
(km or miles)
This indicates the number of miles (or kilometres) which can still be travelled with the fuel remaining in the tank in relation to the average consumption over the last few miles (kilometres) travelled.
Current consumption
(l/100 km or km/l or mpg)
This is the average quantity of fuel consumed over the last few seconds.
Average consumption
(l/100 km or km/l or mpg)
This is the average quantity of fuel consumed since the last trip compu-ter zero reset.
Distance travelled
(km or miles)
This indicates the distance travelled since the last trip computer zero reset.
A few definitions…
When the range falls below 20 miles (30 km), dashes are displayed. After fi lling with at least 5 litres of fuel, the range is recalculated and is displayed when it exceeds 60 miles (100 km).
If dashes are displayed con-tinuously while driving in place of the digits, contact a PEUGEOT dealer.
This function is only displayed from 20 mph (30km/h).
This fi gure may increase fol-lowing a change of driving style or relief, resulting in a signifi cant change in the cur-rent consumption.

Page 175 of 194

168
1
2
3
3
3
3
2
3
3
4
4
1
3
2
3
1
2
3
3
2
2
2
1
2
2
2
1
1
4
3
2
2
3
3
6
1
Each audio source (Radio, CD, MP3,
Jukebox, CD changer) has its own
separate settings.
text message ring
CONFIGURATION DISPLAY CONFIGURATION choose colour
adjust luminosity
set date and time
select units
SOUND voice commands setting
speech synthesis setting
guidance instructions volume
other message volume
select female/male voice
activate/deactivate auxiliary source
* The parameters vary according to vehicle (refer to the "Multifunction displays" chapter).
SELECT LANGUAGE
DEFINE VEHICLE PARAMETERS * VIDEO
ACTIVATE VIDEO MODE
VIDEO PARAMETERS
display formats
adjust luminosity
set colours
set contrasts
VEHICLE DIAGNOSTICS Press the MENU button for more
than 2 seconds to gain access to
the next fl ow chart.
ALERT LOG
STATUS OF FUNCTIONS *
RESET TYRE PRESS. DETEC. SYS. * VOICE COMMANDS LIST
AUDIO/TELEPHONE DIAGNOSTICS
GPS COVERAGE
UNIT BACKUP POWER
UNIT DESCRIPTION
NAVIGATION DEMONSTRATION
SERVICES CONFIGURATION
Press the Music button several
times in succession to access
the following settings.
MUSICAL AMBIENCE
BASS
TREBLE
LOUDNESS CORRECTION
FR-RR BALANCE
LH-RH BALANCE
AUTO VOLUME CORRECTION
Flow chart version 7.0
call diversion to mailbox n°
delete calls log