PEUGEOT 107 2005 Workshop Manual

Accesses48 -
02-06-2005
49Accesses-
02-06-2005
BOOT
2. Spare wheel / Additional
storage compartments
Located under the carpet and a
plastic cover, this contains the tools
for wheel changing and towing.
There are two shelf storage options:
- either behind the rear seats,
- or lat in the boot.
1.
Rear shelf
To remove the shelf:
- unhook the shelf from its ixing A,
- pull upwards on each side to detach it from its ixings,
- raise then tilt the shelf slightly to remove it. In order to obtain additional
space, the spare wheel can
be removed temporarily
(boot tray available as an
accessory).

Accesses50 -
02-06-2005
FILLING THE FUEL TANK
F Open the fuel iller lap.
F Insert the key, turn it slightly to the
left then return to the right.
Low fuel level
When the fuel tank mini-
mum level is reached, the
last block lashes.
You have approximately 5 litres
remaining.
In certain driving conditions and de-
pending on the engine, the distance
which can be travelled with the fuel
remaining may be less than 30 miles
(50 km).
When the frequency of the lashing
increases, you have approximately
3 litres remaining . F
Unscrew the cap and hook it onto
the clip located on the inside of
the lap.
A label afixed on the inside of the
lap reminds you which type of fuel
to use.
When you ill the fuel tank, do not
continue after the 3rd cut-off of the
pump. This could cause malfunc-
tions.
The capacity of the fuel tank is
approximately 35 litres.
F After illing the fuel tank, screw the
cap back on fully to the right until it
clicks and close the lap.
F Remove the key.
Note:
if you run out of fuel,
the emission control system
warning light may come on
on the instrument panel.
It will switch off automatically after
the engine has been started a few
times.
The fuel tank must be illed
with the engine switched
off.

51Visibility-
02-06-2005
LIGHTS STALK
Front and rear lights
Selection is by rotation of ring A.
1 - Lights off
2 - Side lights
3 - Dipped headlamps /
Main beam
headlamps
Dipped headlamps/main beam
headlamps
Dipped headlamps: pull the stalk.
Main beam headlamps: push the
stalk.
Lights on buzzer
When the driver's door is opened
with the ignition off, a continuous
audible signal is heard if you have
left your lights on.
Rear fog lamp
With the dipped head-
lamps on, selection is
by rotation of ring B
forwards to switch on
and rearwards to switch
off. The status is displayed by the in-
dicator light on the instrument panel.
Note: Switching to side lights does
not switch off the rear fog lamps if
they are on.
In clear weather or in rain,
both day and night, the rear
fog lamps are dazzling and
are prohibited.
Do not forget to switch them off when
they are no longer needed.
Direction indicators (lashers)
Left: stalk downwards.
Right : stalk upwards.Headlamp lash
Pull the stalk fully towards you.

Visibility52 -
02-06-2005
53Visibility-
02-06-2005
WINDSCREEN WIPER STALK
Front windscreen wiper
MIST Single wipe.
For a single wipe of the windscreen, push the control
upwards then release it.
OFF Off.
INT Intermittent wipe.
LO Normal wipe (moderate rain).
HI Fast wipe (heavy rain).
When using a car wash,
switch off the ignition and
ensure that the wiper blades
are in the low position.
In winter, you are advised to wait until
the windscreen has been de-iced
fully before operating the windscreen
wipers stalk.
Windscreen wash-wipe
Pull the wipers stalk towards you.
Rear wiper and wash-wipe
Turn ring A to "ON" for a steady
wipe.
Turn it forwards to trigger
the wash-wipe during wi-
ping.
Rear wash-wipe
Ring A at "OFF" (wiper off).
Turn it towards you to trig-
ger a wash-wipe jet.

Visibility52 -
02-06-2005
53Visibility-
02-06-2005
HEADLAMP ADJUSTMENT
Depending on the load in your vehi-
cle, adjusting the beam of the head-
lamps is recommended as follows.
0. 1 or 2 people in the front seats.
-. 3 people.
1. 4 people.
2. 4 people + maximum authorised
load.
3. Driver + maximum authorised
load.
Initial setting is position 0. In this position, it comes
on on opening the driver's
door.
The courtesy light is de-
activated and is permanently
off.
COURTESY LIGHT
Permanently on.

Safety
54 -
02-06-2005
55
Safety
-
02-06-2005
HORN
Press one of the spokes of the steer-
ing wheel.
HAZARD WARNING LIGHTS
Press the button, the direction indi-
cators lash.
They can operate with the ignition
off.
ANTI-LOCK BRAKING
SYSTEM (ABS) AND EBFD/
CSC BRAKING SYSTEM
The ABS, in conjunction with the
EBFD/CSC braking system, increas-
es the stability and manoevrability of
your vehicle on braking and provides
improved control in yaw conditions,
in particular on poor or slippery road
surfaces.
The ABS prevents wheel lock in the
event of emergency braking.
The EBFD/CSC system provides full
control of the braking pressure wheel
by wheel. A distribution between:
- the front and the rear in the case of
the EBFD (Electronic Brake Force
Distribution),
- the left and the right in the case of the CSC (Cornering Stability
Control).
When the vehicle is being
driven, illumination of this
warning light indicates that
the handbrake is still on
or has not been properly
released.
When parking on a slope,
direct your wheels towards
the pavement and pull the
handbrake.
The handbrake must not be used
to stop or brake while the vehicle is
moving.
HANDBRAKE
Applying
Pull the handbrake to immobilise
your vehicle.
Releasing
Pull on the handle and press the
button to release the handbrake.
Note: when changing wheels
(tyres), make sure that these
are approved.
The anti-lock braking system
comes into operation automatically
when there is a risk of wheel lock.

Safety
54 -
02-06-2005
55
Safety
-
02-06-2005
HORN
Press one of the spokes of the steer-
ing wheel.
HAZARD WARNING LIGHTS
Press the button, the direction indi-
cators lash.
They can operate with the ignition
off.
ANTI-LOCK BRAKING
SYSTEM (ABS) AND EBFD/
CSC BRAKING SYSTEM
The ABS, in conjunction with the
EBFD/CSC braking system, increas-
es the stability and manoevrability of
your vehicle on braking and provides
improved control in yaw conditions,
in particular on poor or slippery road
surfaces.
The ABS prevents wheel lock in the
event of emergency braking.
The EBFD/CSC system provides full
control of the braking pressure wheel
by wheel. A distribution between:
- the front and the rear in the case of
the EBFD (Electronic Brake Force
Distribution),
- the left and the right in the case of the CSC (Cornering Stability
Control).
When the vehicle is being
driven, illumination of this
warning light indicates that
the handbrake is still on
or has not been properly
released.
When parking on a slope,
direct your wheels towards
the pavement and pull the
handbrake.
The handbrake must not be used
to stop or brake while the vehicle is
moving.
HANDBRAKE
Applying
Pull the handbrake to immobilise
your vehicle.
Releasing
Pull on the handle and press the
button to release the handbrake.
Note: when changing wheels
(tyres), make sure that these
are approved.
The anti-lock braking system
comes into operation automatically
when there is a risk of wheel lock.

Safety54 -
02-06-2005
55Safety-
02-06-2005
When this warning light
comes on, it indicates that
there is a malfunction of the
ABS, which can cause a
loss of control of the vehicle
when braking.
Consult a PEUGEOT dealer.
When these warn-
ing lights comes
on simultaneous-
ly, it indicates that
there is a malfunc-
tion of the braking system or that the
handbrake has not been released
fully, which can cause a loss of con-
trol of the vehicle when braking.
Stop immediately.
Consult a PEUGEOT dealer.SEAT BELTS
Fastening the seat belts
Pull the strap, then insert the buckle
into the stalk.
Pretensioning front seat
belts with force limiter
Safety in the event of front
impacts has been impro-
ved by means of the introduction of
pretensioning seat belts with force
limiter for the front seats. Depending
on the force of the impact, the pre-
tensioning system instantly tightens
the seat belts and pulls them against
the body of the occupants.
The pretensioning seat belts are ac-
tive when the ignition is on.
The force limiter reduces the pres-
sure of the seat belt on the body
of the occupant in the event of an
accident.
Normal operation of the
ABS may make itself felt by
slight vibrations of the brake
pedal.
In emergency braking,
press very irmly without
releasing the pressure. 3-door
5-door
Rear seat belts
The rear seats are equipped with two
three-point inertia reel seat belts.
You can store the seat belt buckles in
the housing A.

Safety54 -
02-06-2005
55Safety-
02-06-2005
When this warning light
comes on, it indicates that
there is a malfunction of the
ABS, which can cause a
loss of control of the vehicle
when braking.
Consult a PEUGEOT dealer.
When these warn-
ing lights comes
on simultaneous-
ly, it indicates that
there is a malfunc-
tion of the braking system or that the
handbrake has not been released
fully, which can cause a loss of con-
trol of the vehicle when braking.
Stop immediately.
Consult a PEUGEOT dealer.SEAT BELTS
Fastening the seat belts
Pull the strap, then insert the buckle
into the stalk.
Pretensioning front seat
belts with force limiter
Safety in the event of front
impacts has been impro-
ved by means of the introduction of
pretensioning seat belts with force
limiter for the front seats. Depending
on the force of the impact, the pre-
tensioning system instantly tightens
the seat belts and pulls them against
the body of the occupants.
The pretensioning seat belts are ac-
tive when the ignition is on.
The force limiter reduces the pres-
sure of the seat belt on the body
of the occupant in the event of an
accident.
Normal operation of the
ABS may make itself felt by
slight vibrations of the brake
pedal.
In emergency braking,
press very irmly without
releasing the pressure. 3-door
5-door
Rear seat belts
The rear seats are equipped with two
three-point inertia reel seat belts.
You can store the seat belt buckles in
the housing A.

Safety56 -
02-06-2005
57Safety-
02-06-2005
Wherever you are seated in
the vehicle, always fasten
your seat belt, even for short
journeys.
Do not invert the seat belt buckles as
they will not fulil their role fully.
If the seats have armrests*, the lap
part of the seat belt must always
pass under the armrest.
Before and after use, ensure that the
seat belt is rolled up correctly.
In order to be effective, a seat belt:
- must be tightened as close to the body as possible,
- must restrain one adult only,
- must not bear any trace of cuts or fraying,
- must not be twisted,
- must not be transformed or modi- ied. Clean the seat belt straps with soapy
water or a textile cleaning product,
sold by PEUGEOT dealers.
After folding or moving a seat or rear
bench seat, ensure that the seat belt
is positioned and rolled up correctly.
Recommendations for child seats:
- use a suitable child seat if the
passenger is less than 12 years old
or shorter than one metre ifty,
- do not use the strap-guide* when a child seat is installed.
Depending on the nature and
seriousness of the impacts , the pre-
tensioning device may be triggered
before and independently of the air
bags.
In all cases, the air bag warning light
comes on.
Following an impact, have the seat
belts system checked, and if ne-
cessary replaced, by a PEUGEOT
dealer.
* According to model.