PEUGEOT 107 2006 Service Manual

3COMFORT
41
ADVICE ON CHILD
SEATS
The incorrect installation of a child
seat in a vehicle compromises the
child's protection in the event of an
accident.
Remember to fasten the seat belts or
the child seat harness keeping the
slack in relation to the child's body
to a minimum , even for short jour-
neys.
For optimum installation of the "for-
ward facing" child seat, ensure that
the back of the child seat is in contact
with the back of the vehicle's seat
and that the head restraint does not
cause any discomfort.
If the head restraint has to be
removed, ensure that it is stored or
attached securely to prevent it from
being thrown around the vehicle in
the event of sharp braking. Children under the age of 10 must not
travel in the "forward facing" position
on the front passenger seat, unless
the rear seats are already occupied
by other children, cannot be used or
are absent.
Disarm the passenger air bag* when
a "rear facing" child seat is installed
on the front seat. Otherwise, the child
would risk being seriously injured or
killed if the air bag were to inflate.
As a safety precaution, do not leave:
- one or more children alone and
unsupervised in a vehicle,
- a child or an animal in a vehicle which is exposed to the sun, with
the windows closed,
- the keys within reach of children inside the vehicle.
To protect young children from the
rays of the sun, fit side blinds on the
rear windows.
* According to country.
Installing a booster seat
The chest part of the seat belt must
be positioned on the child's shoulder
without touching the neck.
Ensure that the lap part of the seat
belt passes correctly over the child's
thighs.
PEUGEOT recommends the use of
a booster seat which has a back, fit-
ted with a seat belt guide at shoulder
level.

3COMFORT
42
"ISOFIX" MOUNTINGS
Your vehicle has been approved in
accordance with the new ISOFIX
regulation .
The seats*, represented below, are
fitted with regulation ISOFIX mount-
ings: These are three rings for each seat: This ISOFIX mounting system gua
r-
antees you fast, reliable and safe fit-
ting of the child seat in your vehicle.
The ISOFIX child seats are fitted
with two locks which are secured
easily on these lower rings A.
Some also have an upper strap
which is attached to the upper
ring B.
- two lower rings A, located between
the vehicle seat back and cushion,
indicated by a label,
* According to version.
- an upper ring
B, referred to as the
TOP TETHER , indicated by a mark-
ing on the rear seat back panel. To attach this strap, raise the
vehicle seat's head restraint
then pass the hook between
its rods. Then fix the hook
on the upper ring B and tighten the
upper strap.
The incorrect installation of a
child seat in a vehicle com-
promises the child's protec-
tion in the event of an acci-
dent.
For information regarding the ISOFIX
child seats which can be installed in
your vehicle, consult the summary
table for the location of the ISOFIX
child seats.

3COMFORT
43
ISOFIX CHILD SEAT RECOMMENDED BY PEUGEOT
RÖMER Duo (size category B1)
Group 1: from 9 to 18 kg
Installed in the forward facing position.Fitted with an upper strap.
Three seat body angles: sitting, reclining, lying.
This child seat can also be used on seats which are not fitted with ISOFIX mountings. In this case, it must be
attached to the vehicle seat using the three point seat be lt.
Follow the instructions for fitting the child seat given in the seat manufacturer's installation guide.

3COMFORT
44
SUMMARY TABLE FOR THE
LOCATION OF ISOFIX CHILD
SEATS
In accordance with the European
regulation ECE 16, this table indi-
cates the options for the installation
of ISOFIX child seats on the vehicle
seats fitted with ISOFIX mountings.
In the case of the universal and semi-
universal ISOFIX child seats, the
child seat's ISOFIX size category,
determined by a letter A, B, B1, C,
D, E, F, G , is indicated on the child
seat next to the ISOFIX logo. IUF:
seat approved for a Universal
I sofix seat, " Forward facing" with the
"Top Tether" upper strap. Weight of the child
/ indicative age
Less than 10 kg
(group 0)
Up to 6 months approx Less than 10 kg
(group 0)
Less than 13 kg (group 0+)
Up to 1 year approx From 9 to 18 kg
(group 1)
From 1 - 3 years approx
Type of ISOFIX child seat Infant car seat* "rear facing" "rea r facing" "forward facing"
ISOFIX size category F G C D E C D A B B1
Universal ISOFIX child
seats which can be installed on the rear seats X X X X X IUF
* The ISOFIX infant car seat is fixed to the lower rings of an ISOFIX
seat and occupies the two rear
seats.
X:
seat not suitable for the installa-
tion of an ISOFIX child seat of the
size category indicated.

4ACCESSES
45
KEYS / REMOTE CONTROL
Remote control
This carries out the vehicle locking -
unlocking and locating functions at a
distance.
Keys
The keys allow you to switch on the
ignition and operate the locks on the
front doors, the boot, the fuel tank
cap, the steering lock and the pas-
senger air bag disarming switch.Locking
Press button
A to lock the vehicle
from a distance. This is confirmed by
brief lighting of the direction indica-
tors.
Central locking and unlocking
From the driver's door, the keys allow
you to lock and unlock the doors and
boot simultaneously. Unlocking
Press button
B to unlock the vehicle.
This is confirmed by two successive
flashes of the direction indicators. Spotting the vehicle
To spot your vehicle, if you have
locked it, in a car park:

press button A, the direction indi-
cators come on briefly.
Note: after locking, if you
notice that a door is not
closed properly, close it then
lock the vehicle again.
The set of keys or remote
controls, supplied with your
vehicle, enable you to obtain
a maximum of three new
keys.
If all of the keys in your possession
are lost, a major operation will have
to be carried out on your vehicle.
Contact a PEUGEOT dealer.

4ACCESSES
46
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control sys-
tem as soon as the ignition has been
switched off and therefore prevents
starting of the vehicle by anyone who
does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code
must be recognised for starting to be
possible.
In the event of a malfunction, your
vehicle will not start.
Contact a PEUGEOT dealer.
Changing the remote control
battery
To change the battery, remove the
screw then unclip the housing using
a coin inserted at the ring.
Battery CR 2016/3 volts.
If the remote control does not work
after the battery has been changed,
reprogramme it.
Reprogramming the remote
control
Following replacement of the remote
control battery or in the event of a
remote control malfunction, it may be
necessary to reprogramme the sys-
tem.
 Switch off the ignition.
 Switch the ignition on again.
 Press one of the remote control
buttons immediately for a few sec-
onds.
 Switch off the ignition and remove
the key from the ignition lock.
The remote control is now working
again.
If the malfunction persists, contact a
PEUGEOT dealer. Driving with the doors locked
may make access to the pas-
senger compartment by the
emergency services more
difficult in an emergency.
As a safety measure (with children
on board), remove the key from the
ignition when leaving the vehicle,
even for a short time.
Do not make any modifications to the
electronic immobiliser system.
Do not discard the remote
control batteries, they con-
tain metals which are harm-
ful to the environment.
Take them to a PEUGEOT dealer-
ship, or to any other approved collec-
tion point. The high frequency remote control is
a sensitive system; do not operate it
in your pockets as there is a risk that
it may unlock the vehicle without you
being aware of this.
Avoid pressing the buttons of your
remote control out of range of your
vehicle, you risk rendering it inopera-
tive. It would then have to be repro-
grammed.

4ACCESSES
46
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control sys-
tem as soon as the ignition has been
switched off and therefore prevents
starting of the vehicle by anyone who
does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code
must be recognised for starting to be
possible.
In the event of a malfunction, your
vehicle will not start.
Contact a PEUGEOT dealer.
Changing the remote control
battery
To change the battery, remove the
screw then unclip the housing using
a coin inserted at the ring.
Battery CR 2016/3 volts.
If the remote control does not work
after the battery has been changed,
reprogramme it.
Reprogramming the remote
control
Following replacement of the remote
control battery or in the event of a
remote control malfunction, it may be
necessary to reprogramme the sys-
tem.
 Switch off the ignition.
 Switch the ignition on again.
 Press one of the remote control
buttons immediately for a few sec-
onds.
 Switch off the ignition and remove
the key from the ignition lock.
The remote control is now working
again.
If the malfunction persists, contact a
PEUGEOT dealer. Driving with the doors locked
may make access to the pas-
senger compartment by the
emergency services more
difficult in an emergency.
As a safety measure (with children
on board), remove the key from the
ignition when leaving the vehicle,
even for a short time.
Do not make any modifications to the
electronic immobiliser system.
Do not discard the remote
control batteries, they con-
tain metals which are harm-
ful to the environment.
Take them to a PEUGEOT dealer-
ship, or to any other approved collec-
tion point. The high frequency remote control is
a sensitive system; do not operate it
in your pockets as there is a risk that
it may unlock the vehicle without you
being aware of this.
Avoid pressing the buttons of your
remote control out of range of your
vehicle, you risk rendering it inopera-
tive. It would then have to be repro-
grammed.

4ACCESSES
47
ELECTRIC WINDOWS
The driver and front passenger each
have an electric window.
After the ignition has been switched
on, press or pull control 1. The win-
dow stops when you release the con-
trol.
Always remove the key from
the ignition when leaving
the vehicle, even for a short
time.
The driver must ensure that the front
passenger uses his electric window
correctly.
Be aware of children when operating
the windows.
DOORS
Locking/unlocking a door
from the inside
Normal locking/unlocking: the
doors lock/unlock independently.
To lock/unlock a door, press/pull but-
ton A.
Note: operating the handle does
not unlock the door, pull button A to
unlock. Simultaneous central locking/
unlocking of the doors and boot.
To lock/unlock the vehicle, press/pull
button
A on the driver's door.
For the other doors, carry out the
same operation as for normal lock-
ing/unlocking.
Driver's door open
If the driver's door is open,
the courtesy light remains
on if the button is in this
position.

4ACCESSES
48
CHILD LOCK
This prevents the opening of each of
the rear doors from the inside.
Push control 1 towards the outside of
the vehicle.
LOCKING/UNLOCKING THE
BOOT USING THE KEY*
To open, operate the lock B using the
key and raise the tailgate.
LOCKING/UNLOCKING THE
BOOT USING THE REMOTE
CONTROL*
The boot is locked/unlocked using
the buttons on the remote control.
Then, to open, press button C and
raise the tailgate.
Note: the boot can be locked/
unlocked using control A on the driv-
er's door.
REAR WINDOWS (5-door)
To partially open the rear windows,
pull the lever then push the window.
To close the window, pull then press
the lever to lock the window.
Check the status of this
safety device before switch-
ing on the ignition. * According to version.

4ACCESSES
48
CHILD LOCK
This prevents the opening of each of
the rear doors from the inside.
Push control 1 towards the outside of
the vehicle.
LOCKING/UNLOCKING THE
BOOT USING THE KEY*
To open, operate the lock B using the
key and raise the tailgate.
LOCKING/UNLOCKING THE
BOOT USING THE REMOTE
CONTROL*
The boot is locked/unlocked using
the buttons on the remote control.
Then, to open, press button C and
raise the tailgate.
Note: the boot can be locked/
unlocked using control A on the driv-
er's door.
REAR WINDOWS (5-door)
To partially open the rear windows,
pull the lever then push the window.
To close the window, pull then press
the lever to lock the window.
Check the status of this
safety device before switch-
ing on the ignition. * According to version.