PEUGEOT 107 2006 Workshop Manual (93 Pages)

4ACCESSES
49
BOOT
2. Spare wheel / Additional storage compartments
Located under the carpet and a plas-
tic cover, this contains the tools for
wheel changing and towing.
There are two shelf storage options:
- either behind the rear seats,
- or ﬂat in the boot.
1. Rear shelf
To remove the shelf:
- unhook the shelf from its ﬁxing
A,
- pull upwards on each side to detach it from its ﬁxings,
- raise then tilt the shelf slightly to remove it. In order to obtain additional
space, the spare wheel can
be removed temporarily
(boot tray available as an
accessory).

4ACCESSES
50
FILLING THE FUEL TANK
 Open the fuel ﬁller ﬂap.
 Insert the key, turn it slightly to the
left then return to the right. The
key returns to its initial position
and the cap is unlocked.
Low fuel level
When the fuel tank minimum
level is reached, the last
block ﬂashes, accompanied
by an audible signal.
You have approximately 5 litres
remaining.
In certain driving conditions and
depending on the engine, the dis-
tance which can be travelled with
the fuel remaining may be less than
30 miles (50 km).
When the frequency of the ﬂashing
increases, you have approximately
3 litres remaining . 
Unscrew the cap and hook it onto
the clip located on the inside of
the ﬂap.
A label afﬁxed on the inside of the
ﬂap reminds you which type of fuel
to use.
When you ﬁll the fuel tank, do not
continue after the 3rd cut-off of the
pump. This could cause malfunc-
tions.
The capacity of the fuel tank is
approximately 35 litres.
 After ﬁlling the fuel tank, screw the
cap back on fully to the right until it
clicks and close the ﬂap.
 Remove the key.
Note:
if you run out of fuel,
the emission control sys-
tem warning light may come
on on the instrument panel.
It will switch off automatically after
the engine has been started a few
times.
The fuel tank must be ﬁlled
with the engine switched
off .

5VISIBILITY
51
LIGHTS STALK
Front and rear lights
Selection is by rotation of ring A.
1 - Lights off
2 - Side lights
3 - Dipped
headlamps / Main
beam headlampsDipped headlamps/main beam
headlamps
Dipped headlamps: pull the stalk.
Main beam headlamps: push the
stalk.
Lights on buzzer
When the driver's door is opened with
the ignition off, a continuous audible
signal is heard if you have left your
lights on.
Rear fog lamp
With the dipped head-
lamps on, selection is
by rotation of ring B for-
wards to switch on and
rearwards to switch off.
The status is displayed by the indica-
tor light on the instrument panel.
Note: Switching to side lights does
not switch off the rear fog lamps if
they are on.
In clear weather or in rain,
both day and night, the rear
fog lamps are dazzling and
are prohibited.
Do not forget to switch them off when
they are no longer needed.
Direction indicators (ﬂashers)
Left: stalk downwards.
Right: stalk upwards.Headlamp ﬂash
Pull the stalk fully towards you.

5VISIBILITY
52
WINDSCREEN WIPER STALK
Windscreen wipers
MIST Single wipe.
For a single wipe of the windscreen, push the control
upwards then release it.
OFF Off.
INT Intermittent wipe.
LO Normal wipe (moderate rain).
HI Fast wipe (heavy rain).
When using a car wash,
switch off the ignition and
ensure that the wiper blades
are in the low position.
In winter, you are advised to wait until
the windscreen has been de-iced
fully before operating the windscreen
wipers stalk.

Windscreen wash-wipe
Pull the wipers stalk towards you.
Rear wiper and wash-wipe
Turn ring A to "ON" for a steady
wipe.
Turn it forwards to trigger
the wash-wipe during wip-
ing.
Rear wash-wipe
Ring A at "OFF" (wiper off).
Turn it towards you to trig-
ger a wash-wipe jet.

5VISIBILITY
53
HEADLAMP ADJUSTMENT
Depending on the load in your vehi-
cle, adjusting the beam of the head-
lamps is recommended as follows.
0. 1 or 2 people in the front seats.
-. 3 people.
1. 4 people.
2. 4 people + maximum authorised
load.
3. Driver + maximum authorised
load.
Initial setting is position 0. In this position, it comes
on on opening the driver's
door.
The courtesy light is deac-
tivated and is permanently
off.
COURTESY LIGHT
Permanently on.

6SAFETY
54
HORN
Press one of the spokes of the steer-
ing wheel.
HAZARD WARNING LIGHTS
Press the button, the direction indica-
tors ﬂash.
They can operate with the ignition
off.
ANTI-LOCK BRAKING
SYSTEM (ABS) AND EBFD/
CSC BRAKING SYSTEM
The ABS, in conjunction with
the EBFD/CSC braking system,
increases the stability and mano-
evrability of your vehicle on braking
and provides improved control, in
particular on poor or slippery road
surfaces.
The ABS prevents wheel lock in the
event of emergency braking.
The EBFD/CSC system provides full
control of the braking pressure wheel
by wheel. A distribution between:
- the front and the rear in the case of the EBFD (Electronic Brake Force
Distribution),
- the left and the right in the case of the CSC (Cornering Stability
Control).
When the vehicle is being
driven, illumination of this
warning light indicates that
the handbrake is still on
or has not been properly
released.
When parking on a slope,
direct your wheels towards
the pavement and pull the
handbrake.
HANDBRAKE
Applying
Pull the handbrake to immobilise
your vehicle.
Releasing
Pull on the handle and press the but-
ton to release the handbrake.
Note: when changing wheels
(tyres), make sure that these
are approved.
The anti-lock braking system
comes into operation automatically
when there is a risk of wheel lock.

6SAFETY
55
When this warning light
comes on, it indicates that
there is a malfunction of the
ABS, which can cause a
loss of control of the vehicle
when braking.
Consult a PEUGEOT dealer.
When these warn-
ing lights come on
s i m u l t a n e o u s l y,
it indicates that
there is a malfunc-
tion of the braking system or that the
handbrake has not been released
fully, which can cause a loss of con-
trol of the vehicle when braking.
Stop immediately.
Consult a PEUGEOT dealer.SEAT BELTS
Fastening / Unfastening the seat
belts
Pull the strap, then insert the buckle
into the stalk.
Check that the seat belt is fastened
correctly by pulling the strap.
To unfasten the seat belts, press the
button on the stalk.
Pretensioning front seat
belts with force limiter
Safety in the event of front
impacts has been improved
by means of the introduction of pre-
tensioning seat belts with force lim-
iter for the front seats. Depending on
the force of the impact, the preten-
sioning system instantly tightens the
seat belts and pulls them against the
body of the occupants.
The pretensioning seat belts are
active when the ignition is on.
Normal operation of the
ABS may make itself felt by
slight vibrations of the brake
pedal.
In emergency braking,
press very ﬁrmly without
releasing the pressure. 3-door
5-door
The force limiter reduces the
pressure of the seat belt on the body
of the occupant in the event of an
accident.
Rear seat belts
The rear seats are equipped with two
three-point inertia reel seat belts.
You can store the seat belt buckles in
the housing
A.

6SAFETY
56
Wherever you are seated in
the vehicle, always fasten
your seat belt, even for short
journeys.
Do not invert the seat belt buckles as
they will not fulﬁl their role fully.
If the seats have armrests*, the lap
part of the seat belt must always
pass under the armrest.
The seat belts are ﬁtted with an inertia
reel permitting automatic adjustment
of the length of the strap to your size.
The seat belt is stored automatically
when not in use.
Before and after use, ensure that the
seat belt is rolled up correctly.
The lower part of the strap must be
positioned as low as possible on the
pelvis.
The upper part must be positioned in
the hollow of the shoulder.
The inertia reels are ﬁtted with an
automatic locking device which
comes into operation in the event
of a collision or emergency braking.
You can release the device by pulling
rapidly on the strap and releasing it. In order to be effective, a seat belt:
- must be tightened as close to the
body as possible,
- must restrain one adult only,
- must not bear any trace of cuts or fraying,
- must be pulled in front of you with a smooth movement, checking that it
does not twist,
- must not be transformed or modi- ﬁed to avoid altering its perform-
ance.
In accordance with current safety
regulations, all repairs and checks
must be carried out by a PEUGEOT
dealer who guarantees that the work
is carried out correctly.
Have your seat belts checked regu-
larly by a PEUGEOT dealer and par-
ticularly if the straps show signs of
damage.
Clean the seat belt straps with soapy
water or a textile cleaning product,
sold by PEUGEOT dealers.
After folding or moving a seat or rear
bench seat, ensure that the seat belt
is positioned and rolled up correctly. Recommendations for children:
- use a suitable child seat if the pas-
senger is less than 12 years old or
shorter than one metre ﬁfty,
- do not use the strap-guide* when a child seat is installed.
- never use the same seat belt to secure more than one person,
- never allow a child to travel on your lap.
Depending on the nature and seri-
ousness of the impacts , the pre-
tensioning device may be triggered
before and independently of the air
bags.
In all cases, the air bag warning light
comes on.
Following an impact, have the seat
belts system checked, and if nec-
essary replaced, by a PEUGEOT
dealer.
* According to model.

PEUGEOT 107 2006 Workshop Manual

Page 51 of 93

Page 52 of 93

Page 53 of 93

Page 54 of 93

Page 55 of 93

Page 56 of 93

Page 57 of 93

Page 58 of 93

Page 59 of 93

Page 60 of 93

PEUGEOT Manuals