PEUGEOT 107 2009 Manual PDF

7
63
DRIVING
EASY mode (automatic mode)
Select position E using the gear lever.
The gear engaged is displayed on
the instrument panel screen.
The gearbox continuously selects
the most suitable gear.
Manual mode
Place the gear lever in position M ,
then change up or down through the
gears by pressing:
- rearwards, "+" to change up,
- forwards, "-" to change down.
The gear engaged is displayed on
the instrument panel screen.
If the engine speed is too low, the
gearbox automatically changes down
to prevent stalling.
In the event of overheating of
the clutch, position N is selected
automatically and the symbol N
fl ashes accompanied by an audible
signal. Operating fault
Stopping the engine
Before switching off the engine, you
can change to position N to be in
neutral.
In all cases, it is essential that you
apply the parking brake to immobilise
the vehicle. With the ignition on, the
lighting of this warning
lamp indicates a gearbox
malfunction.
On a slope, use the brake
to immobilise the vehicle
and place the gear lever in
position N , E or R .
Do not keep the vehicle immobilised
using the accelerator. Always press the brake pedal
while starting the engine.
Never select neutral
N while
the vehicle is moving.
In all cases, it is essential to
apply the parking brake to
immobilise the vehicle.
Contact a PEUGEOT dealer.

8
64
CHECKS
OPENING THE BONNET

On the inside: pull control A , located
under the dashboard.
On the outside: lift control B and
raise the bonnet.
Bonnet strut
Fix the strut to hold the bonnet open.
To close
Before closing the bonnet, return the
strut to its housing.
Lower the bonnet and release it at
the end of its travel. Check that the
bonnet is fully closed.

8
66
CHECKS
1.0 LITRE PETROL ENGINE

1. Coolant reservoir

2. Windscreen wash reservoir

3. Brake fl uid reservoir

4. Fuse box

5. Battery

6. Air fi lter

7. Engine oil dipstick

8. Engine oil fi ller cap
1.4 LITRE TURBO DIESEL HDI ENGINE

1. Coolant reservoir

2. Windscreen wash reservoir

3. Priming pump

4. Air fi lter

5. Brake fl uid reservoir

6. Fuse box

7. Battery

8. Engine oil dipstick

9. Engine oil fi ller cap

8
67
CHECKS
CHECKING THE LEVELS
There are two marks
on the dipstick:

A = maximum
If you fi ll past this
mark, contact a
PEUGEOT dealer.

B = minimum
Never allow the level
to fall below this mark.
Dipstick
Oil change
According to the information given in
the servicing booklet. Changing the brake fluid
The brake fl uid must be changed at
the intervals stated, according to the
manufacturer's servicing schedule.
Use fl uids recommended by the
manufacturer, which fulfi l DOT4
standards.
Windscreen wash level
For best quality cleaning and for your
safety, we would advise that you
use products recommended by your
manufacturer.
Consult a PEUGEOT dealer.
Oil viscosity grade
In all cases, the oil selected must meet
the manufacturer's requirements. Cooling system
Used oil
Avoid prolonged contact of used oil
with the skin.
Brake fl uid is harmful to health and
very corrosive.
To maintain the reliability of
engines and emission control
systems, the use of additives
in engine oil is prohibited. Slacken the cap by 1/4 of a
turn to release the pressure
to prevent any risk of
scalding. When the pressure
has dropped, remove the cap and
top up the level. Only use the fl uid recom-
mended by the manufacturer.
Otherwise, you risk seriously
damaging your engine.
Do not dispose of used oil,
brake fl uid or coolant into
drains or into the ground.
Empty the used oil into the containers
provided for this purpose in the
PEUGEOT network (France) or at an
authorised waste disposal site.
Oil level
Check the level regularly and top up
between changes. The maximum
consumption is 0.5 l per 600 miles
(1 000 km).
Check the level with the vehicle level,
engine cold, using the dipstick.
When the engine is warm, the tem-
perature of the coolant is controlled
by the engine fan. As this fan can
operate with the ignition key removed
and because the cooling system is
pressurised, wait for at least one hour
after the engine has stopped before
carrying out any work.

8
68
CHECKS
CHECKS Oil filter
Change the fi lter regularly, in accor-
dance with the servicing schedule. Only use products recom-
mended by PEUGEOT or
products of equivalent qual-
ity and specifi cation.
In order to optimise the operation
of units as important as the brak-
ing system, PEUGEOT selects and
offers specifi c products.
In order to avoid damaging the
electrical units, high pressure washing
to clean the engine compartment is
strictly prohibited.
To check the main levels and certain
components, in accordance with the
manufacturer's servicing schedule,
refer to the pages of the Maintenance
and Warranty Guide which correspond
to your vehicle's engine.
Battery
At the start of winter, have your bat-
tery checked by a PEUGEOT dealer.
Air filter and passenger
compartment filter

Have the fi lter elements replaced regularly.

If you drive in dusty conditions, change
them twice as often.
Brake pads
Brake pad wear depends on the style
of driving, in particular for vehicles
which are used in town, over short
distances.
Disc and drum wear
For any information relating to disc
and drum surface wear, contact a
PEUGEOT dealer. Manual gearbox
Have the level checked in accor dance
with the manufacturer's servicing
schedule.
RUNNING OUT OF FUEL (DIESEL)
It may be necessary to check
the thickness of the pads,
even between services.
If the engine stops, it is
possible to restart it to drive
a short distance by operating
the priming pump at least
10 times.
If you run out of fuel, the circuit must
be reprimed:
- fi ll the fuel tank with at least fi ve litres of diesel,
- squeeze and release the manual priming pump at least 10 times.
This is located under the
protective cover which must fi rst
be unclipped and then removed,
- operate the starter until the engine starts.

Notes: if the engine does
not start after approxima tely
15 seconds, operate the priming
pump again approximately
fi fteen times before trying again.
If the emission control warning lamp has
come on, it will only switch off after your
vehicle has been used several times. Parking brake
Where the parking brake travel is
too great or there is a reduction in
the performance of the system, the
parking brake should be adjusted,
even between services.
Have the system checked by a
PEUGEOT dealer.

9
69
PRACTICAL INFORMATION
Parking the vehicle

 As far as possible, immobilise
the vehicle on level, stable, non-
slippery ground.

 Apply the parking brake, switch off
the ignition and engage fi rst gear
or reverse for the manual gear-
box, position N for the "2 Tronic"
gearbox. Tools
The following tools are installed in a
carrier, located in the centre of the
spare wheel:

1. Wheelbrace

2. Jack with handle

3. Removable towing eye
Access to the spare wheel and
the jack in the boot

 Remove the carpet then the plastic
cover using the handle. Tyre pressures
These are indicated on the label
positioned on the inner pillar of the
left door, see "Identifi cation".
CHANGING A WHEEL

 If necessary, chock the wheel dia-
gonally opposite the wheel to be
changed.

 It is imperative that you ensure that
the occupants get out of the vehicle
and wait in a safe location.

9
70
PRACTICAL INFORMATION Refi tting the wheel

1. Position the wheel.

2. Screw in the bolts fully by hand.
Removing the wheel

1. Remove the trim.

2. Slacken the wheel bolts using the
wheelbrace 1 .

3. Place the jack 2 in contact
with one of the four locations A
provided on the underbody, the
one closest to the wheel to be
changed.

4. Extend the jack 2 until its base
is in contact with the ground.
Ensure that the centreline of the
jack base is directly below the
location A used.

5. Lift the vehicle.

6. Remove the bolts and detach the
wheel.

3. Pre-tighten the bolts * using the
wheelbrace 1 .
* If your vehicle is fi tted with alloy wheels, when t ightening the bolts it is normal
to notice that the washers do not come into contact with t he spare wheel. It is
still fi xed securely.

9
71
PRACTICAL INFORMATION
CHANGING A BULB
1. Sidelamps (W 5 W)

 Turn the bulb holder A one quarter
of a turn and remove it.

 Remove the bulb and change it.
2. Direction indicators (PY 21 W amber)

 Turn the bulb holder B one quarter
of a turn and remove it.

 Turn the bulb one quarter of a
turn.

 Remove the bulb and change it.
If you encounter any diffi culties,
contact a PEUGEOT dealer.

Note: in certain climatic con-
ditions (low temperatures,
humidity), the presence
of condensation on the
internal face of the headlamps is
normal ; it disappears a few minutes
after the lights are switched on.
Never go underneath a vehi-
cle supported only by a jack
(use an axle stand).

4. Fold the jack 2 and detach it.

5. Tighten the wheel bolts using the
wheelbrace 1 .

6. Refi t the trim.

7. Store the tools and the wheel in
the boot.
The jack and the tool kit are specifi c to
your vehicle. Do not use them for other
purposes.
After changing a wheel:
- have the tighteness of the bolts and the pressure of the spare wheel
checked as soon as possible,
- have the punctured wheel repaired and refi t it on the vehicle as soon
as possible.
Consult a PEUGEOT dealer. Front lamps

1. Sidelamps

2. Direction indicators

3. Dipped headlamps/Main beam
headlamps

9
71
PRACTICAL INFORMATION
CHANGING A BULB
1. Sidelamps (W 5 W)

 Turn the bulb holder A one quarter
of a turn and remove it.

 Remove the bulb and change it.
2. Direction indicators (PY 21 W amber)

 Turn the bulb holder B one quarter
of a turn and remove it.

 Turn the bulb one quarter of a
turn.

 Remove the bulb and change it.
If you encounter any diffi culties,
contact a PEUGEOT dealer.

Note: in certain climatic con-
ditions (low temperatures,
humidity), the presence
of condensation on the
internal face of the headlamps is
normal ; it disappears a few minutes
after the lights are switched on.
Never go underneath a vehi-
cle supported only by a jack
(use an axle stand).

4. Fold the jack 2 and detach it.

5. Tighten the wheel bolts using the
wheelbrace 1 .

6. Refi t the trim.

7. Store the tools and the wheel in
the boot.
The jack and the tool kit are specifi c to
your vehicle. Do not use them for other
purposes.
After changing a wheel:
- have the tighteness of the bolts and the pressure of the spare wheel
checked as soon as possible,
- have the punctured wheel repaired and refi t it on the vehicle as soon
as possible.
Consult a PEUGEOT dealer. Front lamps

1. Sidelamps

2. Direction indicators

3. Dipped headlamps/Main beam
headlamps

9
72
PRACTICAL INFORMATION
3. Dipped headlamps/Main beam headlamps (H4 - 60/55 W)

 Disconnect the connector.

 Remove the rubber cap C .

 Push the side of the tongue D .

 Remove the bulb holder and
change the bulb.

 Refi t the bulb holder, the tongue
then the rubber cap.
If you encounter any diffi culties,
contact a PEUGEOT dealer.
Rear lamps

1. Brake/side
lamps
(P 21/5 W)

2. Direction indicators (P 21 W)

3. Reversing
lamp (P 21 W),

left-hand side
Foglamp (P 21 W),
right-hand
side These 3 bulbs are changed by
removing the lamp unit:

 open the boot,

 unscrew the two lamp unit fi xing
nuts A ,

 remove the lamp unit by pulling
outwards,

 unclip the harness,