boot PEUGEOT 107 2010 Owners Manual

3
39
COMFORT
Returning the backrest of
the bench seat to its initial
position
Push the backrest towards the rear
and engage it on mounting B .

Take care not to trap the seat belts,
in particular between the seat back
and the mounting B.
Check that the backrest has engaged
correctly. Rear head restraints *
The rear head restraints can be
removed and have two positions:
- high, position for use.
- low, storage position.
To raise the head restraint, pull it
upwards.
To lower it, press lug
A then the head
restraint.
To remove it:
- tilt the seat back slightly,
- move the head restraint to the high position,
- press lug A pulling the head
restraint upwards at the same time.
To refi t it:
- tilt the seat back slightly,
- engage the rods of the head restraint in the openings.
To reach the low position, press lug A .
Folding the backrest of
the bench seat
The seat backrest is folded from
the rear of the vehicle, with the boot
open:
- check that the seat belt is
positioned correctly on the
side of the seat back to avoid
damaging it,
- place the head restraints in the low position (see "rear head
restraints"),
- while folding the seat backrest, pull the strap(s) A , located
behind the seat back.
* According to version.

4
48
ACCESS
KEYS/REMOTE CONTROL
Remote control
This carries out the vehicle locking -
unlocking and locating functions at a
distance.
Keys
The keys allow you to switch on the
ignition and operate the locks on the
front doors, the boot, the fuel tank
cap, the steering lock and the pas-
senger's airbag deactivation switch. Locking
Press button
A to lock the vehicle from
a distance. This is confi rmed by brief
lighting of the direction indicators.
Central locking and unlocking
From the driver's door, the keys allow
you to lock and unlock the doors and
boot simultaneously. Unlocking
Press button
B to unlock the vehicle.
This is confi rmed by two successive
fl ashes of the direction indicators. Locating the vehicle
To locate your vehicle in a car park, if
you have locked it:

 press button A , the direction
indicators come on briefl y.
After locking, if you notice
that a door is not closed
properly, close it then lock
the vehicle again.
The set of keys or remote
controls, supplied with your
vehicle, enable you to ob-
tain a maximum of three new
keys.
If all of the keys in your possession
are lost, a major operation will have
to be carried out on your vehicle.
Contact a PEUGEOT dealer or a
qualifi ed workshop.

4
51
ACCESS
BOOT
Locking/Unlocking the boot
using the remote control *
REAR WINDOWS (5-DOOR)
To partially open the rear windows,
pull the lever then push the window.
To close the window, pull then press
the lever to lock the window. * According to version.
The boot is locked/unlocked using
the buttons on the remote control.
Then, to open, press button
C and
raise the tailgate.
The boot can be locked/
unlocked using control A on
the driver's door.
Locking/unlocking using
the key *
To open, operate the lock
B using the
key and raise the tailgate.

4
51
ACCESS
BOOT
Locking/Unlocking the boot
using the remote control *
REAR WINDOWS (5-DOOR)
To partially open the rear windows,
pull the lever then push the window.
To close the window, pull then press
the lever to lock the window. * According to version.
The boot is locked/unlocked using
the buttons on the remote control.
Then, to open, press button
C and
raise the tailgate.
The boot can be locked/
unlocked using control A on
the driver's door.
Locking/unlocking using
the key *
To open, operate the lock
B using the
key and raise the tailgate.

4
52
ACCESS
BOOT FITTINGS
2. Spare wheel/Additional storage compartments
Located under the carpet and a plastic
cover, this contains the tools for wheel
changing and towing.
There are two shelf storage options:
- either behind the rear seats,
- or fl at in the boot.
1. Rear parcel shelf
To remove the shelf:
- unhook the shelf from its fi xing
A ,
- pull upwards on each side to detach it from its fi xings,
- raise then tilt the shelf slightly to remove it. In order to obtain additional
space, the spare wheel can
be removed temporarily
(boot tray available as an ac-
cessory).

9
72
PRACTICAL INFORMATION
Parking the vehicle

 As far as possible, immobilise
the vehicle on level, stable, non-
slippery ground.

 Apply the parking brake, switch
off the ignition and engage fi rst
gear or reverse for the manual
gearbox, position N for the
"2 Tronic" gearbox. Tools
The following tools are installed in a
carrier, located in the centre of the
spare wheel:

1. Wheelbrace

2. Jack with handle

3. Removable towing eye
Access to the spare wheel and
the jack in the boot

 Remove the carpet then the plastic
cover using the handle. Tyre pressures
These are indicated on the label
positioned on the inner pillar of the left
door, see "Identifi cation markings".
CHANGING A WHEEL

 If necessary, chock the wheel
diagonally opposite the wheel to
be changed.

 It is imperative that you ensure that
the occupants get out of the vehicle
and wait in a safe location.

9
74
PRACTICAL INFORMATION
CHANGING A BULB
1. Sidelamps (W5 W)


Turn the bulb holder A one quarter
of a turn and remove it.

 Remove the bulb and change it.
2. Direction indicators (PY 21 W amber)


Turn the bulb holder B one quarter
of a turn and remove it.

 Turn the bulb one quarter of a
turn.

 Remove the bulb and change it.
If you encounter any diffi culties,
contact a PEUGEOT dealer or a
qualifi ed workshop.
In certain climatic conditions
(low temperatures, humidity),

the presence of condensa-
tion on the internal face of
the headlamps is normal ; it disap-
pears a few minutes after the lighting
is switched on.
Never go underneath a
vehicle supported only by a
jack (use an axle stand).

4. Fold the jack 2 and detach it.

5. Tighten the wheel bolts using the
wheelbrace 1 .

6. Refi t the trim.

7. Store the tools and the wheel in
the boot.
The jack and the tool kit are specifi c
to your vehicle. Do not use them for
other purposes.
After changing a wheel:
- have the tighteness of the bolts and the pressure of the spare wheel
checked as soon as possible,
- have the punctured wheel repaired and refi t it on the vehicle
as soon as possible.
Contact a PEUGEOT dealer or a
qualifi ed workshop. Front lamps

1. Sidelamps

2. Direction indicators

3. Dipped/Main beam headlamps

9
74
PRACTICAL INFORMATION
CHANGING A BULB
1. Sidelamps (W5 W)


Turn the bulb holder A one quarter
of a turn and remove it.

 Remove the bulb and change it.
2. Direction indicators (PY 21 W amber)


Turn the bulb holder B one quarter
of a turn and remove it.

 Turn the bulb one quarter of a
turn.

 Remove the bulb and change it.
If you encounter any diffi culties,
contact a PEUGEOT dealer or a
qualifi ed workshop.
In certain climatic conditions
(low temperatures, humidity),

the presence of condensa-
tion on the internal face of
the headlamps is normal ; it disap-
pears a few minutes after the lighting
is switched on.
Never go underneath a
vehicle supported only by a
jack (use an axle stand).

4. Fold the jack 2 and detach it.

5. Tighten the wheel bolts using the
wheelbrace 1 .

6. Refi t the trim.

7. Store the tools and the wheel in
the boot.
The jack and the tool kit are specifi c
to your vehicle. Do not use them for
other purposes.
After changing a wheel:
- have the tighteness of the bolts and the pressure of the spare wheel
checked as soon as possible,
- have the punctured wheel repaired and refi t it on the vehicle
as soon as possible.
Contact a PEUGEOT dealer or a
qualifi ed workshop. Front lamps

1. Sidelamps

2. Direction indicators

3. Dipped/Main beam headlamps

9
75
PRACTICAL INFORMATION
3. Dipped/Main beam headlamps (H4 - 60/55W)

 Disconnect the connector.

 Remove the rubber cap C .

 Push the side of the tongue D .

 Remove the bulb holder and
change the bulb.

 Refi t the bulb holder, the tongue
then the rubber cap.
If you encounter any diffi culties,
contact a PEUGEOT dealer or a
qualifi ed workshop.
Rear lamps

1. Brake/side lamps
(P 21/5 W)

2. Direction indicators
(P 21 W)

3. Reversing lamp (P 21 W),
left-hand side
Foglamp (P 21 W), right-hand
side These 3 bulbs are changed by
removing the lamp unit:

 open the boot,

 unscrew the two lamp unit fi xing
nuts A ,

 remove the lamp unit by pulling
outwards,

 unclip the harness.

9
75
PRACTICAL INFORMATION
3. Dipped/Main beam headlamps (H4 - 60/55W)

 Disconnect the connector.

 Remove the rubber cap C .

 Push the side of the tongue D .

 Remove the bulb holder and
change the bulb.

 Refi t the bulb holder, the tongue
then the rubber cap.
If you encounter any diffi culties,
contact a PEUGEOT dealer or a
qualifi ed workshop.
Rear lamps

1. Brake/side lamps
(P 21/5 W)

2. Direction indicators
(P 21 W)

3. Reversing lamp (P 21 W),
left-hand side
Foglamp (P 21 W), right-hand
side These 3 bulbs are changed by
removing the lamp unit:

 open the boot,

 unscrew the two lamp unit fi xing
nuts A ,

 remove the lamp unit by pulling
outwards,

 unclip the harness.