Peugeot 107 Dag 2006 Service Manual

41Comfort-
01-01-2006
ADVICE ON CHILD
SEATS
The incorrect installation of a child
seat in a vehicle compromises the
child’s protection in the event of an
accident.
Remember to fasten the seat belts
or the child seat harness keeping
the slack in relation to the child’s
body to a minimum , even for short
journeys.
For optimum installation of the
"forward facing" child seat, ensure
that the back of the child seat is in
contact with the back of the vehicle’s
seat and that the head restraint does
not cause any discomfort.
If the head restraint has to be
removed, ensure that it is stored or
attached securely to prevent it from
being thrown around the vehicle in
the event of sharp braking. Children under the age of 10 must not
travel in the "forward facing" position
on the front passenger seat, unless
the rear seats are already occupied
by other children, cannot be used or
are absent.
Disarm the passenger air bag* when
a "rear facing" child seat is installed
on the front seat. Otherwise, the child
would risk being seriously injured or
killed if the air bag were to inflate.
Installing a booster seat
The chest part of the seat belt must
be positioned on the child’s shoulder
without touching the neck.
Ensure that the lap part of the seat
belt passes correctly over the child’s
thighs.
PEUGEOT recommends the use of a
booster seat which has a back, fitted
with a seat belt guide at shoulder
level.As a safety precaution, do not leave:
- one or more children alone and
unsupervised in a vehicle,
- a child or an animal in a vehicle which is exposed to the sun, with
the windows closed,
- the keys within reach of children inside the vehicle.
To protect young children from the
rays of the sun, fit side blinds on the
rear windows.
* According to country.

Comfort42 -
01-01-2006
"ISOFIX" MOUNTINGS
Your vehicle has been approved in
accordance with the new ISOFIX
regulation .
The seats*, represented below,
are fitted with regulation ISOFIX
mountings: These are three rings for each seat: This ISOFIX mounting system
guarantees you fast, reliable and
safe fitting of the child seat in your
vehicle.
The ISOFIX child seats are fitted
with two locks which are secured
easily on these lower rings A.
Some also have an upper strap
which is attached to the upper
ring B.
- two lower rings A, located between
the vehicle seat back and cushion,
indicated by a label,
* According to version.
- an upper ring
B, referred to as
the TOP TETHER , indicated by
a marking on the rear seat back
panel. To attach this strap, raise the
vehicle seat’s head restraint
then pass the hook between
its rods. Then fix the hook
on the upper ring B and tighten the
upper strap.
The incorrect installation
of a child seat in a vehicle
compromises the child’s
protection in the event of an
accident.
For information regarding the ISOFIX
child seats which can be installed in
your vehicle, consult the summary
table for the location of the ISOFIX
child seats.

43Comfort-
01-01-2006
ISOFIX CHILD SEAT RECOMMENDED BY PEUGEOT
RÖMER Duo (size category B1)
Group 1: from 9 to 18kg
Installed in the forward facing position.Fitted with an upper strap.
Three seat body angles: sitting, reclining, lying.
This child seat can also be used on seats which are not fitted w ith ISOFIX mountings. In this case, it must be attached
to the vehicle seat using the three point seat belt.
Follow the instructions for fitting the child seat given in the sea t manufacturer’s installation guide.

Comfort44 -
01-01-2006
SUMMARY TABLE FOR THE
LOCATION OF ISOFIX CHILD
SEATS
In accordance with the European
regulation ECE 16, this table indicates
the options for the installation of
ISOFIX child seats on the vehicle
seats fitted with ISOFIX mountings.
In the case of the universal and semi-
universal ISOFIX child seats, the
child seat’s ISOFIX size category,
determined by a letter A, B , B1 , C ,
D , E , F, G , is indicated on the child
seat next to the ISOFIX logo. IUF:
seat approved for a Universal
I sofix seat, " Forward facing" with the
"Top Tether" upper strap. Weight of the child
/ indicative age
Less than 10 kg
(group 0)
Up to 6 months approx Less than 10 kg
(group 0)
Less than 13 kg (group 0+)
Up to 1 year approx From 9 to 18 kg
(group 1)
From 1 - 3 years approx
Type of ISOFIX child seat Infant car seat* "rear facing" "rea r facing" "forward facing"
ISOFIX size category F G C D E C D A B B1
Universal ISOFIX child
seats which can be installed on the rear seats X X X X X IUF
* The ISOFIX infant car seat is fixedto the lower rings of an ISOFIX
seat and occupies the two rear
seats.
X:
seat not suitable for the installation
of an ISOFIX child seat of the size
category indicated.

45Accesses-
01-01-2006
KEYS / REMOTE CONTROLRemote control
This carries out the vehicle locking -
unlocking and locating functions at a
distance.
Keys
The keys allow you to switch on the
ignition and operate the locks on
the front doors, the boot, the fuel
tank cap, the steering lock and the
passenger air bag disarming switch.Locking
Press button
A to lock the vehicle
from a distance. This is confirmed
by brief lighting of the direction
indicators.
Central locking and unlocking
From the driver’s door, the keys allow
you to lock and unlock the doors and
boot simultaneously. Unlocking
Press button
B to unlock the vehicle.
This is confirmed by two successive
flashes of the direction indicators. Spotting the vehicle
To spot your vehicle, if you have
locked it, in a car park:

press button A, the direction
indicators come on briefly.
Note: after locking, if you
notice that a door is not
closed properly, close it then
lock the vehicle again.
The set of keys or remote
controls, supplied with your
vehicle, enable you to obtain
a maximum of three new
keys.
If all of the keys in your possession
are lost, a major operation will have
to be carried out on your vehicle.
Contact a PEUGEOT dealer.

Accesses46 -
01-01-2006
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control system
as soon as the ignition has been
switched off and therefore prevents
starting of the vehicle by anyone who
does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code
must be recognised for starting to be
possible.
In the event of a malfunction, your
vehicle will not start.
Contact a PEUGEOT dealer.
Changing the remote control
battery
To change the battery, remove the
screw then unclip the housing using
a coin inserted at the ring.
Battery CR 2016/3 volts.
If the remote control does not work
after the battery has been changed,
reprogramme it.
Reprogramming the remote
control
Following replacement of the remote
control battery or in the event of a
remote control malfunction, it may
be necessary to reprogramme the
system.
 Switch off the ignition.
 Switch the ignition on again.
 Press one of the remote control
buttons immediately for a few
seconds.
 Switch off the ignition and remove
the key from the ignition lock.
The remote control is now working
again.
If the malfunction persists, contact a
PEUGEOT dealer. Driving with the doors locked
may make access to the
passenger compartment by
the emergency services more
difficult in an emergency.
As a safety measure (with children
on board), remove the key from the
ignition when leaving the vehicle,
even for a short time.
Do not make any modifications to the
electronic immobiliser system.
Do not discard the remote
control batteries, they contain
metals which are harmful to
the environment.
Take them to a PEUGEOT dealership,
or to any other approved collection
point. The high frequency remote control is
a sensitive system; do not operate it
in your pockets as there is a risk that
it may unlock the vehicle without you
being aware of this.
Avoid pressing the buttons of your
remote control out of range of
your vehicle, you risk rendering it
inoperative. It would then have to be
reprogrammed.

Accesses46 -
01-01-2006
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control system
as soon as the ignition has been
switched off and therefore prevents
starting of the vehicle by anyone who
does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code
must be recognised for starting to be
possible.
In the event of a malfunction, your
vehicle will not start.
Contact a PEUGEOT dealer.
Changing the remote control
battery
To change the battery, remove the
screw then unclip the housing using
a coin inserted at the ring.
Battery CR 2016/3 volts.
If the remote control does not work
after the battery has been changed,
reprogramme it.
Reprogramming the remote
control
Following replacement of the remote
control battery or in the event of a
remote control malfunction, it may
be necessary to reprogramme the
system.
 Switch off the ignition.
 Switch the ignition on again.
 Press one of the remote control
buttons immediately for a few
seconds.
 Switch off the ignition and remove
the key from the ignition lock.
The remote control is now working
again.
If the malfunction persists, contact a
PEUGEOT dealer. Driving with the doors locked
may make access to the
passenger compartment by
the emergency services more
difficult in an emergency.
As a safety measure (with children
on board), remove the key from the
ignition when leaving the vehicle,
even for a short time.
Do not make any modifications to the
electronic immobiliser system.
Do not discard the remote
control batteries, they contain
metals which are harmful to
the environment.
Take them to a PEUGEOT dealership,
or to any other approved collection
point. The high frequency remote control is
a sensitive system; do not operate it
in your pockets as there is a risk that
it may unlock the vehicle without you
being aware of this.
Avoid pressing the buttons of your
remote control out of range of
your vehicle, you risk rendering it
inoperative. It would then have to be
reprogrammed.

47Accesses-
01-01-2006
ELECTRIC WINDOWS
The driver and front passenger each
have an electric window.
After the ignition has been switched
on, press or pull control 1. The
window stops when you release the
control.
Always remove the key from
the ignition when leaving
the vehicle, even for a short
time.
The driver must ensure that the front
passenger uses his electric window
correctly.
Be aware of children when operating
the windows.
DOORS
Locking/unlocking a door
from the inside
Normal locking/unlocking: the
doors lock/unlock independently.
To lock/unlock a door, press/pull
button A.
Note: operating the handle does
not unlock the door, pull button A to
unlock. Simultaneous central locking/
unlocking of the doors and boot.
To lock/unlock the vehicle, press/pull
button
A on the driver’s door.
For the other doors, carry out the
same operation as for normal locking/
unlocking.
Driver’s door open
If the driver’s door is open,
the courtesy light remains
on if the button is in this
position.

Accesses
48 -
01-01-2006
CHILD LOCK
This prevents the opening of each of
the rear doors from the inside.
Push control 1 towards the outside of
the vehicle.
LOCKING/UNLOCKING THE
BOOT USING THE KEY*
To open, operate the lock B using the
key and raise the tailgate.
LOCKING/UNLOCKING THE
BOOT USING THE REMOTE
CONTROL*
The boot is locked/unlocked using
the buttons on the remote control.
Then, to open, press button C and
raise the tailgate.
Note: the boot can be locked/
unlocked using control A on the
driver’s door.
REAR WINDOWS (5-door)
To partially open the rear windows,
pull the lever then push the window.
To close the window, pull then press
the lever to lock the window.
Check the status of this safety
device before switching on
the ignition.
* According to version.

Accesses
48 -
01-01-2006
CHILD LOCK
This prevents the opening of each of
the rear doors from the inside.
Push control 1 towards the outside of
the vehicle.
LOCKING/UNLOCKING THE
BOOT USING THE KEY*
To open, operate the lock B using the
key and raise the tailgate.
LOCKING/UNLOCKING THE
BOOT USING THE REMOTE
CONTROL*
The boot is locked/unlocked using
the buttons on the remote control.
Then, to open, press button C and
raise the tailgate.
Note: the boot can be locked/
unlocked using control A on the
driver’s door.
REAR WINDOWS (5-door)
To partially open the rear windows,
pull the lever then push the window.
To close the window, pull then press
the lever to lock the window.
Check the status of this safety
device before switching on
the ignition.
* According to version.