PEUGEOT 206 2007.5 Owners Manual

Practical information98 -
Unclip the boot side trim.
Unclip the foam cover and reach
behind the cover to locate the wing
nut.
Remove the wing nut.
Release the light unit.
Press the lug A and disconnect the
connector.
Remove the foam.
Move aside the tabs B and remove
the bulb holder.
Change the faulty bulb.
When refitting, ensure that the bulb
holder, the light and the foam cover
are repositioned correctly.Third brake light 5 bulbs W 5 W
Using a 10 mm spanner, unscrew the
2 nuts A.
Release the light unit.
Squeeze the two tabs B to release
the bulb holder.
Change the faulty bulb.
Rear lights
1. Direction indicators P 21 W.
2. Reversing lights P 21 W.
3. Brake lights/side lights P 21/ 5 W.

99Practical information-
Front fog lamps H1 55 W
Press under the access flap to re-
lease it.
Open the flap.
Turn the cover to remove it.
Disconnect the bulb.
Press the two ends of the securing
clip to release the bulb.
Rear fog lamp P 21 W
Unclip the lamp and release the as-
sembly.
Turn the pin connector a quarter turn
and remove it.
Change the bulb.
Number plate lights W 5 W
Insert a thin screwdriver into one of
the outer holes of the transparent
cover.
Push it outwards to unclip it.
Remove the transparent cover.
Change the faulty bulb.

Practical information100 -
CHANGING A FUSE
The fuse boxes are located under
the fascia and in the engine compart-
ment.Correct Incorrect
Pliers A
Fascia fuse box
Unscrew the catch a quarter turn us-
ing a coin then remove the cover to
gain access to the fuses.
The spare fuses and the pliers A are
fitted inside of the fascia fuse box
lid. Removing and fitting a fuse
Before changing a fuse, the cause of the fault must be foun
d and remedied. The
fuse numbers are indicated on the fuse box.
Use the pliers A.
Always replace a faulty fuse with a fuse of the same rating .

Practical information100 -
CHANGING A FUSE
The fuse boxes are located under
the fascia and in the engine compart-
ment.Correct Incorrect
Pliers A
Fascia fuse box
Unscrew the catch a quarter turn us-
ing a coin then remove the cover to
gain access to the fuses.
The spare fuses and the pliers A are
fitted inside of the fascia fuse box
lid. Removing and fitting a fuse
Before changing a fuse, the cause of the fault must be foun
d and remedied. The
fuse numbers are indicated on the fuse box.
Use the pliers A.
Always replace a faulty fuse with a fuse of the same rating .

101Practical information-
Fuse N° RatingFunctions
1 15 A Alarm siren
4 20 A Multifunction display - Boot lighting - Audio equipment - Steering wheel controls - Trailer
5 15 A Automatic gearbox diagnostics
6 10 A Coolant level - Automatic gearbox - Audio equipment - Stee ring wheel angle sensor (ESP)
7 15 A Driving school accessory - Alarm
9 30 A Rear electric windows
10 40 A Rear screen amd mirror demisting 11 15 A Rear windscreen wiper
12 30 A Front electric windows - Sunroof
14 10 A Engine fuse box - Air bags - Steering wheel controls - Rain sensor
15 15 A Instrument panel - Multifunction display - Air conditioni ng - Audio equipment
16 30 A Locking/unlocking controls for doors, bonnet and boot - Deadlocking controls
20 10 A Right-hand brake light
21 15 A Left-hand brake light - 3rd brake light
22 20 A Front courtesy light - Map reader - Glove box lighting - L ighter
S1 Shunt Shunt PARC shunt

Practical information102 -
or
The electrical circuit of
your vehicle is designed
to operate with standard
or optional equipment.
Before installing other electri-
cal equipment or accessories in
your vehicle, consult a PEUGEOT
dealer.
Some electrical accessories or the
way in which they are fitted may
have an adverse effect on the op-
eration of your vehicle (its elec-
tronic control circuits, the audio
circuit and the electrical charging
circuit).
PEUGEOT declines any responsi-
bility for expenses incurred in the
repair of your vehicle or for any
malfunctions resulting from the in-
stallation of auxiliary accessories,
not supplied and not recommend-
ed by PEUGEOT and not installed
in accordance with PEUGEOT’s
instructions, in particular for any
equipment the power consumption
of which exceeds 10 milliamps.
Fuse N° Rating Functions
1* 20 A Fan unit
2* 60 A ABS/ESP
3* 30 A ABS/ESP
4* 70 A Built-in systems interface supply
5* 70 A Built-in systems interface supply
6* - Not used
7* 30 A Ignition switch supply
8* 20 A Audio amplifier
Engine compartment fuse box
To gain access to the box in the engine compartment (next to t he battery), unclip
the cover.
After carrying out work, close the cover very carefully.
* The maxi fuses provide additional protection for the electri cal systems. Any
work on these must be carried out by a PEUGEOT dealer.

103Practical information-
Fuse N° RatingFunctions
1 10 A Pre-heat unit (diesel) - Water in diesel sensor - Reversing lights sw
itch - Speed sensor -
Air flow sensor (diesel)
2 15 A Canister solenoid valve - Fuel pump
3 10 A ABS/ESP engine control unit - ESP brake switch
4 10 A Automatic gearbox control unit - Engine control unit
5 - Not used
6 15 A Front fog lamps
7 - Not used
8 20 A Fan assembly relay - Engine control unit - Diesel injection pump
-
Diesel high pressure regulator - Engine management solenoid valve
9 15 A Left dipped beam
10 15 A Right dipped beam 11 10 A Left main beam
12 15 A Right main beam
13 15 A Horn
14 10 A Front and rear windscreen wash pumps
15 30 A Throttle housing heater - Diesel injection pump - Oxygen sensor
- Engine control unit -
Air flow sensor - Ignition coil - Engine management solenoid valve - Diesel h eater -
Injectors
16 30 A Air pump relay
17 30 A High and low speed windscreen wiper
18 40 A Air conditioning fan

Practical information104 -
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery,
- Follow the instructions for use giv-en by the battery charger manufac-
turer,
- Reconnect starting with the nega- tive (-) terminal,
- Check that the terminals and con- nectors are clean. If they are cov-
ered with sulphate (white or green-
ish deposit), disconnect them and
clean them. - Wait for 2 minutes after
switching off the ignition
before disconnecting
the battery.
- Never disconnect a ter- minal when the engine
is running.
- Never charge a battery without first disconnecting the terminals.
- Close the windows and the roof before disconnecting the bat-
tery.
- After every reconnection of the battery, switch on the ignition
and wait 1 minute before start-
ing to allow the electronic sys-
tems to be initialised. If slight
difficulties are experienced after
this, please consult a PEUGEOT
dealer.
It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (windscreen wiper, elec-
tric windows, courtesy lights, audio
equipment, etc.) can only be used for
a combined duration of approximate-
ly thirty minutes, to prevent discharg-
ing the battery.
Once the thirty minutes are over, a
switching to economy mode mes-
sage appears on the multi-function
display and the active functions are
put on standby.
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to resume the use of these
functions immediately, the engine
must be started and left to run for a
few minutes.
The time available to you will then be
double the duration for which the en-
gine is left running. However, this pe-
riod will always be between five and
thirty minutes.
To start the vehicle from another
battery:
- Connect the red cable to the posi-
tive (+) terminals of the two batter-
ies,
- Connect one end of the green or black cable to the negative (-) ter-
minal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle, as far as
possible from the battery,
Operate the starter, let the engine
run.
Wait for the engine to return to idle,
then disconnect the cables.
A flat battery prevents the
engine from starting.

105Practical information-
FITTING SPEAKERS
The factory-fitted equipment allows
the fitting of:
- 165 mm diameter speakers in the front doors,
- 130 mm diameter speakers in the rear doors,
- 22.5 mm diameter tweeters in the mirror trims. Making the connections
A1 : -
A2 : -
A3 : -
A4 : -
A5 : -
A6 : (+ve) Ignition positive
A7 : (+ve) Permanent
A8 : Earth
B1 : (+) Rear right speaker
B2 : (-) Rear right speaker
B3 : (+) Front right speaker and
tweeter
B4 : (-) Front right speaker and tweeter
B5 : (+) Front left speaker and tweeter
B6 : (-) Front left speaker and tweeter
B7 : (+) Rear left speaker
B8 : (-) Rear left speaker
Consult a PEUGEOT deal-
er before installing audio
equipment or speakers in
your vehicle.
FITTING AUDIO EQUIPMENT
Your vehicle is equipped with certain
factory-fitted audio equipment:
- roof aerial,
- coaxial aerial cable,
- basic interference suppression,
- supply to front speakers,
- supply to rear speakers,
- two 8-way connectors.

Practical information106 -
Front towing eye
TOWING YOUR VEHICLE
By lifting (two wheels only on the
ground)
It is preferable to lift the vehicle by
the wheels.Never use the radiator
crossmember.
Special features of the automatic
gearbox
When towing with all four wheels on
the ground, the following rules must
be adhered to:
- gear lever in position N,
- tow the vehicle at a speed less than 30 mph (50 km/h) over a distance
of not more than 30 miles (50 km),
- do not add oil to the gearbox. Rear towing eye
From the front or the rear
Attach the tow bar to the towing eye.
Without lifting (four wheels on the
ground)
You must always use a tow bar.