sensor PEUGEOT 206 2008 Owners Manual

SPECIAL FEATURES
118 -
ALARM
Setting and deactivating the
alarm system
Switching off the siren.
The alarm completes the security
equipment for your vehicle. It offers
two types of protection.
- external protection: when it is
set, the alarm sounds if one of
the doors, the boot or the bon-
net is opened;
- internal protection: when it is set,
the alarm sounds if the sensors
detect air movement in the pas-
senger compartment (a broken
window), or movement within
the car.
The alarm also has an anti-tamper
function.
If there is an attempt to tamper with
the wires to the siren, control unit or
the battery, the siren sounds and the
direction indicators light. Setting the alarm (external and
internal protection)
Switch the ignition off and get out
of the vehicle.
Deadlock the vehicle.
The doors lock.
The direction indicators light for
two seconds.
The red light on the switch lashes
once a second.
5 seconds later, internal protection is
set.
45 seconds later, external protection
is set.
Note:
when the alarm is triggered,
the siren sounds for thirty seconds.
After the thirty seconds it stops, but
the alarm remains set.
When the alarm is trig-
gered, if a door, the tail -
gate or bonnet is not
closed correctly, the siren
sounds for a moment. If
the vehicle is closed correctly in the
following 45 seconds, the alarm is
activated and the direction indica-
tors remain on for two seconds. In
all cases, the alarm is activated af -
ter 45 seconds.
Disarming the alarm
(external and internal protection)
Press the unlocking button of the
remote control key.
The doors unlock.
The direction indicators lash for
two seconds.
The red light on the switch goes out.
Note: if the warning light continues to
lash after de-activation of the alarm,
it is a sign that the alarm has been
triggered. The lashing will stop when
the ignition is switched on.

VISIBILITY
64 -
"Follow me home" lighting
When you leave your vehicle, the
side lights and dipped headlamps
can be left on for approximately
30 seconds.
To do this:
- place the key in the STOP
position,
- place the lights stalk in the 0 position,
- lash the headlamps,
- get out of the vehicle and lock it.AUTOMATIC SWITCHING ON
OF LIGHTS
The side lights and dipped beam
headlamps switch on automatical -
ly if the light is poor and when the
windscreen wipers operate continu -
ously and switch off when the light
becomes bright enough or the wind -
screen wipers are switched off.
In foggy weather or in snow, the
brightness sensor can detect suf-
icient light, the lights will not
come on automatically. If neces-
sary, the dipped headlamps must
be switched on manually.
This function is active when the ve -
hicle is supplied to the customer.
To disarm or activate the function:
- Place the key in the accessories position (1st notch),
- Place the lights stalk in the AUTO/0 position,
- Press the end of the lights stalk for more than four seconds.
Do not cover the brightness sen-
sor, coupled with the rain sensor,
located in the centre of the wind-
screen, behind the interior mirror.
It is used for automatic switching
on of the lights. Operating check
In good or rainy weather,
both day and night, the
front fog lamps and the
rear fog lamp are dazzling
and are prohibited.
Do not forget to switch them off
when they are no longer needed.
Direction indicators
(lashers) Left: downwards.
Right: upwards. Disarming
The disarmed function is accompa-
nied by an audible signal.
When the driver uses the manual
lighting controls, the function is tem
-
porarily disarmed.
If the brightness sensor does not
function correctly, the lights come
on accompanied by an audible signal
and a message on the multifunction
display.
Consult a PEUGEOT dealer.
Activation
The activated function is accompa-
nied by an audible signal and a mes-
sage on the multifunction display.

VISIBILITY
64 -
"Follow me home" lighting
When you leave your vehicle, the
side lights and dipped headlamps
can be left on for approximately
30 seconds.
To do this:
- place the key in the STOP
position,
- place the lights stalk in the 0 position,
- lash the headlamps,
- get out of the vehicle and lock it.AUTOMATIC SWITCHING ON
OF LIGHTS
The side lights and dipped beam
headlamps switch on automatical -
ly if the light is poor and when the
windscreen wipers operate continu -
ously and switch off when the light
becomes bright enough or the wind -
screen wipers are switched off.
In foggy weather or in snow, the
brightness sensor can detect suf-
icient light, the lights will not
come on automatically. If neces-
sary, the dipped headlamps must
be switched on manually.
This function is active when the ve -
hicle is supplied to the customer.
To disarm or activate the function:
- Place the key in the accessories position (1st notch),
- Place the lights stalk in the AUTO/0 position,
- Press the end of the lights stalk for more than four seconds.
Do not cover the brightness sen-
sor, coupled with the rain sensor,
located in the centre of the wind-
screen, behind the interior mirror.
It is used for automatic switching
on of the lights. Operating check
In good or rainy weather,
both day and night, the
front fog lamps and the
rear fog lamp are dazzling
and are prohibited.
Do not forget to switch them off
when they are no longer needed.
Direction indicators
(lashers) Left: downwards.
Right: upwards. Disarming
The disarmed function is accompa-
nied by an audible signal.
When the driver uses the manual
lighting controls, the function is tem
-
porarily disarmed.
If the brightness sensor does not
function correctly, the lights come
on accompanied by an audible signal
and a message on the multifunction
display.
Consult a PEUGEOT dealer.
Activation
The activated function is accompa-
nied by an audible signal and a mes-
sage on the multifunction display.