warning lights PEUGEOT 206 2008 Owners Manual

Page 11 of 127

FAMILIARISATION
14 -
MONITORING
Instrument panel
A. When the ignition is on, the fuel
gauge needle should rise.
B. When the engine is running, its
associated low level warning
light should switch off.
C. When the ignition is on, the oil
level indicator should display
between one and six squares for
a few seconds.
If the levels are not correct, top up
the corresponding level. : 17, 24 Warning lights
1.
When the ignition is on, the
orange and red warning lights
come on.
2. When the engine is running,
these warning lights should
switch off.
If warning lights remain on, refer to
the page concerned. : 19 Controls
Lighting of the indicator light indica-
tes the status of the corresponding
function.
A.
Deactivation of the rear electric
windows.
: 68
B. Deactivation of the ESP and
ASR systems.
: 82
C. Central Locking/Unlocking.
: 60

Page 16 of 127

19
INSTRUMENTS and CONTROLS
-
WARNING LIGHTS
A permanently lit warning light or one lashing, with the engine running, indicates an operating fault of the unit
concerned.
The illumination of certain warning lights may be accom panied by an audible signal and a message on the multi-
function display. Do not ignore this warning: consult a P EUGEOT dealer as soon as possible.
If the central STOP warning light comes on when you are driving, stop your vehicle immediately, where it is safe to
do so.
Central (STOP)
warning light
Linked to the warning lights:
- engine oil pressure and temperature,
- handbrake,
- low brake luid level,
- electronic brake force distribution fault.
Linked to the coolant temperature in-
dicator.
You must stop if the light lashes
with the engine running.
Consult a PEUGEOT dealer. Engine oil pressure
and temperature
warning light
Linked to the central (STOP) warning
light.
You must stop.
This warning light indicates one of
the following:
- insuficient oil pressure,
- a lack of oil in the lubrication circuit. Top up the level.
- an oil temperature which is too high. The warning
light is accompanied by an
audible signal. To lower the oil
temperature, reduce your speed.
Consult a PEUGEOT dealer. Handbrake, low
brake fluid level and
Electronic Brake Force
Distribution fault
warning light
Linked to the central (STOP) warning
light.
This indicates one of the following:
- that the handbrake is applied or not fully released,
- an excessive drop in brake luid level (if the warning light remains
on even when the handbrake is
released).
- a fault in the Electronic Brake Force Distribution, if lit at the
same time as the ABS warning
light.
You must stop.
Consult a PEUGEOT dealer.

Page 17 of 127

INSTRUMENTS and CONTROLS
20 -
Battery charge warning
light
This indicates one of the fol-
lowing:
- faulty operation of the charging circuit,
- slack battery or starter terminals,
- a cut or slack alternator belt,
- an alternator failure.
Consult a PEUGEOT dealer.
Emission control
system warning light
(according to model)
This comes on for a few seconds each
time the ignition is switched on.
If it comes on with the engine run -
ning, this indicates incorrect operation
of the injection, ignition or emission
control system.
If the warning light lashes, there
is a risk of damage to the catalytic
converter on petrol engines.
Consult a PEUGEOT dealer. Diesel engine pre-heat
warning light
Wait until the warning light
goes out before starting the engine.
If the temperature is high enough,
the warning light comes on for less
than one second. You can start the
engine without waiting.
Low fuel level
warning light
When this light irst co -
mes on, you have enough fuel to drive
at least 30 miles (50 km). The tank ca-
pacity is approximately 50 litres.
Speed limiter/cruise
control indicator light
This comes on when the
speed limiter or cruise control
is activated.
Dynamic stability
control system (ESP/
ASR) warning light
This comes on for a few seconds each
time the ignition is switched on.
With the engine running and when
the vehicle is moving, it comes on if
the system is activated.
It lights permanently accompanied by
a message on the multifunction dis-
play when the system is disarmed.
If the warning light remains lit with
the engine running and when the ve -
hicle is moving, consult a PEUGEOT
dealer. Anti-lock braking
system (ABS) warning
light
This comes on for a few seconds each
time the ignition is switched on.
If the warning light remains on or co -
mes on above 8 mph (12 km/h), this
indicates an ABS malfunction.
However, the vehicle retains conven -
tional servo-assisted braking.
Illumination of this warning light, ac -
companied by an audible signal and
a message on the multifunction dis-
play, indicates a fault in the ABS sys -
tem.
Consult a PEUGEOT dealer.

Page 23 of 127

25
INSTRUMENTS and CONTROLS
-
TOTAL DISTANCE
RECORDER
Pressing button 1 alternates be-
tween:
- the total distance display,
- the trip distance display,
- the speed limiter or cruise control display when one of
these systems is selected with
the engine running.
To reset the trip recorder to zero,
when it is displayed press button 1
until zeros appear.
LIGHTING RHEOSTAT
With the lights on, press the button
to vary the intensity of the lighting of
the instruments and controls. When
the lighting reaches the minimum (or
maximum) setting, release the button
then press it again to increase (or re-
duce) the brightness.
As soon as the lighting is of the re-
quired brightness, release the button.
HAZARD WARNING
LIGHTS
Press the button, the direction indica -
tors lash.
They can operate with the ignition off.
Automatic lighting of hazard
warning lights
When braking in an emergency, de -
pending on the deceleration, the hazard
warning lights come on automatically.
They switch off automatically the irst
time you accelerate.
It is also possible to switch them off
by pressing the button.