Peugeot 206 CC Dag 2004 Manual PDF

70
21-06-2004
71
21-06-2004
YOUR 206 CC IN DETAIL
Direction indicators (lashers)AUTOMATIC SWITCHING ON
OF LIGHTS
The side lights and dipped beam
headlamps switch on automatically
if the light is poor and when
the windscreen wipers operate
continuously and switch off when the
light becomes bright enough or the
windscreen wipers are switched off.
In foggy weather or in snow, the
brightness sensor can detect
suficient light, the lights will not
come on automatically.
This function is active when the
vehicle is supplied
to the customer.
To disarm or activate the function:
- Place the key in the accessories position (1st notch),
- Place the lights stalk in the AUTO/0
position,
- Press the end of the lights stalk for more than four seconds.
Operating check
Activation
The activated function is
accompanied by an audible signal
and a message on the multifunction
display.
Disarming The disarmed function is
accompanied by an audible signal.
When the driver uses the manual
lighting controls, the function is
temporarily disarmed.
If the brightness sensor does not
function correctly, the lights come
on accompanied by an audible signal
and a message on the multifunction
display.
Contact a PEUGEOT dealer.
Left:
downwards.
Right: upwards.
Do not cover the brightness
sensor, coupled with the rain
sensor, located in the centre
of the windscreen, behind the
interior mirror. It is used for
automatic switching on of the
lights.

70
21-06-2004
71
21-06-2004
YOUR 206 CC IN DETAIL
Direction indicators (lashers)AUTOMATIC SWITCHING ON
OF LIGHTS
The side lights and dipped beam
headlamps switch on automatically
if the light is poor and when
the windscreen wipers operate
continuously and switch off when the
light becomes bright enough or the
windscreen wipers are switched off.
In foggy weather or in snow, the
brightness sensor can detect
suficient light, the lights will not
come on automatically.
This function is active when the
vehicle is supplied
to the customer.
To disarm or activate the function:
- Place the key in the accessories position (1st notch),
- Place the lights stalk in the AUTO/0
position,
- Press the end of the lights stalk for more than four seconds.
Operating check
Activation
The activated function is
accompanied by an audible signal
and a message on the multifunction
display.
Disarming The disarmed function is
accompanied by an audible signal.
When the driver uses the manual
lighting controls, the function is
temporarily disarmed.
If the brightness sensor does not
function correctly, the lights come
on accompanied by an audible signal
and a message on the multifunction
display.
Contact a PEUGEOT dealer.
Left:
downwards.
Right: upwards.
Do not cover the brightness
sensor, coupled with the rain
sensor, located in the centre
of the windscreen, behind the
interior mirror. It is used for
automatic switching on of the
lights.

72
21-06-2004
73
21-06-2004
Front windscreen wiper with
intermittent wipe
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
l Intermittent wipe.
0 Off.
â Single wipe
(press downwards).
In the Intermittent position, the
wiping speed is in proportion to the
vehicle speed. The command must be
reactivated each time the ignition
is switched back on:
- move the stalk to any position,
- then move it back to the required
position.
YOUR 206 CC IN DETAIL
WINDSCREEN WIPER STALK
Front windscreen wiper with
automatic wipe
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
AUTO Automatic wipe.
0 Off.
â Single wipe
(press downwards).
In the AUTO position, the wiping
speed is in proportion to the intensity
of the rainfall. Windscreen and headlamp wash
Pull the windscreen wiper stalk
twards you.
The windscreen wash then the
windscreen wipers operate for a
ixed period.
The windscreen wash and headlamp
wash operate simultaneously for two
seconds,
only if the headlamps are
on.

72
21-06-2004
73
21-06-2004
Automatic timed windscreen
wipers
In the AUTO position, the windscreen
wipers operate automatically and
adapt their speed to the intensity
of the rainfall .
Operating check
Activation
When the function is activated,
the message "Automatic wiping
active" appears on the multifunction
display.
In the event of malfunction , the
driver is informed by an audible
signal and the message "Auto wiper
fault" on the multifunction display.
In the event of malfunction in the
AUTO position, the windscreen wiper
will operate in intermittent mode.
Contact a PEUGEOT dealer.
YOUR 206 CC IN DETAIL
Do not cover the rain
sensor located on the
windscreen behind the
interior mirror.
When using an automatic car
wash, switch off the ignition or
check that the wiper stalk is not in
the automatic position.
In winter, it is advisable to wait
for the windscreen to completely
clear of ice before operating the
automatic wipe.

74
21-06-2004
75
21-06-2004
YOUR 206 CC IN DETAIL
TRIP COMPUTER
Pressing the button on the end of
the wash/wipe stalk enables the
following data to be displayed: Display B
- the range
- the distance travelled
- the average consumption
- the current consumption
- the average speed
Zero reset
Press the stalk for more than two
seconds.Display C
- the current consumption and the
range,
- the average consumption, the distance travelled and the average
speed calculated over a period
"1" ,
- the average consumption, the distance travelled and the average
speed calculated over a period
"2" .
Periods "1" and "2" are deined by
the frequency of the zero reset. They
allow, for instance, daily calculations
over period "1" and monthly
calculations over period "2".
Zero reset
When the required period is
displayed, press the stalk for more
than two seconds.

74
21-06-2004
75
21-06-2004
Range
The display shows the distance that
can still be covered with the fuel
remaining in the tank.
Note: this igure may rise if there
is a change in driving style or road
surface, causing a signiicant drop in
current fuel consumption.
If there are less than 3 litres of fuel in
the tank, only three segments will be
displayed.
YOUR 206 CC IN DETAIL
Current fuel consumption
This gives the fuel consumption
recorded during the last two seconds.
This function is only displayed when
the vehicle is travelling at more than
12 m.p.h. (20 km/h). Average consumption
This is the ratio between the amount
of fuel consumed and the distance
travelled since the computer was last
reset to zero.
Average speed
This is obtained by dividing the
distance travelled by the period of
time the vehicle has been in use (with
the ignition on), since the computer
was last reset to zero.Distance travelled
This shows the distance travelled
since the computer was last reset
to zero.
After the trip computer has been reset
to zero, the range data becomes
meaningful only after the vehicle has
been in use for a certain period.
If horizontal segments are displayed
instead of igures when driving,
contact a PEUGEOT dealer.

76
21-06-2004
77
21-06-2004
Automatic operation
• Opening
The windows open automatically
(when the ignition key is in the 'on'
position, with the engine running or
the vehicle moving).
F Press the switch past the point of
resistance:
- Press briely to completely open the front window; press
briely again to completely
open the rear quarter panel
window,
- Sustained pressure opens the front window, then the rear
quarter panel, completely.
• Closing
Only the front window on the driver's
side closes automatically (engine
running or vehicle moving), when the
rear quarter panel is closed.
F Briely pull the switch past the
point of resistance to completely
close the driver's front window.
Note: the window switches do not
function while the roof is being
operated.
ELECTRIC WINDOWS
1. Driver's electric window switch.
2. Passenger's electric windows switch.
Each switch controls, on its own side,
the front window and the rear quarter
panel window.
Manual operation
F Press the switch (to open) or pull
it (to close) without going beyond
the point of resistance.
The window stops when the switch is released.
The rear quarter panel window can be opened only when the
front window is completely open,
after an inactive period of one
second.
YOUR 206 CC IN DETAIL
Always remove the key
from the ignition when
leaving the vehicle, even
for a short time.
If an obstacle is detected when
operating the electric windows,
you must reverse the movement
of the window. To do this, press
the control concerned.
When the driver operates the
passenger electric window
controls, he must ensure that no
one is preventing correct closing
of the windows.
The driver must ensure that
passengers use the electric
windows correctly.
Be aware of children when
operating the windows.

76
21-06-2004
77
21-06-2004
YOUR 206 CC IN DETAIL
Manual interior mirror
The interior mirror has two positions:
- day (normal),
- night (anti-dazzle).
To change from one to the other,
push or pull the lever on the lower
edge of the mirror.ELECTRIC EXTERIOR
MIRRORS
Turn knob 1 to the right or to the left
to select the corresponding mirror.
Move knob 1 in all four directions to
adjust.
Fold-back electric mirrors
With the ignition on, turn knob 1 to
position A . The exterior mirror on the
driver's side is convex
in order to eliminate the
'blind spot'.
Furthermore, objects observed
in the driver's and passenger's
mirrors are in reality closer than
they appear.
This must be taken into account
to judge correctly the distance
of vehicles approaching from
behind.

78
21-06-2004
79
21-06-2004
YOUR 206 CC IN DETAIL
HEADLAMP ADJUSTMENT
Depending on the load in your
vehicle, adjusting the beam of the
headlamps is recommended as
follows.
0. 1 or 2 people in the front seats.
-. 3 people.
1 4 people.
2. 4 people + maximum authorised
load.
3. Driver + maximum authorised
load.
Initial setting is position 0.
STEERING WHEEL HEIGHT
ADJUSTMENT
When stationary, lower the handle to
unlock the steering wheel.
Adjust to the desired height and
lift the handle to lock the steering
wheel.
HORN
Press one of the spokes or
the centre of the steering
wheel.

78
21-06-2004
79
21-06-2004
YOUR 206 CC IN DETAIL
COURTESY LIGHT LIGHTER
Press and wait a few moments until it
springs out automatically.
It is supplied with power with the
ignition key in the accessories
position (1st notch).
In this position, it comes on
for about 30 seconds :
- on unlocking the vehicle,
- when opening a door,
- on switching off the ignition.
It lashes while driving if a door is not
closed correctly.
Permanently off.
Permanently on when
the ignition key is in the
accessories position or the
ignition is on.
FRONT ASHTRAY
To empty, close the cover.
Pull the lug and release the ashtray
upwards.
SUN VISOR
The sun visors are itted with a vanity
mirror, with a concealing lap on the
driver's side.
AREAS FOR TOLL CARDS /
CAR PARK TICKETS
The athermic windscreen has two
non-relective zones located either
side of the base of the interior
mirror.
They are intended for afixing toll
cards and/or car park tickets.