Peugeot 206 CC Dag 2005 Owner's Manual

106 -Practical information
01-03-2005
107
-
Practical information
01-03-2005
or Your vehicle's electri-
cal circuit is designed to
operate with standard or
optional equipment.
Before installing additional elec-
trical equipment or accessories,
consult a PEUGEOT dealer.
Some electrical accessories, or
the way in which they are itted,
may adversely affect the operation
of your vehicle (the electronic con-
trol circuits, the radio circuit and
the electrical charging circuit).
PEUGEOT does not accept any
responsibility for expenses in-
curred by repairs or for any faults
resulting from the installation of
additional accessories which are
not supplied or recommended
by PEUGEOT and which were
not installed in accordance with
the manufacturer's instructions,
in particular equipment with a
consumption greater than 10 milli-
amps.
Engine compartment fuse box
To access the fuse box located in
the engine compartment (next to the
battery), unclip the cover.
Fuse no. Rating Functions
1* 20A Fan unit
2* 60A ABS/ESP
3* 30A ABS/ESP
4* 70A Supply to built-in systems interface
5* 70A Supply to built-in systems interface
6* - Not used
7* 30A Ignition lock supply
8* - Not used
* The maxi fuses provide additional protection for the electrica l systems. Any
work must be carried out by a PEUGEOT dealer.
After changing the fuse, close the
cover very carefully.

106 -Practical information
01-03-2005
107
-Practical information
01-03-2005
Fuse no. Rating
Functions
1 10A Pre-heat unit (Diesel) - Water in diesel sensor - Reversing lights sw
itch - Speed sensor -
Air low sensor (Diesel)
2 15A Canister solenoid valve- Fuel pump
3 10A ABS/ESP engine control unit - ESP stop switch
4 10A Automatic gearbox control unit - Engine control unit
5 - Not used
6 15A Front fog lamps
7 20A Headlamp wash pump
8 20A Fan unit relay - Engine control unit - Diesel injection pump
- Diesel high pressure regulator
- Engine management solenoid valve
9 15A Left-hand dipped beam
10 15A Right-hand dipped beam
11 10A Left-hand main beam
12 15A Right-hand main beam
13 15A Horn
14 10A Front windscreen wash pump
15 30A Throttle unit heater - Diesel injection pump - Oxygen sensor - En
gine control unit -
Air low sensor - Ignition coil - Engine management solenoid valve - Diesel heater - Injectors
16 30A Air pump relay
17 30A High and low speed windscreen wiper
18 40A Air conditioning fan

108 -Practical information
01-03-2005
109
-Practical information
01-03-2005
ECONOMY MODE FUNCTION
After the engine has stopped, with
the key in the accessories position,
certain functions (windscreen wiper,
electric windows, courtesy lights,
audio equipment, etc.) can only be
used for a cumulative duration of
thirty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, the
message
"Economy mode active"
appears on the multifunction display
and the active functions are put on
standby.
To resume the use of these functions
immediately, start the engine and let
it run for a few minutes.
The time that you will then have
available will be double the time
during which the engine was running.
However, this time will always be
between ive and thirty minutes.
A lat battery will prevent the engine
from starting.
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery,
- Follow the instructions for use given by the battery charger
manufacturer,
- Reconnect starting with the negative (-) terminal,
- Check that the terminals and connectors are clean. If they are
covered with sulphate (white or
greenish deposit), disconnect them
and clean them.
It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
- Wait for 2 minutes after switching off the ignition
before disconnecting the
battery.
- Never disconnect a terminal when the engine is running.
- Never charge a battery without irst disconnecting the terminals.
- Close the windows and the roof before disconnecting the
battery.
- After every reconnection of the battery, switch on the ignition
and wait 1 minute before
starting to allow the electronic
systems to be initialised. If slight
dificulties are experienced after
this, please consult a PEUGEOT
dealer.
To start the vehicle from another
battery:
- Connect the red cable to the
positive (+) terminals of the two
batteries,
- Connect one end of the green or black cable to the negative (-)
terminal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle, as far as
possible from the battery,
Operate the starter, let the engine
run.
Wait for the engine to return to idle,
then disconnect the cables.

108 -Practical information
01-03-2005
109
-Practical information
01-03-2005
FITTING SPEAKERS
The factory-itted equipment allows
the itting of:
- 165 mm diameter speakers in the
front doors,
- 130 mm diameter speakers in the rear doors,
- 22.5 mm diameter tweeters in the mirror trims.
FITTING AUDIO EQUIPMENT
Your vehicle is equipped with certain
factory-itted audio equipment:
- roof aerial,
- coaxial aerial cable,
- basic interference suppression,
- supply to front speakers,
- supply to rear speakers,
- two 8-way connectors. Making the connections
A1 : -
A2 : -
A3 : -
A4 : -
A5 : -
A6 : (+ve) Ignition positive
A7 : (+ve) Permanent
A8 : Earth
B1 : (+) Rear right speaker
B2 : (-) Rear right speaker
B3 : (+) Front right speaker and
tweeter
B4 : (-) Front right speaker and tweeter
B5 : (+) Front left speaker and tweeter
B6 : (-) Front left speaker and tweeter
B7 : (+) Rear left speaker
B8 : (-) Rear left speaker
Consult a PEUGEOT
dealer before installing
audio equipment or
speakers in your vehicle.

110 -Practical information
01-03-2005
111
-Practical information
01-03-2005
Special features of the automatic
gearboxes
When towing with all four wheels on
the ground, the following rules must
be adhered to:
- gear lever in position
N,
- tow the vehicle at a speed less than 30 mph (50 km/h) over a distance
of not more than 30 miles (50 km),
- do not add oil to the gearbox.
From the front or the rear
Attach the tow bar to the towing eye.TOWING YOUR VEHICLE
Never use the radiator
crossmember.
BOOT LUGGAGE CARRIER*
A boot luggage carrier is available
from your PEUGEOT dealer.
When it is used, take care not to
conceal the third brake light.
Follow the manufacturer's recom-
mendations.
Without lifting (four wheels on the
ground)
You must always use a tow bar. * Available as an accessory.
By lifting (two wheels only on the
ground)
It is preferable to lift the vehicle by
the wheels.

110 -Practical information
01-03-2005
111
-Practical information
01-03-2005
TOWING A TRAILER,
CARAVAN, BOAT etc.
Only use original PEUGEOT tow
bars that have been tested and
approved from the design stage of
your vehicle. The tow bar must be
itted by a PEUGEOT dealer.
Your vehicle is primarily designed
for transporting people and luggage
but it may also be used for towing a
trailer.
Driving with a trailer subjects the
towing vehicle to more signiicant
stress and its driver must be
particularly careful.
Air density decreases with altitude,
thus reducing engine performance.
Above 1000 metres, the maximum
towing load must be reduced by 10%
and so on for every 1000 metres of
altitude. Driving advice
Distribution of loads :
Distribute the
load in the trailer so that the heaviest
items are as close as possible to the
axle and the nose weight approaches
the maximum permitted without
exceeding it.
Cooling :
Towing a trailer on a slope increases
the temperature of the coolant.
As the fan is electrically controlled,
its cooling capacity is not dependent
on the engine speed.
On the contrary, use a high gear to
lower the engine speed and reduce
your speed.
The maximum towing load on a long
slope depends on the gradient and
the outside temperature.
In all cases, pay attention to the
coolant temperature.
If the warning light comes on, stop
the vehicle and switch off the engine
as soon as possible. Tyres :
Check the tyre pressures of the
towing vehicle and of the trailer,
observing the recommended
pressures.
Braking :
Towing increases the braking
distance.
Lights :
Check the electrical signalling on the
trailer.
Side wind :
Take into acount the increased
sensitivity to side wind.

112 -Practical information
01-03-2005
113
-Practical information
01-03-2005
BODYWORK MAINTENANCE
To preserve the paintwork and the
plastic trim on your vehicle, we
recommend that you wash them
regularly.
- by hand: there are no speciic
precautions to take;
- using an automatic car wash: repeated use of poorly maintained
automatic car washes can lead
to the appearance of microscopic
scratches which give the paintwork
a matt appearance (especially
visible on dark colours);
- using a high pressure washer: always follow the recommendations
on the equipment (pressure and
spraying distance).
If there are damaged areas on
the vehicle (painted bumpers or
headlamps), it is not recommended
to direct the high pressure jet onto
them. Wash these areas by hand.
Also avoid the entry of water into the
locks.
For all questions relating to the
maintenance of your vehicle, contact
an approved dealer who can advise
you on quality products selected by
our departments. - Clean off bird drop-
pings, resinous depos-
its, tar stains and grease
marks as soon as pos-
sible; (these all contain
substances which can
cause serious damage
to the paintwork).
- Do not use a dry or abrasive cloth or detergent or solvent products
to clean the double lens, complex
surface headlamps as they are
itted with polycarbonate glass
covered in a protective inish.
- Do not use petrol, oil or cloth stain removers to clean the
bodywork and plastic parts of
your vehicle.
- To prevent the development of bodywork corrosion as a result
of accidental damage (stone
chips, scratches, etc.) have
them repaired swiftly.

112 -Practical information
01-03-2005
113
-Practical information
01-03-2005
ROOF EMERGENCY MODE

114 -Practical information
01-03-2005
115
-Practical information
01-03-2005
Moving shelf Roof hook(s)
Pressure release
Screen
Shelf release
Boot lid
Tailgate lap

114 -Practical information
01-03-2005
115
-Practical information
01-03-2005
Manual operation of the roof
(emergency mode)
In the event of
an electric or
hydraulic malfunction of the roof, it
is possible to close this manually.
This is an emergency solution .
If at all possible, this operation is
to be carried out by two people.
F Unhook the screen 1 and release
it while holding it steady.
F Take the Allen key out of the
repair aerosols insulated box 2.
F
Park the vehicle on level ground.
F Lower the windows.
F Switch off the ignition.
F Take the key out of the ignition.
F Apply the handbrake.
F Open the boot lid. When closing the roof,
take care not to pinch your
hands in the mechanism.
F Push the Allen key 3 irmly into
the pressure release screw 4,
then unscrew it a quarter turn to
the left.
F Remove and keep hold of the
key.