Peugeot 206 CC Dag 2005 Manual PDF

70 -Visibility
01-03-2005
71
-Visibility
01-03-2005
Direction indicators (lashers)AUTOMATIC SWITCHING ON
OF LIGHTS
The side lights and dipped beam
headlamps switch on automatically
if the light is poor and when
the windscreen wipers operate
continuously and switch off when the
light becomes bright enough or the
windscreen wipers are switched off.
In foggy weather or in snow, the
brightness sensor can detect
suficient light, the lights will not
come on automatically.
This function is active when the
vehicle is supplied
to the customer.
To disarm or activate the function:
- Place the key in the accessories position (1st notch),
- Place the lights stalk in the AUTO/0
position,
- Press the end of the lights stalk for more than four seconds.
Operating check
Activation
The activated function is
accompanied by an audible signal
and a message on the multifunction
display.
Left:
downwards.
Right: upwards.
Do not cover the brightness
sensor, coupled with the rain
sensor, located in the centre
of the windscreen, behind the
interior mirror. It is used for
automatic switching on of the
lights.
Disarming
The disarmed function is
accompanied by an audible signal.
When the driver uses the manual
lighting controls, the function is
temporarily disarmed.
If the brightness sensor does not
function correctly, the lights come
on accompanied by an audible signal
and a message on the multifunction
display.
Contact a PEUGEOT dealer.

70 -Visibility
01-03-2005
71
-Visibility
01-03-2005
Direction indicators (lashers)AUTOMATIC SWITCHING ON
OF LIGHTS
The side lights and dipped beam
headlamps switch on automatically
if the light is poor and when
the windscreen wipers operate
continuously and switch off when the
light becomes bright enough or the
windscreen wipers are switched off.
In foggy weather or in snow, the
brightness sensor can detect
suficient light, the lights will not
come on automatically.
This function is active when the
vehicle is supplied
to the customer.
To disarm or activate the function:
- Place the key in the accessories position (1st notch),
- Place the lights stalk in the AUTO/0
position,
- Press the end of the lights stalk for more than four seconds.
Operating check
Activation
The activated function is
accompanied by an audible signal
and a message on the multifunction
display.
Left:
downwards.
Right: upwards.
Do not cover the brightness
sensor, coupled with the rain
sensor, located in the centre
of the windscreen, behind the
interior mirror. It is used for
automatic switching on of the
lights.
Disarming
The disarmed function is
accompanied by an audible signal.
When the driver uses the manual
lighting controls, the function is
temporarily disarmed.
If the brightness sensor does not
function correctly, the lights come
on accompanied by an audible signal
and a message on the multifunction
display.
Contact a PEUGEOT dealer.

70 -Visibility
01-03-2005
71
-Visibility
01-03-2005
Front windscreen wiper with
intermittent wipe
2
Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
l Intermittent wipe.
0 Off.
â Single wipe (press
downwards).
In the Intermittent position, the
wiping speed is in proportion to the
vehicle speed. The command must be reactivated
whenever the ignition has been
switched off for more than one
minute:
- move the stalk to any position,
- then move it back to the required
position.
WINDSCREEN WIPER STALK
Front windscreen wiper with
automatic wipe
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
AUTO Automatic wipe.
0 Off.
â Single wipe (press
downwards).
In the AUTO position, the wiping
speed is in proportion to the intensity
of the rainfall.
Windscreen and headlamp
wash
Pull the windscreen wiper stalk
towards you. The windscreen wash
then the windscreen wipers operate
for a ixed period.
The headlamp wash is also activated,
if the headlamps are on.

72 -Visibility
01-03-2005
73
-Visibility
01-03-2005
Automatic windscreen wipers
In the
AUTO position, the windscreen
wipers operate automatically and
adapt their speed to the intensity
of the rainfall . Do not cover the rain
sensor located on the
windscreen behind the
interior mirror.
When using an automatic car
wash, switch off the ignition or
check that the wiper stalk is not in
the AUTO position.
In winter, it is advisable to wait
for the windscreen to completely
clear of ice before operating the
automatic wipe.
Operating check
Activation
Activation of the function is
accompanied by a message on the
multi-function display.
In the event of malfunction
, the
driver is informed by an audible
signal.
In the AUTO position, the windscreen
wiper will operate in intermittent
mode.
Contact a PEUGEOT dealer to have
the system checked.

72 -Visibility
01-03-2005
73
-Visibility
01-03-2005
TRIP COMPUTER
Pressing the button on the end of
the
wash/wipe stalk enables the
following data to be displayed: Display B
- the range
- the distance travelled
- the average consumption
- the current consumption
- the average speed
Display C
- the current consumption and the
range,
- the average consumption, the distance travelled and the average
speed calculated over a period
"1" ,
- the average consumption, the distance travelled and the average
speed calculated over a period
"2" .
Periods "1" and "2" are deined by
the frequency of the zero reset. They
allow, for instance, daily calculations
over period "1" and monthly
calculations over period "2".
Zero reset
Press the stalk for more than two
seconds.
Zero reset
When the required period is
displayed, press the stalk for more
than two seconds.

74 -Visibility
01-03-2005
75
-Visibility
01-03-2005
Range
The display shows the distance that
can still be covered with the fuel
remaining in the tank.
Note:
this igure may rise if there
is a change in driving style or road
surface, causing a signiicant drop in
current fuel consumption.
If there are less than 3 litres of fuel in
the tank, only three segments will be
displayed.
Current fuel consumption
This gives the fuel consumption
recorded during the last two seconds.
This function is only displayed when
the vehicle is travelling at more than
12 m.p.h. (20 km/h). Average consumption
This is the ratio between the amount
of fuel consumed and the distance
travelled since the computer was last
reset to zero.
Average speed
This is obtained by dividing the
distance travelled by the period of
time the vehicle has been in use (with
the ignition on), since the computer
was last reset to zero.Distance travelled
This shows the distance travelled
since the computer was last reset
to zero.
After the trip computer has been reset
to zero, the range data becomes
meaningful only after the vehicle has
been in use for a certain period.
If horizontal segments are displayed
instead of igures when driving,
contact a PEUGEOT dealer.

74 -Visibility
01-03-2005
75
-Visibility
01-03-2005
Automatic operation
Pressing the switch triggers complete
opening or closing of the window,
pressing the switch again stops the
movement of the window.
A long press controls the movement
of the window which then stops if
you release the switch. A maintained
press or a second press triggers the
opening or closing of the rear quarter
panel window.
Notes:
Only the front window on the
driver's side closes automatically
(engine running or vehicle moving),
when the rear quarter panel window
is closed.
The window switches do not function
while the roof is being operated.
ELECTRIC WINDOWS
1. Driver's electric window switch.
2. Passenger's electric windows switch.
Each switch controls, on its own side,
the front window and the rear quarter
panel window. Always remove the key
from the ignition when
leaving the vehicle, even
for a short time.
If an obstacle is detected when
operating the electric windows,
you must reverse the movement
of the window. To do this, press
the control concerned.
When the driver operates the
passenger electric window
controls, he must ensure that no
one is preventing correct closing
of the windows.
The driver must ensure that
passengers use the electric
windows correctly.
Be aware of children when
operating the windows.
The battery must be disconencted
with the doors closed.
Manual operation
Press the switch (to open) or pull it
(to close) without going beyond the
point of resistance.
The window stops when the switch
is released.
The rear quarter panel window
can be opened only when the front
window is completely open, after an
inactive period of one second.
REINITIALISING THE
ELECTRIC WINDOWS
Following reconnection of the battery
or in the event of a malfunction,
release the switch and pull it again
until the window closes completely.
Continue to pull the switch for
approximately one second after
closing.
The safety auto-reverse function
does not operate during these
operations.

76 -Visibility
01-03-2005
Manual interior mirror
The interior mirror has two positions:
- day (normal),
- night (anti-dazzle).
To change from one to the other,
push or pull the lever on the lower
edge of the mirror.ELECTRIC EXTERIOR
MIRRORS
Turn knob 1 to the right or to the left
to select the corresponding mirror.
Move knob 1 in all four directions to
adjust. The exterior mirror on the
driver's side is convex
in order to eliminate the
"blind spot".
Furthermore, objects observed
in the driver's and passenger's
mirrors are in reality closer than
they appear.
This must be taken into account
to judge correctly the distance
of vehicles approaching from
behind.
Fold-back electric mirrors
With the ignition on, turn knob 1 to
position A .

77
-Layout
01-03-2005
HEADLAMP ADJUSTMENT
Depending on the load in your
vehicle, adjusting the beam of the
headlamps is recommended as
follows.
0.
1 or 2 people in the front seats.
-. 3 people.
1. 4 people.
2. 4 people + maximum authorised
load.
3. Driver + maximum authorised
load.
Initial setting is position 0.
STEERING WHEEL HEIGHT
ADJUSTMENT
When stationary, lower the handle to
unlock the steering wheel.
Adjust to the desired height and
lift the handle to lock the steering
wheel.
HORN
Press one of the spokes of
the steering wheel.

78 -Layout
01-03-2005
79
-Layout
01-03-2005
COURTESY LIGHT
LIGHTER
Press and wait a few moments until it
springs out automatically.
It is supplied with power with the
ignition key in the accessories
position (1st notch).
In this position, it comes on
for about 30 seconds :
- on unlocking the vehicle,
- when opening a door,
- on switching off the ignition.
It lashes while driving if a door is not
closed correctly.
Permanently off.
Permanently on when the
ignition key is in the acces-
sories position or the ignition
is on.
FRONT ASHTRAY
To empty, close the cover.
Pull the lug and release the ashtray
upwards.
SUN VISOR
The sun visors are itted with a vanity
mirror, with a concealing lap on the
driver's side.
AREAS FOR TOLL CARDS /
CAR PARK TICKETS
The athermic windscreen has two
non-relective zones located either
side of the base of the interior
mirror.
They are intended for afixing toll
cards and/or car park tickets.