Peugeot 206 CC Dag 2006 Manual PDF

65
-Accesses
01-01-2006
DOORS Locking from the inside
To lock, press button
A .
Locking one of the front doors locks
the doors and the boot.
Opening the doors from outside
Opening the doors from inside* Before carrying out any
work which requires
cutting off of the battery,
leave the doors and
windows closed.
If the battery is cut off, the doors
can still be opened. However, it
is imperative that the door is not
slammed when it is closed.
Contact your PEUGEOT dealer as
soon as possible.
In order to make it easier to open
the doors, the window lowers
automatically by a few centimetres.
It rises and adjusts automatically
when the door is closed to provide
perfect sealing.
Unlocking from the inside*
To unlock, pull button A or the
handle.
''Door open'' alert
With the engine running , an
audible signal and a message or
diagram locating the problem on the
multifunction screen, warns you that
a door is not properly closed.
When the vehicle is moving ,
with the courtesy light button in the
"lighting on opening a door" position,
the courtesy light flashes.
* According to version.

66 -Accesses
01-01-2006
LOCKING AND UNLOCKING
THE BOOT
Lock the boot using the key (turn
the key from A to C ) or the remote
control.
Unlock it using the key (turn the key
from A to B ).
The lighting is controlled by
opening the boot.
Locking / Unlocking from the
inside*
Pressing button
A permits
locking/unlocking of the doors. To switch on
Press and hold button
A.
Activation of the function is
accompanied by an audible signal
and a message on the multifunction
display.
The message is displayed each time
the vehicle is started.
* According to specification.

To switch off
Press and hold button A.
Notes: if one of the doors is open,
locking from the inside and automatic
central locking are not possible.
If the boot is open, automatic central
locking of the doors is active.
Automatic central locking of the
doors
The doors can lock automatically
when you are driving (at a speed of
more than 6 mph (10km/h)).
Above 6 mph (10 km/h), press
button A briefly to unlock the doors
temporarily.
You can activate or deactivate this
function.

66 -Accesses
01-01-2006
LOCKING AND UNLOCKING
THE BOOT
Lock the boot using the key (turn
the key from A to C ) or the remote
control.
Unlock it using the key (turn the key
from A to B ).
The lighting is controlled by
opening the boot.
Locking / Unlocking from the
inside*
Pressing button
A permits
locking/unlocking of the doors. To switch on
Press and hold button
A.
Activation of the function is
accompanied by an audible signal
and a message on the multifunction
display.
The message is displayed each time
the vehicle is started.
* According to specification.

To switch off
Press and hold button A.
Notes: if one of the doors is open,
locking from the inside and automatic
central locking are not possible.
If the boot is open, automatic central
locking of the doors is active.
Automatic central locking of the
doors
The doors can lock automatically
when you are driving (at a speed of
more than 6 mph (10km/h)).
Above 6 mph (10 km/h), press
button A briefly to unlock the doors
temporarily.
You can activate or deactivate this
function.

67
-Accesses
01-01-2006
OPENING THE BONNET
Inside the vehicle
: pull the handle
on the left-hand side, under the
fascia.
Outside the vehicle : lift the catch
and raise the bonnet.
BONNET STRUT
Secure the strut to hold the bonnet
open.
Before closing the bonnet, replace
the strut in its housing.
FILLING THE FUEL TANK
The tank must be filled with fuel with
the engine switched off .
Insert the key then turn it to the left.
Remove the cap.
A label indicates which type of fuel
to use.
If you fill your tank, do not continue
after the third cut-off of the pump
nozzle. This could result in vehicle
malfunctions.
The capacity of the tank is
approximately 10.3 gallons
(47 litres).
To close
Lower the bonnet and release it at
the end of its travel. Check that the
bonnet is locked.

68 -Accesses
01-01-2006
THE ELECTRIC
RETRACTABLE ROOF
Opening the roof
Never switch the ignition off
during operation of the roof.

Park the vehicle on horizontal
ground.
 Ensure that the screen 1 is
hooked on (no object must be
placed on the screen; if there is
luggage in the boot, this must not
push the screen upwards).
 Check that no object has been
placed on the rear parcel shelf.
 Close the boot correctly.
 With the vehicle stationary
and the handbrake applied, turn
the ignition switch to the running
position (2nd notch). 
Release the two hooks 2
completely ; this operation is
confirmed by an audible signal.
 Pull switch 3 until you hear a
signal which confirms that the roof
opening operation is complete.
When carrying out this manoeuvre,
the front windows and then the rear
quarter panel windows lower, the
boot lid opens, the roof folds up and
stores itself in the boot. Then the
boot lid closes and the moving shelf
positions itself.
Note: The control buttons for the
windows become operational again
at the end of the roof operation. Operating malfunction:
If the cycle does not begin, check
that the screen is pulled correctly and
that the boot is closed correctly.
If movement of the roof stops, a
continuous audible signal sounds:

Release switch 3, then press it
again to finish opening the roof.
If the malfunction persists, contact
a PEUGEOT dealer to have the
system checked.
After rain or washing the vehicle,
it is advisable to wait for the roof
to dry before opening it.

69
-Accesses
01-01-2006
Closing the roof
Never switch the ignition off
during operation of the roof.

Ensure that the screen 1 is
hooked on (no object must be
placed on the screen; if there is
luggage in the boot, this must not
push the screen upwards).
 Close the boot correctly.
 With the vehicle stationary and
the handbrake applied, turn the
ignition key to the running position
(2nd notch).
 Press switch 3 until you hear a
signal which confirms that the roof
closing operation is complete.
When carrying out this operation,
the front windows and then the rear
quarter panel windows open, the
moving parcel shelf folds up, the
boot lid opens, the roof unfolds and
positions itself, then the boot lid
closes again.
 Only then, lock the two hooks 2.
Note: The control buttons for the
windows become operational again
at the end of the roof operation. Operating malfunction:
If the cycle does not begin, check
that the screen is pulled correctly and
that the boot is closed correctly.
If movement of the roof stops, a
continuous audible signal sounds:

Release switch
3, then press it
again to finish closing the roof.
If the problem persists, contact
a PEUGEOT dealer to have the
system checked.
When the vehicle is moving, if a
continuous audible signal can be
heard, this means that the roof or the
boot lid, or both, are not locked:
 Stop the vehicle and apply the
handbrake,
 Open the roof and close it again
completely, in accordance with
the procedure.
If the problem persists, contact
a PEUGEOT dealer to have the
system checked. In the case of an electric or
hydraulic malfunction of the roof,
it is possible to close the roof
manually.
When the side windows no longer
open completely, it is impossible
to operate the roof; however it
is possible to close it by using a
special procedure.
Please consult the breakdown
procedure described at the end
of this handbook.
The roof must not be
operated when a loaded
luggage carrier is fitted to
the boot lid.
During roof opening and
closing operations, to avoid any
risk of injury, ensure that there
is no-one in the proximity of the
moving parts.
Never release button 3 for more
than five minutes when the roof
is in an intermediate position
(neither completely open or
closed). However, in the event
of danger, release the control
knob and the operation will stop
instantly. You can resume the
cycle before the audible signal
ceases.

70 -Visibility
01-01-2006
Note: when the lights are switched
off automatically or when the dipped
headlamps are switched off manually,
the front fog lamps, the rear fog lamp
and the side lights remain on (turn
the ring backwards to switch off the
front fog lamps. The side lights then
switch off).
Dipped/Main beam change
Pull the stalk towards you.
Note:
with the ignition off and the
automatic lighting function switched
off, if the driver's door is open, a
buzzer sounds if you have left your
lights on.
THE LIGHTS STALK
Front and rear lights
Selection is by turning ring A.
Lights off
Side lights
Dipped / Main beam
headlamps
Automatic switching
on of lights Front fog lamps (1st forwards
turn of the ring)
Front fog lamps and rear fog
lamp
Rotate the ring
B forwards to switch
on and backwards to switch off. The
status is confirmed by the light on the
instrument panel.
The front fog lamps operate with the
side lights and dipped headlamps.
When the main beam headlamps are
switched on, the front fog lamps are
switched off. They are switched on
again when the main beam head-
lamps are switched off. Front fog lamps and
rear fog lamp (2nd
forwards turn of the
ring)
Note: to switch off the rear fog lamp
and the front fog lamps, turn the ring
twice backwards. In good or rainy weather,
both day and night, the
front fog lamps and the
rear fog lamp are dazzling
and are prohibited.
Do not forget to switch them off
when they are no longer needed.
"Follow me home" lighting
When you leave your vehicle, the
side lights and dipped headlamps
can be left on for approximately 30
seconds.
To do this:
- place the key in the
STOP
position,
- place the lights stalk in the 0
position,
- flash the headlamps,
- get out of the vehicle and lock it.

71
-
Visibility
01-01-2006
Direction indicators (flashers)
AUTOMATIC SWITCHING ON
OF LIGHTS
The side lights and dipped beam
headlamps switch on automatically
if the light is poor and when
the windscreen wipers operate
continuously and switch off when the
light becomes bright enough or the
windscreen wipers are switched off.
In foggy weather or in snow, the
brightness sensor can detect
sufficient light, the lights will not
come on automatically.
This function is active when the
vehicle is supplied
to the customer.
To disarm or activate the function:
- Place the key in the accessories position (1st notch),
- Place the lights stalk in the AUTO/0
position,
- Press the end of the lights stalk for more than four seconds. Operating check
Activation
The activated function is
accompanied by an audible signal
and a message on the multifunction
display.
Left:
downwards.
Right: upwards.
Do not cover the brightness
sensor, coupled with the rain
sensor, located in the centre
of the windscreen, behind the
interior mirror. It is used for
automatic switching on of the
lights.
Disarming
The disarmed function is
accompanied by an audible signal.
When the driver uses the manual
lighting controls, the function is
temporarily disarmed.
If the brightness sensor does not
function correctly, the lights come
on accompanied by an audible signal
and a message on the multifunction
display.
Contact a PEUGEOT dealer.
HEADLAMP ADJUSTMENT
Depending on the load in your
vehicle, adjusting the beam of the
headlamps is recommended as
follows.
0. 1 or 2 people in the front seats.
-. 3 people.
1. 4 people.
2. 4 people + maximum authorised
load.
3. Driver + maximum authorised
load.
Initial setting is position 0.

71
-
Visibility
01-01-2006
Direction indicators (flashers)
AUTOMATIC SWITCHING ON
OF LIGHTS
The side lights and dipped beam
headlamps switch on automatically
if the light is poor and when
the windscreen wipers operate
continuously and switch off when the
light becomes bright enough or the
windscreen wipers are switched off.
In foggy weather or in snow, the
brightness sensor can detect
sufficient light, the lights will not
come on automatically.
This function is active when the
vehicle is supplied
to the customer.
To disarm or activate the function:
- Place the key in the accessories position (1st notch),
- Place the lights stalk in the AUTO/0
position,
- Press the end of the lights stalk for more than four seconds. Operating check
Activation
The activated function is
accompanied by an audible signal
and a message on the multifunction
display.
Left:
downwards.
Right: upwards.
Do not cover the brightness
sensor, coupled with the rain
sensor, located in the centre
of the windscreen, behind the
interior mirror. It is used for
automatic switching on of the
lights.
Disarming
The disarmed function is
accompanied by an audible signal.
When the driver uses the manual
lighting controls, the function is
temporarily disarmed.
If the brightness sensor does not
function correctly, the lights come
on accompanied by an audible signal
and a message on the multifunction
display.
Contact a PEUGEOT dealer.
HEADLAMP ADJUSTMENT
Depending on the load in your
vehicle, adjusting the beam of the
headlamps is recommended as
follows.
0. 1 or 2 people in the front seats.
-. 3 people.
1. 4 people.
2. 4 people + maximum authorised
load.
3. Driver + maximum authorised
load.
Initial setting is position 0.

72 -Visibility
01-01-2006
Front windscreen wiper with
intermittent wipe
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
l Intermittent wipe.
0 Off.
 Single wipe (press
downwards).
In the Intermittent position, the
wiping speed is in proportion to the
vehicle speed. The command must be reactivated
whenever the ignition has been
switched off for more than one
minute:
- move the stalk to any position,
- then move it back to the required
position.
WINDSCREEN WIPER STALK
Front windscreen wiper with
automatic wipe
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
AUTO Automatic wipe.
0 Off.
 Single wipe (press
downwards).
In the AUTO position, the wiping
speed is in proportion to the intensity
of the rainfall. Windscreen and headlamp wash
Pull the windscreen wiper stalk
towards you.
The windscreen wash then the
windscreen wipers operate for a
fixed period.
The headlamp wash is also activated,
if the headlamps are on.