Peugeot 206 Dag 2008 Owner's Manual

95
PRACTICAL INFORMATION
-
SPECIAL FEATURES OF
ALLOY WHEELSFitting the spare wheel
If your vehicle is equipped with a steel
spare wheel, when itting it, it is nor-
mal to notice that the bolt washers
do not come into contact with the rim.
The spare wheel is secured by the
cone shape of each bolt. Wheel anti-theft bolts
If your wheels are itted with anti-theft
bolts (one per wheel), the chrome-
plated trim cap and then the plastic
cover on the wheel must be removed,
using the
yellow tool (located in the
box ixed to the left-hand side of the
boot), before slackening the bolt us-
ing the anti-theft socket (located in
the glove box) and the wheelbrace,
located in the boot rear right inner
panel.
Note: take a careful note of the code
number engraved on the head of the
anti-theft socket. This will enable you
to obtain a duplicate anti-theft socket
from a PEUGEOT dealer.
Fitting snow tyres
If you it snow tyres that are mounted
on steel rims onto your vehicle, it is
es-
sential that you use special bolts avail-
able from your PEUGEOT dealer.
Bolt covers
Alloy wheel bolts are covered by
chrome trims.
Use the yellow tool
4 to remove the
trims before slackening the bolts.
Tool 4 is located on the rear right in-
ner panel of the boot.

PRACTICAL INFORMATION
96 -
Dipped headlamps H7 55W /
main beam headlamps H1 55W
F Remove the protective cover A
for the H7 55W bulb or B for the
H1 55W bulb.
F Disconnect the connector(s) C.
F Press the end of the securing
clip(s) D to remove it(them).
Change the faulty bulb.CHANGING A BULB
To make access easier, on the right-
hand side , irst remove the screen
wash reservoir iller pipe:
F align the notches by turning,
F pull upwards.
1. Dipped beam headlamps /
main beam headlamps
2. Side lights
3. Direction indicators F
On itting, ensure that the
direction notches are in the
correct position and that the
securing clip(s) is(are) secured
correctly.
F Reconnect the connector.
F Replace the protective cover(s),
then the screen wash reservoir
iller pipe (right-hand side).

97
PRACTICAL INFORMATION
-
Amber direction indicators PY21W
F Turn the pin connector 3 a
quarter turn (towards the front of
the vehicle) and remove it.
F Change the bulb. Amber direction indicator
side repeater WY5W
F
Push the repeater forwards and
release it.
F Remove the repeater and
change it.
It can be obtained from a PEUGEOT
dealer.
Side lights W5W
F
Turn the pin connector 2 a
quarter turn and remove it.
F Change the bulb.
Handle the bulbs with a
dry cloth.
The headlamps are it
-
ted with polycarbon glass
with a protective coating. Do not
clean them using a dry or abra-
sive cloth, or using detergents
or solvents.
Use a sponge and soapy water.
High pressure washing
When using this type of washing
on stubborn dirt, do not persist on
the headlamps, lights and their
surrounds to avoid damaging their
coating and seal.

PRACTICAL INFORMATION
98 -
Unclip the boot side trim.
Unclip the foam cover and reach
behind the cover to locate the wing
nut.
Remove the wing nut.
Release the light unit.
Press the lug A and disconnect the
connector.
Remove the foam.
Move aside the tabs B and remove
the bulb holder.
Change the faulty bulb.
When reitting, ensure that the bulb
holder, the light and the foam cover
are repositioned correctly. Third brake light 5 bulbs
W5W
Using a 10 mm spanner, unscrew the
2 nuts
A.
Release the light unit.
Squeeze the two tabs B to release
the bulb holder.
Change the faulty bulb.
Rear lights
1.
Direction indicators
P21W.
2. Reversing lights P21W.
3. Brake lights/side lights
P21/5W.

99
PRACTICAL INFORMATION
-
Front fog lamps
H1 55W
Press under the access lap to re-
lease it.
Open the lap.
Turn the cover to remove it.
Disconnect the bulb.
Press the two ends of the securing
clip to release the bulb. Rear fog lamp P21W
Unclip the lamp and release the as-
sembly.
Turn the pin connector a quarter turn
and remove it.
Change the bulb.
Number plate lights
W5W
Insert a thin screwdriver into one of the
outer holes of the transparent cover.
Push it outwards to unclip it.
Remove the transparent cover.
Change the faulty bulb.

PRACTICAL INFORMATION
100 -
CHANGING A FUSE
The fuse boxes are located under
the fascia and in the engine compart-
ment.
Correct Incorrect
Pliers A
Fascia fuse box
Unscrew the catch a quarter turn us-
ing a coin then remove the cover to
gain access to the fuses.
The spare fuses and the pliers
A are
secured on the inside of the fascia
fuse box cover. Removing and itting a fuse
Before changing a fuse, the cause of the fault must be foun
d and remedied. The
fuse numbers are indicated on the fuse box.
Use the pliers A.
Always replace a faulty fuse with a fuse of the same rating .

PRACTICAL INFORMATION
100 -
CHANGING A FUSE
The fuse boxes are located under
the fascia and in the engine compart-
ment.
Correct Incorrect
Pliers A
Fascia fuse box
Unscrew the catch a quarter turn us-
ing a coin then remove the cover to
gain access to the fuses.
The spare fuses and the pliers
A are
secured on the inside of the fascia
fuse box cover. Removing and itting a fuse
Before changing a fuse, the cause of the fault must be foun
d and remedied. The
fuse numbers are indicated on the fuse box.
Use the pliers A.
Always replace a faulty fuse with a fuse of the same rating .

101
PRACTICAL INFORMATION
-
Fuse N° Rating Functions
1 15A Heated seat - Alarm
4 20AMultifunction display - Boot lighting - Audio equipment - Stee ring wheel controls - Trailer
5 15A Automatic gearbox diagnostics
6 10A Coolant level - Automatic gearbox - Audio equipment - Stee ring wheel angle sensor (ESP)
7 15A Driving school accessory - Alarm itted as an accessory
9 30A Rear electric windows
10 40A Rear screen and mirror demisting
11 15A Rear windscreen wiper
12 30A Front electric windows - Sunroof
14 10AEngine fuse box - Air bags - Steering wheel controls - Rain sensor
15 15A Instrument panel - Multifunction display - Air condition ing - Audio equipment
16 30A Locking/unlocking controls for doors, bonnet and boot
20 10A Right-hand brake light
21 15A Left-hand brake light - 3rd brake light
22 20A Front courtesy light - Map reading light - Glove box lighting - Lighter
S1 Shunt PARC shunt

PRACTICAL INFORMATION
102 -
or The electrical circuit of
your vehicle is designed
to operate with standard
or optional equipment.
Before installing other electri-
cal equipment or accessories in
your vehicle, consult a PEUGEOT
dealer.
Some electrical accessories or the
way in which they are itted may
have an adverse effect on the op-
eration of your vehicle (its elec -
tronic control circuits, the audio
circuit and the electrical charging
circuit).
PEUGEOT declines any respon-
sibility for expenses incurred
through the repair of your vehicle
or for any malfunctions resulting
from the installation of auxiliary
accessories, not supplied and not
recommended by PEUGEOT and
not installed in accordance with
PEUGEOT's instructions, in par-
ticular for any equipment the pow-
er consumption of which exceeds
10 milliamps.
Fuse N° Rating Functions
1 * 20AFan unit
2 * 60A ABS/ESP
3 * 30A ABS/ESP
4 * 70ABuilt-in systems interface supply
5 * 70ABuilt-in systems interface supply
6 * - Not used
7 * 30A Ignition switch supply
8 * 20A Audio equipment ampliier Engine compartment fuse box
To gain access to the box in the engine compartment (next to t he battery), unclip
the cover.
After carrying out work, close the cover very carefully.
* The maxi fuses provide additional protection for the electr ical systems. Any
work on these fuses must be carried out by a PEUGEOT dealer.

103
PRACTICAL INFORMATION
-
Fuse N° Rating Functions
1 10APre-heat unit (diesel) - Water in diesel sensor - Reversing lights sw
itch - Speed sensor -
Air low sensor (diesel)
2 15A Canister solenoid valve - Fuel pump
3 10A ABS/ESP engine control unit - ESP stop switch
4 10A Automatic gearbox control unit - Engine control unit
5 - Not used
6 15A Front fog lamps
7 20AHeadlamp wash pump
8 20A Fan assembly relay - Engine control unit - Diesel injection pump
- Diesel high pressure
regulator - Engine management solenoid valve
9 15A Left-hand dipped beam
10 15A Right-hand dipped beam
11 10ALeft-hand main beam
12 15A Right-hand main beam
13 15A Horn
14 10A Front and rear windscreen wash pumps
15 30A Throttle housing heater - Diesel injection pump - Oxygen senso
r - Engine control unit -
Air low sensor - Ignition coil - Engine management solenoid valve - Diesel heater -
Injectors
16 30A Air pump relay
17 30A High and low speed windscreen wiper
18 40A Air conditioning fan