mirror controls Peugeot 206 P Dag 2009 Owner's Manual

FAMILIARISATION
1. Steering lock.

2. Audio equipment steering wheel
control.

3. Wipers/screen wash/trip computer
control.

4. Hazard warning lights control.

5. Multifunction display.

6. Air conditioning and rear screen
and mirrors de-icing control.

7. Audio equipment.

8. Front ashtray.

9. Gear lever.

10. 12 V accessories socket.

11. Glove box.
INSTRUMENTS AND CONTROLS

49
AUTOMATIC SWITCHING ON OF
LIGHTS
The side lights and dipped beam head-
lamps switch on automatically if the light
is poor and when the windscreen wip-
ers operate continuously and switch off
when the light becomes bright enough
or the windscreen wipers are switched
off.

In foggy weather or in snow, the
brightness sensor can detect suffi -
cient light, the lights will not come
on automatically. If necessary, the
dipped headlamps must be switched
on manually.
This function is active when the vehicle
is supplied to the customer.
To disarm or activate the function:
- Place the key in the accessories po- sition (1st notch),
- Place the lights stalk in the 0 posi-
tion,
- Press the end of the lights stalk for more than four seconds.

Do not cover the brightness sensor,
coupled with the rain sensor, located
in the centre of the windscreen, be-
hind the interior mirror. It is used for
automatic switching on of the lights. Operating check
Activation
The activated function is accompanied
by an audible signal and a message on
the multifunction display.
Disarming
The disarmed function is accompanied
by an audible signal.
When the driver uses the manual light-
ing controls, the function is temporarily
disarmed.

If the brightness sensor does not
function correctly , the lights come on
accompanied by an audible signal and
a message on the multifunction display.
Consult a PEUGEOT dealer.
HEADLAMP ADJUSTMENT
Depending on the load in your vehicle,
it is recommended that the headlamp
beam is adjusted.

0. 1 or 2 people in the front seats.

-. 3 people.

1. 5 people.

2. 5 people + maximum authorised load.

3. Driver + maximum authorised load.

Initial setting is position 0.