ECO mode Peugeot 206 P Dag 2010 User Guide

!
72
Programming

 Turn dial 1 to the "LIMIT" position:
the speed limiter mode is selected
but is not switched on (OFF).
Exceeding the programmed speed
Pressing the accelerator pedal to exceed the programmed
speed will not have any effect unless you press the pedal

fi rmly past the point of resistance .
The speed limiter is deactivated temporarily and the pro-
grammed speed, which is still displayed, fl ashes.
Returning to the programmed speed, by means of intentional
or unintentional deceleration of the vehicle, automaticall y
cancels the fl ashing of the programmed speed. Return to normal driving

 Turn dial 1 to the "0" position: the
speed limiter mode is deselected.
The display returns to the distance
recorder.
You do not have to switch the speed
limiter on in order to set the speed.

 Switch the speed limiter off by pressing button 4 : the
display confi rms that it has been switched off (OFF).

 Switch the speed limiter back on by pressing button 4
again.

 Set the speed value by pressing button 2 or 3 (e.g.: 55 mph
(90 km/h)).
You can then change the programmed speed using but tons 2
and 3 :
- by + or - 1 mph (km/h) = short press,
- by + or - 5 mph (km/h) = long press,
- in steps of + or - 5 mph (km/h) = maintained press.

 Switch the speed limiter on by pressing button 4 . Operating fault
In the event of a speed limiter malfunc-
tion, the speed is cleared resulting in
fl ashing of the dashes.
Have the system checked by a PEUGEOT
dealer.
On a steep descent or in the event
of sharp acceleration, the speed
limiter will not be able to prevent
the vehicle from exceeding the pro-
grammed speed.
To avoid any risk of jamming of the
pedals:
- ensure that the mat is posi-tioned correctly,
- do not fi t one mat on top of ano- ther.

!i
92
ECONOMY MODE FUNCTION
After the engine has stopped, with the
key in the accessories position, certain
functions (windscreen wiper, courtesy
lamps, audio equipment, dipped beam
headlamps, etc.) can only be used for
a maximum cumulative duration of ap-
proximately fi fteen minutes, to prevent
discharging of the battery.
Once the fi fteen minutes are over, the
message "Economy mode active" ap-
pears on the multifunction screen and
the active functions are put on standby.
These functions will be reactivated au-
tomatically the next time the vehicle is
used.
To resume the use of these functions
immediately, start the engine and let it
run for a few minutes.
The time available will then be double
the time for which the engine is left run-
ning. However, this time will always be
between fi ve and fi fteen minutes.
A fl at battery will prevent the en-
gine from starting.
TOWING THE VEHICLE
Procedure for having your vehicle towed.
Towing your vehicle

 On the front bumper, unclip the cover
to gain access to the towing eye.

 Switch on the hazard warning lamps
on the towed vehicle.

 Place the gear lever in neutral. Towing another vehicle
Failure to comply with this special
requirement may result in damage
to certain braking components
and the absence of braking assis-
tance the next time the engine is
started.

10
104

Button
Function

A Radio On/Off.

B - Decrease volume.

C + Increase volume.

D




CD eject.

E RDS * RDS function on/off.
Press for more than 2 seconds: regional following mode on/off.

F TA * Traffi c information priority on/off.
Press for more than 2 seconds: PTY function on/off.

G



Setting of the bass, treble, loudness, sound distribution a
nd automatic volume correction.

H



Increase the setting of the functions associated with butto
n G .

I



Decrease the setting of the functions associated with butto
n G .

J



Manual and automatic search of higher frequencies.
Selection of the next track on the CD and of the PTY (radio).


K MAN Manual/automatic operation of buttons J and L .

L



Manual and automatic search of lower frequencies.
Selection of the previous track on the CD and of the PTY (radi
o).

M CH. CD Selection of the CD changer source.
Press for more than 2 seconds: random play.

N CD Selection of the CD source.
Press for more than 2 seconds: random play.

O Radio Selection of the radio source. Selection of the FM1, FM2, FMAST
, AM wavebands.
Press for more than 2 seconds: automatic storing of stations (autosto re).

1 to 6 1 2 3 4 5 6 Selection of the stored station.
Press for more than 2 seconds: storing of a station.
* According to country.

10
105
GENERAL FUNCTIONS
On/off
With the ignition key in
the accessories position
or with the ignition on,
press button A to switch
the audio equipment on
or off.
Anti-theft system
The audio equipment is coded in such
a way that it can only operate in your
vehicle. It would not work if fi tted in an-
other vehicle.

The anti-theft system is automatic
and requires no action on your part.
Press button C to increase the audio
equipment volume or button B to de-
crease it.
A continuous press of buttons B and C
adjusts the volume gradually.
AUDIO SETTINGS
Press button G several
times in succession to
access the bass (BASS) ,
treble (TREB) , loudness

(LOUD) , fader (FAD) ,
balance (BAL) and auto-
matic volume correction
settings.
Exit from audio mode is automatic after
a few seconds without any action or by
pressing button G following confi gura-
tion of the automatic volume correction. Adjusting the bass
When "BASS" is dis-
played, press button H or

I to change the setting.
- "BASS -9" for a min-
imum bass setting,
- "BASS 0" for a stan-
dard setting,
- "BASS +9" for a maximum bass
setting.
Adjusting the treble
When "TREB" is displayed, press but-
ton H or I to change the setting.
- "TREB -9" for a minimum treble set-
ting,
- "TREB 0" for a standard setting,
- "TREB +9" for a maximum treble
setting.
Adjusting the loudness (LOUD)
This function automatically emphasises
bass and treble tones.
Press button H or I to switch the func-
tion on or off.

Note: bass, treble and loudness settings
are specifi c to each source. They can be
set differently for the radio or CD.

The audio equipment can operate for
30 minutes without the ignition being
switched on.

10
108
RDS *
Using the RDS on FM
The RDS (Radio Data System) allows
you to continue listening to the same
station, whatever frequency it is using
in the region you are travelling through. Press the "RDS" button
briefl y to switch the func-
tion on or off.
The multifunction screen will indicate:
- "RDS" if the function is selected,
- "(RDS)" if the function is selected
but not available.
RDS station following
The display indicates the name of the sta-
tion selected. When the RDS is selected,
the radio searches continuously for the
transmitter which is broadcasting the se-
lected station with the best reception.
Traffi c information programme (TA) Regional following mode (REG)
When they are part of a network, cer-
tain stations broadcast regional pro-
grammes in the various areas they
serve. The regional following mode
allows you to continue listening to the
same programme.
To do this, press the
"RDS" button for
more than two seconds to switch the
function on or off.
Any traffi c information announcement
will be given priority, whatever source
you are listening to (radio, CD).
If you wish to interrupt a message,
press the
"TA" button; this switches the
function off.

Note: the volume of the traffi c infor-
mation is independent of the volume
of normal radio listening. You can
adjust it using the volume button.
The setting will be stored and will be
used for subsequent messages.
Search by type of programme (PTY)
This allows you to listen to stations broad-
casting a specifi c type of programme
(News, Culture, Sport, Rock...). When FM is selected,
press the "TA" button for
more than two seconds
to switch the function on
or off. To search for a
PTY programme:
- select the PTY function,
- press button J or L briefl y to scroll
down the list of the different types of
programme offered,
- when the programme of your choice is displayed, press button J or L for
more than two seconds to carry out
an automatic search (following an
automatic search, the PTY function
is switched off).
In PTY mode, the types of programme
can be stored. To do this, press the pre-
selection buttons "1" to "6" for more
than two seconds. Press the corre-
sponding button briefl y to recall the type
of programme stored.
EON system
This system connects stations which
are part of the same network. It permits
the broadcasting of TA traffi c informa-
tion or of a PTY programme broadcast
by a station which is part of the same
network as the station to which you are
listening.
This service is available when you have
selected the TA traffi c information pro-
gramme or the PTY search by type of
programme.
Press the
"TA" button to
switch the function on or
off.
The multifunction screen will indicate:
- "TA" if the function is selected,
- "(TA)" if the function is selected but
not available.
* According to country.

10
!
109
COMPACT DISC MODE
Selecting CD mode
Ejecting a disc Selecting a track
Press button
J to select the next track.
Press button L to return to the start of
the current track or to select the previ-
ous track.
Accelerated play
Press and hold button J or L for for-
wards or backwards accelerated play.
Accelerated play stops as soon as the
button is released. Random play (RDM)
When the CD player is selected, press
button
N for two seconds. The tracks
will be played in random order. Pressing
button N again for two seconds returns
you to normal play.
The random play mode is switched
off each time the audio equipment is
switched off.
The use of copied compact discs
may cause malfunctions.
Insert circular compact discs only.
Press button
D to eject
the disc from the player.
After inserting a disc,
printed face uppermost,
the player starts auto-
matically.
If the player already contains a disc,
press button N .