Peugeot 206 SW 2004.5 Owner's Guide

22 -
31-01-2005
23
-
31-01-2005
Seat belt not fastened
warning light*
When the ignition is switched
on, this indicator light comes
on if the driver has not fastened his
seat belt.
Above 12 mph (20 km/h), the
warning light lashes for about two
minutes accompanied by an increas-
ingly audible signal and a message
on the multifunction display. This
warning light remains lit until the driv-
er's seat belt is fastened.
Passenger air bag
disarmed warning
light*
Illumination of this warning light ac-
companied by a message on the
multi-function display, indicates that
the passenger air bag is disarmed.
The warning light remains lit as long as
the passenger air bag is disarmed.
Always consult a PEUGEOT dealer if
the warning light lashes.
Air bags warning light
The light will come on for a
few seconds when the igni-
tion is switched on.
With the engine running, illumination
of this warning light, accompanied by
an audible signal and a message on
the multi-function display, indicates a
fault in the air bags.
Consult a PEUGEOT dealer.
Coolant temperature indicator
- needle in zone (A), the tempera-
ture is correct,
- needle in zone (B), the tempera-
ture is too high. The central STOP
warning light lashes.
You must stop.
Consult a PEUGEOT dealer.
Engine oil temperature
indicator
With the engine running, this indi-
cates the oil temperature:
- needle in zone (C), the tempera-
ture is correct,
- needle in zone (D), the tempera-
ture is too high. To lower the oil
temperature, reduce your speed.
* According to country.
Instruments and controls

22 -
31-01-2005
23
-
31-01-2005
Seat belt not fastened
warning light*
When the ignition is switched
on, this indicator light comes
on if the driver has not fastened his
seat belt.
Above 12 mph (20 km/h), the
warning light lashes for about two
minutes accompanied by an increas-
ingly audible signal and a message
on the multifunction display. This
warning light remains lit until the driv-
er's seat belt is fastened.
Passenger air bag
disarmed warning
light*
Illumination of this warning light ac-
companied by a message on the
multi-function display, indicates that
the passenger air bag is disarmed.
The warning light remains lit as long as
the passenger air bag is disarmed.
Always consult a PEUGEOT dealer if
the warning light lashes.
Air bags warning light
The light will come on for a
few seconds when the igni-
tion is switched on.
With the engine running, illumination
of this warning light, accompanied by
an audible signal and a message on
the multi-function display, indicates a
fault in the air bags.
Consult a PEUGEOT dealer.
Coolant temperature indicator
- needle in zone (A), the tempera-
ture is correct,
- needle in zone (B), the tempera-
ture is too high. The central STOP
warning light lashes.
You must stop.
Consult a PEUGEOT dealer.
Engine oil temperature
indicator
With the engine running, this indi-
cates the oil temperature:
- needle in zone (C), the tempera-
ture is correct,
- needle in zone (D), the tempera-
ture is too high. To lower the oil
temperature, reduce your speed.
* According to country.
Instruments and controls

22 -
31-01-2005
23
-
31-01-2005
Display screen showing the
positions of the automatic
gearbox selector lever Automatic gearbox indicator
lights
Park
Reverse
Neutral
Drive
Manual mode: 1st gear engaged
2nd gear engaged
3rd gear engaged
4th gear engaged "SPORT" Indicator light
This comes on when the
"SPORT"
program is selected.
"SNOW" Indicator light
This comes on when the
"SNOW" program is selected.
Operating abnormality
If the Sport and Snow indicator
lights lash, accompanied by an
audible signal and a message on
the multi-function diplay, consult a
PEUGEOT dealer.
Instruments and controls

24 -
31-01-2005
25
-
31-01-2005
Service indicator
This is a visual reminder of when the
next service is due. This service is to
be carried out according to the man-
ufacturer's servicing schedule. 5 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the display
shows the total or trip distances.
The distance remaining before
the next service is less than
500 miles (1,000 km).
Example:
400 miles (900 km) re-
main before the next service is due.
When switching on the ignition and
for 5 seconds, the display shows:
5 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the symbol re-
mains lit.
This indicates that a service should
be carried out shortly. The display
shows the total or trip distances. The service is overdue.
Each time the ignition is switched on
and for 5 seconds, the symbol and
the excess distance lash.
Example:
the service is overdue by
300 miles/km. The service should be
carried out very shortly.
When the ignition is switched on and
for 5 seconds, the display shows:
INSTRUMENT PANEL
DISPLAY
After switching on the ignition, three
functions are shown in succession:
- service indicator,
- engine oil level indicator,
- total distance recorder, it remains displayed for 30 seconds when the
ignition is switched off, on opening
the driver's door, as well as on
locking and unlocking the vehicle.
5 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the symbol re-
mains lit. The display shows the total
or trip distances.
Note: the service spanner lights if the
two-year interval has been exceeded*.
* According to country.
Operation
As soon as the ignition is switched
on and for 5 seconds, the spanner
symbolising ''service operation'' is lit.
The trip recorder display shows the
distance remaining (in round igures)
before the next service.
Example:
4,800 miles/km remain
before the next service is due.
When the ignition comes on and for
5 seconds the display indicates:
Instruments and controls

24 -
31-01-2005
25
-
31-01-2005
Resetting the service indicator
Your PEUGEOT dealer carries out
this operation after each service.
The reset procedure is as follows:
- Switch off the ignition.
- Press and hold button 1.
- Switch on the ignition.
The display begins a 10 second
countdown.
-
Keep button 1 pressed for 10 seconds.The display shows [= 0] and the
service symbol disappears.
Engine oil level indicator
When the ignition is switched on,
the engine oil level is indicated for
approximately 10 seconds, after the
service information.
Oil level gauge fault
Flashing of the six segments indi-
cates a malfunction of the oil level
gauge.
There is a risk of damage to the engine.
Contact a PEUGEOT dealer.
Surplus of oil
Flashing of the six squares and dis-
playing of "max" indicate a surplus of
oil which could damage the engine.
If the surplus of oil is conirmed by
a check using the dipstick, contact a
PEUGEOT dealer without delay.
Lack of oil
Flashing of the six segments and dis-
playing of "min" indicate a lack of oil
which could damage the engine.
If the lack of oil is conirmed by a
check using the dipstick, it is essen-
tial that the level is topped up. The level read on the gauge
will only be correct if the vehi-
cle is on level ground and the
engine has been off for more
than 10 minutes.
Instruments and controls

26 -
31-01-2005
Total distance recorder
Briely pressing button 1 alternates
between the total and trip distance
displays.
To reset the trip recorder to zero,
when it is displayed press button 1
until zeros appear.
LIGHTING RHEOSTAT
With the lights on, press the button
to vary the intensity of the lighting of
the instruments and controls. When
the lighting reaches the minimum (or
maximum) setting, release the button
then press it again to increase (or re-
duce) the brightness.
As soon as the lighting is of the re-
quired brightness, release the button.
HAZARD WARNING
LIGHTS
Press the button, the direction indica-
tors lash.
They can operate with the ignition off.
Automatic lighting of hazard
warning lights*
When braking in an emergency, de-
pending on the deceleration, the hazard
warning lights come on automatically.
They switch off automatically the irst
time you accelerate.
It is also possible to switch them off
by pressing the button.
* According to country.
Instruments and controls

27
-
31-01-2005
CLOCKAdjusting the parameters
Press and hold button 1 for two sec-
onds to access the settings; the data
lashes, indicating it is ready to be
modiied.
Then, each press of button 1 scrolls
through the various data in the fol-
lowing order:
- language of information displayed,
- hours (12 then 24 hour mode),
- minutes,
- year,
- month,
- day,
- unit of temperature (degrees Celsius or Fahrenheit).
Pressing button 2 allows modiication
of the data selected. Press and hold
for rapid advance (return to start after
the last possible value).
After 7 seconds with no action, the main
display returns; the modiied data are
now recorded.
Note: Pressing button 2 briely dis-
plays the outside temperature for a
few seconds.
Button
1: hour adjustment
Button 2: minute adjustment
Press and hold the button for rapid
advance.DISPLAY A
This displays the following information:
- the time,
- the date,
- the outside temperature* (this lashes if there is a risk
of ice),
- the audio system displays,
- a door check (e.g.: ''left front door open''),
- warning messages (e.g. ''remote control battery lat'')
or information messages
(e.g. ''economy mode active''),
displayed temporarily.
* According to model.
Multifunction displays

28 -
31-01-2005
29
-
31-01-2005
Setting the parameters
Press button 1 for two seconds to
access the settings. The informa-
tion lashes to show it is ready to be
modiied.
Then, individual presses on button 1
allow you to scroll through the vari-
ous data in the following sequence:
- language in which the information is displayed,
- unit of distance (kms or miles),
- unit of temperature (degrees Cel- sius or Fahrenheit),
- time format (12 then 24 hour mode),- hour,
- minutes,
- year,
- month,
- day.
Pressing button 2 allows you to
change the information selected.
Maintain the pressure for rapid scrolling.
After 7 seconds without operation, the
screen returns to the normal display
and the modiied data is recorded.
MONOCHROME DISPLAY B
This enables the following informa-
tion to be displayed:
- the time,
- the date,
- the outside temperature (this lash- es when there is a risk of ice),
- the radio displays,
- the status of the doors. The display shows you, by means of a graphic,
whether a door is open,
- the warning messages (e.g. ''bat- tery charge fault'') or information
messages (e.g. "fuel level low''), dis-
played temporarily, can be cleared
by pressing button 1 or 2,
- the trip computer.
Multifunction displays

28 -
31-01-2005
29
-
31-01-2005
MONOCHROME SCREEN CT
Coniguration menu
This gives access to the following
parameters:
- "Adjust the brightness": adjust the
brightness of the display.
- "Sound": voice synthesiser setting (for the masculine/feminine voice
parameter; insert the coniguration
CD-Rom); setting of the spoken
commands.
- "International parameters": date and time setting (12 or 24 hour mode,
adjustment of the minutes on GPS);
units setting (l/100 - °C or mpg - °F).
- "Choice of the language": choice of the language of the display, in-
formation and spoken commands
(German, English, Spanish, French,
Italian, Dutch, Portuguese: insert
the coniguration CD-Rom).
Main menu
Press the RT3 audio/telephone
"MENU"
button to access the main menu and
select one of the following applications:
- navigation - guidance (see section "Satellite navigation system"),
- audio functions (see "RT3 Audio/ telephone" section),
- trip computer (see corresponding section),
- directory (see "RT3 audio/telephone" section),
- telematics (see "RT3 audio/telephone" section),
- coniguration.
This is controlled by the RT3 GPS
audio/telephone keypad.
It enables the following information to
be displayed:
- the time,
- the date,
-
the outside temperature (a message
warns you when there is a risk of ice),
- the audio source displays (radio, CD, ...),- the telematic system displays (tele- phone, services, ...),
- the status of the openings (doors, bonnet, ...),
- the warning messages (e.g. "Fuel level low") and vehicle functions sta-
tus messages (e.g. "Passenger air
bag deactivated") displayed tempo-
rarily,
- the trip computer display (see cor- responding section),
- the satellite navigation system dis- plays (see corresponding section). Note:
to enable you to use all of your
system's functions, you have two CD
ROMs: one, "Coniguration", contains
the software and the various display
and spoken information languages,
the other, "Navigation", contains the
satellite navigation system map data.
Multifunction displays

30 -
31-01-2005
31
-
31-01-2005
AUDIO RB3
Stalk movement Function
1 - Press (behind) Increase volume.
2 - Press (behind) Decrease volume.
1 + 2 - Simultaneous press Sound cut-off (mute); restoring of the sound b y pressing any button.
3 - Press Automatic search of higher frequencies (radio) -
Selection of the next track (CD).
4 - Press Automatic search of lower frequencies (radio) -
Selection of the previous track (CD).
5 - Press the end Change of source (radio/cassette/CD changer).
6 - Rotation (clockwise) Selection of next station stored in the memory (radio) -
Selection of next CD.
7 - Rotation (anti-clockwise) Selection of previous station stored in the memory (radio) -
Selection of previous CD.
Audio equipment and telematics