Peugeot 206 SW Dag 2004 Manual PDF

72
14-06-2004
73
14-06-2004
Guidance options Calculation criteria
The menu ''Guidance options''
provides access to the following
functions:
- changing of the route calculation criteria,
- voice synthesis adjustment of guid- ance messages,
- description of the information relat- ing to the navigation CD-Rom,
- management of the addresses stored in the directory. The last criterion used is displayed.
Select a criterion from the list, then
validate by pressing the dial.
When the criterion of your choice
has been selected, select the
"OK"
function then conirm by pressing
the dial.
Adjusting the voice synthesiser
Select the type of voice "male" or
"female" , after inserting the conigu-
ration CD-Rom.
Adjust the volume of the voice syn-
thesis by turning the dial, then vali-
date by pressing the dial.
Note: the volume can also be ad-
justed during a message, using the
audio/telephone button or the steer-
ing wheel control.
Management of the directory
This function enables you to rename
an address stored in the directory.
Select the description correspond-
ing to the stored address to be
changed.
Select the "Rename" function, then
conirm by pressing the dial.
Select the "OK" function, then con-
irm by pressing the dial to record the
changes made.
Stopping/Resuming guidance ฀• "Stop guidance"
During guidance, select this function
then validate. ฀• "Resume guidance"
In the absence of guidance, select
this function then validate to activate
guidance to the last destination pro-
grammed.
Note: after re-starting the engine,
a screen appears enabling you to
resume guidance activated before
the ignition was switched off.
YOUR 206 IN DETAIL

72
14-06-2004
73
14-06-2004
"Navigation - Guidance"
contextual menu
The contextual menu associated with
the "Navigation - Guidance" appli-
cation appears as a superimposed
display, when this is the application
currently in use in the main screen
window.
This menu is limited to the following
functions:
- changing of the initial route (enter- ing of a diversion),
- storing of the current location (post- al address if available or, if it is not,
the GPS co-ordinates),
- changing of the route calculation criteria,
- stopping or resuming of guidance (displaying of the message which
changes depending on the previ-
ous status). TMC (Trafic Message Channel)
RDS Trafic Information*
This function enables you to re-
ceive messages regarding the trafic
conditions (accidents, trafic jams,
weather, ...).
They may appear temporarily as a
superimposed display or be read by
the voice synthesiser, if it is active.
YOUR 206 IN DETAIL
Select the
"TMC Trafic Informa-
tion" function on the "Telematics"
menu, you can choose:
- "Consult the messages" to display the list of TMC messages available,
- "Filter the TMC information" to se- lect a type of message and initialise
the TMC station,
- "Voice synthesiser" to listen to the TMC messages received,
- "Activate/Deactivate trafic infor- mation" to choose whether or not
to display the TMC messages re-
ceived.
* During the year. Initialisation of the TMC station
To initialise this function, you must
select an FM station which is able to
transmit these messages.
Select the
"Selection of the TMC
station" function from the "TMC
Trafic Information" menu, the
screen will then show either:
- the name of the station to which you are listening,
- "No TMC station available" if no station is selected or if it does not
transmit TMC messages,
- "Searching" if you have activated the search for the next station.

74
14-06-2004
75
14-06-2004
YOUR 206 IN DETAIL
Filtering of the TMC messages
To ilter these messages, select the
"Filter the TMC information" func-
tion from the "TMC Trafic Informa-
tion" menu, the screen then shows:
- "Filter according to route" to obtain the messages relating to the route
of the guidance in progress,
- "Filter by event" to display only messages relating to accidents or
trafic jams or...,
- "Geographical ilter" to consider messages within a radius of action
to be deined around the vehicle
and/or a location.
You can ilter these messages using
one or more ilters simultaneously.

74
14-06-2004
75
14-06-2004
YOUR 206 IN DETAIL

76
14-06-2004
77
14-06-2004
YOUR 206 IN DETAIL

76
14-06-2004
77
14-06-2004
YOUR 206 IN DETAIL
VENTILATION
1. Windscreen de-icing or
demisting vents.
2. Front door windows de-icing or
demisting vents.
3. Side vents.
4. Centre vents.
5. Air outlet to front footwells.
6. Air outlet to rear footwells.
Advice on operation
- Place the air low control at a level
suficient to ensure correct renewal
of air in the passenger compart-
ment. Only use the ''OFF'' position
occasionally (risk of condensa-
tion).
- Select the air distribution most suited to your requirements and
the climatic conditions.
- Gradually adjust the temperature setting for optimum comfort.
- Position the outside air control to the left; the ''Outside Air'' position.
- For perfectly even air distribution, take care not to obstruct the exte-
rior air intake grille on the bonnet,
the vents and the air ducts under
the front seats. Check that the
passenger compartment ilter is in
good condition.

78
14-06-2004
79
14-06-2004
HEATING/VENTILATION
2. Air distribution adjustment
YOUR 206 IN DETAIL
1. Temperature adjustment
To be adjusted to your requirements.
From blue (exterior temperature) to
red (hot).Windscreen and side win-
dows (de-icing/demisting).Windscreen, side windows
and footwells.
Footwells.
Centre and side vents.
These settings are recommended for
cold climates.
This setting is recommended for hot
climates.
3. Air low adjustment
Turn the control from posi-
tion 1 to position 4 to obtain
an air low suficient to en-
sure your comfort.

78
14-06-2004
79
14-06-2004
YOUR 206 IN DETAIL
5. Demisting the rear screen and the mirrors
With the engine running,
press once to demist the rear
screen and the mirrors.
It switches off automatically
after approximately twelve minutes.
Press again to switch it back on for
twelve minutes.
It is possible to stop demisting by
pressing the button again before the
end of the twelve minutes. Rapid de-icing/demisting
To quickly de-ice or demist the wind-
screen and side windows:
- position the air intake control to the
left; the ''Outside Air" position,
- turn the temperature and air low controls to maximum,
- close the centre vents.
4. Air intake control
Intake of exterior air.
This is the normal operating posi-
tion. Recirculation of interior air.
This position prevents exterior
odours and smoke entering the pas-
senger compartment. It speeds up
the rate at which the passenger com-
partment can be heated but equally,
there is a risk of misting the windows
due to condensation. As soon as possible, position the
control in the exterior air intake
position to prevent misting of the
windows.

80
14-06-2004
81
14-06-2004
YOUR 206 IN DETAIL
AIR CONDITIONING
The air conditioning does not op-
erate while the air low adjustment
control is in the "OFF" position.
Note
It is quite normal that the condensa-
tion created by the air conditioning
results in a low of water under the
vehicle when it is stationary.
1. Air conditioning
In all seasons, the air conditioning
increases the effectiveness of the
demisting. In summer, it enables the
temperature to be lowered. 2. Temperature adjustment
To be adjusted to your requirements.
From blue (cold when the air condi-
tioning is on) to red (hot).
Windscreen and side win-
dows (de-icing/demisting).
Windscreen, side windows
and footwells.
Press the switch to activate
the air conditioning. The indi-
cator light comes on. Footwells.
3. Air distribution adjustment
Centre and side vents.
These settings are recommended for
cold climates.
This setting is recommended for hot
climates.

80
14-06-2004
81
14-06-2004
YOUR 206 IN DETAIL
6. Demisting the rear screen and the mirrors
With the engine running,
press once to demist the rear
screen and the mirrors.
It switches off automatically
after approximately twelve minutes.
Press again to switch it back on for
twelve minutes.
It is possible to stop demisting by
pressing the button again before the
end of the twelve minutes. Rapid de-icing/demisting
To quickly de-ice or demist the wind-
screen and side windows:
- operate the air conditioning,
- turn the temperature and air low
controls to maximum,
- close the centre vents,
- position the air intake control to the left, the "Outside Air" position.
Important precaution
Operate the air conditioning system
for 5 to 10 minutes, once or twice a
month, to keep it in perfect working
order.
If the system does not produce cold air,
do not use it and contact a PEUGEOT
dealer.
4. Air low adjustment
Turn the control from posi-
tion 1 to position 4 to obtain
an air low suficient to en-
sure your comfort.
Intake of exterior air.
Recirculation of interior air.
This is the normal operating posi-
tion.
This position prevents exterior
odours and smoke entering the pas-
senger compartment.
Used simultaneously with the air
conditioning,
recirculation enables
both heating and cooling perform-
ance to be improved .
Used without the air conditioning,
recirculation may result in misting of
the windows.
As soon as possible, position the
control in the exterior air intake posi-
tion.
5. Air intake control