Peugeot 206 SW Dag 2005.5 Owner's Manual

117Layout-
01-10-2005
HEADLAMP ADJUSTMENT
Depending on the load in your
vehicle, it is recommended that the
headlamp beam is adjusted.
0 - 1 or 2 people in the front seats.
- - 3 people.
1 - 5 people.
2 - 5 people + maximum authorised
load.
3 - Driver + maximum authorised
load.
Initial setting is position 0.
STEERING WHEEL HEIGHT
ADJUSTMENT
When stationary, lower the handle to
unlock the steering wheel.
Adjust to the desired height and
lift the handle to lock the steering
wheel.
HORN
Press one of the spokes of
the steering wheel.

Layout118 -
01-10-2005
119Layout-
01-10-2005
COURTESY LIGHTS
Front courtesy light (button A)Map-reading light (button B)
With the key in the accessories or
ignition on position, turn button
B to
the left or to the right.
AREAS FOR TOLL CARDS/
CAR PARK TICKETS
The athermic windscreen has two
non-relective zones located either
side of the base of the interior
mirror.
They are intended for afixing toll
cards and/or car park tickets.
SUN VISOR
The sun visors are itted with a vanity
mirror, with a concealing lap on the
driver's side.
Rear courtesy light (206 SW)
In this position, it comes on
for about 30 seconds:
- on unlocking the vehicle,
- when opening a door,
- when opening the tailgate and the rear screen (206 SW),
- on switching off the ignition.
It switches off on locking the vehicle.
The courtesy light lashes while
driving if a door or the boot is not
closed correctly.
Permanently off.
Permanently on when the key
is in the accessories position
or with the ignition on. In this position, it comes on
for about 30 seconds:
- on unlocking the vehicle,
- when opening a door, the tailgate and the rear screen,
- on switching off the ignition.
It switches off on locking the vehicle.
It lashes while driving if a door or the
boot is not closed correctly.
Permanently off.
Permanently on when the key
is in the accessories position
or with the ignition on.

Layout118 -
01-10-2005
119Layout-
01-10-2005
GLOVE BOX
To open the glove box, lift the handle.
The light comes on when the cover
is opened.
1. Handbook pack storage.
2. Can holder.
3. Pen holder.
4. Spectacles storage.
5. Map storage.
6. Coin storage.
FRONT ASHTRAY
To empty, close the cover.
Pull the lug and release the ashtray
upwards.
LIGHTER
Press and wait a few moments until it
springs out automatically.
It is supplied with power with the
ignition key in the accessories
position (1st notch).

Layout120 -
01-10-2005
121Layout-
01-10-2005
Luggage retaining net
Use the stowing rings on the boot
loor and on the back of the rear
seat* to hook on your luggage
retaining net.
There are several options for storing
the shelf:
- either behind the front seats,
- or behind the rear seat using the
luggage retaining net,
- or lat in the boot.
Rear parcel shelf
To remove the shelf:
- unhook the two strings
1
,
- slightly raise the shelf, then remove it.
BOOT LAYOUT (saloon)
* According to version.

Layout120 -
01-10-2005
121Layout-
01-10-2005
Retaining strap
A strap secured to the side of the
boot enables you to secure various
objects (cans, irst aid kit, etc.).

Layout122 -
01-10-2005
123Layout-
01-10-2005

Layout122 -
01-10-2005
123Layout-
01-10-2005
BOOT LAYOUT (206 SW)
1. Grab handles and coat hooks
2. Coat hooks
There are six hooks to accommodate
coats.
3. High load retaining net fastenings
The high load retaining net can be
installed behind the front seats or
behind the rear seat.
Open the covers of the corresponding
upper fastenings.
Install one end of the metal bar in
one of the two fastenings, compress
the bar, then install the other end and
release.
Secure the two net strap hooks
behind the front seats, with the rear
seat folded down, or in the stowing
rings on the loor.
The rings are located directly below
the corresponding upper fastenings.
Pull the two straps taut.
4. Hooks
There are two side hooks on which to
hang light bags. 5. 12V Socket for accessories
This is a 12 volt socket (lighter type)
installed on the the rear left trim
and supplied from the accessories
position (1st notch).
6. Storage nets
There are two nets (which cannot
be removed), which can contain the
luggage retaining net, a irst aid kit,
etc.
7. Retaining straps
There are two straps for securing
various objects: cans, etc.
8. Load space cover
Note:
release the rear seat back to
make installation and removal of the
load space cover easier.
To install it:
- position one end of the roller in one of the two supports,
- compress the opposite end of the roller and position it,
- release it to allow it to engage,
- unroll the cover as far as the boot pillars,
- insert the cover guides in the rails in the pillars.
To remove it:
- remove the cover guides from the pillar rails,
- return the cover into its roller, compress it and remove it from its
support. 9. Stowing rings
Stowing rings are provided for
securing the luggage retaining net:
they are located on the rear seat
back and on the boot loor (two of
which are under the carpet, at the far
end of the boot).
Warning triangle
The tailgate has a location intended
for a warning triangle.

Layout124 -
01-10-2005
BOOT LAYOUT (206 GTi 180)
1. Insulated storage box containing a puncture repair
kit, the jack and the folding
chock
2. Grab handles with coat hook
3. Removable rear shelf
4. Stowing rings
Stowing rings are provided onto
which the luggage retaining net may
be hooked: they are located on the
back of the rear seats and on the
boot rear inner panel (on the right
and on the left).
5. Luggage retaining net storage (example of location)

125Driving-
01-10-2005
"PORSCHE TIPTRONIC
system" AUTOMATIC
GEARBOX
The four speed automatic gearbox
offers a choice between the comfort
of integral automatic operation ,
enhanced by a sport and a
snow program, or manual gear
changing .
Gear selection gate
F Move the lever in the gate to
select a position.
The indicator light corresponding to the position selected appears
on the instrument panel screen.
P ark: to immobilise the vehicle
and to start the engine , with the
handbrake on or off.
R everse: to reverse (select this
position with the vehicle stationary,
engine at idle).
N eutral: to start the engine and to
park , with the handbrake on.
If position N is inadvertently engaged
while driving, allow the engine
to return to idle before engaging
position D to accelerate.
D rive: for driving in automatic
mode. M anual: for selection of gears.
S : sport program.
T: snow program.
Moving Off
With the engine running, to move off
from position P:
F it is essential to press the brake
pedal to exit position P,
F select position R, D or M, then
gradually release the pressure
on the brake pedal; the vehicle
moves off immediately.
You can also move off from position N:
F release the handbrake, with your
foot on the brake,
F select position R, D or M, then
gradually release the pressure
on the brake pedal; the vehicle
moves off immediately.
Starting the engine
F with the handbrake on, select
position P or N in the gate,
F turn the ignition key to the Start
position. WARNING
When the engine is at idle, brakes
not applied, if position
R, D or M
is selected, the vehicle moves
even without the accelerator being
pressed.
For this reason, do not leave
children unsupervised inside the
vehicle, with the engine running.
When maintenance operations need
to be carried out with the engine
running, apply the handbrake and
select position P.

Driving126 -
01-10-2005
127Driving-
01-10-2005
Automatic operation
Automatic changing of the four
gears:
F select position D in the gate.
The gearbox always selects the
most suitable gear according to the
following parameters:
- the road proile,
- the vehicle load.
The gearbox is then operating in
auto-adaptive mode, without any
action on your part. If you take your foot off the
accelerator suddenly, the gearbox
will not change to a higher gear for
reasons of safety.
Manual operation
Manual
changing of the four gears:
F select position M in the gate,
F push the lever to the + sign to
change to a higher gear,
F pull the lever to the - sign to
change to a lower gear.
You can change from position D
(driving in automatic mode) to
position M (driving in manual mode)
at any time.
WARNING
Never select position N when the
vehicle is moving.
Never select positions P or R unless
the vehicle is stationary.
Never change between positions
to optimise braking on a slippery
surface.
Notes
For immediate maximum acceleration
without touching the gear lever, press
the accelerator pedal down as far as
it will go (kick down). The gearbox
will automatically change down or
maintain the gear selected until
maximum engine speed is reached.
When the brake is applied, the
gearbox will automatically change
down in order to provide eficient
engine braking.
Sport and snow programs
In addition to the auto-adaptive
program, there are two special
programs.
The program is displayed on the
instrument panel screen.
Sport program
F Press button S once the engine
has been started.
The gearbox automatically favours
sporty driving and more dynamic
acceleration.
Snow program
This program improves starting and
drive when traction is poor.
F Press button
T once the engine
has been started.
The gearbox adapts to driving on
slippery roads.
Note: you can return to the auto-
adaptive program at any time.
F Press button S or
T again to switch
off the program you are in. Notes
It is only possible to change from
one gear to another if the vehicle
speed and engine speed permit. If
they do not, the vehicle will operate
temporarily in automatic mode.
When the vehicle is stationary or
moving very slowly, the gearbox
automatically selects gear
M1.
Programs S (sport) and
T (snow) do
not operate in manual mode.