Peugeot 206 SW Dag 2007.5 Manual PDF

65Visibility-
WINDSCREEN WIPER STALK
Front windscreen wiper with
intermittent wipe
2 Fast wipe (heavy rain).
1 Normal wipe
(moderate rain).
l Intermittent wipe.
0 Off.
 Single wipe (press
downwards).
In the Intermittent position, the wiping
speed is in proportion to the vehicle
speed.
Front windscreen wiper with
automatic wipe
2 Fast wipe (heavy rain).
1 Normal wipe (moderate
rain).
AUTO Automatic wipe.
0 Off.
 Single wipe (press
downwards).
In the AUTO position, the wiping
speed is in proportion to the intensity
of the rainfall. The command must be reactivated
whenever the ignition has been
switched off for more than one
minute:
- move the stalk to any position,
- then move it back to the required
position.
Windscreen and headlamp wash
Pull the windscreen wiper stalk
towards you. The windscreen wash
then the windscreen wipers operate
for a fixed period.The headlamp wash is also activated,
if the headlamps are on.

Visibility66 -
Automatic windscreen wipers
In the AUTO position, the windscreen
wipers operate automatically and
adapt their speed to the intensity
of the rainfall . Do not cover the rain sen-
sor located on the wind-
screen behind the interior
mirror.
When using an automatic car
wash, switch off the ignition or
check that the wiper stalk is not in
the AUTO position.
In winter, it is advisable to wait
for the windscreen to completely
clear of ice before operating the
automatic wipe.Rear screen wiper
Rear screen wash Turn ring
A to the first notch
for intermittent wiping.
If the ignition is switched
off, it is necessary to reac-
tivate the control each time. To do
this, move the stalk to any position,
then move it back to the required
position.
Turn ring A past the first
notch; the screen wash then
the wiper operate for a fixed
period.
Operating check
Activation
Activation of the function is accom-
panied by a message on the multi-
function display.
In the event of malfunction
, the
driver is informed by an audible
signal.
In the AUTO position, the wind-
screen wiper will operate in intermit-
tent mode.
Contact a PEUGEOT dealer to have
the system checked. Automatic rear screen wiper
When the windscreen wipers control
is activated and you engage reverse
gear, the rear screen wiper operates
intermittently.
Note:
if you use a bicycle carrier,
consult a PEUGEOT dealer to have
this function deactivated or install a
specific bicycle carrier approved by
PEUGEOT.

67Visibility-
TRIP COMPUTER
Pressing the button on the end of the
wash/wipe stalk enables the follow-
ing data to be displayed:
Display B
- the range
- the distance travelled
- the average consumption
- the current consumption
- the average speed
Zero reset
Press the stalk for more than two
seconds.
Range
This shows the distance that can still
be covered with the fuel remaining in
the tank.
Note: this figure may increase if there
is a change in the style of driving or
the road surface, producing a signifi-
cant drop in current consumption.
When the range is less than 20
miles
(30 km), three segments are dis-
played. After filling with fuel, the
range is displayed when it exceeds
60 miles (100 km).
If horizontal segments are displayed
for long periods instead of digits,
contact a PEUGEOT dealer. Distance travelled
This indicates the distance travelled
since the computer was last set to
zero.
Average consumption
This is the average fuel consumption
since the computer was last set to
zero. Current consumption
This is the average quantity of
fuel consumed during the last few
seconds.
This function is displayed only when
the vehicle is travelling at a speed
greater than 20 mph (30 km/h).
Average speed
This is the average speed calculated
since the computer was last set to
zero (with the ignition on).

Visibility68 -
ELECTRIC WINDOWS
1. Driver’s electric window switch
- Manual operation:
Press or pull switch 1 gently. The
window stops as soon as the switch
is released.
- Automatic operation:
Press or pull switch 1 firmly. One
touch completely opens or closes
the window.
Automatic closing only operates
when the engine is running and only
on the driver’s electric window. 2. Passenger’s electric window
switch.
3. Rear left electric window switch.
4. Rear right electric window switch.
REAR QUARTER LIGHTS
(3 DOOR)
To partially open the rear windows,
tilt lever then push the window. Always remove the key
from the ignition when
leaving the vehicle, even
for a short time.
If an obstacle is detected when
operating the electric windows,
you must reverse the movement
of the window. To do this, press
the control concerned.
When the driver operates the pas-
senger electric window controls,
he must ensure that no one is
preventing correct closing of the
windows.
The driver must ensure that pas-
sengers use the electric windows
correctly.
Be aware of children when operat-
ing the windows.
This switch enables the rear windows
to be locked whatever their position.
A 1st press activates the control (the
indicator light on the button comes
on) and a 2nd press deactivates it
(the indicator light on the button goes
out).
Temporary disarming of the
rear windows (child safety)

69Visibility-
Manual interior mirror
The interior mirror has two positions:
- day (normal),
- night (anti-dazzle).
To change from one to the other,
push or pull the lever on the lower
edge of the mirror.Manual exterior mirrors
Move the lever in all four directions
to adjust.
When the vehicle is parked, the
exterior mirrors can be folded back
manually.
Electric exterior mirrors
Turn knob
1 to the right or to the left
to select the corresponding mirror.
Move knob 1 in all four directions to
adjust.
Objects observed in the
driver’s and passenger’s
mirrors are in reality closer
than they appear. This must be taken into account
to judge correctly the distance of
vehicles approaching from behind.
Fold-back electric mirrors
With the ignition on, turn knob
1 to
position A.

Layout70 -
HEADLAMP ADJUSTMENT
Depending on the load in your ve-
hicle, it is recommended that the
headlamp beam is adjusted.
0. 1 or 2 people in the front seats.
-. 3 people.
1. 5 people.
2. 5 people + maximum authorised
load.
3. Driver + maximum authorised
load.
Initial setting is position 0.
STEERING WHEEL HEIGHT
ADJUSTMENT
When stationary, lower the handle to
unlock the steering wheel.
Adjust to the desired height and
lift the handle to lock the steering
wheel.
HORN
Press one of the spokes of
the steering wheel.

71Layout-
COURTESY LIGHTS
Front courtesy light (button A)Map-reading light (button B)
With the key in the accessories or ig-
nition on position, turn button B to the
left or to the right.
AREAS FOR TOLL CARDS/
CAR PARK TICKETS
The athermic windscreen has two
non-reflective zones located either
side of the base of the interior mirror.
They are intended for affixing toll
cards and/or car park tickets.
SUN VISOR
The sun visors are fitted with a vanity
mirror, with a concealing flap on the
driver’s side.
In this position, it comes on
for about 30 seconds:
- on unlocking the vehicle,
- when opening a door,
- when opening the tailgate and the rear screen (206 SW),
- on switching off the ignition.
It switches off on locking the vehicle.
The courtesy light flashes while
driving if a door or the boot is not
closed correctly. Permanently off
Permanently on when the key
is in the accessories position
or with the ignition on.

Layout72 -
GLOVE BOX
To open the glove box, lift the handle.
The light comes on when the cover
is opened.
1. Handbook pack storage.
2. Can holder.
3. Pen holder.
4. Spectacles storage.
5. Map storage.
6. Coin storage.
FRONT ASHTRAY
To empty, close the cover.
Pull the lug and release the ashtray
upwards.
LIGHTER
Press and wait a few moments until it
springs out automatically.
It is supplied with power with the igni-
tion key in the accessories position
(1st notch).

73Layout-
Luggage retaining net
Use the stowing rings on the boot
floor and on the back of the rear seat
to hook on your luggage retaining
net.
There are several options for storing
the shelf:
- either behind the front seats,
- or behind the rear seat using the luggage retaining net,
- or flat in the boot.
Rear parcel shelf
To remove the shelf:
- unhook the two strings
1,
- slightly raise the shelf, then remove it.
BOOT LAYOUT
Retaining strap
A strap secured to the side of the
boot enables you to secure various
objects (cans, first aid kit, etc.).

Driving74 -
"PORSCHE TIPTRONIC
system" AUTOMATIC
GEARBOX
The four speed automatic gearbox
offers a choice between the comfort
of integral automatic operation , en-
hanced by a sport and a snow pro-
gramme, or manual gear changing .
Gear selection gate
 Move the lever in the gate to se-
lect a position.
The indicator light corresponding to the position selected appears
on the instrument panel screen.
Park: to immobilise the vehicle and
to start the engine , with the hand-
brake on or off.
Reverse: to reverse (select this posi-
tion with the vehicle stationary, engine
at idle).
Neutral: to start the engine and to
park , with the handbrake on.
If position N is inadvertently engaged
while driving, allow the engine to re-
turn to idle before engaging position
D to accelerate.
Drive: for driving in automatic
mode.
Manual: for selection of gears.
S: sport programme.
: snow programme.
Moving Off
With the engine running, to move off
from position P:
 it is essential to press the brake
pedal to exit position P,
 select position R, D or M, then
gradually release the pressure
on the brake pedal; the vehicle
moves off immediately.
You can also move off from position
N :
 release the handbrake, with your
foot on the brake,
 select position R, D or M, then
gradually release the pressure
on the brake pedal; the vehicle
moves off immediately.
Starting the engine
 with the handbrake on, select po-
sition P or N in the gate,
 turn the ignition key to the Start
position. WARNING
When the engine is at idle, brakes
not applied, if position
R, D or M is
selected, the vehicle moves even wi-
thout the accelerator being pressed.
For this reason, do not leave chil-
dren unsupervised inside the ve-
hicle, with the engine running.
When maintenance operations need
to be carried out with the engine run-
ning, apply the handbrake and select
position P.