PEUGEOT 207 2005 Service Manual

2
i
COMFORT
48
5. Air conditioning On/Off (manual air conditioning)
The air conditioning is de-
signed to operate effectively in
all seasons, with the windows
closed. The control button is located on
the heating or air conditioning
system control panel.REAR SCREEN DE-ICING

Switch off the de-icing of the
rear screen and exterior mirrors
as soon as you consider this
necessary as lower current con-
sumption results in reduced fuel
consumption.
If the engine is switched off before
the de-icing is switched off automa-
tically, de-icing will resume next time
the engine is switched on.
Switching on
The rear screen de-icing can only oper-
ate when the engine is running.
 Press this button to de-ice the rear
screen and the exterior mirrors. The
indicator light associated with the
button comes on.
Switching off
The de-icing switches off automatically
to prevent an excessive consumption of
current.
 It is possible to stop the de-icing op-
eration before it is switched off auto-
matically by pressing the button
again. The indicator light associated
with the button switches off.
It enables you to:
- lower the temperature, in summer,
- increase the effectiveness of the de-
misting, in winter above 0 °C.
Switching on
 Press the "A/C" button, the associ-
ated indicator light comes on.
The air conditioning does not oper-
ate when the air flow adjustment dial
2 is in position "0".
Switching off
 Press the "A/C" button again, the as-
sociated indicator light switches off.

2
i
COMFORT
48
5. Air conditioning On/Off (manual air conditioning)
The air conditioning is de-
signed to operate effectively in
all seasons, with the windows
closed. The control button is located on
the heating or air conditioning
system control panel.REAR SCREEN DE-ICING

Switch off the de-icing of the
rear screen and exterior mirrors
as soon as you consider this
necessary as lower current con-
sumption results in reduced fuel
consumption.
If the engine is switched off before
the de-icing is switched off automa-
tically, de-icing will resume next time
the engine is switched on.
Switching on
The rear screen de-icing can only oper-
ate when the engine is running.
 Press this button to de-ice the rear
screen and the exterior mirrors. The
indicator light associated with the
button comes on.
Switching off
The de-icing switches off automatically
to prevent an excessive consumption of
current.
 It is possible to stop the de-icing op-
eration before it is switched off auto-
matically by pressing the button
again. The indicator light associated
with the button switches off.
It enables you to:
- lower the temperature, in summer,
- increase the effectiveness of the de-
misting, in winter above 0 °C.
Switching on
 Press the "A/C" button, the associ-
ated indicator light comes on.
The air conditioning does not oper-
ate when the air flow adjustment dial
2 is in position "0".
Switching off
 Press the "A/C" button again, the as-
sociated indicator light switches off.

2
i
i
COMFORT
49
When the engine is cold, to prevent
too great a distribution of cold air,
the air flow will only reach its opti-
mum level gradually.On entering the vehicle, if the in-
terior temperature is much colder
or warmer than the comfort value,
there is no need to alter the value
displayed in order to obtain the re-
quired level of comfort. The system
eliminates the temperature differ-
ence automatically and as quickly
as possible.
The air conditioning can only operate
with the engine running.
The driver and his front pas-
senger can each set the tem-
perature to suit their require-
ments.A setting around 21 enables you to ob-
tain an optimum level of comfort. De-
pending on your requirements, a setting
between 18 and 24 is usual.
In addition, it is recommended that you avoid
a left/right setting difference of more than 3.
4. Automatic visibility programme The automatic comfort pro-
gramme may not be sufficient
to quickly demist or de-ice the
windscreen and side windows
(humidity, several passen-
gers, ice...).
 In this case, select the automatic vis-
ibility programme.
The system automatically controls the
air conditioning, the air flow and the air
intake and provides optimum distribu-
tion of the ventilation to the windscreen
and side windows.
 To exit this programme, press the "vis-
ibility" button again or the "AUTO"
button, the indicator light on the button
switches off and "AUTO" is displayed.
Automatic operation
1. Automatic comfort programme
 Press the "AUTO" button.
The "AUTO" symbol is dis-
played. 2. Driver’s side adjustment
3. Passenger side adjustment
DUAL ZONE AUTOMATIC AIR CONDITIONING
We recommend that you use this mode:
it provides optimised automatic control
of all of the functions, passenger com-
partment temperature, air flow, air dis-
tribution and air recirculation, in accord-
ance with the comfort value that you
have selected.
This system is designed to operate ef-
fectively in all seasons, with the win-
dows closed. The value indicated on the display cor-
responds to a level of comfort and not
to a temperature in degrees Celsius or
Fahrenheit.

 Turn dial 2 or 3 to the left to reduce
the value or to the right to increase it.

2
!
!
i
COMFORT
50
Resuming manual control
Depending on your requirements, you
can make a different selection from that
offered by the system by changing a
setting. The other functions will still be
controlled automatically.
 Press the "AUTO" button to return
to fully automatic operation.
 Press this button to switch
the air conditioning off.
Switching the system off may result in
discomfort (humidity, condensation).
 Press the button again to return to
automatic operation of the air con-
ditioning. The symbol "A/C" is dis-
played. 6. Air distribution adjustment
 Press this button several
times in succession to di-
rect the air flow in turn to-
wards:
7. Air flow adjustment  Press the "small fan" but-
ton to reduce the air flow.
8. Air intake/Air recirculation
Deactivation of the system
 Press the "small fan" button until
the fan symbol disappears.
This action deactivates all of the func-
tions of the air conditioning system.
The temperature is no longer main-
tained at a comfortable level. However,
a slight flow of air, due to the movement
of the vehicle, can still be felt.
 Press the "large fan" button again
or the "AUTO" button to reactivate
the system with the values which
were set before it was deactivated.
 Press this button to recircu-
late the interior air. The air
recirculation symbol is dis-
played.
5. Air conditioning On/Off
Avoid driving for too long with the
air conditioning deactivated.
Avoid prolonged operation in inte-
rior air recirculation mode (risk of
condensation and of deterioration
of the air quality).
- the windscreen, the side windows and
the footwells,
- the windscreen and side windows (de- misting or de-icing),
- the central and side vents,
- the central vents, the side vents and the footwells,
- the footwells.
 Press the "large fan" button
to increase the air flow.
The air flow symbol, the fan, is filled in
progressively in relation to the value re-
quired. Air recirculation prevents exterior odours
and smoke from entering the passenger
compartment.

As soon as possible, press this but-
ton again to permit the intake of ex-
terior air and prevent condensation.
For maximum cooling or heating of
the passenger compartment, you
can exceed the minimum value of
14 or the maximum value of 28.
 Turn dial 2 or 3 to the left until
"LO" is displayed or to the right
until "HI" is displayed.

2
!
i
i
COMFORT
51
As a safety precaution, do not han-
dle the cartridge while driving.
Do not disassemble the cartridges.
Do not try to refill the fragrance dif-
fuser or the cartridges. Only use
genuine PEUGEOT cartridges.
Avoid any contact with the skin and
the eyes.
Store out of reach of children and
pets.
The intensity of diffusion of the fra-
grance may depend on the ventila-
tion or air conditioning settings.
FRAGRANCE DIFFUSER
System which permits the diffusion of
fragrance in the passenger compartment
in accordance with your requirements,
by means of the adjustment dial and the
various fragrance cartridges available.
Fitting the cartridge

Remove the sealing cap from the
cartridge.
 Install the cartridge in the fascia.
 Press the cartridge and turn it one
quarter of a turn.Controls
A. Adjustment dial.
This dial permits simultaneous adjust-
ment of the ventilation and of the inten-
sity of diffusion of the fragrance. There
are three main positions:
0. Zero ventilation.
1. Maximum ventilation/Zero diffusion.
2. Maximum ventilation/Maximum
diffusion. B. Fragrance cartridge.
This cartridge can be removed very
easily.
You can change it at any time and store
it, using the cap which seals it if it has
been partly used.
You can obtain different fragrance car-
tridges from your PEUGEOT dealer.
Removing the cartridge

Turn the cartridge one quarter of a turn.
 Remove the cartridge from the fas-
cia.
 Refit its sealing cap.
Do not discard the original car-
tridge as this is used as a closer
when you are not using a fragrance
cartridge.
To prolong the lifespan of the car-
tridge, set the dial to position "0" or
"1" as soon as you no longer wish
to diffuse the fragrance in the pas-
senger compartment.

2COMFORT
52
FRONT SEATS
Seat consisting of a seat cushion, seat
back and head restraint which can all
be adjusted to adapt your position for
maximum ease of driving and comfort.
1. Forwards-backwards adjustment
 Lift the control and slide the seat for-
wards or backwards. 2. Driver’s or passenger’s seat
height adjustment
 Pull the handle upwards or push it
downwards as many times as nec-
essary to obtain the required posi-
tion. 3.
Seat back angle adjustment
 Push the handle towards the rear.

2
!
!
COMFORT
53
No person or object must prevent
the seat slide from returning to its
initial position; return to this posi-
tion is necessary for the seat to
lock in place.
4. Access to rear seats (3 door)

Pull the handle to fold the seat back
and move the seat forwards. On re-
positioning, the seat returns to its ini-
tial position. 5. Head restraint height and angle
adjustment
 To raise the head restraint, pull it up-
wards.
 To remove the head restraint, press
the lug A and pull the head restraint
upwards.
 To put the head restraint back in po-
sition, locate the stems of the head
restraint in the holes, taking care to
keep them in line with the seat back.
 To lower the head restraint, press
the lug A and the head restraint at
the same time. The head restraint has a frame with
a notch which prevents the head re-
straint from lowering; this is a safety
device which provides protection in
the event of an impact.
The adjustment is correct when
the upper edge of the head re-
straint is level with the top of the
head.
Never drive with the head restraints
removed; they must be in place and
correctly adjusted.
 To tilt the head restraint, tilt the lower
part forwards or rearwards.

2
!
COMFORT
54
REAR SEATS
Bench seat the left-hand part (2/3) or
right-hand part (1/3) of which can be
folded to adapt the load space in the
boot.Never drive with the head restraints
removed; they must be in place and
correctly adjusted.
Rear head restraints
These have a high position (comfort)
and a low position (rear visibility).
They can also be removed; to remove them:
 pull the head restraint upwards to
the stop,
 then, press the lug.
6. Armrests
These can be folded down and are re-
movable.

To remove them, press the button lo-
cated between the armrest and the
side of the seat and pull it.

2
!
COMFORT
54
REAR SEATS
Bench seat the left-hand part (2/3) or
right-hand part (1/3) of which can be
folded to adapt the load space in the
boot.Never drive with the head restraints
removed; they must be in place and
correctly adjusted.
Rear head restraints
These have a high position (comfort)
and a low position (rear visibility).
They can also be removed; to remove them:
 pull the head restraint upwards to
the stop,
 then, press the lug.
6. Armrests
These can be folded down and are re-
movable.

To remove them, press the button lo-
cated between the armrest and the
side of the seat and pull it.

2
!
COMFORT
55
Folding the seat
To fold a rear seat without any risk of
damage to it, always start with the
seat cushion, never the seat back :
 move the corresponding front seat
forward if necessary,
 raise the front of the seat cushion 1,
 tilt the seat cushion 1 against the
front seat,
 check that the seat belt is positioned
correctly on the side of the seat
back,
Repositioning the seat
When repositioning the rear seat:
 straighten the seat back 3 and secure
it,
 fold back the seat cushion 1.

pull control 2 upwards to release the
seat back 3,
 place the head restraints in the low
position or remove them if neces-
sary,
 tilt the seat back 3.
When repositioning the rear seat,
take care not to trap the seat belts.