Heated Peugeot 207 CC 2010 Owner's Manual

PRACTICAL INFORMATION
132
Dashboard fuses
The fusebox is placed in the lower dash-
board (left-hand side).
Access to the fuses

 refer to the "Access to the tools"
paragraph. Fuse table

Fuse N° Rating Functions

G37 30 A Retractable roof unit supply.

G38 20 A Hi-Fi amplifi er.

G39 20 A Driver and passenger heated seats.

G40 40 A Trailer fusebox supply.

Fuse N° Rating Functions

F1 - Not used.

F2 - Not used.

F3 5 A Airbags and pre-tensioners control unit.

F4 10 A Clutch pedal switch, diagnostic socket,
electrochromatic rear view mirror, air conditioning,
steering wheel angle sensor, particle emission fi lter
pump (Diesel).

F5 30 A Rear electric windows, retractable roof.

F6 30 A Front electric windows, folding mirrors supply.

F7 5 A Front courtesy lamp, map reading reading lamps,
sun visor lighting, glove box lighting.

PRACTICAL INFORMATION
133

Fuse N° Rating Functions

F8 20 A Audio/telephone, multifunction screen, steering
mounted controls, tyre under-infl ation detection,
trailer fusebox, alarm (accessory).

F9 30 A Front 12 V socket, front courtesy lamp, map readin
g
lamps, sun visor lighting, glove box lighting.

F10 15 A Alarm siren, alarm control unit, directional
headlamps.

F11 15 A Diagnostic socket, low current ignition switch,
automatic gearbox control unit.

F12 15 A Sunshine sensor, trailer fusebox, retractable roof.

F13 5 A Engine fusebox, ABS relay, dual-function brake
switch.

F14 15 A
Instrument panel, seat belt warning lamps panel,
headlamp adjustment, air conditioning, audio equipm
ent,
Bluetooth system, rear parking sensors control unit .

F15 30 A Locking and deadlocking.

F17 40 A Heated rear screen and door mirrors.

SH - PARC shunt.

!
i
PRACTICAL INFORMATION
138
A fl at battery prevents the engine
from starting (refer to the corre-
sponding paragraph).
If a roof operation is in progress,
it will be completed, but no further
operation is possible.
ENERGY ECONOMY MODE
System which manages the duration of
use of certain functions to conserve a
suffi cient level of charge in the battery.
After the engine has stopped, you can
still use functions such as the audio
equipment, windscreen wipers, dipped
beam headlamps, courtesy lamp, etc.
for a maximum combined duration of
thirty minutes.
Exiting economy mode
These functions are reactivated auto-
matically next time the vehicle is driven.

 In order to resume the use of these
functions immediately, start the
engine and let it run for a few minutes.
The time available to you will then be
double the duration for which the engine
is left running. However, this period will al-
ways be between fi ve and thirty minutes.
Switching to economy mode
Once the thirty minutes are over, a
message appears on the multifunction
screen indicating that the vehicle has
switched to economy mode and the ac-
tive functions are put on standby.
CHANGING A WIPER BLADE
Procedure for replacing a worn wiper
blade with a new one without the use
of tools.
Removing a front wiper blade

 Raise the corresponding wiper arm.

 Unclip the wiper blade and remove it.
Fitting a front wiper blade

 Check the size of the wiper blade
as the shorter blade is fi tted on the
right-hand side of the vehicle.

 Put the corresponding new wiper
blade in place and clip it.

 Fold down the wiper arm carefully.
LOAD REDUCTION MODE
System which manages the use of cer-
tain functions according to the level of
charge remaining in the battery.
When the vehicle is being driven, the load
reduction function temporarily deactivates
certain functions, such as the air condi-
tioning, the heated rear screen...
The deactivated functions are reactivat-
ed automatically as soon as conditions
permit.