wheel bolts Peugeot 207 CC Dag 2007.5 Owner's Manual

Page 128 of 204

i
PRACTICAL INFORMATION
118
Parking the vehicle
Immobilise the vehicle where it
does not block trafi c: if possible,
park the vehicle on level, stable
and non-slippery ground.
Apply the handbrake, switch off the
ignition and engage i rst gear * to
lock the wheels.
If necessary, place a chock under
the wheel diagonally opposite the
wheel to be changed.
Never go underneath a vehicle
raised using a jack; use an axle
stand.
Removing the wheel
List of operations


Remove the chromed bolt cover from
each of the bolts using the tool 3 .

 Fit the anti-theft socket 4 on the
wheelbrace 1 to unlock the anti-theft
bolt.

 Unlock the other bolts using the
wheelbrace 1 only.

 Place the jack 2 in contact with one
of the two front A or rear B locations
provided on the underframe, which-
ever is closest to the wheel to be
changed.

 Extend the jack 2 until its base plate
is in contact with the ground. Ensure
that the centreline of the jack base
plate is directly below the location A
or B used.

 Raise the vehicle until there is
sufi cient space between the wheel
and the ground to admit the spare
(not punctured) wheel easily.

 Remove the bolts and store them in
a clean place.

 Remove the wheel.

Page 129 of 204

i
PRACTICAL INFORMATION
119
After changing a wheel
Using the "space-saving" spare
wheel:

 do not i t the wheel trim,

 do not exceed a speed of
50 mph (80 km/h).
Have the tightening of the bolts and
the pressure of the spare wheel
checked by a PEUGEOT dealer
without delay.
Have the punctured wheel repaired
and replace it on the vehicle as
soon as possible.
Fitting the wheel
List of operations

 Put the wheel in place on the hub.

 Screw in the bolts by hand to the
stop.

 Pre-tighten the anti-theft bolt using
the wheelbrace 1 i tted with the anti-
theft socket 4 .

 Pre-tighten the other bolts using the
wheelbrace 1 only.

 Lower the vehicle fully.

 Fold the jack 2 and detach it.

 Lock the anti-theft bolt using the
wheelbrace 1 i tted with the anti-
theft socket 4 .

 Lock the other bolts using the wheel-
brace 1 only.

 Rei t the chromed bolt covers on
each of the bolts.

 Store the tools in the box at the
bottom of the boot.

 Store the punctured wheel in a
corner of the boot.