PEUGEOT 207 DAG 2006 Owners Manual

9PRACTICAL INFORMATION
10
CHANGING A WHEEL
Procedure for changing a faulty wheel
for the spare wheel using the tools
provided with the vehicle.
The tools are installed in the boot under
the floor.
To gain access to them:
 open the boot,
 raise the floor,
 secure it by hooking its cord on the
hook on the rear shelf support,
 unclip and remove the box containing
the tools.
 take out the polystyrene storage
support. 1.
Wheelbrace.
Permits removal of the wheel fixing bolts.
2. Jack with integral handle.
Permits raising of the vehicle.
3. "Bolt cover" tool.
Permits removal of the bolt protectors (covers) on alloy
wheels.
4. Socket for the anti-theft bolts.
Permits adaptation of the wheelbrace to the special "anti-
theft" bolts.
List of tools Other accessories
5. Removable towing eye.
Refer to the paragraph "Towing the vehicle".
Access to the tools

9
i
i
PRACTICAL INFORMATION
11
Fixing the "space-saving" type
spare wheel
Your vehicle is fitted with alloy
wheels, it is normal to notice, when
tightening the bolts on fitting, that
the washers do not come into
contact with the "space-saving"
type spare wheel. The wheel is
secured by the conical contact of
each bolt.
Access to the spare wheel
The "space-saving" type spare wheel is
installed in the boot under the floor.
To gain access to it, refer to the
paragraph "Access to the tools" on the
previous page.Taking out the wheel

Unscrew the yellow central bolt.
 Raise the spare wheel towards you
from the rear.
 Take the wheel out of the boot.
Putting the wheel back in place
 Put the spare wheel back in its
housing.
 Unscrew the yellow central bolt by a
few turns then put it in place in the
centre of the wheel.
 Tighten fully until the central bolt
clicks to retain the wheel correctly.
 Put the polystyrene storage support
back in place.
 Put the box back in place in the
centre of the wheel and clip it.
 Put the boot floor back in place.
Tyre under-inflation detection
The spare wheel is not fitted with
a sensor. The punctured wheel
must be repaired by a PEUGEOT
dealer.

9
i
PRACTICAL INFORMATION
12
Parking the vehicle
Immobilise the vehicle where it
does not block traffic: if possible,
park the vehicle on level, stable
and non-slippery ground.
Apply the handbrake, switch off the
ignition and engage first gear to
lock the wheels.
If necessary, place a chock under
the wheel diagonally opposite the
wheel to be changed.
Never go underneath a vehicle
raised using a jack.
Removing the wheelList of operations
 Remove the chromed bolt cover from
each of the bolts using the tool 3.
 Fit the anti-theft socket 4 on the
wheelbrace 1 to unlock the anti-theft
bolt.
 Unlock the other bolts using the
wheelbrace 1 only.
 Place the jack 2 in contact with one
of the two front A or rear B locations
provided on the underframe,
whichever is closest to the wheel to
be changed.
 Extend the jack 2 until its base plate
is in contact with the ground. Ensure
that the centreline of the jack base
plate is directly below the location A
or B used.
 Raise the vehicle until there is
sufficient space between the wheel
and the ground to admit the spare
(not punctured) wheel easily.
 Remove the bolts and store them in
a clean place.
 Remove the wheel.

9
i
!
PRACTICAL INFORMATION
13
After changing a wheel
When using the "space-saving"
type spare wheel, do not exceed
50 mph (80 km/h).
Have the tightening of the bolts and
the pressure of the spare wheel
checked by a PEUGEOT dealer
without delay.
Have the punctured wheel repaired
and replace it on the vehicle as
soon as possible.
Fitting the wheelList of operations
 Put the wheel in place on the hub.
 Screw in the bolts by hand to the
stop.
 Pre-tighten the anti-theft bolt using
the wheelbrace 1 fitted with the anti-
theft socket 4.
 Pre-tighten the other bolts using the
wheelbrace 1 only.
 Lower the vehicle fully.
 Fold the jack 2 and detach it.
 Lock the anti-theft bolt using the
wheelbrace 1 fitted with the anti-theft
socket 4.
 Lock the other bolts using the
wheelbrace 1 only.
 Refit the chromed bolt covers on
each of the bolts.
 Store the tools in the box.
The 205/45 R17 tyres cannot be
fitted with snow chains. For further
information, contact a PEUGEOT
dealer.

6SAFETY
8
SEAT BELTS
Front seat belts
The front seat belts are fitted with
a pretensioning and force limiting
system.
The adoption of this system improves
safety in the front seats in the event of
front impacts. Depending on the severity
of the impact, the pretensioning system
instantly tightens the seat belts against
the body of the occupants.
The pretensioning seat belts are active
when the ignition is on.
The force limiter reduces the pressure
of the seat belt on the body of the
occupant in the event of an accident.
On the passenger side, a sliding guide,
fitted on the seat belt, enables you to
keep the buckle as close as possible to
the strap return.Fastening

Pull the strap, then insert the tongue
into the clasp.
 Check that the seat belt is fastened
correctly by pulling the strap.
Unfastening
 Press the red button on the clasp.
TRAJECTORY CONTROL
SYSTEMS
Associated systems which guarantee
the directional stability of the vehicle
within the limits of the laws of physics:
- the anti-skid regulation (ASR),
- the electronic stability programme
(ESP).
Reactivation
These systems are not reactivated
automatically each time the ignition
has been switched off or from 30 mph
(50 km/h) in the case of the 1.6 litre
THP 16V 175 bhp petrol engine.
 Press the "ESP OFF" button again
to reactivate them manually.
The warning light on the instrument panel and the indicator light on the
button are switched off indicating
that the ASR and ESP systems have
been reactivated.
* According to country.

6SAFETY
8
SEAT BELTS
Front seat belts
The front seat belts are fitted with
a pretensioning and force limiting
system.
The adoption of this system improves
safety in the front seats in the event of
front impacts. Depending on the severity
of the impact, the pretensioning system
instantly tightens the seat belts against
the body of the occupants.
The pretensioning seat belts are active
when the ignition is on.
The force limiter reduces the pressure
of the seat belt on the body of the
occupant in the event of an accident.
On the passenger side, a sliding guide,
fitted on the seat belt, enables you to
keep the buckle as close as possible to
the strap return.Fastening

Pull the strap, then insert the tongue
into the clasp.
 Check that the seat belt is fastened
correctly by pulling the strap.
Unfastening
 Press the red button on the clasp.
TRAJECTORY CONTROL
SYSTEMS
Associated systems which guarantee
the directional stability of the vehicle
within the limits of the laws of physics:
- the anti-skid regulation (ASR),
- the electronic stability programme
(ESP).
Reactivation
These systems are not reactivated
automatically each time the ignition
has been switched off or from 30 mph
(50 km/h) in the case of the 1.6 litre
THP 16V 175 bhp petrol engine.
 Press the "ESP OFF" button again
to reactivate them manually.
The warning light on the instrument panel and the indicator light on the
button are switched off indicating
that the ASR and ESP systems have
been reactivated.
* According to country.

6SAFETY
9
Height adjustment
Seat belt not fastened /
unfastened warning light1.
Front left seat belt warning light.
2. Front right seat belt warning light.
3. Rear left seat belt warning light.
4. Rear right seat belt warning light.
On the central bar, the corresponding
warning light 1 or 2 comes on:
- in red, if the seat belt is not fastened or is unfastened,
- in green, if it is fastened.

To lower the attachment point,
squeeze the control A and slide it
downwards.
 To raise the attachment point, slide
the control A upwards.
When the ignition is switched
on, this warning light comes
on on the instrument panel
if the driver* and/or the front
passenger has not fastened his
seat belt.
Above approximately 12 mph (20 km/h)
and for two minutes, this warning light
flashes accompanied by an audible
signal of increasing volume. When the
two minutes have elapsed, this warning
light remains on until the driver* and/or
the front passenger fastens his seat
belt. Seat belt not fastened /
unfastened warning lights bar
Rear seat belts
The rear seats are fitted with two seat
belts, each with three anchoring points
and an inertia reel with force limiter.
Seat belt unfastened warning light
This warning light comes on on
the instrument panel if one or
more rear passengers unfasten
their seat belt.
Fastening
 Pull the strap, then insert the tongue
into the clasp.
 Check that the seat belt is fastened
correctly by pulling the strap. Seat belt unfastened warning lights
bar
When the ignition is switched on, the
corresponding warning lights
3 and 4
come on for approximately 30 seconds:
- in red, if the seat belt is not fastened,
- in green, if it is fastened.
When the engine is running, the
corresponding warning light 3 or 4
comes on in red, accompanied by an
audible signal and a message on the
multifunction display, if a rear passenger
has unfastened his seat belt.
Unfastening

Press the red button on the clasp.

10TECHNICAL DATA
14
MODELS:ENGINES AND GEARBOXES
Model codes: WC8FS-C
WA8FS-C WC5FW-C
WA5FW-C WC5FW-F
WA5FW-F WM5FY-C
PETROL ENGINES 1.4 litre 16V
95 bhp 1.6 litre 16V
120 bhp 1.6 litre THP 16V
175 bhp
Cubic capacity (cm
3) 1 397 1 598 1 598
Bore x stroke (mm) 77 x 75 77 x 85.8 77 x 85.8
Max power: EU standard (kW) 70 88 128
Max power engine speed (rpm) 6 000 6 000 6 000
Max torque: EU standard (Nm) 135 160 240
Max torque engine speed (rpm) 3 500 4 250 1 600
Fuel Unleaded Unleaded Unleaded*
Catalytic converter Yes Yes Yes
GEARBOX Manual
(5-speed) Manual
(5-speed) Automatic
(4-speed) Manual
(5-speed)
OIL CAPACITIES (in litres)
Engine (with cartridge replacement) 4.25 4.25 4.25 4.25
Gearbox - Final drive 1.9 1.9 - 1.9

10TECHNICAL DATA
15
CONSUMPTION In accordance with EC Directive 80/1268 (as amended)
Petrol engines Gearbox Model
codes Urban driving
(MPG [litres/ 100 km]) Extra-urban
driving
(MPG [litres/ 100 km]) Mixed driving
(MPG [litres/ 100 km]) Emission of
CO
2 by weight (g/km)
1.4 litre 16V 95 bhp Manual WC8FS-C
WA8FS-C - - - -
1.6 litre 16V 120 bhp Manual
WC5FW-C
WA5FW-C 33.6 (8.4) 58.8 (4.8) 46.3 (6.1) 145
Auto. WC5FW-F
WA5FW-F 28.8 (9.8) 51.4 (5.5) 40.4 (7.0) 167
1.6 litre THP 16V
175 bhp Manual WM5FY-C
28.5 (9.9) 49.6 (5.7) 39.2 (7.2) 171
Consumption values correct at time of printing.
These consumption values were established in accordance with EC Directive 80/1268 (as amended). They may vary
depending on the style of driving, traffic conditions, weathe r conditions, the load in the vehicle, the maintenance of the vehicle
and the use of the accessories.
* PEUGEOT recommends the use of RON98 unleaded petrol to guara ntee optimum performance from your engine.

10TECHNICAL DATA
16
WEIGHTS AND TOWED LOADS (in kg)
Petrol engines
1.4 litre 16V 95 bhp 1.6 litre 16V 120 bhp1.6 litre THP 16V 175 bhp
Gearbox Manual Manual Auto. Manual
Model codes: WC8FS-C
WA8FS-C WC5FW-C
WA5FW-C WC5FW-F
WA5FW-F WM5FY-C
- Kerb weight 1 253 - 1 240 1 275 1 321 - 1 312 1 325
- Payload 387 - 400 375 - 365 374 - 366 275
- Gross vehicle weight (GVW) 1 640 1 650 - 1 640 1 695 - 1 678 1 600
- Gross train weight (GTW)
on a 12% gradient 2 580 2 600 2 645 - 2 638 2 500
- Braked trailer (within GTW limit)
on a 10% or 12% gradient 940 950 - 960 950 - 960 900
on an 8% gradient - 1 000 - 1 010 1 000 - 1 010 -
- Braked trailer* (with load transfer within GTW limit) 1 150 1 150 1 150 1 080
- Unbraked trailer 600 600 600 600
- Recommended nose weight 46 46 46 44
* The weight of the braked trailer can be increased, within the GTW limit, on condition that the GVW of the towing vehicle is
reduced by the same amount; warning, towing using a lightly loaded towing vehicle may have an adverse effect on its road
holding performance.
The GTW and towed load values indicated are valid up to a maximum altitude of 1000 metres; the towed load mentioned must
be reduced by 10 % for each additional 1000 metres.
The speed of a towing vehicle must not exceed 60 mph (100 km/ h) (comply with the legislation in force in your country).
High exterior temperatures may result in a reduction in the perfo rmance of the vehicle in order to protect the engine; when
the exterior temperature is higher than 37 °C, limit the wei ght towed.