start stop button Peugeot 208 2012 Owner's Manual

Page 19 of 328

.
17
Familiarisation
Driving safely


Stop & Start


Going into engine STOP mode
95
The "ECO"warning lamp comes
on in the instrument panel and the
en
gine goes into standby:
Going into engine START mode

Deactivation
/ Reactivation

You can deactivate the system at any time bypressing the "ECO OFF"
button; the button's
warning lamp comes on.
96
96
The system is automatically reactivated every time the engine is star ted withthe key.
Before refuelling or doing anything under the bonnet, you must switch off the ignition with the key. Th
e "ECO"
warning lamp goes off
and the engine restar ts:
-with a manual gearbox, when you press
the clutch pedal,-with an electronic gearbox:●
with the gear lever in position A
or M,
whenyou release the brake pedal,

or with the gear lever in position N
andbrake pedal released, when you move thegear lever to position A
or M,●
or when you engage reverse.
-with a manual gearbox
, at speeds below
12 mph (20 km/h), when you put the gear lever into neutral, and you release theclutch pedal,
-
with an electronic gearbox
, at speeds
below 5 mph (8 km/h), when you press the
brake pedal or you put the gear lever into position N .

In certain circumstances,
START mode may beinvoked automatically; the "ECO"
warning lamp
flashes for a few seconds, then goes off. In certain circumstances,
STOP mode may not
be available; the "ECO"warning lamp flashes
for a few seconds, then goes off.

Page 40 of 328

38
Instruments and controls
System that gives you information on
the journey in progress (range, fuelconsumption…).

Tr i p c o m p u t e r
Instrument panel screen
Information displa
y
)
Press the button on the end of the wiper control stalkto display the various tabs insuccession.



- Th
e current information tab with:



the range,


the current fuel consumption,


the Stop & Start time counter.



-
Trip "1"with:



the average speed.


the average fuel consumption,


the distance travelled,

for the first trip.



- Tr i p
"2"
with:



the average speed,


the average fuel consumption,


the distance travelled,
for the second trip.

Page 52 of 328

50
Access
Lost keys
Visit a PEUGEOT dealer with the vehicle's registration document, your personal identification documents and if possible the key code label.
The PEUGEOT dealer will be able to look up the key code and the transponder code required to order a new key.
Remote control
The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the risk of stopping it fromworking and the remote control would have to be reinitialised.The remote control does not operate when the key is in the ignition switch, even when the ignition is switched off, except for reinitialisation.
Locking the vehicle
Driving with the doors locked may make access to the passenger compar tment by the emergency services more difficult in an emergency. However, the vehicle unlocks automatically in the event of a serious impact causing airbag deployment.
As a safety precaution (with children on board), remove the key from the ignition switch when you leave the vehicle, even for a shor t time.
Anti-theft protection
Do not make any modifications to the electronic engine immobiliser system; this could cause malfunctions.
When purchasing a second-hand vehicle
Have the pairing of all of the keys in your possession checked by a PEUGEOT dealer, to ensure that only your keys can be used to open andstart the vehicle.

Page 93 of 328

91
4
Driving

Sport setting

Operating fault
When immobilising the vehicle, with the engine running, you must place the gear lever in neutral N.Before carrying out any work in the engine compar tment, check that the gear lever is in neutral N
and that the parking brake is applied.


You must press the brake pedal when starting the engine.
Whatever the circumstances, you mustmanually apply the parking brake to immobilise the vehicle.

)After selection of manual or automated
mode, press the S
button to activate theSport setting, which provides a more
dynamic driving style. With the i
gnition on, the flashing
o
f this warning lamp and theflashing of AUTO
, accompanied
by an audible signal and a message in
the instrument panel screen, indicates a
malfunction of the
gearbox.
have it checked by PEUGEOT or a qualified
workshop.
S appears along side the gear engaged in the instrument panel screen.
)Press the Sbutton again to deactivate it. Sthen disappears from the instrument panelscreen.

Return to normal mode is automatic ever
y time
the ignition is switched off.

Stopping the vehicle
Before switching off the engine, you can
choose to:
- move to position N
to engage neutral,
- leave the gear engaged; in this case, it will
not be possible to move the vehicle.
In both cases,
you must apply the parkingbrake to immobilise the vehicle.