tailgate Peugeot 208 2012 Owner's Manual

55
2
Access
















Boot
)After unlocking the boot or the vehicle
using the remote control or the key, press
the opening control, then raise the tailgate.
Tailgate release
System for mechanical unlocking of the boot in
the event of a central locking malfunction.

Opening Closing
)
Lower the tailgate using the interior grab
handle. ) If necessary, press down on the tailgate
to fully close it.
I
f the tailgate is not closed correctly:
- when the en
gine is running ,
this warning lamp comes on, accompanied by the display of analert message for a few seconds,
- when the vehicle is moving
(speed above6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal and
the display of an aler t message for a fewseconds.


Unlocking
)
Fold back the rear seats to gain access to
the lock from inside the boot. ) Insert a small screwdriver into hole Aof thelock to unlock the tailgate.

162
Practical information
Changing the third brake lamp
bulbs
)Unscrew the fixing pins on each side of the lamp, without removing them completely.)Push on the screws to unclip the lamp.
)Disconnect the lamp connector.)Remove the lamp from the outside. )Turn the bulb holder which corresponds
to the faulty bulb one quar ter of a turn and remove it.)Pull the bulb and change it.
To r e f i t , c a r ry out these operations in reverse order.
Number plate lamps
To facilitate the removal of the lamp, carry out
this operation with the tailgate half open.
) Insert a thin screwdriver into the lenscutout. )
Push it outwards. )
Remove the lens. )
Change the faulty bulb.
To refit, press on the lens to clip it in place.
Access is by passing a hand under the bumper. )Turn the bulb holder a quarter of a turn and
pull it out. )Disconnect the connector on the bulb holder. )Pull the bulb out and change it.
To r e f i t , c a r ry out these operations in reverse order.
You can also contact a PEUGEOT dealer or a qualified workshop for the replacement of thesebulbs.

Changing a foglamp bulb