boot PEUGEOT 3008 2009.5. Service Manual

PRACTICAL INFORMATION
187
TOWING THE VEHICLE
Access to the tools Towing your vehicle

 On the front bumper, unclip the
cover by pressing at the bottom.

 Screw the towing eye in fully.

 Install the towbar.

 Switch on the hazard warning lights
on the towed vehicle.
 On the rear bumper, unclip the
cover by pressing at the bottom.

 Screw the towing eye in fully.

 Install the towbar.

 Switch on the hazard warning lights
on the towed vehicle.
Towing another vehicle
The towing eye is installed in the boot
under the fl oor.
To gain access to it:

 open the boot,

 raise the fl oor,

 secure it by hooking the cords on
the hooks on the shelf support,

 remove the polystyrene box,

 remove the towing eye from the
holder. When towing with all four
wheels on the ground, always
use a towbar.
When towing with only two wheels on
the ground, always use professional
lifting equipment.
When towing with the engine off,
there is no longer any braking or
steering assistance.

 Place the gear lever in
neutral (position N on the
piloted manual gearbox or
automatic gearbox).
Failure to observe this special
condition could result in dam-
age to certain braking com-
ponents and the absence of
braking assistance the next
time the engine is started.
Procedure for having your vehicle towed
or for towing another vehicle using a
removable towing eye.

FITTINGS
Covers conceal each screen.
REAR MULTIMEDIA
Multimedia system permitting the con-
nection of any external portable sys-
tem: Ipod Video, games consoles, DVD
player, … Two separate
audio sources
can be connected via the RCA
connectors (red and white).
The audio is heard through
two wireless headphones with
Bluetooth technology which
operate with rechargeable
batteries.
The A/B button allows you to pair the
headphones with the screen: A left-hand
side, B right-hand side.
The video is displayed on
two 7’’ screens, integrated in
the head restraints.
Two separate
video sources
can be connected via the RCA
connectors (yellow). You have a 12 V charger with two out-
puts permitting simultaneous charging
of both headphones.
It is also possible to connect a 3
rd set of
Bluetooth headphones.
Set-up


With the engine running, connect
your portable system to the RCA con-
nectors (e.g. with AV1 on the left).

 Press the system's ON/OFF button,
the indicator lamp comes on and the
AV1 indicator lamps come on.

 Press and hold the ON/OFF button
on the headphones, the indicator
lamp on the headphones fl ashes in
blue.

 Press and hold the system's ON/OFF
button, the pairing with the head-
phones is complete when the blue
indicator lamps on the headphones
and on the system (in the shape of
headphones) are lit continuously.

 Press the ON/OFF buttons on the
screens if you have a video source.

 Start playing your portable system. If your seat is in the table position, re-
move the head restraint to avoid dam-
aging the screen:
- Unclip the protective boot.
- Disconnect the connector.
- Raise the head restraint.