Peugeot 307 2004.5 Owner's Manual

154
30-08-2004
155
30-08-2004
CHANGING A FUSE
The fuse boxes are located under
the fascia (left hand side) and in the
engine compartment.
The spare fuses and special pliers A
are ixed to the inside of the lid of the
fascia panel fuse box.
Correct Incorrect Pliers A
Fascia fuses
F Unscrew the bolt a quarter of a
turn with a coin, then pull the han-
dle to open the cover and access
the fuses.
PRACTICAL INFORMATION
Fuse no. Rating Functions
1 10 A Rear fog lamp.
2 15 A Rear screen wiper.
4 15 A Front electric window - Sunroof.
5 15 A Left brake light including trailer.
7 20 A Rear courtesy light, front courtesy light, map
reading lights - 12 V front socket - Glove box
lighting.
Removing and changing a
fuse
Before changing a fuse you must ind
out the cause of the fault and have
it corrected. The fuse numbers are
indicated on the fuse box.
F
Use the special pliers A.
Always change a faulty fuse for
one of the same rating.

156
30-08-2004
157
30-08-2004
PRACTICAL INFORMATION
Engine compartment fuses
Fuse box
To access the fuse box in the engine
compartment (beside the battery):
F unclip the cover.
Carefully close the cover and re-
it the style cover when you have
inished. The electrical system of
your vehicle is designed
to operate with standard
or optional equipment.
Before installing other electri-
cal equipment or accessories on
your vehicle, contact a PEUGEOT
dealer.
PEUGEOT will not accept re-
sponsibility for the cost incurred in
repairing your vehicle or for rectify-
ing the malfunctions resulting from
the installation of accessories not
supplied and not recommended
by PEUGEOT and not installed in
accordance with its instructions,
in particular where the equipment
in question consumes more than
10 milliamperes.
* The maxi-fuses provide addi- tional protection for the electrical
systems. All work on the maxi-
fuses must be carried out by a
PEUGEOT dealer.
Fuse N° Rating Functions
1* 50 A
460 W fan unit.
30 A 200 W fan unit.
2* 30 A ESP/ABS pump motor.
3* 30 A ESP/ABS solenoid valves.
4* 70 A Built-in Systems Interface supply.
5* 70 A Built-in Systems Interface supply.
6* 20 A Not used.
7* 30 A Ignition switch, power.
8* 70 A Power steering electro-pump unit.

156
30-08-2004
157
30-08-2004
PRACTICAL INFORMATION
Fuse N° RatingFunctions
1 10 A Automatic gearbox reversing lights switch - Automatic gearbox starting inhibitor
relay control - Manual gearbox reversing lights switch - Vehicle spee d sensor -
Water in diesel sensor.
2 15 A Canister solenoid valve - Fuel pump.
3 10 A Power steering control unit - ABS or ESP control unit.
4 10 A Injection control unit - Fan unit relay control - Additional heating relay control -
Automatic gearbox control unit - Automatic gearbox sequential cont rol -
Automatic gearbox shiftlock relay.
5 15 A Particulate emission ilter control unit.
6 15 A Front fog lamps.
7 20 A Not used.
8 20 A Fan unit relay control - Engine management control unit supply -
Injection pump (Diesel).
9 15 A Left dipped beam.
10 15 A Right dipped beam.
11 10 A Right main beam.
12 10 A Left main beam.
13 15 A Horn.
14 10 A Front and rear windscreen wash pumps.
15 30 A Oxygen sensors - Exhaust gas recirculation solenoid valve -
Ignition coil - Diesel high pressure regulator - Injectors supply (petrol) -
Pre-heat control unit - Air low sensor (Diesel) - Engine management con trol unit (Diesel) -
Injection pump (Diesel) - Diesel heater.
16 30 A Petrol engine air pump with automatic gearbox.
17 30 A Front wiper low/high speed.
18 40 A Air conditioning blower.

154
30-08-2004
155
30-08-2004
CHANGING A FUSE
The fuse boxes are located under
the fascia (left hand side) and in the
engine compartment.
The spare fuses and special pliers A
are ixed to the inside of the lid of the
fascia panel fuse box.
Correct Incorrect Pliers A
Fascia fuses
F Unscrew the bolt a quarter of a
turn with a coin, then pull the han-
dle to open the cover and access
the fuses.
PRACTICAL INFORMATION
Fuse no. Rating Functions
1 10 A Rear fog lamp.
2 15 A Rear screen wiper.
4 15 A Front electric window - Sunroof.
5 15 A Left brake light including trailer.
7 20 A Rear courtesy light, front courtesy light, map
reading lights - 12 V front socket - Glove box
lighting.
Removing and changing a
fuse
Before changing a fuse you must ind
out the cause of the fault and have
it corrected. The fuse numbers are
indicated on the fuse box.
F
Use the special pliers A.
Always change a faulty fuse for
one of the same rating.

154
30-08-2004
155
30-08-2004
PRACTICAL INFORMATION
* Fuse located on the ceiling of the fuse box.
Fuse no. RatingFunctions
9 30 A Front electric windows - Front automatic windows - Sunroof.
10 15 A Diagnostic socket - 12 volt rear socket - Trailer.
11 20 A Audio equipment - Multi-function display - Steering wheel contro ls - Automatic gearbox.
12 10 A Front right and rear right side lights - Number plate and trai
ler lighting -
Central locking/alarm/hazard warning lights/ESP switches lighting -
Air conditioning/ashtray lighting - Automatic gearbox switches lig hting -
Lighter.
14 30 A Door opening/closing controls - Deadlocking controls.
15 30 A Press-operation electric rear windows.
16 10 A Engine fuse box - Alarm - Particulate emission ilter - Steering wheel controls - Air bags.
17 10 A Rear right brake light, 3rd brake light.
18 10 A Diagnostic socket - Steering wheel controls - Electrochromatic interior
mirror -
Brake pedal (stop) and clutch switches - Coolant level switch -
Second brake switch.
19 30 A PARC shunt.
22 10 A Front left and rear left side lights - Number plate and trai ler lighting.
23 15 A Alarm siren - Interior alarm control unit.
24 15 A Instrument panel - Audio equipment - Multi-function display - Air
conditioning -
Rear parking assistance - Rain/brightness sensor.
26 30 A Heated rear screen.
27* 10 A Air bags.

158
30-08-2004
159
30-08-2004
PRACTICAL INFORMATION
CHANGING A WINDSCREEN
WIPER BLADE
Special front windscreen wiper
position
F Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
ECONOMY MODE FUNCTION
After the engine has stopped, with
the key in the accessories position,
certain functions (windscreen wiper,
electric windows, courtesy lights,
audio equipment etc.) can only be
used for a cumulative duration of
thirty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, the
message "Economy mode active"
appears on the multifunction display
and the active functions are put on
standby.
To resume the use of these functions
immediately, start the engine and let
it run for a few seconds.
A lat battery will prevent
the engine from starting.
LOAD REDUCTION
FUNCTION
When driving, certain functions (air
conditioning, heated rear screen,
heating system for passenger com-
partment of diesel vehicles, etc.) may
be switched off temporarily, depend-
ing on the level of battery charge.
Reactivation of these functions is
automatic, once the battery charge
is suficient.
Note: at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.
Changing a wiper blade
F Lift the wiper arm, then unclip the blade and remove it.
F Fit the new blade and push back the arm.
Note: the shortest blade is itted on
the vehicle's right-hand windscreen
wiper arm.
To return the windscreen wipers
to their normal position, switch on
the ignition and operate the wiper
stalk.

158
30-08-2004
159
30-08-2004
PRACTICAL INFORMATION
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery,
- Follow the instructions for use given by the battery charger manu-
facturer,
- Reconnect starting with the nega- tive (-) terminal,
- Check that the terminals and connectors are clean. If they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them. - Before disconnecting
the battery, you must
wait for 2 minutes after
switching off the igni-
tion.
- Never disconnect a terminal when the engine is running.
- Never charge a battery without irst disconnecting the termi-
nals.
- Close the windows and sunroof before disconnecting the battery.
If they do not operate normally
following reconnection of the
battery, they must be reintialised
(see sections "Reinitialisation of
the electric windows" and "Sun-
roof").
- After every reconnection of the battery, switch on the ignition
and wait 1 minute before start-
ing to allow the electronic sys-
tems to be initialised. If slight
dificulties are experienced
after this, please contact a
PEUGEOT dealer.
It is advisable to disconnect
the battery if the vehicle is not
to be used for a period of more
than one month.
To start the vehicle from
another battery:
- Connect the red cable to the positive (+) terminals of the two batteries,
- Connect one end of the green or black cable to the negative (-) ter-
minal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery.
Operate the starter, let the engine run.
Wait for the engine to return to idle,
then disconnect the cables.

160
30-08-2004
161
30-08-2004
PRACTICAL INFORMATION
Without lifting (4 wheels on
the ground)
You must always use a tow bar.
The removable towing eye is inside
the spare wheel.
Estate: The removable towing eye is
inside the right-hand boot trim. From the front:
F Unclip the cover, by pressing the
bottom part,
F Screw in the towing eye as far as
it will go.
Lifting (2 wheels only on the
ground)
It is preferable to raise the vehicle
with a professional lifting device.
When towing with the en-
gine switched off, there is
no braking or steering as-
sistance.
TOWING YOUR VEHICLE
From the rear:
F Unclip the top of the cover using a
coin,
F Screw in the towing eye as far as
it will go.
Special features of the
automatic gearbox
When towing with four wheels on the
ground, the following rules must be
obeyed:
- lever in position N,
- tow the vehicle at less than 30 mph (50 km/h) over a maximum dis-
tance of 30 miles (50 km).
- do not add oil to the gearbox.

160
30-08-2004
161
30-08-2004
PRACTICAL INFORMATION
Driving advice
Distribution of loads: Distribute the
load in the trailer so that the heaviest
items are as close as possible to the
axle and the nose weight approach-
es the maximum permitted without
exceeding it.
Cooling: towing a trailer on a slope
increases the temperature of the
coolant.
As the fan is electrically controlled,
its cooling capacity is not dependent
on the engine speed.
On the contrary, use a high gear to
lower the engine speed and reduce
your speed.
The maximum towing load on a long
slope depends on the gradient and
the outside temperature.
In all cases, pay attention to the cool-
ant temperature.
If the warning light comes on, stop
the vehicle and switch off the engine
as soon as possible. Tyres:
check the tyre pressures of
the towing vehicle and of the trailer,
observing the recommended pres-
sures.
Braking: towing increases the brak-
ing distance.
Lights: check the electrical signal-
ling on the trailer.
Side wind: take into acount the in-
creased sensitivity to side wind. TOWING A TRAILER,
CARAVAN, BOAT etc.
Only use original PEUGEOT tow
bars that have been tested and ap-
proved from the design stage of your
vehicle.
The tow bar must be itted by a
PEUGEOT dealer.
Your vehicle is primarily designed
for transporting people and luggage
but it may also be used for towing a
trailer.
Driving with a trailer subjects the tow-
ing vehicle to more signiicant stress
and its driver must be particularly
careful.
Air density decreases with altitude,
thus reducing engine performance.
Above 1 000 metres, the maximum
towing load must be reduced by 10 %
and so on for every 1 000 metres of
altitude.
The rear parking assistance function
will be disarmed automatically when
a towbar is itted.

162
30-08-2004
163
30-08-2004
PRACTICAL INFORMATION
REMOVING THE MAT
When removing the mat on the driv-
er's side, push the seat as far back
as possible and unscrew the ixings.
When reitting, position the mat and re-
place the ixings by pressing them in.
FITTING ROOF BARS
Saloon: When itting transverse roof
bars, use the four threads provided
for this purpose. To access these,
push the concealing laps in the di-
rection of the arrow.
Estate: When itting transverse roof
bars, observe their positioning. This
is indicated by marks on each of the
longitudinal bars.
Use accessories approved by
PEUGEOT and follow the manu-
facturer's fitting instructions. Maximum authorised weight
on the roof rack, for a loading
height not exceeding 40 cm
(with the exception of bicycle
carriers): 75 kg (saloon), 100 kg
(estate).
If the height exceeds 40 cm,
adapt the speed of the vehicle
to the profile of the road to
avoid damaging the roof bars
and the fixings on the roof.