wipers Peugeot 307 2007.5 Owner's Manual

Page 8 of 212

FAMILIARISATION

Control A: windscreen wipers

2 Fast wipe.

1 Normal wipe.

I Intermittent wipe.

0 Park.

AUTO Automatic wiping or single
wipe.
Wash-wipe: pull the control towards
you.

Ring A: front and rear lights
Lights off.
Automatic switching on of
the lights.
Side lights.
Rear fog lamp.
Front and rear fog lamps.

 73
Dipped/main beam headlamps.

Ring B: fog lamps
or
Ring B: rear wiper
Park.
Intermittent wipe.
Wash-wipe.

 76

The position is displayed on the
instrument panel by the corresponding
indicator light.
Wipers

Switching off "AUTO" mode
Push the control up and return it to
position "0" .
If the ignition has been off for more
than approximately one minute,
the automatic wiping must be
reactivated.
Lights

Switching on "AUTO" mode
Push the control down and release
it.

Page 82 of 212

VISIBILITY
74
Automatic switching on of the
lights
Side lights and dipped beam
headlamps switch on automatically if
the light is poor, or during operation of
the windscreen wipers. They switch
off as soon as the light becomes
bright enough or the windscreen
wipers stop.

Note: in foggy weather or in snow,
the brightness sensor can detect
sufi cient light. As a consequence, the
lights will not come on automatically.
Deactivation

 Turn ring A to a position other
than "AUTO" . Switching off is
accompanied by a message on
the multifunction display.

If the brightness sensor does not
function correctly, the lights come
on accompanied by the service
warning light, an audible signal and
a message on the multifunction
display.
Contact a PEUGEOT dealer.
Manual "Follow-me-home"
lighting

When the automatic switching on
of the lights function is deactivated ,
the side lights and dipped headlamps
remain on for the duration selected
for the automatic "follow-me-home"
lighting.

If the vehicle is not i tted with the
automatic switching on of the lights
function , when you leave your vehicle,
the side lights and dipped headlamps
remain on for thirty seconds.
Direction indicators (l ashers)

Left: downwards.

Right: upwards.

Note: if you forget to cancel the
direction indicator, the volume of the
audible signal will increase, if you
are driving at a speed greater than
50 mph (80 km/h).
Automatic "Follow me home"
lighting
With the ignition off, when you leave
your vehicle with the automatic
switching on of the lights function
activated , the side lights and dipped
headlamps remain on for the selected
duration. Activation:

 switch off the engine,

 "l ash" the headlamps,

 get out of the vehicle and lock it.
Deactivation:

 "l ash" the headlamps again,

 get out of the vehicle and lock it.

To deactivate or activate this
function, go to the multifunction
display coni guration menu.
The duration of the timed
period must also be set (15,
30, 60 seconds), via the multifunction
display coni guration menu, except in
the case of the monochrome screen
A for which it is pre-set.

Cancelling:

 "l ash" the headlamps,

 get out of the vehicle and lock it. Activation

 Turn ring A to the "AUTO"
position. The automatic lighting
is accompanied by a message on
the multifunction display.
Do not cover the brightness
sensor, coupled with the rain
sensor, located in the centre
of the windscreen, behind
the interior mirror. It is used for the
automatic switching on of the lights.

Page 83 of 212

VISIBILITY
74
Automatic switching on of the
lights
Side lights and dipped beam
headlamps switch on automatically if
the light is poor, or during operation of
the windscreen wipers. They switch
off as soon as the light becomes
bright enough or the windscreen
wipers stop.

Note: in foggy weather or in snow,
the brightness sensor can detect
sufi cient light. As a consequence, the
lights will not come on automatically.
Deactivation

 Turn ring A to a position other
than "AUTO" . Switching off is
accompanied by a message on
the multifunction display.

If the brightness sensor does not
function correctly, the lights come
on accompanied by the service
warning light, an audible signal and
a message on the multifunction
display.
Contact a PEUGEOT dealer.
Manual "Follow-me-home"
lighting

When the automatic switching on
of the lights function is deactivated ,
the side lights and dipped headlamps
remain on for the duration selected
for the automatic "follow-me-home"
lighting.

If the vehicle is not i tted with the
automatic switching on of the lights
function , when you leave your vehicle,
the side lights and dipped headlamps
remain on for thirty seconds.
Direction indicators (l ashers)

Left: downwards.

Right: upwards.

Note: if you forget to cancel the
direction indicator, the volume of the
audible signal will increase, if you
are driving at a speed greater than
50 mph (80 km/h).
Automatic "Follow me home"
lighting
With the ignition off, when you leave
your vehicle with the automatic
switching on of the lights function
activated , the side lights and dipped
headlamps remain on for the selected
duration. Activation:

 switch off the engine,

 "l ash" the headlamps,

 get out of the vehicle and lock it.
Deactivation:

 "l ash" the headlamps again,

 get out of the vehicle and lock it.

To deactivate or activate this
function, go to the multifunction
display coni guration menu.
The duration of the timed
period must also be set (15,
30, 60 seconds), via the multifunction
display coni guration menu, except in
the case of the monochrome screen
A for which it is pre-set.

Cancelling:

 "l ash" the headlamps,

 get out of the vehicle and lock it. Activation

 Turn ring A to the "AUTO"
position. The automatic lighting
is accompanied by a message on
the multifunction display.
Do not cover the brightness
sensor, coupled with the rain
sensor, located in the centre
of the windscreen, behind
the interior mirror. It is used for the
automatic switching on of the lights.

Page 85 of 212

VISIBILITY
76
Special position of the front
windscreen wiper
In the minute following switching off
of the ignition, any action on the stalk
positions the wipers in the centre of
the windscreen.
This action enables you to position
the wiper blades for winter parking,
cleaning or replacement (See section
"Practical information - Changing a
wiper blade").
To park the wipers after this has
been done, switch on the ignition and
operate the stalk.
Windscreen and headlamp wash
Pull the windscreen wiper stalk
towards you. The windscreen wash
then the windscreen wipers operate
for a i xed period.
The headlamp wash is also activated,

if the headlamps are on. WINDSCREEN WIPER STALK

2 Fast wipe (heavy rain).

1
Normal wipe (moderate rain).

I Intermittent wipe.

0 Off.

AUTO
 Automatic or single wipe
(press downwards).
In the I ntermittent position, the wiping
speed is in proportion to the speed of
the vehicle.
In AUTO mode, the wiping speed is
in proportion to the intensity of the
rainfall. The i rst press of the stalk
downwards activates the automatic
wipe.
Subsequent presses trigger a single
wipe. Front windscreen wiper with
intermittent wipe

2 Fast wipe (heavy rain).

1 Normal wipe (moderate rain).

I Intermittent wipe.

0 Off.

 Single wipe (press downwards).
In the I ntermittent position, the wiping
speed is in proportion to the vehicle
speed.
Front windscreen wiper with
automatic wipe

Page 86 of 212

VISIBILITY
77
Automatic windscreen wipers
In AUTO mode, the windscreen
wipers operate automatically and

adapt their speed to the intensity
of the rainfall . Do not cover the rain sensor
located on the windscreen
behind the interior mirror.
When using an automatic car
wash, switch off the ignition.
In winter, it is advisable to wait for the
windscreen to completely clear of ice
before operating the automatic wipe.
Activation
Activation of the function is accom-
panied by a message on the multi-
function display.
Rear windscreen wiper
To activate or deactivate
this function, go to the multi-
function display coni guration
menu.
If there is a signii cant
accumulation of snow or ice and
when using a bicycle carrier on the
tailgate (estate), deactivate the
automatic rear wiper by going to the
multifunction display coni guration
menu.
Rear windscreen wash
Deactivation
Deactivation of the function is
accompanied by a message on the
multifunction display.
The function is deactivated when the
windscreen wipers stalk is moved to
position I , 1 or 2 .

In the event of
malfunction of the
automatic windscreen wipers, the
windscreen wipers will operate in
intermittent mode.
Contact a PEUGEOT dealer to have
the system checked. Turn ring
A past the i rst
notch; the windscreen wash
then the windscreen wiper
operate for a i xed period.
Turn ring
A to the i rst notch
for intermittent wiping.
When reverse gear is
engaged, if the windscreen
wipers are in operation, the
rear wiper starts.

The automatic windscreen
wipers function must be
reactivated if the ignition
has been switched off for
more than one minute, by pressing
the stalk downwards.

Page 87 of 212

VISIBILITY
77
Automatic windscreen wipers
In AUTO mode, the windscreen
wipers operate automatically and

adapt their speed to the intensity
of the rainfall . Do not cover the rain sensor
located on the windscreen
behind the interior mirror.
When using an automatic car
wash, switch off the ignition.
In winter, it is advisable to wait for the
windscreen to completely clear of ice
before operating the automatic wipe.
Activation
Activation of the function is accom-
panied by a message on the multi-
function display.
Rear windscreen wiper
To activate or deactivate
this function, go to the multi-
function display coni guration
menu.
If there is a signii cant
accumulation of snow or ice and
when using a bicycle carrier on the
tailgate (estate), deactivate the
automatic rear wiper by going to the
multifunction display coni guration
menu.
Rear windscreen wash
Deactivation
Deactivation of the function is
accompanied by a message on the
multifunction display.
The function is deactivated when the
windscreen wipers stalk is moved to
position I , 1 or 2 .

In the event of
malfunction of the
automatic windscreen wipers, the
windscreen wipers will operate in
intermittent mode.
Contact a PEUGEOT dealer to have
the system checked. Turn ring
A past the i rst
notch; the windscreen wash
then the windscreen wiper
operate for a i xed period.
Turn ring
A to the i rst notch
for intermittent wiping.
When reverse gear is
engaged, if the windscreen
wipers are in operation, the
rear wiper starts.

The automatic windscreen
wipers function must be
reactivated if the ignition
has been switched off for
more than one minute, by pressing
the stalk downwards.

Page 146 of 212

10PRACTICAL INFORMATION
131
* For fuse box 1 only.
** The maxi-fuses provide additional protection for the electrical systems. All work on the maxi-fuses must be carried out by
a PEUGEOT dealer.

Fuse N° Rating
Functions

F8 25 A Starter control.

F9 10 A Additional heating unit (Diesel), coolant level switch.

F10 30 A Engine control unit actuators (ignition coil, solenoid valves,
oxygen sensors, control units,
injectors, heaters), purge canister solenoid valve (1.4 litre petro l and 1.6 litre petrol).

F11 40 A Air conditioning blower.

F12 30 A Windscreen wipers low/high speed.

F13 40 A Built-in systems interface supply (ignition positive).

F14 30 A Air pump (2 litre petrol).

F15 * 10 A Right main beam headlamp.

F16 * 10 A Left main beam headlamp.

F17 * 15 A Left dipped headlamp.

F18 * 15 A Right dipped headlamp.

F41 15 A Six speed automatic gearbox control unit.

Page 148 of 212

10PRACTICAL INFORMATION
Special front windscreen
wiper position

 Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
Changing a wiper blade

 Lift the wiper arm, then unclip the
blade and remove it.

 Fit the new blade and push back
the arm.

Note: the shortest blade is i tted on
the vehicle’s right-hand windscreen
wiper arm.

To return the windscreen wipers
to their normal position, switch on
the ignition and operate the wiper
stalk.
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery starting
with the negative (-) terminal,
- Follow the instructions for use given by the battery charger
manufacturer,
- Check that the terminals and connectors are clean; if they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them,
- Reconnect the battery starting with the negative (-) terminal. Before disconnecting the
battery, you must wait for
2 minutes after switching off
the ignition.
Never disconnect a terminal when
the engine is running.
Never charge a battery without i rst
disconnecting the terminals.
Close the windows and sunroof
before disconnecting the battery.
If they do not operate normally
following reconnection of the
battery, they must be reinitialised
(see sections "Reinitialisation of the
electric windows" and "Sunroof").
After every reconnection of the
battery, switch on the ignition and
wait 1 minute before starting to
allow the electronic systems to be
initialised. If slight difi culties are
experienced after this, please contact
a PEUGEOT dealer.
Following disconnection of the battery,
the remote control key and the GPS
satellite navigation system must
be reinitialised (see corresponding
section).
It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
To start the vehicle from another
battery:
- Connect the red cable to the positive (+) terminals of the two
batteries,
- Connect one end of the green or black cable to the negative (-)
terminal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery,
-
Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables. The batteries contain harmful
substances such as sulphuric
acid and lead. They must be
disposed of in accordance
with regulations and must never be
discarded with household waste.
Take used remote control and vehicle
batteries to an approved collection
point.
CHANGING A WINDSCREEN
WIPER BLADE