Peugeot 307 Break 2004.5 Manual PDF

66
30-08-2004
67
30-08-2004
Selecting a service
If you wish to be directed to a service,
select the category corresponding to
the service, then conirm by pressing
the dial.
The list of services corresponding to
the category selected is displayed.
Select the service then conirm
by pressing the dial to access the
"Choice of a location" function.
The last address entered is dis-
played.
There are three options for deining
the location in which you wish to
obtain this service:
- accept the last address entered using the "OK" function,
- ill in the "Town" and "Road" zones,
- automatically enter the name of your current location using the
"Curr. loc." function. Note:
if the service selected is not
available in the programmed loca-
tion, a temporary message informs
you of this.
Following validation of the location,
the service closest to it is displayed.
The distance indicated is the distance
as the crow lies from the service to
the selected location.
An indication on the edge of the
screen (x/n) shows you the maximum
number of establishments providing
the same service within a radius of
30 miles (50 km), as the crow lies,
from the selected location.
Use buttons "<" and ">" to consult
the list provided.
When the establishment of your
choice is displayed, you can: ฀•฀฀ select the "OK" function to activate
guidance towards this service,
฀•฀฀ select the "Store" function to
enter this establishment in your
directory. GPS details
The most recent destinations are
shown.
There are three possible methods
of deining the location to which you
wish to travel:
- accept the last details input by
means of the "OK" function,
- input the details of your destination,
- automatically input the details of your current location by means of
the "Curr. loc." function.
YOUR 307 IN DETAIL

68
30-08-2004
69
30-08-2004
Selecting a destination stored in
the directory Selection of one of the previous
destinations Changing the initial route
Select the
''Directory'' function to
access the ile in which the address
you are looking for is archived.
Select a description by scrolling
down the list by means of the dial,
then conirm by pressing the dial.
The directory ile is then displayed.
Select the "OK" function, then press
the dial to access the guidance acti-
vation function.
Follow the directions given by the
system. Select the
"Previous destinations"
function to access one of the last
twenty addresses stored.
Select a description by scrolling
down the list by means of the dial,
then conirm it by pressing the dial.
The complete address is then dis-
played.
Select the "OK" function, then press
the dial to access the guidance acti-
vation function.
Follow the instructions given by
the system. Activate the function
''Divert route'',
then input the distance involved in
the change required.
Select the ''OK'' function then vali-
date by pressing the dial.
The system calculates the change
which is closest to the value input
and gives you the option of whether
or not to use this change.
YOUR 307 IN DETAIL
Details of the route
You can consult the destination ad-
dress at any time by activating the
"Chosen destination" function on
the "Navigation - Guidance" menu.

68
30-08-2004
69
30-08-2004
Guidance options Calculation criteria
The menu ''Guidance options''
provides access to the following
functions:
- changing of the route calculation criteria,
- voice synthesis adjustment of guidance messages,
- description of the information rela- ting to the navigation CD-Rom,
- management of the addresses stored in the directory. The last criterion used is displayed.
Select a criterion from the list, then
validate by pressing the dial.
When the criterion of your choice
has been selected, select the
"OK"
function then conirm by pressing
the dial.
Note: the volume can also be adjusted
during a message, using the audio/
telephone button or the steering wheel
control.
YOUR 307 IN DETAIL
Adjusting the voice synthesiser
Select the type of voice "male" or
"female" , after inserting the conigu-
ration CD-Rom.
Adjust the volume of the voice
synthesis by turning the dial, then
validate by pressing the dial. Management of the directory
This function enables you to rename
an address stored in the directory.
Select the description corresponding
to the stored address to be changed.
Select the
"Rename" function, then
conirm by pressing the dial.
Select the "OK" function, then con-
irm by pressing the dial to record the
changes made.
Stopping/Resuming guidance ฀•฀฀ "Stop guidance"
During guidance, select this function
then validate. ฀•฀฀ "Resume guidance"
In the absence of guidance, select
this function then validate to activate
guidance to the last destination pro-
grammed.
Note: after re-starting the engine,
a screen appears enabling you to
resume the guidance activated be-
fore the ignition was switched off.

70
30-08-2004
71
30-08-2004
"Navigation - Guidance"
contextual menu
The contextual menu associated with
the "Navigation - Guidance" applica-
tion appears as a superimposed display,
when this is the application currently in
use in the main screen window.
This menu is limited to the following
functions:
- changing of the initial route (entering of a diversion)*,
- switching to "Selection-Movement on map" mode**,
- storing of the current location (postal address if available or, if it is not, the
GPS co-ordinates),
- changing of the route calculation criteria,
- stopping or resuming of guidance (dis- playing of the message which changes
depending on the previous status),
- displaying of the map, full screen or reduced size on the right (displaying
of the message which varies de-
pending on the previous status)**. TMC (Traffic Message Channel)
RDS Traffic Information
This function enables you to re-
ceive messages regarding the trafic
conditions (accidents, trafic jams,
weather, ...).
They may appear temporarily as a
superimposed display or be read by
the voice synthesiser, if it is active.
Select the
"TMC Traffic Informa-
tion" function on the "Telematics"
menu, you can choose:
- "Consult the messages" to display the list of TMC messages available,
- "Filter the TMC information" to se- lect one or more types of message
and initialise the TMC station,
- "Voice synthesiser" to listen to the TMC messages received,
- "Activate/Deactivate trafic informa- tion" to display or not display the
TMC messages received.
YOUR 307 IN DETAIL
You can read the messages trans-
mitted by the TMC station, while
listening to another station**.
In map mode **, special TMC symbols
are displayed depending on the type
of information.
* CT monochrome screen only.
** DT colour screen only. Initialising the TMC station
To initialise this function, you must se-
lect an FM station which can transmit
these messages.
Select the
"Choice of the TMC
station" function from the "Traffic
Information TMC" menu, one of
the following will then appear on the
screen:
- the name of the station that you are currently listening to,
- "No TMC station available" if no station has been selected or if the
station selected does not transmit
TMC messages,
- "Searching" if you have activated the search for the next station.

70
30-08-2004
71
30-08-2004
YOUR 307 IN DETAIL
Filtering the TMC messages
To ilter these messages, select the
"Filter the TMC information" func-
tion from the "Traffic Information
TMC" menu, you then obtain:
- "Route information ilter" to obtain the messages relating to the cur-
rent guidance outline,
- "Filter by event" to display the mes- sages speciic only to accidents, or
trafic jams, ...
- "Geographic ilter" to take into ac- count the messages within a radius
of action to be deined around the
vehicle and/or a location.
You can ilter these messages using
one or more ilters simultaneously. General notes on the "Map"
application**
The
"Map" application has two dis-
play modes:
- "Vehicle following on map"
mode, representing active guid-
ance on the map on the right and
a large-scale view of the next inter-
section on the left,
- "Selection-Movement on map"
mode, representing consultation
of the map at full screen size or
reduced size on the right with a
compass on the left.
To switch from one mode to the other,
press the dial on the right briely, then
select the "Move the map" or "Exit
the map mode" function. In
"Selection-movement on map"
mode, you can see symbols, repre-
senting the various types of services
which exist, sorted by category:
- "Administration and safety" symbol on a grey background,
- "Hotels, bars and restaurants" sym- bol on a yellow background,
- "Other businesses" symbol on a purple background,
- "Culture, tourism and entertain- ment" symbol on a white back-
ground,
- "Sports centres and open air centres" symbol on a green back-
ground,
- "Transportation and automobiles" symbol on a blue background.
A "Zoom" function enables you to
enlarge the map, in accordance with
the thirteen preset levels relating to
the following scales:
- 50 m/cm, 100 m/cm, 150 m/cm, 200 m/cm, 500 m/cm,
- 1 km/cm, 2 km/cm, 5 km/cm,
- 10 km/cm, 20 km/cm, 50 km/cm,
- 100 km/cm, 200 km/cm.
This is achieved by turning the dial.
** Only with DT colour screen.

70
30-08-2004
71
30-08-2004
YOUR 307 IN DETAIL
Filtering the TMC messages
To ilter these messages, select the
"Filter the TMC information" func-
tion from the "Traffic Information
TMC" menu, you then obtain:
- "Route information ilter" to obtain the messages relating to the cur-
rent guidance outline,
- "Filter by event" to display the mes- sages speciic only to accidents, or
trafic jams, ...
- "Geographic ilter" to take into ac- count the messages within a radius
of action to be deined around the
vehicle and/or a location.
You can ilter these messages using
one or more ilters simultaneously. General notes on the "Map"
application**
The
"Map" application has two dis-
play modes:
- "Vehicle following on map"
mode, representing active guid-
ance on the map on the right and
a large-scale view of the next inter-
section on the left,
- "Selection-Movement on map"
mode, representing consultation
of the map at full screen size or
reduced size on the right with a
compass on the left.
To switch from one mode to the other,
press the dial on the right briely, then
select the "Move the map" or "Exit
the map mode" function. In
"Selection-movement on map"
mode, you can see symbols, repre-
senting the various types of services
which exist, sorted by category:
- "Administration and safety" symbol on a grey background,
- "Hotels, bars and restaurants" sym- bol on a yellow background,
- "Other businesses" symbol on a purple background,
- "Culture, tourism and entertain- ment" symbol on a white back-
ground,
- "Sports centres and open air centres" symbol on a green back-
ground,
- "Transportation and automobiles" symbol on a blue background.
A "Zoom" function enables you to
enlarge the map, in accordance with
the thirteen preset levels relating to
the following scales:
- 50 m/cm, 100 m/cm, 150 m/cm, 200 m/cm, 500 m/cm,
- 1 km/cm, 2 km/cm, 5 km/cm,
- 10 km/cm, 20 km/cm, 50 km/cm,
- 100 km/cm, 200 km/cm.
This is achieved by turning the dial.
** Only with DT colour screen.

72
30-08-2004
73
30-08-2004
"Selection-Movement on map"
mode
This mode permits:
- selection of any point on the map to obtain guidance towards it or to
obtain information about it (postal
address if available or, if it is not,
GPS co-ordinates),
- movement on the map by means of the four directional arrows, rep-
resenting the four cardinal points
(North, East, South, West),
- zooming in on the map in accor- dance with the thirteen preset
levels,
- displaying of the "Map" contextual
menu. Map
From the
general menu , the main
"Map" menu offers various options
for guidance management:
- switching to "Selection-Movement on map" mode,
- direction of the map towards the North or in the direction of the
vehicle,
- recentering of the map around the vehicle,
- opening of the services selection window visible on the map, such as
hotels, service stations, etc.
- displaying of the window for entering the description for recording the
current position of the vehicle in a
directory ile.
YOUR 307 IN DETAIL
"Vehicle following on map" mode
This mode permits:
- displaying of the vehicle on the map with the route proposed by the
navigation if the guidance is active,
- zooming in on the map in accor- dance with the thirteen preset levels,
- displaying of the "Navigation -
Guidance" contextual menu.

72
30-08-2004
73
30-08-2004
"Map" contextual menu
The contextual menu associated
with the "Map" application and with
the "Selection-Movement on map"
mode appears as a superimposed
display, when these are in use in the
main screen window.
This menu is limited to the following
functions:
- displaying of the information on the location selected on the map,
- selection of a location on the map as a destination,
- storing of the location selected (postal address if available or, if it is
not, GPS co-ordinates, so that they
can be recorded in a directory ile),
- switching to "Vehicle following on map" mode.
YOUR 307 IN DETAIL

74
30-08-2004
75
30-08-2004
YOUR 307 IN DETAIL

74
30-08-2004
75
30-08-2004
YOUR 307 IN DETAIL
VENTILATION
1. Windscreen de-icing or
demisting vents.
2. Front window de-icing or
demisting vents.
3. Side vents.
4. Centre vents.
5. Air outlet to front footwells.
6. Air outlet to rear footwells.
Advice on operation
F Place the air low control at a
level suficient to ensure a good
renewal of air in the passenger
compartment.
The "OFF" position cuts off all the air
circulation in the passenger compart-
ment.
Note: only use the "OFF" position
occasionally (risk of condensation).
F For perfectly even air distribution,
take care not to obstruct the ex-
terior air intake grilles, the vents
and the air ducts under the front
seats, as well as the air extractor
located in the boot. Check that the
passenger compartment ilter is in
good condition.