PEUGEOT 307 BREAK 2004 Manual Online

76
30-08-2004
77
30-08-2004
HEATING/VENTILATION
2. Air distribution adjustment
YOUR 307 IN DETAIL
1. Temperature adjustment
To be adjusted to your requirements.Windscreen and side win-
dows (de-icing/demisting).To quickly de-ice or demist the wind-
screen and side windows:
- Place air intake control button
4 in
the ''Outside Air'' position, (button 4
released, indicator light off),
- Place the temperature and air low controls to maximum,
- Close the centre vents.
Windscreen, side windows
and footwells.
Footwells.
Centre and side vents.

76
30-08-2004
77
30-08-2004
YOUR 307 IN DETAIL
4. Air intake Pressing button 4 permits re-
circulation of the interior air.
Recirculation, indicated by
illumination of the indicator
light, prevents exterior odours and
smoke from entering the passenger
compartment.
As soon as possible, switch button 4
to the outside air position to prevent
misting of the windows and deterio-
ration of the air quality. The indicator
light switches off. 5. Demisting the rear screen and
exterior mirrors
With the engine running,
pressing the button once
demists the rear screen and
the mirrors.
This switches off automatically after
approximately twelve minutes.
Pressing again activates demisting
for a further twelve minutes.
It is possible to stop demisting by
pressing the button again before the
end of the twelve minutes.
3. Air low adjustment
Turn the control from posi-
tion 1 to position 4 to obtain
an air low suficient to en-
sure your comfort.

78
30-08-2004
79
30-08-2004
YOUR 307 IN DETAIL
AIR CONDITIONING
The air conditioning does not op-
erate while the air low adjustment
control is in the "OFF" position.
Note: It is quite normal that the
condensation created by the air
conditioning results in a low of
water under the vehicle when it is
stationary.
1. Air conditioning control
The air conditioning is designed to
operate in all seasons. In summer,
it enables the temperature to be
lowered and in winter, above 0 °C,
it increases the effectiveness of the
demisting.
2. Temperature adjustment
To be adjusted to your requirements.3. Air distribution adjustment
Windscreen and side win-
dows (de-icing/demisting).
Windscreen, side windows
and footwells.
Footwells.
Press the switch, the indica-
tor light comes on. Centre and side vents.
To quickly de-ice or demist the wind-
screen and side windows:
- Place the temperature and air low
controls to maximum,
- Close the centre vents,
- Switch air intake button 5 to the "Out-
side Air" position (button 5 released,
indicator light off),
- Start the air conditioning by pressing the A/C button.

78
30-08-2004
79
30-08-2004
YOUR 307 IN DETAIL
5. Air intake Pressing button 5 permits re-
circulation of the interior air.
Recirculation, indicated by
illumination of the indicator
light, prevents exterior odours and
smoke from entering the passenger
compartment.
Used simultaneously with the air
conditioning, recirculation enables
cooling performance to be improved.
Used in a humid climate, recircu-
lation may result in misting of the
windows.
As soon as possible, switch button 5
to the outside air position, to prevent
deterioration of the air quality. The
indicator light switches off. 6. Demisting the rear screen and
the mirrors
With the engine running,
pressing the button once
demists the rear screen and
the mirrors.
This switches off automatically after
approximately twelve minutes.
Pressing again activates demisting
for a further twelve minutes.
It is possible to stop demisting by
pressing the button again before the
end of the twelve minutes.
4. Air low adjustment
Turn the control from posi-
tion 1 to position 4 to obtain
an air low suficient to en-
sure your comfort.
Important precaution
Operate the air conditioning system
for 5 to 10 minutes, once or twice a
month, to keep it in perfect working
order.
If the system does not produce
cold air, do not use it and contact a
PEUGEOT dealer.

80
30-08-2004
81
30-08-2004
AUTOMATIC AIR CONDITIONING
Automatic operation
2. Automatic comfort programPress the AUTO button. The
system automatically adjusts
the atmosphere inside the
vehicle in accordance with
the value that you have chosen. To
do this, it controls the temperature,
the low, the distribution and the
intake of air as well as the air condi-
tioning. Note:
for your comfort, when the en-
gine is switched off, the settings are
retained until the engine is switched
on again, if the temperature in the pas-
senger compartment has not altered
signiicantly; otherwise, operation
resumes in automatic mode.
3. Automatic visibility program
In some cases, the auto-
matic comfort program may
not be suficient for de-icing
or demisting of the windows
(humidity, several passengers, ice,
etc.). Select this program to clear the
windows quickly.
To exit this program and return to the
automatic comfort program, press
the AUTO button.
Manual operation
If you wish, you can make a different
choice from that offered by the system
by changing a setting. The other func-
tions will still be controlled automatical-
ly. Pressing the AUTO button returns
the system to completely automatic
operation.
1. Temperature adjustment
The value indicated on the
display corresponds to a
level of comfort and not to
a temperature in degrees
Celsius or Fahrenheit.
Press the arrows 1 (up and down) to
change this value. A setting around
21 enables a comfortable tempera-
ture to be obtained.
YOUR 307 IN DETAIL

80
30-08-2004
81
30-08-2004
4. Air conditioningPress this button to stop air
cooling. The symbol ECO is
displayed. Automatic opera-
tion of the air conditioning is
resumed when the button is pressed
again. The symbol A/C is displayed.
It is quite normal that the condensa-
tion created by the air conditioning
results in a low of water under the
vehicle when it is stationary.
To prevent condensation on the
inside of the vehicle in cold or wet
weather, you are advised to avoid
using the ECO mode.
5. Air distribution Pressing this button several
times in succession enables
the air low to be directed in
turn towards:
-
the windscreen (de-icing or demisting),- the windscreen and the footwells,
- the footwells,
- the centre and side vents and the footwells,
- the centre and side vents. 6. Air low
The low of air can be
increased or reduced
by pressing buttons +
or - respectively.
7. Air intake 8. Switching the system off
The OFF button switches
off all the functions of the
system.
Temperature-related comfort
is no longer guaranteed but a slight
low of air is maintained to prevent
condensation and to renew the air.
Pressing the OFF, AUTO , or vis-
ibility button again reactivates the
system with the values set before it
was switched off.
Note: if you wish to cut off the low
of air completely, press the air intake
button 7.
9. Demisting the rear screen and the mirrors
Press this button to demist
the rear screen and the mir-
rors. Demisting switches off
automatically. It is possible
to stop operation of the demisting
before it is switched off automatically
by pressing the button again.
Important precaution
Operate the air conditioning for 5 to
10 minutes, once or twice a month,
to keep it in good working order.
If the system does not produce cold
air, do not use it and contact your
PEUGEOT dealer.
Press this button for recir-
culation of the interior air.
Recirculation, shown on the
display, enables the passen-
ger compartment to be isolated from
exterior odours and smoke.
Avoid prolonged recirculation of inte-
rior air. To do this, press the button
again to resume automatic manage-
ment of the intake of air.
Note: To prevent condensation on
the inside of the vehicle in cold or wet
weather, you are advised to avoid us-
ing this mode.
YOUR 307 IN DETAIL

82
30-08-2004
83
30-08-2004
YOUR 307 IN DETAIL
FRONT SEATS
1 - Forwards-backwards adjustment
Lift the control and slide the seat for-
wards or backwards.
2 - Access to rear seats (3 door)
Pull the handle to fold the seat back
and move the seat forwards. On
repositioning, the seat returns to its
initial position.
Note: you can also use control 3.
Then adjust the angle.
Warning: no person or object must
prevent the seat slide from returning
to its initial position; a return to this
position is necessary for the seat to
lock in place.
3 - Seat back angle adjustment
Push the handle towards the rear.

82
30-08-2004
83
30-08-2004
YOUR 307 IN DETAIL
4 - Driver's or passenger's seat height adjustment
Pull the handle upwards or push it
downwards as many times as neces-
sary to obtain the required position.
5 - Front armrests
These can be folded down and are
removable.
To remove them, press the button
located between the armrest and the
side of the seat and pull it. 6 - Head restraint height and
angle adjustment
To raise or lower the restraint, pull it
forwards, sliding it at the same time. 7 - Storage drawers
There is a storage drawer under
each front seat.
- To open it, lift it and pull.
- To take it out, open it to its full ex-
tent, press the ends of the slides
and lift it, then remove it completely.
Do not place heavy objects in the
drawers.
Under the front passenger seat, the
layout of the loor allows for storage
of a irst aid kit and a warning triangle
(small version).
Never drive with the head
restraints removed; they
should be in place and
correctly adjusted.
REAR HEAD RESTRAINTS
These have a high position for when
they are in use and a low position for
when they are stored.
The head restraints are removable.
To remove them, pull upwards as far
as the stop then press the lug.
The adjustment is correct when
the upper edge of the head re-
straint is level with the top of the
head.
To remove the head restraint:
- place it in the top position then
lower it by a few millimetres,
- lift the lug using a coin,
- keep the lug in the lifted position and pull the head restraint.
To put it back in position, locate the
stems of the restraint in the holes,
taking care to keep them in line with
the seat back.
Active seat back (front seats)
This possesses a device to prevent
'whiplash'.
When there is an impact from the
rear, the action of the body on the
seat back forces the head restraint
forwards and upwards, preventing
the head being thrown backwards.

82
30-08-2004
83
30-08-2004
YOUR 307 IN DETAIL
4 - Driver's or passenger's seat height adjustment
Pull the handle upwards or push it
downwards as many times as neces-
sary to obtain the required position.
5 - Front armrests
These can be folded down and are
removable.
To remove them, press the button
located between the armrest and the
side of the seat and pull it. 6 - Head restraint height and
angle adjustment
To raise or lower the restraint, pull it
forwards, sliding it at the same time. 7 - Storage drawers
There is a storage drawer under
each front seat.
- To open it, lift it and pull.
- To take it out, open it to its full ex-
tent, press the ends of the slides
and lift it, then remove it completely.
Do not place heavy objects in the
drawers.
Under the front passenger seat, the
layout of the loor allows for storage
of a irst aid kit and a warning triangle
(small version).
Never drive with the head
restraints removed; they
should be in place and
correctly adjusted.
REAR HEAD RESTRAINTS
These have a high position for when
they are in use and a low position for
when they are stored.
The head restraints are removable.
To remove them, pull upwards as far
as the stop then press the lug.
The adjustment is correct when
the upper edge of the head re-
straint is level with the top of the
head.
To remove the head restraint:
- place it in the top position then
lower it by a few millimetres,
- lift the lug using a coin,
- keep the lug in the lifted position and pull the head restraint.
To put it back in position, locate the
stems of the restraint in the holes,
taking care to keep them in line with
the seat back.
Active seat back (front seats)
This possesses a device to prevent
'whiplash'.
When there is an impact from the
rear, the action of the body on the
seat back forces the head restraint
forwards and upwards, preventing
the head being thrown backwards.

84
30-08-2004
85
30-08-2004
YOUR 307 IN DETAIL
REAR SEATS (SALOON)
To fold down the rear left seat (2/3 part)
or the right seat (1/3 part), always
start with the seat, never with the
seat back (risk of damage) :
- move the front seat(s) forward if necessary,
- lift the front of the seat cushion 1,
- tilt the seat cushion 1 against the
front seat(s),
- check that the seat belt is correctly positioned on the side of the seat
back,
- pull control 2 forwards to unlock the
seat back 3,
- place the head restraints in the low position,
- fold down the seat back 3.
Note: the seat cushion 1 can be
removed to increase the volume of
the load space.
Squeeze the seat cushion ixings to
detach them from their fastenings.
Rear armrest
(saloon and estate)
- Lower the armrest to access the storage shelf on the seat back.
- Lift the lid. lt contains a storage tray as well as two cup holders and two
pen holders.
When repositioning:
- fold up the seat back and lock it (the red marker of control 2 should
no longer be visible),
- fold up the seat.
Take care not to trap the seat belts
and to position the stalks cor-
rectly.