Peugeot 307 Break 2005 Owner's Manual

Practical information128 -
01-06-2005
129Practical information-
01-06-2005
Third brake light (estate)(4 W 5 W bulbs)
F Remove the tailgate upper trim
carefully by unclipping it on either
side, perpendicular to its direction
of engagement.
F Insert a screwdriver into the two
outer holes B to press on the two
tabs C.
F Push the light unit outwards while
maintaining the pressure on the
tabs.
F Pull the light unit outwards while tilting it.
F Change the faulty bulb.
F When reitting, ensure that the light unit tabs are engaged cor-
rectly and that the tailgate upper
trim has been put back in place
correctly.
Rear lights (estate)
1. Brake lights (P 21 W).
2. Side lights (x 2) (R 5 W).
3. Direction indicators (P 21 W).
4. Reversing light (P 21 W), left-hand side.
Fog lamp (P 21 W), right-hand
side.
These 6 bulbs are changed by re-
moving the light:
F Remove the corresponding boot
side trim to access the light,
F Remove the light ixing nut inside
the boot,
F Remove the light ixing nut out-
side the boot,
F Remove the light,
F Unclip the harness, F
Remove the bulb holder pressing
on the tabs A,
F Change the faulty bulb.
Note: if necessary, use the wheel-
brace to remove the nuts.
When reitting, take care to position
the bulb holder and the light cor-
rectly.
Number plate lights (W 5 W)
F Insert a thin screwdriver into one of the external holes of the lens.
F Push it outwards to unclip it.
F Remove the lens.
F Change the faulty bulb.

Practical information128 -
01-06-2005
129Practical information-
01-06-2005
CHANGING A FUSE
The fuse boxes are located in the
glovebox (passenger side) and in
the engine compartment (left-hand
side).Correct Incorrect
Fascia panel fuses
F Unscrew the screw a quarter of a
turn with a coin, then pull the han-
dle to open the cover and access
the fuses.
Fuse no. Rating Functions F1 15 A Rear wiper.
F2 30 A Locking and deadlocking.
F3 5 A Air bags and pre-tensioners unit
.
F4 10 ABrake (STOP) and clutch pedal switches,
engine coolant level switch, steering wheel
angle sensor, ESP dual-function sensor, particle
emission ilter pump, diagnostic socket,
electrochromatic mirror.
F5 30 A Front electric windows, sunroof, heated mirrors.
Changing a fuse
Before changing a fuse, you must
establish the cause of the fault and
have it corrected. The fuse numbers
are indicated on the fuse box.
Always change a faulty fuse for one
of the same rating (same colour).
Use the special pliers located on the
inside of the fasca fuse box cover,
this support also contains the spare
fuses.

Practical information130 -
01-06-2005
131Practical information-
01-06-2005
Engine compartment fuses
To access the fuse box in the engine
compartment (next to the battery),
unclip the cover.
Close the cover carefully when you
have inished to guarantee the sea-
ling of the fuse box.Fuse box 2
Fuse No. RatingFunctions
F1 20 A Engine control unit and fan assembly high speed relay supply.
F2 15 A Horn.
F3 10 A Front and rear wash-wipe.
F4 20 A Headlamp wash.
F5 15 A Fuel pump and purge canister solenoid valve.
F6 10 A Automatic gearbox control unit, automatic gearbox lever locking con
trol, push control
switch, fan assembly high speed relay.
F7 10 A ABS/ESP control unit, power steering electro-pump unit control unit .
or
Fuse box 1

Practical information132 -
01-06-2005
133Practical information-
01-06-2005
Fuse No. RatingFunctions
F8 20 A Ignition switch.
F9 10 A Additional heating unit (Diesel), coolant level switch.
F10 30 A Engine control unit actuators (ignition coil, solenoid valves,
oxygen sensors, control units,
injectors, heaters).
F11 40 A Air conditioning blower.
F12 30 A Windscreen wipers low/high speed.
F13 40 A Built-in systems interface supply (ignition positive).
F14 30 A Air pump (2 litre petrol).
F15* 10 A Right main beam headlamp.
F16* 10 A Left main beam headlamp.
F17* 15 A Left dipped headlamp.
F18* 15 A Right dipped headlamp.
* For fuse box 1 only.

Practical information132 -
01-06-2005
133Practical information-
01-06-2005
The electrical system of
your vehicle is designed
to operate with standard or
optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a PEUGEOT dealer. Fusible N° Rating
Fonctions
MF1* 30 A
200 W fan unit.
50 A 400 W and 460 W fan unit.
MF2* 30 A ABS/ESP pump.
MF3* 30 A ABS/ESP solenoid valves.
MF4* 80 A Built-in systems interface supply.
MF5* 80 A Built-in systems interface supply.
MF6* 80 A Passenger compartment fuse box.
MF8* 70 A Power steering electro-pump unit.
PEUGEOT will not accept responsi-
bility for the cost incurred in repairing
your vehicle or for rectifying the mal-
functions resulting from the installa-
tion of accessories not supplied and
not recommended by PEUGEOT
and not installed in accordance with
its instructions, in particular where
the equipment in question consumes
more than 10 milliamperes. * The maxi-fuses provide additional
protection for the electrical systems.
All work on the maxi-fuses must be
carried out by a PEUGEOT dealer.

Practical information128 -
01-06-2005
129Practical information-
01-06-2005
CHANGING A FUSE
The fuse boxes are located in the
glovebox (passenger side) and in
the engine compartment (left-hand
side).Correct Incorrect
Fascia panel fuses
F Unscrew the screw a quarter of a
turn with a coin, then pull the han-
dle to open the cover and access
the fuses.
Fuse no. Rating Functions F1 15 A Rear wiper.
F2 30 A Locking and deadlocking.
F3 5 A Air bags and pre-tensioners unit
.
F4 10 ABrake (STOP) and clutch pedal switches,
engine coolant level switch, steering wheel
angle sensor, ESP dual-function sensor, particle
emission ilter pump, diagnostic socket,
electrochromatic mirror.
F5 30 A Front electric windows, sunroof, heated mirrors.
Changing a fuse
Before changing a fuse, you must
establish the cause of the fault and
have it corrected. The fuse numbers
are indicated on the fuse box.
Always change a faulty fuse for one
of the same rating (same colour).
Use the special pliers located on the
inside of the fasca fuse box cover,
this support also contains the spare
fuses.

Practical information130 -
01-06-2005
131Practical information-
01-06-2005
Fuse no. RatingFunctions
F6 30 A Rear electric windows.
F7 5 A Front and rear courtesy lights, map reading lights, glove box li ghting
.
F8 20 AAudio equipment, audio/telephone, multifunction display,
alarm siren, alarm unit, 12 V rear
socket, trailer fuse box, driving school module.
F9 30 A 12 V front socket.
F10 15 A Automatic gearbox control unit, tyre under-inlation control unit , STOP switch.
F11 15 A Diagnostic socket, particle emission ilter unit, low current igni tion switch.
F12 15 A Driving school module.
F13 5 A Engine fuse box, rain and brightness sensor.
F14 15 A Trailer fuse box, instrument panel, air bags unit, automatic air conditioning, hands-free kit.
F15 30 A Locking and deadlocking.
F16 - PARC shunt.
F17 40 A Heated rear screen.

Practical information134 -
01-06-2005
135Practical information-
01-06-2005
CHANGING A WINDSCREEN
WIPER BLADE
Special front windscreen wiper
position
F Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
Changing a wiper blade
F Lift the wiper arm, then unclip the
blade and remove it.
F Fit the new blade and push back
the arm.
Note: the shortest blade is itted on
the vehicle's right-hand windscreen
wiper arm.
To return the windscreen wipers
to their normal position, switch on
the ignition and operate the wiper
stalk.
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery starting with the negative (-) terminal,
- Follow the instructions for use given by the battery charger manu-
facturer,
- Check that the terminals and con- nectors are clean; if they are covered
with sulphate (white or greenish
deposit), disconnect them and clean
them,
- Reconnect the battery starting with the negative (-) terminal. Before disconnecting the
battery, you must wait for
2 minutes after switching
off the ignition.
Never disconnect a termi-
nal when the engine is running.
Never charge a battery without irst
disconnecting the terminals.
Close the windows and sunroof be-
fore disconnecting the battery. If they
do not operate normally following re-
connection of the battery, they must
be reinitialised (see sections "Reini-
tialisation of the electric windows"
and "Sunroof").
After every reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to allow the
electronic systems to be initialised. If
slight dificulties are experienced af-
ter this, please contact a PEUGEOT
dealer.
Following disconnection of the bat-
tery, the remote control key and the
GPS satellite navigation system
must be reinitialised (see corre-
sponding section).
It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
To start the vehicle from
another battery:
- Connect the red cable to the positive (+)
terminals of the two batteries,
- Connect one end of the green or black cable to the negative (-) ter-
minal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery,
- Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables. The batteries contain harm-
ful substances such as sul-
phuric acid and lead. They
must be disposed of in ac-
cordance with regulations
and must never be discarded with
household waste.
Take used remote control and vehi-
cle batteries to an approved collec-
tion point.

Practical information
134 -
01-06-2005
135
Practical information
-
01-06-2005
ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (windscreen wiper, electric
windows, sunroof, courtesy lights,
audio equipment, telephone, etc) can
only be used for a combined duration
of approximately thirty minutes, to
prevent discharging the battery.
Once the thirty minutes are over, a
switching to economy mode mes-
sage appears on the multi-function
display and the active functions are
put on standby.
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to resume the use of these
functions immediately, the engine
must be started and left to run for a
few minutes.
The time available to you will then
be double the duration for which the
engine is left running. However, this
period will always be between ive
and thirty minutes.
Note: if the telephone is being used
when economy mode starts, it will
still be possible to inish the call.
A lat battery prevents the
engine from starting.
LOAD REDUCTION
FUNCTION
When driving, certain functions (air
conditioning, heated rear screen,
heating system for passenger com-
partment of diesel vehicles, etc.) may
be switched off temporarily, depend-
ing on the level of battery charge.
Reactivation of these functions is
automatic, once the battery charge
is suficient.
Note: at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.

Practical information136 -
01-06-2005
137Practical information-
01-06-2005
Without lifting
(4 wheels on the ground)
You must always use a tow bar.
The removable towing eye is inside
the spare wheel.
Estate: the removable towing eye is
inside the right-hand boot trim. From the front:
F
Unclip the cover, by pressing the
bottom part,
F Screw in the towing eye as far as
it will go.
Lifting
(2 wheels only on the ground)
It is preferable to raise the vehicle
with a professional lifting device.
When towing with the
engine switched off, there
is no braking or steering
assistance.
TOWING YOUR VEHICLE
From the rear:
F Unclip the top of the cover using a
coin,
F Screw in the towing eye as far as
it will go.
Special features
of the automatic gearbox
When towing with four wheels on the
ground, the following rules must be
obeyed:
- lever in position N,
- tow the vehicle at less than 30 mph (50 km/h) over a maximum dis-
tance of 30 miles (50 km),
- do not add oil to the gearbox.