Peugeot 307 Break Dag 2005.5 Owner's Manual

Practical information126 -
01-10-2005
127Practical information-
01-10-2005
Integrated direction indicator side
repeaters.
F Push the repeater forwards and
release it.
F Remove the repeater and change it.
These can be obtained from a
PEUGEOT dealer.
Amber coloured bulbs,
such as the direction indi-
cators, must be replaced
with bulbs of identical spec-
iication and colour.
3. Side lights (W 5 W).
F
Remove the protective cover cor-
responding to the faulty bulb.
F Disconnect the connector.
F Remove the bulb and change it.
4. Direction indicators (PY 21 W amber).
F Turn the bulb holder a quarter of a
turn and remove it.
F Change the bulb.
Note: in certain climatic conditions
(low temperature, humidity), con-
densation inside the headlamp
glass is normal ; it disappears a few
minutes after the lights are switched
on. 5. Fog lamps (H11-55 W).
Contact a PEUGEOT dealer to have
these bulbs changed.

Practical information126 -
01-10-2005
127Practical information-
01-10-2005
Rear lights (saloon)
1. Direction indicators (P 21 W).
2. Reversing lights (P 21 W), right-hand side.
Fog lamp (P 21 W), left-hand side.
3. Brake lights (P 21 W).
4. Side lights (x 2) (R 5 W).
Third brake light (saloon)(4 W 5 W bulbs)
F Using a 10 mm box spanner, un- screw the 2 ixing nuts 1.
F Release the lamp unit by pushing
it outwards.
F Squeeze the two tabs 2 to release
the bulb holder.
F Change the faulty bulb.
F When reitting, ensure that the lamp unit seal has been put back
in place correctly.
These 6 bulbs are changed from in-
side the boot:
F Move aside the boot trim to ac-
cess the bulb holder,
F Press the two tabs and remove
the bulb holder,
F Change the faulty bulb.
When reitting, take care to pass the
trim under the seal.

Practical information128 -
01-10-2005
129Practical information-
01-10-2005
Third brake light (estate)
(4 W 5 W bulbs)
F Remove the tailgate upper trim
carefully by unclipping it on either
side, perpendicular to its direction
of engagement.
F Insert a screwdriver into the two
outer holes B to press on the two
tabs C.
F Push the light unit outwards while
maintaining the pressure on the
tabs.
F Pull the light unit outwards while tilting it.
F Change the faulty bulb.
F When reitting, ensure that the light unit tabs are engaged cor-
rectly and that the tailgate upper
trim has been put back in place
correctly.
Rear lights (estate)
1. Brake lights (P 21 W).
2. Side lights (x 2) (R 5 W).
3. Direction indicators (P 21 W).
4. Reversing light (P 21 W), right-hand side.
Fog lamp (P 21 W), left-hand side.
These 6 bulbs are changed by re-
moving the light:
F Remove the corresponding boot
side trim to access the light,
F Remove the light ixing nut inside
the boot,
F Remove the light ixing nut out-
side the boot,
F Remove the light,
F Unclip the harness, F
Remove the bulb holder, pressing
on the tabs A,
F Change the faulty bulb.
Note: if necessary, use the wheel-
brace to remove the nuts.
When reitting, take care to position
the bulb holder and the light cor-
rectly.
Number plate lights (W 5 W)
F Insert a thin screwdriver into one of the external holes of the lens.
F Push it outwards to unclip it.
F Remove the lens.
F Change the faulty bulb.

Practical information128 -
01-10-2005
129Practical information-
01-10-2005
CHANGING A FUSE
The fuse boxes are located in the
lower part of the fascia (driver's side)
and in the engine compartment (left-
hand side).Correct Incorrect
Fascia panel fuses
F Unscrew the screw a quarter of a
turn with a coin (1), then unclip the
lap, pulling at the top right (2).
Fuse no. Rating Functions F1 15 A Rear wiper.
F2 30 A Locking and deadlocking.
F3 5 A Air bags and pre-tensioners unit.
F4 10 A Brake (STOP) and clutch pedal switches,
engine coolant level switch, steering wheel
angle sensor, ESP dual-function sensor,
particle emission ilter pump, diagnostic socket,
electrochromatic mirror.
F5 30 A Front electric windows, sunroof, heated mirrors.
Changing a fuse
Before changing a fuse, you must
establish the cause of the fault and
have it corrected. The fuse numbers
are indicated on the fuse box.
Always change a faulty fuse for one
of the same rating (same colour).
Use the special pliers located on the
inside of the fascia fuse box cover,
this support also contains the spare
fuses.

Practical information130 -
01-10-2005
131Practical information-
01-10-2005
Engine compartment fuses
To access the fuse box in the engine
compartment (next to the battery),
unclip the cover.
Close the cover carefully when you
have inished to guarantee the seal-
ing of the fuse box.Fuse box 2
Fuse N° Rating Functions
F1 20 A Engine control unit and fan assembly high speed relay supply.
F2 15 A Horn.
F3 10 A Front and rear wash-wipe.
F4 20 A Headlamp wash.
F5 15 A Fuel pump and purge canister solenoid valve.
F6 10 A Automatic gearbox control unit, automatic gearbox lever locking con
trol, push control
switch, fan assembly high speed relay, right and left xenon b ulb headlamps.
F7 10 A ABS/ESP control unit, power steering electro-pump unit control unit .
or
Fuse box 1

Practical information132 -
01-10-2005
133Practical information-
01-10-2005
Fuse N° RatingFunctions
F8 20 A Starter control.
F9 10 A Additional heating unit (Diesel), coolant level switch.
F10 30 A Engine control unit actuators (ignition coil, solenoid valves,
oxygen sensors, control units,
injectors, heaters).
F11 40 A Air conditioning blower.
F12 30 A Windscreen wipers low/high speed.
F13 40 A Built-in systems interface supply (ignition positive).
F14 30 A Air pump (2 litre petrol).
F15* 10 A Right main beam headlamp.
F16* 10 A Left main beam headlamp.
F17* 15 A Left dipped headlamp.
F18* 15 A Right dipped headlamp.
* For fuse box 1 only.

Practical information132 -
01-10-2005
133Practical information-
01-10-2005
The electrical system of
your vehicle is designed
to operate with standard or
optional equipment.
Before installing other elec-
trical equipment or accessories on
your vehicle, contact a PEUGEOT
dealer. Fuse N° Rating
Functions
MF1* 30 A
200 W fan unit.
50 A 400 W and 460 W fan unit.
MF2* 30 A ABS/ESP pump.
MF3* 30 A ABS/ESP solenoid valves.
MF4* 80 A Built-in systems interface supply.
MF5* 80 A Built-in systems interface supply.
MF6* 80 A Passenger compartment fuse box.
MF8* 70 A Power steering electro-pump unit.
PEUGEOT will not accept responsi-
bility for the cost incurred in repairing
your vehicle or for rectifying the mal-
functions resulting from the installa-
tion of accessories not supplied and
not recommended by PEUGEOT
and not installed in accordance with
its instructions, in particular where
the equipment in question consumes
more than 10 milliamperes. * The maxi-fuses provide additional protection for the electrical
systems. All work on the maxi-
fuses must be carried out by a
PEUGEOT dealer.

Practical information128 -
01-10-2005
129Practical information-
01-10-2005
CHANGING A FUSE
The fuse boxes are located in the
lower part of the fascia (driver's side)
and in the engine compartment (left-
hand side).Correct Incorrect
Fascia panel fuses
F Unscrew the screw a quarter of a
turn with a coin (1), then unclip the
lap, pulling at the top right (2).
Fuse no. Rating Functions F1 15 A Rear wiper.
F2 30 A Locking and deadlocking.
F3 5 A Air bags and pre-tensioners unit.
F4 10 A Brake (STOP) and clutch pedal switches,
engine coolant level switch, steering wheel
angle sensor, ESP dual-function sensor,
particle emission ilter pump, diagnostic socket,
electrochromatic mirror.
F5 30 A Front electric windows, sunroof, heated mirrors.
Changing a fuse
Before changing a fuse, you must
establish the cause of the fault and
have it corrected. The fuse numbers
are indicated on the fuse box.
Always change a faulty fuse for one
of the same rating (same colour).
Use the special pliers located on the
inside of the fascia fuse box cover,
this support also contains the spare
fuses.

Practical information130 -
01-10-2005
131Practical information-
01-10-2005
Fuse N° RatingFunctions
F6 30 A Rear electric windows.
F7 5 A Front and rear courtesy lights, map reading lights, glove box li ghting.
F8 20 A Audio equipment, audio/telephone, multifunction display,
alarm siren, alarm unit, trailer fuse
box, driving school module, steering wheel stalks supply.
F9 30 A 12 V front socket, 12 V rear socket.
F10 15 A Automatic gearbox control unit, tyre under-inlation detection co ntrol unit, STOP switch.
F11 15 A Diagnostic socket, particle emission ilter unit, low current igni tion switch.
F12 15 A Driving school module, rear parking assistance.
F13 5 A Engine fuse box, rain and brightness sensor.
F14 15 A Trailer fuse box, instrument panel, air bags and pre-tensioners u
nit, automatic air
conditioning, hands-free kit.
F15 30 A Locking and deadlocking.
F16 - PARC shunt.
F17 40 A Heated rear screen.
F39 20 A Driver and passenger heated seats.

Practical information134 -
01-10-2005
135Practical information-
01-10-2005
CHANGING A WINDSCREEN
WIPER BLADE
Special front windscreen wiper
position
F Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
Changing a wiper blade
F Lift the wiper arm, then unclip the
blade and remove it.
F Fit the new blade and push back
the arm.
Note: the shortest blade is itted on
the vehicle's right-hand windscreen
wiper arm.
To return the windscreen wipers
to their normal position, switch on
the ignition and operate the wiper
stalk.
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery starting with the negative (-) terminal,
- Follow the instructions for use given by the battery charger manu-
facturer,
- Check that the terminals and con- nectors are clean; if they are covered
with sulphate (white or greenish
deposit), disconnect them and clean
them,
- Reconnect the battery starting with the negative (-) terminal. Before disconnecting the
battery, you must wait for
2 minutes after switching
off the ignition.
Never disconnect a termi-
nal when the engine is running.
Never charge a battery without irst
disconnecting the terminals.
Close the windows and sunroof be-
fore disconnecting the battery. If they
do not operate normally following re-
connection of the battery, they must
be reinitialised (see sections "Reini-
tialisation of the electric windows"
and "Sunroof").
After every reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to allow the
electronic systems to be initialised. If
slight dificulties are experienced af-
ter this, please contact a PEUGEOT
dealer.
Following disconnection of the bat-
tery, the remote control key and the
GPS satellite navigation system
must be reinitialised (see corre-
sponding section).
It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
To start the vehicle from
another battery:
- Connect the red cable to the positive (+) terminals of the two batteries,
- Connect one end of the green or black cable to the negative (-) ter-
minal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery,
- Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables. The batteries contain harm-
ful substances such as sul-
phuric acid and lead. They
must be disposed of in ac-
cordance with regulations
and must never be discarded with
household waste.
Take used remote control and vehi-
cle batteries to an approved collec-
tion point.