PEUGEOT 307 CC 2004 Owners Manual

90
30-08-2004
91
30-08-2004
YOUR 307 CC IN DETAIL
OPENING THE BONNET
From inside: push the handle on the
left-hand side under the fascia.
From outside: lift the catch and
raise the bonnet.
The engine must be switched off
when illing with fuel.
F Open the fuel iller lap.
F Insert the key then turn it to the left.
F Remove the cap and hang it on
the hook located on the inside of
the lap.
A label afixed to the inside of the fuel
iller lap indicates which type of fuel
to use.
When you ill your tank, do not con-
tinue after the third cut-off of the
pump. This could cause your vehicle
to malfunction.
FILLING WITH FUEL
Low fuel level
Bonnet strut
Secure the strut to hold the bonnet
open.
Before closing the bonnet, replace
the strut in its housing.
To close
Lower the bonnet and release it at
the end of its travel. Check that the
bonnet is properly locked.
When the minimum fuel
level in the tank is reached,
this warning light comes on.
You can still drive approximately
30 miles (50 km).
Flashing of the warning light indicates
a malfunction of the fuel gauge.
Contact a PEUGEOT dealer.
The capacity of the tank is
approximately 60 litres.
F After filling the tank, lock the cap
and close the fuel filler flap.

94
30-08-2004
95
30-08-2004
YOUR 307 CC IN DETAIL
THE LIGHTS STALK
Front and rear lights
Selection is by turning ring A.
Dipped/Main beam change
Pull the stalk towards you.
Note: with the ignition off, if the driv-
er's door is open, a buzzer sounds if
you have left your lights on.
Note: when the lights are switched
off automatically or when the dipped
headlamps are switched off manu-
ally, the front fog lamps, the rear fog
lamp and the side lights will remain
on (turn the ring backwards to switch
off the front fog lamps. The side lights
will then be switched off).
Lights off
Side lights
Dipped/Main beam
headlampsAutomatic switching on
of lights Front fog lamps (1st forwards
turn of the ring)
The front fog lamps operate with the
side lights and dipped headlamps.
When the main beam headlamps are
switched on, the front fog lamps are switched
off. They are switched on again when the
main beam headlamps are switched off.
Front fog lamps and rear fog
lamp
Rotate the ring B forwards to switch
on and backwards to switch off. The
status is conirmed by the light on the
instrument panel.
In good or rainy weather,
both day and night, the
front fog lamps and the
rear fog lamp are dazzling
and are prohibited.
Do not forget to switch them off
when they are no longer needed.
Front fog lamps and
rear fog lamp (2nd for-
wards turn of the ring)
Note: to switch off the rear fog lamp
and the front fog lamps, turn the ring
twice backwards.

94
30-08-2004
95
30-08-2004
YOUR 307 CC IN DETAIL
"Follow me home" lighting
In poor light or at night, if you leave
your vehicle, the side lights and
dipped headlamps can be left on for
approximately one minute.
To do this:
- place the key in the
STOP position,
- place the lights stalk in the
0 posi-
tion,
- lash the headlamps,
- get out of the vehicle and lock it.
AUTOMATIC SWITCHING ON
OF LIGHTS
The side lights and dipped beam
headlamps switch on automati-
cally if the light is poor and when the
windscreen wipers operate continu-
ously and switch off when the light
becomes bright enough or the wind-
screen wipers are switched off.
In foggy weather or in snow, the
brightness sensor can detect sufi-
cient light, the lights will not come
on automatically.
This function is active when the vehi-
cle is supplied to the customer.
To disarm or activate the function:
- Place the key in the accessories position (1st notch),
- Place the lights stalk in the
AUTO/0
position,
- Press the end of the lights stalk for more than four seconds.
Do not cover the brightness sen-
sor, coupled with the rain sensor,
located in the centre of the wind-
screen, behind the interior mirror.
It is used for automatic switching
on of the lights.
Operating check
Activation
The activated function is accompa-
nied by an audible signal and a mes-
sage on the multifunction display.
Direction indicators (lashers)
Left:
downwards.
Right: upwards.
Disarming
The disarmed function is accompa-
nied by an audible signal.
When the driver uses the manual
lighting controls, the function is tem-
porarily disarmed.
If the brightness sensor does not
function correctly, the lights come
on accompanied by an audible signal
and a message on the multifunction
display.
Contact a PEUGEOT dealer.

94
30-08-2004
95
30-08-2004
YOUR 307 CC IN DETAIL
"Follow me home" lighting
In poor light or at night, if you leave
your vehicle, the side lights and
dipped headlamps can be left on for
approximately one minute.
To do this:
- place the key in the
STOP position,
- place the lights stalk in the
0 posi-
tion,
- lash the headlamps,
- get out of the vehicle and lock it.
AUTOMATIC SWITCHING ON
OF LIGHTS
The side lights and dipped beam
headlamps switch on automati-
cally if the light is poor and when the
windscreen wipers operate continu-
ously and switch off when the light
becomes bright enough or the wind-
screen wipers are switched off.
In foggy weather or in snow, the
brightness sensor can detect sufi-
cient light, the lights will not come
on automatically.
This function is active when the vehi-
cle is supplied to the customer.
To disarm or activate the function:
- Place the key in the accessories position (1st notch),
- Place the lights stalk in the
AUTO/0
position,
- Press the end of the lights stalk for more than four seconds.
Do not cover the brightness sen-
sor, coupled with the rain sensor,
located in the centre of the wind-
screen, behind the interior mirror.
It is used for automatic switching
on of the lights.
Operating check
Activation
The activated function is accompa-
nied by an audible signal and a mes-
sage on the multifunction display.
Direction indicators (lashers)
Left:
downwards.
Right: upwards.
Disarming
The disarmed function is accompa-
nied by an audible signal.
When the driver uses the manual
lighting controls, the function is tem-
porarily disarmed.
If the brightness sensor does not
function correctly, the lights come
on accompanied by an audible signal
and a message on the multifunction
display.
Contact a PEUGEOT dealer.

96
30-08-2004
97
30-08-2004
YOUR 307 CC IN DETAIL
WINDSCREEN WIPER STALK Front windscreen wiper with
automatic wipe
2 Fast wipe(heavy rain).
1 Normal wipe(moderate rain).
AUTO Automatic wipe.
0 Off.
â Single wipe
(press downwards).
In the
AUTO position, the wiping
speed is in proportion to the intensity
of the rainfall.
The command must be reactivated
each time the ignition is switched
back on:
- move the stalk to any position,
- then move it back to the required position.
Special position of the front
windscreen wiper
In the minute following switching off
of the ignition, any action on the stalk
positions the wipers in the centre of
the windscreen.
This action enables you to position
the wiper blades for winter parking,
cleaning or replacement (See sec-
tion "Practical information - Chang-
ing a wiper blade").
To park the wipers after this has been
done, switch on the ignition and op-
erate the stalk.
Windscreen wash
Pull the wiper stalk towards you. The
windscreen wash, then the wind-
screen wipers, operate for a speci-
ied time.
Front windscreen wiper with
intermittent wipe
2 Fast wipe (heavy rain).
1 Normal wipe(moderate rain).
I Intermittent wipe.
0 Off.
â Single wipe
(press downwards).
In the
Intermittent position, the wip-
ing speed is in proportion to the ve-
hicle speed.

96
30-08-2004
97
30-08-2004
YOUR 307 CC IN DETAIL
Automatic windscreen wipers

In the AUTO position, the wind-
screen wipers operate automatically
and adapt their speed to the inten-
sity of the rainfall .
Do not cover the rain sensor
located on the windscreen
behind the interior mirror.
When using an automatic
car wash, switch off the ignition or
check that the wiper stalk is not in
the automatic position.
In winter, it is advisable to wait
for the windscreen to completely
clear of ice before operating the
automatic wipe.
Operating check
Activation
When the function is activated, the
message "Automatic wiping ac-
tive" appears on the multi-function
display.
In the event of malfunction, the
driver is informed by an audible sig-
nal and the message
"Auto wiper
fault" on the multi-function display.
In the
AUTO position, the windscreen
wiper will operate in intermittent mode.
Contact a PEUGEOT dealer to have
the system checked.

96
30-08-2004
97
30-08-2004
YOUR 307 CC IN DETAIL
Automatic windscreen wipers

In the AUTO position, the wind-
screen wipers operate automatically
and adapt their speed to the inten-
sity of the rainfall .
Do not cover the rain sensor
located on the windscreen
behind the interior mirror.
When using an automatic
car wash, switch off the ignition or
check that the wiper stalk is not in
the automatic position.
In winter, it is advisable to wait
for the windscreen to completely
clear of ice before operating the
automatic wipe.
Operating check
Activation
When the function is activated, the
message "Automatic wiping ac-
tive" appears on the multi-function
display.
In the event of malfunction, the
driver is informed by an audible sig-
nal and the message
"Auto wiper
fault" on the multi-function display.
In the
AUTO position, the windscreen
wiper will operate in intermittent mode.
Contact a PEUGEOT dealer to have
the system checked.

98
30-08-2004
99
30-08-2004
TRIP COMPUTERColour screen DT
Monochrome screen B
- the remaining range
- the distance travelled
- the average consumption
- the current consumption
- the average speed
In addition, it allows access to the
warning log information. - the
"Current information"
with:
• the range,
• the current consumption,
• the distance still to be driven.
- 'Route 1' with:
• the distance travelled,
• the average consumption,
• the average speed,
- 'Route 2' with the same features.
It also permits access to the warning
log information.
Each time the button on the end
of the
wiper stalk is pressed, the
following sequence of data is dis-
played:
Monochrome screen CT
- the 'vehicle' tab with:
• range, current consumption and the distance still to be driven,
- tab "1" (route "1") with:
• the distance driven, the aver- age consumption and the aver-
age speed calculated over route
"1"
- tab '2' (route '2') with the same fea-
tures.
It also permits access to the warning
log information.
YOUR 307 CC IN DETAIL
Zero reset
Press the stalk for more than two
seconds.
Zero re-set
When the required route is displayed,
press the button for more than two
seconds.Zero re-set
When the required route is displayed,
press the button for more than two
seconds.

98
30-08-2004
99
30-08-2004
Range
This shows the distance that can still
be covered with the fuel remaining in
the tank.
Note: this i gure may increase if
there is a change in the style of driv-
ing or the road surface, producing a
signii cant drop in current consump-
tion.
When the range is less than 20 miles
(30 km), three segments are dis-
played. After i lling with fuel, the
range is displayed when it exceeds
62 miles (100 km).
If horizontal segments are displayed
for long periods instead of digits,
contact a PEUGEOT dealer.
Distance remaining to be travelled
This is the distance remaining to the
destination. It can either be calcu-
lated by the navigation if guidance
is activated, or entered by the user,
minus the distance covered since the
distance was entered.
Note: if digits are missing, dashes
are displayed in their place.
The routes
The routes "1" and ''2'' are independ-
ent but have identical application.
Route "1" for example allows you
to make daily calculations and route
"2" monthly calculations.
YOUR 307 CC IN DETAIL
Current consumption
This is the average quantity of fuel con-
sumed during the last few seconds.
This function is displayed only when
the vehicle is travelling at a speed
greater than 20 mph (30 km/h).
Average consumption
This is the average fuel consump-
tion since the computer was last set
to zero.
Distance travelled
This indicates the distance travelled
since the computer was last set to
zero.
Average speed
This is the average speed calculated
since the computer was last set to
zero (with the ignition on).
The warning log
This summarises the active warning
messages by displaying them on the
multi-function display.

98
30-08-2004
99
30-08-2004
TRIP COMPUTERColour screen DT
Monochrome screen B
- the remaining range
- the distance travelled
- the average consumption
- the current consumption
- the average speed
In addition, it allows access to the
warning log information. - the
"Current information"
with:
• the range,
• the current consumption,
• the distance still to be driven.
- 'Route 1' with:
• the distance travelled,
• the average consumption,
• the average speed,
- 'Route 2' with the same features.
It also permits access to the warning
log information.
Each time the button on the end
of the
wiper stalk is pressed, the
following sequence of data is dis-
played:
Monochrome screen CT
- the 'vehicle' tab with:
• range, current consumption and the distance still to be driven,
- tab "1" (route "1") with:
• the distance driven, the aver- age consumption and the aver-
age speed calculated over route
"1"
- tab '2' (route '2') with the same fea-
tures.
It also permits access to the warning
log information.
YOUR 307 CC IN DETAIL
Zero reset
Press the stalk for more than two
seconds.
Zero re-set
When the required route is displayed,
press the button for more than two
seconds.Zero re-set
When the required route is displayed,
press the button for more than two
seconds.