service indicator Peugeot 307 CC 2007.5 Owner's Manual

24
INSTRUMENTS and CONTROLS
After switching on the ignition, three
functions are shown in succession:
- service indicator,
- engine oil level indicator,
- total distance recorder (total and trip distances).

Note: the total and trip distances are
displayed for 30 seconds when the
ignition is switched off, on opening
the driver’s door, as well as on locking
and unlocking the vehicle.
It also displays the information relating
to the cruise control or speed limiter,
when either of these is activated (see
corresponding section).
Service indicator
This indicates when the next service
is due in accordance with the
manufacturer’s servicing schedule.
The point at which the next service
is due is calculated from the last indi-
cator zero reset (see corresponding
section). It is determined by two pa-
rameters:
- the distance travelled,
- the time which has elapsed since the last service.

Note: the distance remaining before
the next service may be weighted
by the time factor, depending on the
user’s driving habits.
Operation
For 5 seconds after the ignition is
switched on, the spanner symbolis-
ing the servicing operations comes
on; the distance recorder display in-
dicates the number of miles [kilome-
tres] (rounded off) remaining until the
next service.

Example: 4,800 miles/km remain
before the next service. For i ve sec-
onds after the ignition is switched on,
the display indicates:
INSTRUMENT PANEL DISPLAY
The distance remaining to the next
service is less than 500 miles (1,000 km).

Example: 400 miles (900 km) remain
before the next service.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and

the spanner remains lit .
It indicates that a service must
be carried out soon. The display
indicates the total and trip distance.
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and
the display indicates the total and trip
distance.

24
INSTRUMENTS and CONTROLS
After switching on the ignition, three
functions are shown in succession:
- service indicator,
- engine oil level indicator,
- total distance recorder (total and trip distances).

Note: the total and trip distances are
displayed for 30 seconds when the
ignition is switched off, on opening
the driver’s door, as well as on locking
and unlocking the vehicle.
It also displays the information relating
to the cruise control or speed limiter,
when either of these is activated (see
corresponding section).
Service indicator
This indicates when the next service
is due in accordance with the
manufacturer’s servicing schedule.
The point at which the next service
is due is calculated from the last indi-
cator zero reset (see corresponding
section). It is determined by two pa-
rameters:
- the distance travelled,
- the time which has elapsed since the last service.

Note: the distance remaining before
the next service may be weighted
by the time factor, depending on the
user’s driving habits.
Operation
For 5 seconds after the ignition is
switched on, the spanner symbolis-
ing the servicing operations comes
on; the distance recorder display in-
dicates the number of miles [kilome-
tres] (rounded off) remaining until the
next service.

Example: 4,800 miles/km remain
before the next service. For i ve sec-
onds after the ignition is switched on,
the display indicates:
INSTRUMENT PANEL DISPLAY
The distance remaining to the next
service is less than 500 miles (1,000 km).

Example: 400 miles (900 km) remain
before the next service.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and

the spanner remains lit .
It indicates that a service must
be carried out soon. The display
indicates the total and trip distance.
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and
the display indicates the total and trip
distance.

25
INSTRUMENTS and CONTROLS
Your PEUGEOT dealer carries out
this operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:

 Switch off the ignition,

 Press and hold the trip recorder
re-set button,

 Switch on the ignition.
The display begins a countdown.
When the display shows "=0" , re-
lease the button; the spanner disap-
pears.

Important: after this operation, if you
wish to disconnect the battery, lock
the vehicle and wait for at least i ve
minutes, otherwise the zero re-set
will not be registered.
The service is overdue.
The spanner l ashes for 5 seconds
after the ignition is switched on.

Example: the service is overdue by
300 miles/km, your vehicle must be
serviced as soon as possible.
For 5 seconds after the ignition is
switched on, the display indicates:
Engine oil level indicator
When the ignition is switched on,
the engine oil level is indicated for
a few seconds, after the service
information.
Oil level correct
Oil level gauge fault
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and
the spanner remains lit. The display
indicates the total and trip distance.

Note: the spanner may also come on
if more than two years have elapsed
since the last service. Flashing of
"OIL --"
indicates a malfunc-
tion of the engine
oil level gauge.
Contact a PEUGEOT dealer.

The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 15 minutes.
Flashing of
"OIL" ,
linked with the ser-
vice warning light,
accompanied by
an audible signal
and a message on
the multifunction display, indicates a
lack of oil which could damage the
engine.
If the lack of oil is coni rmed by a
check using the dipstick, it is essential
that the level is topped up.
Lack of oil
Service indicator zero re-set

25
INSTRUMENTS and CONTROLS
Your PEUGEOT dealer carries out
this operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:

 Switch off the ignition,

 Press and hold the trip recorder
re-set button,

 Switch on the ignition.
The display begins a countdown.
When the display shows "=0" , re-
lease the button; the spanner disap-
pears.

Important: after this operation, if you
wish to disconnect the battery, lock
the vehicle and wait for at least i ve
minutes, otherwise the zero re-set
will not be registered.
The service is overdue.
The spanner l ashes for 5 seconds
after the ignition is switched on.

Example: the service is overdue by
300 miles/km, your vehicle must be
serviced as soon as possible.
For 5 seconds after the ignition is
switched on, the display indicates:
Engine oil level indicator
When the ignition is switched on,
the engine oil level is indicated for
a few seconds, after the service
information.
Oil level correct
Oil level gauge fault
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and
the spanner remains lit. The display
indicates the total and trip distance.

Note: the spanner may also come on
if more than two years have elapsed
since the last service. Flashing of
"OIL --"
indicates a malfunc-
tion of the engine
oil level gauge.
Contact a PEUGEOT dealer.

The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 15 minutes.
Flashing of
"OIL" ,
linked with the ser-
vice warning light,
accompanied by
an audible signal
and a message on
the multifunction display, indicates a
lack of oil which could damage the
engine.
If the lack of oil is coni rmed by a
check using the dipstick, it is essential
that the level is topped up.
Lack of oil
Service indicator zero re-set

25
INSTRUMENTS and CONTROLS
Your PEUGEOT dealer carries out
this operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:

 Switch off the ignition,

 Press and hold the trip recorder
re-set button,

 Switch on the ignition.
The display begins a countdown.
When the display shows "=0" , re-
lease the button; the spanner disap-
pears.

Important: after this operation, if you
wish to disconnect the battery, lock
the vehicle and wait for at least i ve
minutes, otherwise the zero re-set
will not be registered.
The service is overdue.
The spanner l ashes for 5 seconds
after the ignition is switched on.

Example: the service is overdue by
300 miles/km, your vehicle must be
serviced as soon as possible.
For 5 seconds after the ignition is
switched on, the display indicates:
Engine oil level indicator
When the ignition is switched on,
the engine oil level is indicated for
a few seconds, after the service
information.
Oil level correct
Oil level gauge fault
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and
the spanner remains lit. The display
indicates the total and trip distance.

Note: the spanner may also come on
if more than two years have elapsed
since the last service. Flashing of
"OIL --"
indicates a malfunc-
tion of the engine
oil level gauge.
Contact a PEUGEOT dealer.

The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 15 minutes.
Flashing of
"OIL" ,
linked with the ser-
vice warning light,
accompanied by
an audible signal
and a message on
the multifunction display, indicates a
lack of oil which could damage the
engine.
If the lack of oil is coni rmed by a
check using the dipstick, it is essential
that the level is topped up.
Lack of oil
Service indicator zero re-set