PEUGEOT 307 CC DAG 2004 Owners Manual

126
30-08-2004
127
30-08-2004
PRACTICAL INFORMATION
Special features of alloy
wheels
Bolt covers
Alloy wheel bolts are covered by
chrome trims.
Use tool 6 to remove the trims before
slackening the bolts. Fitting the spare wheel
If your vehicle is itted with a steel
spare wheel, when itting it, it is
normal
when tightening the bolts to
notice that the washers do not come
into contact with the rim. The spare
wheel is secured by the cone shape
of each bolt.
Anti-theft bolts
If your wheels are itted with an
anti-theft bolt (one per wheel), the
chrome trim and then the plastic
cover must be removed using tool 6,
before unscrewing the bolt using one
of the two anti-theft sockets (which
were given to you on delivery of your
vehicle along with the duplicate keys
and the conidential card) and the
wheel brace 1.
Note: make a careful note of the
code number engraved on the head
of the anti-theft socket. This will en-
able you to obtain duplicate anti-theft
sockets from a PEUGEOT dealer.
Fitting snow tyres
If you it snow tyres mounted on steel
wheels onto your vehicle, it is
es-
sential to use special bolts available
from your PEUGEOT dealer.

126
30-08-2004
127
30-08-2004
PRACTICAL INFORMATION
F Turn the protective cover cor-
responding to the faulty bulb a
quarter of a turn and remove it.
F Disconnect the connector.
F Press the end of the securing clip
to free it. Change the bulb.
When itting the new bulb, ensure that
the direction notches are positioned
correctly and the securing clip is ixed
properly.
F Reconnect the connector.
F Reit the protective cover, posi-
tioning it with the arrow upwards,
then turn it a quarter of a turn to
the right. The headlamps are itted with poly-
carbonate glass with a protective
coating.
Do not clean them with a
dry or abrasive cloth, nor with a
detergent or solvent product. Use
a sponge and soapy water.
4 - Side lights (W 5 W).
F Pull the socket rearwards, remove
the bulb and change it.
5 - Direction indicators (PY 21 W amber).
F Turn the bulb holder a quarter of a
turn and remove it.
F Change the bulb.
Note: In certain climatic conditions
(low temperature, humidity), conden-
sation inside the headlamp glass is
normal ; it disappears a few minutes
after the lights are switched on.CHANGING A BULB
Front lights
Handle the bulbs with a dry cloth.
1 - Dipped beam headlamps (H7-55 W).
2 - Main beam headlamps (H1-55 W).
3 - Front fog lamps (H1-55 W).

128
30-08-2004
129
30-08-2004
PRACTICAL INFORMATION
Direction indicator side
repeaters (WY 5 W amber).
F Push the repeater forwards and
release the assembly.
F Hold the connector and turn the
lens a quarter of a turn.
F Change the bulb.
Amber coloured bulbs (di-
rection indicators and side
repeaters), must be repla-
ced with bulbs of identical
speciication and colour.
Rear lights
1 - Brake lights (diodes).
2 - Side lights (diodes).
3 - Direction indicators (P 21 W).
4 - Reversing light (P 21 W), right side.
Fog lamp (P 21 W), left side. Direction indicators
F
Remove the 3 bolts of the cor-
responding boot side trim to ac-
cess the light (use the 20 Torx
TM
adaptor of tool C located in the
handbook pocket),
F Remove the light ixing nut inside
the boot,
F Remove the light,
F Unscrew the bulb holder 5 a quar-
ter of a turn,
F Remove the bulb holder,
F Change the faulty bulb.
Note: When reitting, take care to
position the bulb holder and the light
correctly.
All work on the diode
lights must be carried out
by a PEUGEOT dealer.

128
30-08-2004
129
30-08-2004
PRACTICAL INFORMATION
Direction indicator side
repeaters (WY 5 W amber).
F Push the repeater forwards and
release the assembly.
F Hold the connector and turn the
lens a quarter of a turn.
F Change the bulb.
Amber coloured bulbs (di-
rection indicators and side
repeaters), must be repla-
ced with bulbs of identical
speciication and colour.
Rear lights
1 - Brake lights (diodes).
2 - Side lights (diodes).
3 - Direction indicators (P 21 W).
4 - Reversing light (P 21 W), right side.
Fog lamp (P 21 W), left side. Direction indicators
F
Remove the 3 bolts of the cor-
responding boot side trim to ac-
cess the light (use the 20 Torx
TM
adaptor of tool C located in the
handbook pocket),
F Remove the light ixing nut inside
the boot,
F Remove the light,
F Unscrew the bulb holder 5 a quar-
ter of a turn,
F Remove the bulb holder,
F Change the faulty bulb.
Note: When reitting, take care to
position the bulb holder and the light
correctly.
All work on the diode
lights must be carried out
by a PEUGEOT dealer.

128
30-08-2004
129
30-08-2004
PRACTICAL INFORMATION
Reversing light/fog lamp
F unclip the corresponding boot lid
trim at two points,
F move the trim aside gently to ac-
cess the bulb holder 6,
F unscrew the bulb holder a quarter
of a turn,
F remove the bulb holder,
F change the faulty bulb.
Note: When reitting, take care to po-
sition the bulb holder correctly.Third brake light (diodes) Number plate lights (W 5 W)
F Insert a thin screwdriver into one
of the external holes of the lens.
F Push it outwards to unclip it.
F Remove the lens.
F Change the faulty bulb.
All work on the diode
lights must be carried out
by a PEUGEOT dealer.

130
30-08-2004
131
30-08-2004
CHANGING A FUSE
The fuse boxes are located in the
lower part of the fascia (driver's side)
and in the engine compartment.
The spare fuses and special pliers A
are ixed to the inside of the lid of the
fascia panel fuse box.
Correct Incorrect Pliers A
PRACTICAL INFORMATION
Fuse no. Rating Functions
1 10 A Rear fog lamp.
2 - Not used.
4 15 A Front electric windows - Roll-over hoops -
Retractable roof.
5 15 A Left brake light including trailer.
7 30 A Rear courtesy light, front courtesy light,
map reading lights - 12 V front socket -
Glove box lighting.
Removing and changing a
fuse
Before changing a fuse, you must
establish the cause of the fault and
have it corrected. The fuse numbers
are indicated on the fuse box.
F
Use the special pliers A.
Always change a faulty fuse for
one of the same rating.Fascia panel fuses
F Unscrew the screw a quarter of a
turn with a coin, then pull the han-
dle to open the cover and access
the fuses.

132
30-08-2004
133
30-08-2004
PRACTICAL INFORMATION
Engine compartment fuses
Fuse box
To access the fuse box in the engine
compartment (next to the battery):
F unclip the cover.
Carefully close the cover and re-
it the style cover when you have
inished. The electrical system of
your vehicle is designed
to operate with standard
or optional equipment.
Before installing other
electrical equipment or acces-
sories on your vehicle, contact a
PEUGEOT dealer.
PEUGEOT will not accept re-
sponsibility for the cost incurred in
repairing your vehicle or for rectify-
ing the malfunctions resulting from
the installation of accessories not
supplied and not recommended
by PEUGEOT and not installed in
accordance with its instructions,
in particular where the equipment
in question consumes more than
10 milliamperes.
Fuse N° Rating Functions
1* 50 A Fan unit.
2* 30 A ESP/ABS pump motor.
3* 30 A ESP/ABS solenoid valves.
4* 70 A Built-in Systems Interface supply.
5* 70 A Built-in Systems Interface supply.
6* 60 A Heated seats - Retractable roof pump.
7* 30 A Ignition switch.
8* 70 A Power steering electro-pump unit.
* The maxi-fuses provide addition-al protection for the electrical
systems. All work on the maxi-
fuses and external fuses must
be carried out by a PEUGEOT
dealer.
External fuse N°Rating Functions
FV1* 20 A Single speed fan unit.
FV2* 30 A Dual-speed fan unit.

132
30-08-2004
133
30-08-2004
PRACTICAL INFORMATION
Fuse N° RatingFunctions
1 10 A Automatic gearbox reversing lights switch -
Automatic gearbox starting inhibitor relay control - Manual gearbo x reversing lights switch -
Vehicle speed sensor.
2 15 A Canister solenoid valve - Fuel pump.
3 10 A Power steering control unit - ABS or ESP control unit.
4 10 A Injection control unit - Fan unit relay control - Additional heating relay control -
Automatic gearbox control unit - Automatic gearbox sequential cont rol -
Automatic gearbox shiftlock relay.
5 - Not used.
6 15 A Front fog lamps.
7 20 A Headlamp wash pump.
8 20 A Fan unit relay control - Engine ECU supply.
9 15 A Left-hand dipped beam.
10 15 A Right-hand dipped beam.
11 10 A Right-hand main beam.
12 10 A Left-hand main beam.
13 15 A Horn.
14 10 A Wash-wipe pump.
15 30 A Oxygen sensors - Exhaust gas recirculation solenoid valve - Ignition co il -
Injectors supply.
16 30 A Petrol engine air pump with automatic gearbox.
17 30 A Low/high speed wiper.
18 40 A Air conditioning blower.

130
30-08-2004
131
30-08-2004
CHANGING A FUSE
The fuse boxes are located in the
lower part of the fascia (driver's side)
and in the engine compartment.
The spare fuses and special pliers A
are ixed to the inside of the lid of the
fascia panel fuse box.
Correct Incorrect Pliers A
PRACTICAL INFORMATION
Fuse no. Rating Functions
1 10 A Rear fog lamp.
2 - Not used.
4 15 A Front electric windows - Roll-over hoops -
Retractable roof.
5 15 A Left brake light including trailer.
7 30 A Rear courtesy light, front courtesy light,
map reading lights - 12 V front socket -
Glove box lighting.
Removing and changing a
fuse
Before changing a fuse, you must
establish the cause of the fault and
have it corrected. The fuse numbers
are indicated on the fuse box.
F
Use the special pliers A.
Always change a faulty fuse for
one of the same rating.Fascia panel fuses
F Unscrew the screw a quarter of a
turn with a coin, then pull the han-
dle to open the cover and access
the fuses.

130
30-08-2004
131
30-08-2004
PRACTICAL INFORMATION
* Fuses located inside the top of the fuse box.
Fuse N° RatingFunctions
9 30 A Front electric windows - Automatic front electric windows.
10 15 A Diagnostic socket - 12 volt rear socket - Trailer.
11 20 A Audio equipment - Multi-function display - Steering wheel contro
ls - Automatic gearbox -
Retractable roof control unit.
12 10 A Front right and rear right side lights - Number plate and trai
ler lighting -
Central locking/alarm/hazard warning lights/ESP switches lighting -
Air conditioning/ashtray lighting - Heated seats/Automatic gearb ox switches lighting -
Lighter.
14 30 A Door opening/closing controls - Deadlocking controls.
15 30 A Press-operation electric rear windows - Hinged covers motor.
16 10 A Engine fuse box - Alarm - Steering wheel controls - Air bags.
17 10 A Rear right brake light - 3rd brake light.
18 10 A Diagnostic socket - Steering wheel controls - Electrochromatic mirror -
Brake pedal (stop) and clutch switches - Coolant level switch - Secon
d brake switch.
19 30 A PARC shunt.
22 10 A Front left and rear left side lights - Number plate and trai ler lighting.
23 15 A Alarm siren - Interior alarm control unit.
24 15 A Instrument panel - Audio equipment - Multi-function display - Air
conditioning -
Rear parking assistance - Rain/brightness sensor.
26 30 A Heated rear screen.
27* 20 A Heated seats.
28* 40 A Retractable roof pump.
29* 10 A Air bags.
30* 20 A JBL audio system.
31* 10 A Roll-over hoops.