PEUGEOT 307 CC DAG 2004 Owners Manual

134
30-08-2004
135
30-08-2004
PRACTICAL INFORMATION
CHANGING A WINDSCREEN
WIPER BLADE
Special front windscreen wiper
position
F Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
ECONOMY MODE FUNCTION
After the engine has stopped, with
the key in the accessories position,
certain functions (windscreen wiper,
electric windows, courtesy lights,
audio equipment etc.) can only be
used for a cumulative duration of
thirty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, the
message "Economy mode active"
appears on the multifunction display
and the active functions are put on
standby.
To resume the use of these functions
immediately, start the engine and let
it run for a few seconds.
A lat battery will prevent
the engine from starting.
LOAD REDUCTION
FUNCTION
When driving, certain functions (air
conditioning, heated rear screen,
etc.) may be switched off tempora-
rily, depending on the level of battery
charge.
Reactivation of these functions is
automatic, once the battery charge
is suficient.
Note: at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.
Changing a wiper blade
F Lift the wiper arm, then unclip the
blade and remove it.
F Fit the new blade and push back
the arm.
Note: the shortest blade is itted on
the vehicle's right-hand windscreen
wiper arm.
To return the windscreen wipers to
their normal position, switch on the
ignition and operate the wiper stalk.

134
30-08-2004
135
30-08-2004
PRACTICAL INFORMATION
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery,
- Follow the instructions for use given by the battery charger manu-
facturer,
- Reconnect starting with the nega- tive (-) terminal,
- Check that the terminals and con- nectors are clean. If they are cov-
ered with sulphate (white or greenish
deposit), disconnect them and clean
them. - Before disconnecting
the battery, you must
wait for 2 minutes after
switching off the ignition.
- Never disconnect a ter- minal when the engine
is running.
- Never charge a battery without irst disconnecting the termi-
nals.
- Close the windows, the retract- able roof and the doors before
disconnecting the battery. If the
windows do not operate normal-
ly following reconnection of the
battery, they must be reinitial-
ised (see sections "Reinitialisa-
tion of the electric windows" and
"Reinitialisation of the automatic
partial opening of the door win-
dows").
- After every reconnection of the battery, switch on the igni-
tion and wait 1 minute before
starting to allow the electronic
systems to be initialised. If slight
dificulties are experienced after
this, please contact a PEUGEOT
dealer.
It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
To start the vehicle from another
battery:
- Connect the red cable to the posi- tive (+) terminals of the two batter-
ies,
- Connect one end of the green or black cable to the negative (-) ter-
minal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery,
Operate the starter, let the engine
run.
Wait for the engine to return to idle,
then disconnect the cables.

136
30-08-2004
137
30-08-2004
PRACTICAL INFORMATION
From the front:
F Unclip the cover, by pressing the
bottom part,
F Screw in the towing eye as far as
it will go.Lifting (2 wheels only on the
ground)
It is preferable to raise the vehicle
with a professional lifting device.
Special features of the
automatic gearbox
When towing with four wheels on the
ground, the following rules must be
obeyed:
- lever in position N,
- tow the vehicle at less than 50 km/h over a maximum distance of 50 km.
- do not add oil to the gearbox.
When towing with the
engine switched off, there
is no braking or steering
assistance.
TOWING YOUR VEHICLE
Without lifting (4 wheels on
the ground)
You must always use a towbar.
The removable towing eye is inside
the spare wheel. From the rear:
F
Unclip the top of the cover using a
coin,
F Screw in the towing eye as far as
it will go.

136
30-08-2004
137
30-08-2004
PRACTICAL INFORMATION
Driving advice
Distribution of loads: Distribute the
load in the trailer so that the heaviest
items are as close as possible to the
axle and the nose weight approach-
es the maximum permitted without
exceeding it.
Cooling: towing a trailer on a slope
increases the temperature of the
coolant.
As the fan is electrically controlled,
its cooling capacity is not dependent
on the engine speed.
On the contrary, use a high gear to
lower the engine speed and reduce
your speed.
The maximum towing load on a long
slope depends on the gradient and
the outside temperature.
In all cases, pay attention to the cool-
ant temperature.
If the warning light comes on, stop
the vehicle and switch off the engine
as soon as possible. Tyres:
check the tyre pressures of
the towing vehicle and of the trailer,
observing the recommended pres-
sures.
Braking: towing increases the brak-
ing distance.
Lights: check the electrical signal-
ling on the trailer.
Side wind: take into acount the in-
creased sensitivity to side wind.
TOWING A TRAILER,
CARAVAN, BOAT etc.
Only use original PEUGEOT tow
bars that have been tested and ap-
proved from the design stage of your
vehicle.
The tow bar must be itted by a
PEUGEOT dealer.
Your vehicle is primarily designed
for transporting people and luggage
but it may also be used for towing a
trailer.
Driving with a trailer subjects the tow-
ing vehicle to more signiicant stress
and its driver must be particularly
careful.
Air density decreases with altitude,
thus reducing engine performance.
Above 1 000 metres, the maximum
towing load must be reduced by
10 % and so on for every 1 000 me-
tres of altitude.
The rear parking assistance function
will be disarmed automatically when
a towbar is itted.

138
30-08-2004
139
30-08-2004
PRACTICAL INFORMATION
REMOVING THE MAT
When removing the mat on the
driver's side, push the seat as far
back as possible and unscrew the
ixings.
When reitting, position the mat and re-
place the ixings by pressing them in.
BOOT LUGGAGE CARRIER*
A boot luggage carrier is available
from your PEUGEOT dealer.
When it is used, take care not to con-
ceal the third brake light.
Follow the manufacturer's recom-
mendations.
* Available as an accessory.

138
30-08-2004
139
30-08-2004
PRACTICAL INFORMATION
Roof emergency mode

140
30-08-2004
141
30-08-2004
PRACTICAL INFORMATION
Boot lid Moving shelf Roof locking bolt
Boot sill Bleed screw Plastic covers Hinged covers
Screen

140
30-08-2004
141
30-08-2004
PRACTICAL INFORMATION
Manual closing of the roof
(emergency mode)
If the roof opening or closing cycle
does not begin or does not function
correctly, check the following points:
F ignition key in
the accessories
or running position (1st or 2nd
notch),
F the screen must be pulled out,
F the boot must be closed,
F the vehicle speed must be below
6 mph (10 km/h),
F the roof fuse must be in good
condition (see corresponding sec-
tion),
F the windows must be initialised
(see corresponding section),
F the battery voltage must be suf-
icient (the roof control button
indicator light must be lit),
F the vehicle must not be subject
to "Economy mode active" re-
strictions (see corresponding sec-
tion),
F the exterior temperature must not
be below - 20 °C. In the event of an electrical or hy-
draulic roof malfunction
, it is pos-
sible to close the roof manually.
Contact a PEUGEOT dealer to have
the system checked.
This possibility is a breakdown so-
lution .
Following manual closing of the roof,
the boot lid hinges will no longer be
locked and the boot will no longer be
sealed.
Two people are required to carry
out this operation. Considerable
force is necessary.
F Park the vehicle, if possible on
level ground.
F Lower the windows.
F Switch off the ignition.
F Apply the handbrake.
When carrying out the
roof closing operation,
take care not to catch
your hands in the mecha-
nisms. The following two tools are provided
in the handbook pocket:
F
Allen
TM key with 5 adaptor A and
6 adaptor B,
F Torx
TM key with 20 adaptor C and
30 adaptor D.

142
30-08-2004
143
30-08-2004
PRACTICAL INFORMATION
F Open the boot lid.
F Using the hook 1, secure the boot mat on the screen bar
2 .
This allows access to the hydraulic pump screw.
F Press the Allen
TM key adaptor B irmly into the bleed
screw 3, then unscrew half a turn. F
Using the Torx
TM key adaptor C, remove the six plastic
cover bolts 4, located on either side of the boot.
F Remove the two plastic covers 5.
F Extract the cable buckles 6 from the trims.
Note: if a cable buckle is not visible, carefully insert your
hand behind the trim to extract it.

142
30-08-2004
143
30-08-2004
PRACTICAL INFORMATION
F Pull the two control cables 7 at the same time to unlock
the boot lid locks.
F While continuing to pull the cables, lift the boot li d hinges
8 carefully.
Considerable force is required. Release the cables.
Then, lift the assembly rearwards.
Note: the unfolding of the hinges locks the lid in the upper
position. F
Raise the moving shelf 9 lifting it on either side.
Considerable force is required.
F Guide the movement of the shelf until it is in a vertical
position.
F Take hold of the roof 10, unfold it (considerable force is
required) and move it as close as possible to the wind-
screen.
F Reposition the boot mat and roll up the screen.