Peugeot 307 CC Dag 2005.5 Owner's Manual

Driving86 -
01-10-2005
87Driving-
01-10-2005
CRUISE CONTROL*
This cruise control, of the new gen-
eration, is linked with the speed lim-
iter. It has a display on the instrument
panel to indicate the memorised ref-
erence speed.
It enables the vehicle to maintain a
steady speed programmed by the
driver.
In order for it to be memorised or
activated, the vehicle speed must be
greater than 25 mph (40 km/h) with
at least fourth gear engaged for vehi-
cles itted with a manual gearbox.
On vehicles itted with an automatic
gearbox, the lever must be in posi-
tion D, or in at least second gear in
sequential mode. Instrument panel display
When the cruise control function
is activated, pressing this button
enables you to display the distance
recorders.
After a few seconds or when this
button is pressed again, the display
returns to the cruise control function.First activation / memorising a
reference speed
As soon as you reach the chosen
speed, press button
2 or 3. This
memorises the speed and the
display indicates (e.g. at 70 mph
(110 km/h)):
Selecting the function
F Place switch 1 in the CRUISE
position. The cruise control is
not yet active and no speed has
been memorised. The display in-
dicates: Note:
It is possible to accelerate
and drive momentarily at a speed
greater than the memorised speed.
The value memorised lashes. When
the accelerator pedal is released, the
vehicle will return to the memorised
speed.
Cancelling the cruise control
If you wish to cancel the cruise con-
trol:
F Press button 4 or the brake or
clutch pedal.
The display indicates (e.g. at 70 mph
(110 km/h)):
* According to country.

Driving88 -
01-10-2005
89Driving-
01-10-2005
Cancelling the memorised
reference speed
F When the vehicle becomes sta-
tionary, after switching off the
ignition, the system no longer
memorises a speed. This warning light comes
on for a few seconds, ac-
companied by an audible
signal and a message on
the multifunction display.
Contact a PEUGEOT dealer to have
the system checked.
When changing the memo-
rised reference speed by
means of a maintained
press, pay attention as the
speed can increase or de-
crease rapidly.
Do not use the cruise control on slip-
pery roads or in heavy trafic.
In the event of a steep slope, the
cruise control cannot prevent the
vehicle from exceeding the pro-
grammed speed.
In any event, the cruise control can-
not replace the need to observe the
speed limits, nor can it replace the
need for vigilance and responsibility
on the part of the driver.
To prevent the mat from becoming
caught under the pedals:
- ensure that the mat is positioned correctly.
- never it one mat on top of another.
Reactivating the cruise control
After cancellation of the cruise con-
trol,
press button 4. Your vehicle will
return to the last memorised speed.
The display indicates (e.g. at 70 mph
(110 km/h)):
Changing the memorised
reference speed
To memorise a speed higher than the
previous one, there are two options:
Without using the accelerator:
F press button 3;
A brief press increases by 1 mph
(1 km/h).
An extended press increases by
5 mph (5 km/h).
A maintained press increases in
steps of 5 mph (5 km/h).
Using the accelerator:
F exceed the memorised speed un-
til the required speed is reached,
F press button 2 or 3. Switching the function off
F
Place dial 1 in position 0 to switch
the system off.
Operating fault
In the event of a cruise control mal-
function, the memorised speed is
erased, the dashes lash for a few
seconds:
To memorise a speed lower than the
previous one:
F
press button 2;
A brief press decreases by 1 mph
(1 km/h).
An extended press decreases by
5 mph (5 km/h).
A maintained press decreases in
steps of 5 mph (5 km/h).

Driving88 -
01-10-2005
89Driving-
01-10-2005
First activation / memorising a
reference speed
As soon as you reach the chosen
speed, press button 2 or 3. This
memorises the speed and the
display indicates (e.g. at 70 mph
(110 km/h)):
CRUISE CONTROL*
This cruise control has a display on
the instrument panel to indicate the
memorised reference speed.
It enables the vehicle to maintain a
steady speed programmed by the
driver.
In order for it to be memorised or
activated, the vehicle speed must be
greater than 25 mph (40 km/h) with
at least fourth gear engaged for vehi-
cles itted with a manual gearbox.
On vehicles itted with an automatic
gearbox, the lever must be in posi-
tion D or at least second gear must
be engaged in sequential driving
mode. Instrument panel display
When the cruise control function
is activated, pressing this button
enables you to display the distance
recorder.
After a few seconds or when this
button is pressed again, the display
returns to the cruise control function.
Selecting the function
F
Place switch 1 in the ON position.
The cruise control is not yet active
and no speed has been memo-
rised. The display indicates: Note:
It is possible to accelerate
and drive momentarily at a speed
greater than the memorised speed.
The value memorised lashes. When
the accelerator pedal is released, the
vehicle will return to the memorised
speed.
Cancelling the cruise control
If you wish to cancel the cruise con-
trol:
F Press button 4 or the brake or
clutch pedal.
The display indicates (e.g. at 70 mph
(110 km/h)):
* According to country.

Driving90 -
01-10-2005
91Driving-
01-10-2005
Reactivating the cruise control
After cancellation of the cruise
control, press button 4. Your vehicle
will return to the last memorised
speed. The display indicates (e.g. at
70 mph (110 km/h)):
Cancelling the memorised
reference speed
F When the vehicle is stationary,
after the ignition has been
switched off, the system no longer
stores any speed.
Changing the memorised
reference speed
To memorise a speed higher than the
previous one, there are two options:
Without using the accelerator:
F
press button 3;
A brief press increases by 1 mph
(1 km/h).
An extended press increases by
5 mph (5 km/h).
A maintained press increases in
steps of 5 mph (5 km/h).
Using the accelerator:
F exceed the memorised speed until
the required speed is reached,
F press button 2 or 3. Switching the function off
F
Place dial 1 in the OFF position to
switch the system off.
Operating fault
In the event of a cruise control
malfunction, the memorised speed
is erased, the dashes lash for a few
seconds: This warning light comes
on for a few seconds,
accompanied by an audible
signal and a message on
the multifunction display.
Contact a PEUGEOT dealer to have
the system checked.
When changing the
memorised reference
speed by means of a
maintained press, pay
attention as the speed
can increase or decrease
rapidly.
Do not use the cruise control on
slippery roads or in heavy trafic.
In the event of a steep slope,
the cruise control cannot prevent
the vehicle from exceeding the
programmed speed.
In any event, the cruise control
cannot replace the need to observe
the speed limits, nor can it replace the
need for vigilance and responsibility
on the part of the driver.
To prevent the mat from becoming
caught under the pedals:
- ensure that the mat is positioned correctly.
- never it one mat on top of another.
To memorise a speed lower than the
previous one:
F
press button 2;
A brief press decreases by 1 mph
(1 km/h).
An extended press decreases by
5 mph (5 km/h).
A maintained press decreases in
steps of 5 mph (5 km/h).

Driving90 -
01-10-2005
91Driving-
01-10-2005
REAR PARKING ASSISTANCE
This system consists of four prox-
imity sensors, located in the rear
bumper.
This detects any obstacle (person,
vehicle, tree, gate, etc.) behind the
vehicle. Nevertheless, it cannot de-
tect obstacles located just below the
bumper.
An object, such as a stake, a road-
works cone or any other similar
object may be detected at the begin-
ning of the manoeuvre, but may no
longer be detected when the vehicle
comes close to it.
Note: this function will be disarmed
automatically when the vehicle is
towing a trailer (vehicle itted with
towing attachment recommended by
PEUGEOT).
In bad or wintry weather, ensure that
the sensors are not covered with
mud, frost or snow. When reverse
gear is engaged, an audible signal
(long bleep) indicates that the sen-
sors may be dirty. The proximity information is given
by:
- an audible signal, which becomes
more rapid as the vehicle
approaches the obstacle.
- a graphic on the multifunction dis- play, with blocks which become
progressively closer to the vehicle.
The rear speakers transmit an audi-
ble signal:
- on the right if an obstacle is detec- ted on the right,
- on the left if an obstacle is detected on the left,
- on the right and on the left if an obstacle is detected in the centre.
When the distance between the rear
of the vehicle and the obstacle is less
than approximately twenty-ive centi-
metres, the audible signal becomes
continuous and the "Danger" symbol
appears on the multifunction display.
Switching the system off
F Change to neutral, the system is
again inactive.
If there is an operating
fault, when reverse gear
is engaged, the service
warning light comes on,
accompanied by an audible
signal (short bleep) and a message
on the multifunction display.
Contact a PEUGEOT dealer.
Activation / Deactivation
Activation
The system is activated as soon as
reverse gear is engaged.
This is accompanied by an audible
signal and displaying of the vehicle
on the multifunction display. The system can be acti-
vated or deactivated from
the multifunction display
coniguration menu.
The activation and deactivation of
the system are memorised when the
engine is switched off.

Checks92 -
01-10-2005
93Checks-
01-10-2005
OPENING THE BONNET
From inside: push the handle on the
left-hand side under the fascia.
From outside: lift the catch and
raise the bonnet.
Bonnet strut
Secure the strut to hold the bonnet
open.
Before closing the bonnet, replace
the strut in its housing.
To close
Lower the bonnet and release it at
the end of its travel.
Check that the bonnet is properly
locked.
RUNNING OUT OF FUEL
(DIESEL)
If you should run out of fuel, it is nec-
essary to re-prime the circuit.
The repriming pump and the degas
screw are located under the bonnet
(see corresponding drawing):
2 litre 16V HDI engine
- ill the fuel tank with at least ive litres of diesel,
- unclip the style cover to gain ac- cess to the repriming pump,
- unscrew the degas screw,
- squeeze and release the manual repriming pump until diesel is seen
escaping via the degas screw,
- retighten the degas screw,
- operate the starter until the engine starts.

Checks94 -
01-10-2005
95Checks-
01-10-2005
1. Power steering reservoir.
2. Windscreen/headlamp wash
reservoir.
3. Coolant reservoir. 4.
Brake luid reservoir.
5. Battery.
6. Fuse box. 7.
Air ilter.
8. Dipstick.
9. Engine oil reservoir.
1.6 LITRE 16V PETROL ENGINE

Checks94 -
01-10-2005
95Checks-
01-10-2005
1. Power steering reservoir.
2. Windscreen/headlamp wash
reservoir.
3. Coolant reservoir. 4.
Brake luid reservoir.
5. Battery.
6. Fuse box. 7.
Air ilter.
8. Dipstick.
9. Engine oil reservoir.
2 LITRE 16V PETROL ENGINE

Checks96 -
01-10-2005
97Checks-
01-10-2005
2 LITRE 16V (180 bhp) PETROL ENGINE
1. Power steering reservoir.
2. Windscreen/headlamp wash
reservoir.
3. Coolant reservoir. 4.
Brake luid reservoir.
5. Battery
6. Fuse box. 7.
Air ilter.
8. Dipstick.
9. Engine oil reservoir.

Checks96 -
01-10-2005
97Checks-
01-10-2005
1. Power steering reservoir.
2. Windscreen/headlamp wash
reservoir.
3. Coolant reservoir. 4.
Brake luid reservoir.
5. Battery.
6. Fuse box.
7. Air ilter. 8.
Engine oil reservoir.
9. Dipstick.
10. Priming pump.
11. Degas screw.
2 LITRE 16V TURBO DIESEL HDI ENGINE (136 bhp)