Peugeot 307 CC Dag 2005 Owner's Manual

Practical information134 -
01-03-2005
135Practical information-
01-03-2005
Special features of alloy
wheels
Bolt covers
Alloy wheel bolts are covered by
chrome trims.
Use the yellow tool 6 to remove the
trims before slackening the bolts. Fitting the spare wheel
If your vehicle is itted with a steel
spare wheel, when itting it, it is
normal
when tightening the bolts to
notice that the washers do not come
into contact with the rim. The spare
wheel is secured by the cone shape
of each bolt.
Anti-theft bolts
If your wheels are itted with an
anti-theft bolt (one per wheel), the
chrome trim and then the plastic
cover must be removed using tool 6,
before unscrewing the bolt using one
of the two anti-theft sockets and the
wheel brace.
Note: these two anti-theft sockets
were given to you on delivery of
you vehicle along with the duplicate
keys and the conidential card. Make
a careful note of the code number
engraved on the head of the anti-
theft socket.
This will enable you to obtain
duplicate anti-theft sockets from a
PEUGEOT dealer.
Fitting snow tyres
If you it snow tyres mounted on
steel wheels onto your vehicle, it
is
essential to use special bolts
available from your PEUGEOT
dealer.

Practical information136 -
01-03-2005
137Practical information-
01-03-2005
F Turn the protective cover
corresponding to the faulty bulb
a quarter of a turn to the left and
remove it.
F Disconnect the connector.
F Press the end of the securing clip
to free it. Change the bulb.
When itting the new bulb, ensure that the direction notches are
positioned correctly and the
securing clip is ixed properly.
F Reconnect the connector.
F Reit the protective cover,
positioning it with the arrow
upwards, then turn it a quarter of
a turn to the right.
The headlamps are itted with
polycarbonate glass with a protective
coating. Do not clean them with a
dry or abrasive cloth, nor with a
detergent or solvent product. Use
a sponge and soapy water. 4. Side lights (W 5 W).
F
Pull the socket rearwards, remove
the bulb and change it.
5. Direction indicators (PY 21 W amber).
F Turn the bulb holder a quarter of a
turn and remove it.
F Change the bulb.
Note : in certain climatic conditions
(low temperature, humidity), con-
densation inside the headlamp
glass is normal ; it disappears a few
minutes after the lights are switched
on.
CHANGING A BULB
Front lights
Handle the bulbs with a dry cloth.
1. Dipped beam headlamps (H7-55W).
2. Main beam headlamps (H1-55W).
3. Front fog lamps (H1-55 W).

Practical information136 -
01-03-2005
137Practical information-
01-03-2005
Direction indicator side repeaters
(WY 5W amber).
F Push the repeater forwards and
release the assembly.
F Hold the connector and turn the
lens a quarter of a turn.
F Change the bulb.
Amber coloured bulbs
(direction indicators and
side repeaters), must be
replaced with bulbs of
identical speciication and
colour.Rear lights
1. Brake lights (diodes).
2. Side lights (diodes).
3 Direction indicators (P 21 W).
4. Reversing light (P 21 W), right side.
Fog lamp (P 21 W), left side. Direction indicators
F
Remove the 3 bolts of the
corresponding boot side trim
to access the light (use the
20 Torx
TM adaptor of tool C
located in the handbook pocket).
F Remove the light ixing nut inside
the boot.
F Remove the light.
F Unscrew the bulb holder 5 a
quarter of a turn.
F Remove the bulb holder.
F Change the faulty bulb.
Note: when reitting, take care to
position the bulb holder and the light
correctly.
All work on the diode lights
must be carried out by a
PEUGEOT dealer.

Practical information136 -
01-03-2005
137Practical information-
01-03-2005
Direction indicator side repeaters
(WY 5W amber).
F Push the repeater forwards and
release the assembly.
F Hold the connector and turn the
lens a quarter of a turn.
F Change the bulb.
Amber coloured bulbs
(direction indicators and
side repeaters), must be
replaced with bulbs of
identical speciication and
colour.Rear lights
1. Brake lights (diodes).
2. Side lights (diodes).
3 Direction indicators (P 21 W).
4. Reversing light (P 21 W), right side.
Fog lamp (P 21 W), left side. Direction indicators
F
Remove the 3 bolts of the
corresponding boot side trim
to access the light (use the
20 Torx
TM adaptor of tool C
located in the handbook pocket).
F Remove the light ixing nut inside
the boot.
F Remove the light.
F Unscrew the bulb holder 5 a
quarter of a turn.
F Remove the bulb holder.
F Change the faulty bulb.
Note: when reitting, take care to
position the bulb holder and the light
correctly.
All work on the diode lights
must be carried out by a
PEUGEOT dealer.

Practical information138 -
01-03-2005
139Practical information-
01-03-2005
Reversing light/fog lamp
F Unclip the corresponding boot lid
trim at two points.
F Move the trim aside gently to
access the bulb holder 6.
F Unscrew the bulb holder a quarter
of a turn.
F Remove the bulb holder.
F Change the faulty bulb.
Note: when reitting, take care to
position the bulb holder correctly.
Third brake light (diodes)
All work on the diode lights
must be carried out by a
PEUGEOT dealer.
Number plate lights (W 5 W)
F Insert a thin screwdriver into one
of the external holes of the lens.
F Push it outwards to unclip it.
F Remove the lens.
F Change the faulty bulb.

Practical information138 -
01-03-2005
139Practical information-
01-03-2005
CHANGING A FUSE
The fuse boxes are placed in the
lower part of the fascia (driver's side)
and in the engine compartment (left-
hand side).Correct Incorrect
Fascia fuses
To access the fuses, unscrew the bolt
a quarter of a turn using a coin, then
pull the handle to open the cover.
Replacing a fuse
Before replacing a fuse, the cause
of the incident must be found and
rectiied. The fuse numbers are
indicated on the fuse box.
Always replace a faulty fuse with
a fuse of the same rating (same
colour).
Use the special pliers located on
the inside of the fascia fuse box
cover, this support also contains the
replacement fuses. Fuse N° Rating Functions
F36 20 A Hi-Fi ampliier.
F39 20 A Driver and passenger heated seats.
F40 30 A Retractable roof pump supply.

Practical information140 -
01-03-2005
141Practical information-
01-03-2005
Engine compartment fuses
To access the fuses located in the
engine compartment (next to the
battery), unclip the fuse box lid.
When you have inished, close the lid
carefully to guarantee the sealing of
the fuse box.Fuse N° Rating Functions
F1 20 A Fan assembly relay control, engine control unit control.
F2 15 A Horn.
F3 10 A Front wash-wipe.
F4 20 A Headlamp wash.
F5 15 A Fuel pump and purge canister solenoid valve.
F6 10 A Automatic gearbox control unit, automatic gearbox lever locking con
trol, push control switch,
fan assembly high speed relay.
F7 10 A ABS/ESP control unit, power steering control unit.

Practical information142 -
01-03-2005
143Practical information-
01-03-2005
Fuse N° RatingFunctions
F8 20 A Ignition switch.
F9 10 A Engine coolant level switch.
F10 30 A Engine management actuators (ignition coil, solenoid valves, oxyg
en sensors, control units,
injectors).
F11 40 A Air conditioning blower.
F12 30 A Windscreen wipers low/high speed.
F13 40 A Built-in system interface supply (ignition positive).
F14 30 A Air pump (2 litre petrol).
F15 10 A Right main beam headlamp.
F16 10 A Left main beam headlamp.
F17 15 A Left dipped headlamp.
F18 15 A Right dipped headlamp.

Practical information142 -
01-03-2005
143Practical information-
01-03-2005
The electrical system of
your vehicle is designed
to operate with standard or
optional equipment.
Before installing other
electrical equipment or accessories
on your vehicle, contact a PEUGEOT
dealer. Fuse N° Rating
Functions
MF1* 30 A
200 W fan unit.
50 A 400 W and 460 W fan unit.
MF2* 30 A ABS/ESP pump.
MF3* 80 A ABS/ESP solenoid valves.
MF4* 80 A Built-in systems interface supply.
MF5* 50 A Built-in systems interface supply.
MF6* 50 A Passenger compartment fuse box.
MF8* 70 A Power steering electro-pump unit.
PEUGEOT will not accept
responsibility for the cost incurred
in repairing your vehicle or for
rectifying the malfunctions resulting
from the installation of accessories
not supplied and not recommended
by PEUGEOT and not installed in
accordance with its instructions,
in particular where the equipment
in question consumes more than
10 milliamperes. * The maxi-fuses provide additional
protection for the electrical
systems. All work must be carried
out by a PEUGEOT dealer.

Practical information138 -
01-03-2005
139Practical information-
01-03-2005
CHANGING A FUSE
The fuse boxes are placed in the
lower part of the fascia (driver's side)
and in the engine compartment (left-
hand side).Correct Incorrect
Fascia fuses
To access the fuses, unscrew the bolt
a quarter of a turn using a coin, then
pull the handle to open the cover.
Replacing a fuse
Before replacing a fuse, the cause
of the incident must be found and
rectiied. The fuse numbers are
indicated on the fuse box.
Always replace a faulty fuse with
a fuse of the same rating (same
colour).
Use the special pliers located on
the inside of the fascia fuse box
cover, this support also contains the
replacement fuses. Fuse N° Rating Functions
F36 20 A Hi-Fi ampliier.
F39 20 A Driver and passenger heated seats.
F40 30 A Retractable roof pump supply.