Peugeot 307 CC Dag 2005 Owner's Manual

Practical information140 -
01-03-2005
141Practical information-
01-03-2005
Fuse N° RatingFunctions
F1 - Not used.
F2 30 A Locking and deadlocking.
F3 5 A Air bags and pre-tensioners unit.
F4 10 A Brake and clutch pedal switches, engine coolant level switch, st
eering wheel angle sensor,
diagnostic socket, ESP sensor, electrochromatic mirror.
F5 30 A Front electric windows and heated mirrors supply.
F6 30 A Rear electric windows supply, hinged laps motor.
F7 5 A Front and rear courtesy lights, map reading lights, glove box li ght.
F8 20 A Multifunction display supply, audio equipment, audio/tele
phone, alarm siren, alarm control
unit, 12V rear socket, trailer fuse box,.
F9 30 A 12V front socket.
F10 15 A Automatic gearbox control unit, brake switch.
F11 15 A Diagnostic socket, low current ignition switch.
F12 - Not used.
F13 5 A Engine fuse box supply, rain and brightness sensor.
F14 15 A Trailer fuse box, instrument panel, automatic air conditioning
, air bags and pre-tensioners
unit.
F15 30 A Locking and deadlocking supply.
F16 - PARC shunt.
F17 40 A Heated rear screen.

Practical information144 -
01-03-2005
145Practical information-
01-03-2005
CHANGING A WINDSCREEN
WIPER BLADE
Special front windscreen wiper
position
F Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
Changing a wiper blade
F Lift the wiper arm, then unclip the
blade and remove it.
F Fit the new blade and push back
the arm.
Note : the shortest blade is itted on
the vehicle's right-hand windscreen
wiper arm.
To return the windscreen wipers
to their normal position, switch on
the ignition and operate the wiper
stalk.
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery starting with
the negative (-) terminal,
- Follow the instructions for use given by the battery charger
manufacturer,
- Check that the terminals and connectors are clean; if they are
covered with sulphate (white or
greenish deposit), disconnect them
and clean them,
- Reconnect the battery starting with the negative (-) terminal. Before disconnecting the
battery, you must wait for 2
minutes after switching off
the ignition.
Never disconnect a terminal
when the engine is running.
Never charge a battery without irst
disconnecting the terminals.
Close the windows, the retractable
roof and the doors before
disconnecting the battery. If the
windows do not operate normally
following reconnection of the
battery, they must be reinitialised
(see sections "Reinitialisation of the
electric windows" and "Reinitialisation
of the automatic partial opening of
the door windows").
After every reconnection of the
battery, switch on the ignition and
wait 1 minute before starting to
allow the electronic systems to
be initialised. If slight dificulties
are experienced after this, please
contact a PEUGEOT dealer.
Following disconnection of the
battery, the remote control key
and the GPS satellite navigation
system must be reinitialised (see
corresponding section).
It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
To start the vehicle from
another battery:
- Connect the red cable to the positive (+) terminals of the two
batteries,
- Connect one end of the green or black cable to the negative (-)
terminal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery,
- Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables.

Practical information144 -
01-03-2005
145Practical information-
01-03-2005
ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (windscreen wiper, electric
windows, courtesy lights, audio
equipment, telephone, etc) can only
be used for a combined duration
of approximately thirty minutes, to
prevent discharging the battery.
Once the thirty minutes are over, a
switching to economy mode message
appears on the multi-function display
and the active functions are put on
standby.
These functions are reactivated
automatically next time the vehicle
is driven.
In order to resume the use of these
functions immediately, the engine
must be started and left to run for a
few minutes.
The time available to you will then
be double the duration for which the
engine is left running. However, this
period will always be between ive
and thirty minutes.
Note: if the telephone is being used
when economy mode starts, it will
still be possible to inish the call.
A lat battery prevents the
engine from starting.
LOAD REDUCTION
FUNCTION
When driving, certain functions (air
conditioning, heated rear screen,
etc.) may be switched off temporarily,
depending on the level of battery
charge.
Reactivation of these functions is
automatic, once the battery charge
is suficient.
Note: at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.

Practical information146 -
01-03-2005
147Practical information-
01-03-2005
Without lifting (4 wheels on
the ground)
You must always use a towbar.
The removable towing eye is inside
the spare wheel.From the rear:
F
Unclip the top of the cover using a
coin,
F Screw in the towing eye as far as
it will go.
Special features of the
automatic gearbox
When towing with four wheels on the
ground, the following rules must be
obeyed:
- lever in position N,
- tow the vehicle at less than 50 km/h over a maximum distance
of 50 km.
- do not add oil to the gearbox.
When towing with the
engine switched off, there
is no braking or steering
assistance.
TOWING YOUR VEHICLE
Lifting (2 wheels only on the
ground)
It is preferable to raise the vehicle
with a professional lifting device.
From the front:
F
Unclip the cover, by pressing the
bottom part,
F Screw in the towing eye as far as
it will go.

Practical information146 -
01-03-2005
147Practical information-
01-03-2005
Driving advice
Distribution of loads: Distribute the
load in the trailer so that the heaviest
items are as close as possible to the
axle and the nose weight approaches
the maximum permitted without
exceeding it.
Cooling : towing a trailer on a slope
increases the temperature of the
coolant.
As the fan is electrically controlled,
its cooling capacity is not dependent
on the engine speed.
To lower the engine speed, reduce
your speed.
The maximum towing load on a long
slope depends on the gradient and
the outside temperature.
In all cases, pay attention to the
coolant temperature.
If the warning light comes on, stop
the vehicle and switch off the engine
as soon as possible. Tyres :
check the tyre pressures
of the towing vehicle and of the
trailer, observing the recommended
pressures.
Braking : towing increases the brak-
ing distance.
Lights : check the electrical signal-
ling on the trailer.
Side wind : take into acount the
increased sensitivity to side wind.
TOWING A TRAILER,
CARAVAN, BOAT, etc.
Only use original PEUGEOT towbars
that have been tested and approved
from the design stage of your
vehicle.
The towbar must be itted by a
PEUGEOT dealer.
Your vehicle is primarily designed
for transporting people and luggage
but it may also be used for towing a
trailer.
Driving with a trailer subjects the
towing vehicle to more signiicant
stress and its driver must be
particularly careful.
Air density decreases with altitude,
thus reducing engine performance.
Above 1000 metres, the maximum
towing load must be reduced by 10%
and so on for every 1000 metres of
altitude.
The rear parking assistance function
will be disarmed automatically when
a towbar is itted.
BOOT LUGGAGE CARRIER*
A boot luggage carrier is available
from your PEUGEOT dealer.
When it is used, take care not to
conceal the third brake light.
Follow the manufacturer's recom-
mendations.
* Available as an accessory.

Practical information148 -
01-03-2005
149Practical information-
01-03-2005
ROOF EMERGENCY MODE

Practical information148 -
01-03-2005
149Practical information-
01-03-2005
Boot lidMoving shelfRoof locking bolt
Boot sill Bleed screw Plastic covers Hinged covers
Screen

Practical information150 -
01-03-2005
151Practical information-
01-03-2005
Manual closing of the roof
(emergency mode)
If the roof opening or closing cycle
does not begin or does not function
correctly, check the following points:
F ignition key in running position,
F the screen must be pulled
across,
F the boot must be closed,
F the vehicle speed must be below
6mph (10 km/h),
F the roof fuse must be in good
condition (see corresponding
section),
F the windows must be initialised
(see corresponding section),
F the battery voltage must be
suficient (the roof control button
indicator light must be lit),
F the vehicle must not be in economy
mode (see corresponding
section),
F the exterior temperature must not
be below - 20°C. In the event of an electrical or
hydraulic roof malfunction
, it is
possible to close the roof manually.
Contact a PEUGEOT dealer to have
the system checked.
This possibility is a breakdown
solution .
Following manual closing of the roof,
the boot lid hinges will no longer be
locked and the boot will no longer be
sealed.
Two people are required to carry
out this operation. Considerable
force is necessary.
F Park the vehicle, if possible on
level ground.
F Lower the windows.
F Switch off the ignition.
F Apply the handbrake.
When carrying out the roof
closing operation, take care
not to catch your hands in
the mechanisms. The following two tools are provided
in the handbook pocket:
F
Allen
TM key with 5 adaptor A and
6 adaptor B,
F Torx
TM key with 20 adaptor C and
30 adaptor D.

Practical information150 -
01-03-2005
151Practical information-
01-03-2005
F Open the boot lid.
F Using the hook 1, secure the boot mat on the screen
bar 2.
This allows access to the hydraulic pump screw.
F Press the Allen
TM key adaptor B irmly into the bleed
screw 3, then unscrew half a turn. F
Using the Torx
TM key adaptor C, remove the six plastic
cover bolts 4, located on either side of the boot.
F Remove the two plastic covers 5.
F Extract the cable rings 6 from the trims.
Note: if a cable ring is not visible, carefully insert your hand
behind the trim to extract it.

Practical information152 -
01-03-2005
153Practical information-
01-03-2005
F Pull the two control cables 7 at the same time to unlock
the boot lid locks.
F While continuing to pull the cables, lift the boot li d hinges
8 carefully.
Considerable force is required. Release the cables.
Then, lift the assembly rearwards.
Note: the unfolding of the hinges locks the lid in the upper
position. F
Raise the moving shelf 9 lifting it on either side.
Considerable force is required.
F Guide the movement of the shelf until it is in a vertical
position.
F Take hold of the roof 10, unfold it (considerable force
is required) and move it as close as possible to the
windscreen.
F Reposition the boot mat and roll up the screen.