Peugeot 307 CC Dag 2007.5 Owner's Guide

23
INSTRUMENTS and CONTROLS
When the engine is running, this indi-
cates the oil temperature.
The temperature is too high if the
maximum graduation is reached.

You must stop immediately
.
Contact a PEUGEOT dealer.
Park
Automatic gearbox lever
positions indicator In the event of under-revving or over-
revving, the gear selected l ashes for
a few seconds, then the actual gear
engaged is displayed.

Reverse

Neutral

Drive
Manual mode:

1st gear engaged

2nd gear engaged

3rd gear engaged

4th gear engaged This comes on when the au-
tomatic gearbox
"SPORT"
operating programme is se-
lected.
This comes on when the au-
tomatic gearbox "SNOW"
operating programme is se-
lected.
This is displayed if a gear
is not engaged correctly
(selector between two posi-
tions).
"SNOW" indicator light
Invalid value during manual
operation
"SPORT" indicator light
Engine oil temperature
indicator Automatic gearbox indicator
lights

24
INSTRUMENTS and CONTROLS
After switching on the ignition, three
functions are shown in succession:
- service indicator,
- engine oil level indicator,
- total distance recorder (total and trip distances).

Note : the total and trip distances are
displayed for 30 seconds when the
ignition is switched off, on opening
the driver's door, as well as on lock-
ing and unlocking the vehicle.
It also displays the information relat-
ing to the cruise control or speed lim-
iter, when either of these is activated
(see corresponding section).
Service indicator
This indicates when the next service
is due in accordance with the manu-
facturer's servicing schedule.
The point at which the next service
is due is calculated from the last indi-
cator zero reset (see corresponding
section). It is determined by two pa-
rameters:
- the distance travelled,
- the time which has elapsed since the last service.

Note: the distance remaining before
the next service may be weighted by
the time factor, depending on the us-
er's driving habits.
Operation
For 5 seconds after the ignition is
switched on, the spanner symbolis-
ing the servicing operations comes
on; the distance recorder display in-
dicates the number of miles [kilome-
tres] (rounded off) remaining until the
next service.

Example: 4,800 miles/km remain
before the next service. For i ve sec-
onds after the ignition is switched on,
the display indicates:
INSTRUMENT PANEL DISPLAY
The distance remaining to the
next service is less than
500 miles (1,000 km).

Example: 400 miles (900 km) remain
before the next service.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and

the spanner remains lit .
It indicates that a service must be
carried out soon. The display indi-
cates the total and trip distance.
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and
the display indicates the total and trip
distance.

24
INSTRUMENTS and CONTROLS
After switching on the ignition, three
functions are shown in succession:
- service indicator,
- engine oil level indicator,
- total distance recorder (total and trip distances).

Note : the total and trip distances are
displayed for 30 seconds when the
ignition is switched off, on opening
the driver's door, as well as on lock-
ing and unlocking the vehicle.
It also displays the information relat-
ing to the cruise control or speed lim-
iter, when either of these is activated
(see corresponding section).
Service indicator
This indicates when the next service
is due in accordance with the manu-
facturer's servicing schedule.
The point at which the next service
is due is calculated from the last indi-
cator zero reset (see corresponding
section). It is determined by two pa-
rameters:
- the distance travelled,
- the time which has elapsed since the last service.

Note: the distance remaining before
the next service may be weighted by
the time factor, depending on the us-
er's driving habits.
Operation
For 5 seconds after the ignition is
switched on, the spanner symbolis-
ing the servicing operations comes
on; the distance recorder display in-
dicates the number of miles [kilome-
tres] (rounded off) remaining until the
next service.

Example: 4,800 miles/km remain
before the next service. For i ve sec-
onds after the ignition is switched on,
the display indicates:
INSTRUMENT PANEL DISPLAY
The distance remaining to the
next service is less than
500 miles (1,000 km).

Example: 400 miles (900 km) remain
before the next service.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and

the spanner remains lit .
It indicates that a service must be
carried out soon. The display indi-
cates the total and trip distance.
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and
the display indicates the total and trip
distance.

25
INSTRUMENTS and CONTROLS
Your PEUGEOT dealer carries out
this operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:

 Switch off the ignition,

 Press and hold the trip recorder
re-set button,

 Switch on the ignition.
The display begins a countdown.
When the display shows "=0" , re-
lease the button; the spanner disap-
pears.

Important: after this operation, if you
wish to disconnect the battery, lock
the vehicle and wait for at least i ve
minutes, otherwise the zero re-set
will not be registered.
The service is overdue.
The spanner l ashes for 5 seconds
after the ignition is switched on.

Example: the service is overdue by
300 miles/km, your vehicle must be
serviced as soon as possible.
For 5 seconds after the ignition is
switched on, the display indicates:
Engine oil level indicator
When the ignition is switched on, the
engine oil level is indicated for a few
seconds, after the service information.
Oil level correct
Oil level gauge fault
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and the
spanner remains lit. The display indi-
cates the total and trip distance.

Note: the spanner may also come on
if more than two years have elapsed
since the last service. Flashing of
"OIL --"
indicates a malfunc-
tion of the engine
oil level gauge.
Contact a PEUGEOT dealer.

The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 15 minutes.
Flashing of
"OIL" ,
linked with the
service warning
light, accompanied
by an audible sig-
nal and a message
on the multifunction display, indicates
a lack of oil which could damage the
engine.
If the lack of oil is coni rmed by a
check using the dipstick, it is essen-
tial that the level is topped up.
Lack of oil
Service indicator zero re-set

25
INSTRUMENTS and CONTROLS
Your PEUGEOT dealer carries out
this operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:

 Switch off the ignition,

 Press and hold the trip recorder
re-set button,

 Switch on the ignition.
The display begins a countdown.
When the display shows "=0" , re-
lease the button; the spanner disap-
pears.

Important: after this operation, if you
wish to disconnect the battery, lock
the vehicle and wait for at least i ve
minutes, otherwise the zero re-set
will not be registered.
The service is overdue.
The spanner l ashes for 5 seconds
after the ignition is switched on.

Example: the service is overdue by
300 miles/km, your vehicle must be
serviced as soon as possible.
For 5 seconds after the ignition is
switched on, the display indicates:
Engine oil level indicator
When the ignition is switched on, the
engine oil level is indicated for a few
seconds, after the service information.
Oil level correct
Oil level gauge fault
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and the
spanner remains lit. The display indi-
cates the total and trip distance.

Note: the spanner may also come on
if more than two years have elapsed
since the last service. Flashing of
"OIL --"
indicates a malfunc-
tion of the engine
oil level gauge.
Contact a PEUGEOT dealer.

The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 15 minutes.
Flashing of
"OIL" ,
linked with the
service warning
light, accompanied
by an audible sig-
nal and a message
on the multifunction display, indicates
a lack of oil which could damage the
engine.
If the lack of oil is coni rmed by a
check using the dipstick, it is essen-
tial that the level is topped up.
Lack of oil
Service indicator zero re-set

25
INSTRUMENTS and CONTROLS
Your PEUGEOT dealer carries out
this operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:

 Switch off the ignition,

 Press and hold the trip recorder
re-set button,

 Switch on the ignition.
The display begins a countdown.
When the display shows "=0" , re-
lease the button; the spanner disap-
pears.

Important: after this operation, if you
wish to disconnect the battery, lock
the vehicle and wait for at least i ve
minutes, otherwise the zero re-set
will not be registered.
The service is overdue.
The spanner l ashes for 5 seconds
after the ignition is switched on.

Example: the service is overdue by
300 miles/km, your vehicle must be
serviced as soon as possible.
For 5 seconds after the ignition is
switched on, the display indicates:
Engine oil level indicator
When the ignition is switched on, the
engine oil level is indicated for a few
seconds, after the service information.
Oil level correct
Oil level gauge fault
5 seconds after the ignition was
switched on, the distance recorder
resumes its normal operation and the
spanner remains lit. The display indi-
cates the total and trip distance.

Note: the spanner may also come on
if more than two years have elapsed
since the last service. Flashing of
"OIL --"
indicates a malfunc-
tion of the engine
oil level gauge.
Contact a PEUGEOT dealer.

The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 15 minutes.
Flashing of
"OIL" ,
linked with the
service warning
light, accompanied
by an audible sig-
nal and a message
on the multifunction display, indicates
a lack of oil which could damage the
engine.
If the lack of oil is coni rmed by a
check using the dipstick, it is essen-
tial that the level is topped up.
Lack of oil
Service indicator zero re-set

26
INSTRUMENTS and CONTROLS
With the lights on, press the button
to vary the intensity of the lighting of
the instruments and controls. When
the lighting reaches the minimum (or
maximum) setting, release the button
then press it again to increase (or re-
duce) the brightness.
As soon as the lighting is of the re-
quired brightness, release the button.
With the ignition on, press the button
until the zeros appear.
Pressing the button enables you to
alternate between the distance re-
corder and cruise control or speed
limiter displays, when either of these
is activated.
Dipstick
There are 2 marks on the
dipstick:
- never exceed level A,
- in position B, top up the level via the oil i ller cap,
using the type of oil suited
to your engine.

A = max.

B = min.
Lighting rheostat
Trip recorder zero reset
button

26
INSTRUMENTS and CONTROLS
With the lights on, press the button
to vary the intensity of the lighting of
the instruments and controls. When
the lighting reaches the minimum (or
maximum) setting, release the button
then press it again to increase (or re-
duce) the brightness.
As soon as the lighting is of the re-
quired brightness, release the button.
With the ignition on, press the button
until the zeros appear.
Pressing the button enables you to
alternate between the distance re-
corder and cruise control or speed
limiter displays, when either of these
is activated.
Dipstick
There are 2 marks on the
dipstick:
- never exceed level A,
- in position B, top up the level via the oil i ller cap,
using the type of oil suited
to your engine.

A = max.

B = min.
Lighting rheostat
Trip recorder zero reset
button

27
INSTRUMENTS and CONTROLS
- the current information tab with:

i
i
!
28
INSTRUMENTS and CONTROLS
Distance remaining to be
travelled
(km or miles)
This is the distance remaining to be
travelled to the i nal destination. It
is either calculated instantly by the
navigation system if guidance is acti-
vated, or entered by the user.
If the distance is not entered, dashes
are displayed in place of the digits.
Average speed
(km/h or mph)
This is the average speed calculated
since the last trip computer zero re-
set (ignition on).
Range
(km or miles)
This indicates the number of miles
(or kilometres) which can still be
travelled with the fuel remaining in
the tank in relation to the average
consumption over the last few miles
(kilometres) travelled. Current consumption
(l/100 km or km/l or mpg)
This is the average quantity of fuel
consumed over the last few sec-
onds.
Average consumption
(l/100 km or km/l or mpg)
This is the average quantity of fuel
consumed since the last trip compu-
ter zero reset. Distance travelled
(km or miles)
This indicates the distance travelled
since the last trip computer zero re-
set.
A few definitions…
When the range falls below 20 miles
(30 km), dashes are displayed. After
i lling with at least 5 litres of fuel, the
range is recalculated and is displayed
when it exceeds 60 miles (100 km). This function is only displayed
from 20 mph (30 km/h).
This i gure may increase follow-
ing a change of driving style or
relief, resulting in a signii cant
change in the current consump-
tion.
If dashes are displayed continu-
ously while driving in place of
the digits, contact a PEUGEOT
dealer.