key battery PEUGEOT 307 CC DAG 2007 Owners Manual

i
52
ACCESS
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control system
a few moments after the ignition has
been switched off and therefore pre-
vents starting of the vehicle by any-
one who does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code is
recognised and starting is possible.

If the system does not function
correctly, the service warning light
comes on, accompanied by an audi-
ble signal and a message on the mul-
tifunction display.
In this case, your vehicle will not
start.Contact a PEUGEOT dealer as
soon as possible.
A heavy object attached to the key
(key ring, ...), weighing down on the
shaft of the key in the switch, may
cause a malfunction.
Battery ref.: CR1620/3 volts.
The information "battery l at" is given
by displaying of the service warning
light, accompanied by an audible sig-
nal and a message on the multifunc-
tion display.
To replace the battery, unclip the cas-
ing using a coin at the notch.
If the remote control does not work
after the battery has been changed,
re-programme the remote control.
Key in ignition
A buzzer sounds on opening the driv-
er's door, if the key has been left in
the ignition.
mote control battery or in the event
of a remote control malfunction, the
remote control must be reinitialised.

 Switch off the ignition.

 Switch the ignition on again.

 Press the remote control locking
button immediately for a few sec-
onds.

 Switch off the ignition and remove
the remote control key from the
ignition lock.
The remote control is now working
again.
Locating your vehicle
To locate your vehicle, if you have
locked it, in a car park:

 press button B , the courtesy lights
come on and the direction indica-
tors l ash for a few seconds.

 Press button D to unlock and par-
tially open the boot.
This action also unlocks the doors.
Partial opening of the boot
Changing the remote control
battery
When the vehicle is locked, if un-
locking is activated inadvertent-
ly without a door being opened
within 30 seconds, the vehicle
will lock automatically.
The folding and unfolding of the
mirrors can be deactivated by a
PEUGEOT dealer.
Reprogramming the remote
control
Following disconnection of the vehi-
cle's battery, replacement of the re-

i
52
ACCESS
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control system
a few moments after the ignition has
been switched off and therefore pre-
vents starting of the vehicle by any-
one who does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code is
recognised and starting is possible.

If the system does not function
correctly, the service warning light
comes on, accompanied by an audi-
ble signal and a message on the mul-
tifunction display.
In this case, your vehicle will not
start.Contact a PEUGEOT dealer as
soon as possible.
A heavy object attached to the key
(key ring, ...), weighing down on the
shaft of the key in the switch, may
cause a malfunction.
Battery ref.: CR1620/3 volts.
The information "battery l at" is given
by displaying of the service warning
light, accompanied by an audible sig-
nal and a message on the multifunc-
tion display.
To replace the battery, unclip the cas-
ing using a coin at the notch.
If the remote control does not work
after the battery has been changed,
re-programme the remote control.
Key in ignition
A buzzer sounds on opening the driv-
er's door, if the key has been left in
the ignition.
mote control battery or in the event
of a remote control malfunction, the
remote control must be reinitialised.

 Switch off the ignition.

 Switch the ignition on again.

 Press the remote control locking
button immediately for a few sec-
onds.

 Switch off the ignition and remove
the remote control key from the
ignition lock.
The remote control is now working
again.
Locating your vehicle
To locate your vehicle, if you have
locked it, in a car park:

 press button B , the courtesy lights
come on and the direction indica-
tors l ash for a few seconds.

 Press button D to unlock and par-
tially open the boot.
This action also unlocks the doors.
Partial opening of the boot
Changing the remote control
battery
When the vehicle is locked, if un-
locking is activated inadvertent-
ly without a door being opened
within 30 seconds, the vehicle
will lock automatically.
The folding and unfolding of the
mirrors can be deactivated by a
PEUGEOT dealer.
Reprogramming the remote
control
Following disconnection of the vehi-
cle's battery, replacement of the re-

10
!
110
PRACTICAL INFORMATION
Special front windscreen
wiper position

 Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
Changing a wiper blade

 Lift the wiper arm, then unclip the
blade and remove it.

 Fit the new blade and push back
the arm.

Note: the shortest blade is i tted on
the vehicle's right-hand windscreen
wiper arm.

To return the windscreen wipers to
their normal position, switch on the
ignition and operate the wiper stalk.
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery starting
with the negative (-) terminal,
- Follow the instructions for use given by the battery charger manu-
facturer,
- Check that the terminals and connectors are clean; if they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them,
- Reconnect the battery starting with the negative (-) terminal.

It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
To start the vehicle from
another battery:
- Connect the red cable to the posi-
tive (+) terminals of the two batter-
ies,
- Connect one end of the green or
black cable to the negative (-) ter-
minal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery,
-
Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables.
WIPER BLADE
Before disconnecting the bat-
tery, you must wait for 2 minutes
after switching off the ignition.
Never disconnect a terminal
when the engine is running.
Never charge a battery without
i rst disconnecting the terminals.
Close the windows, the retract-
able roof and the doors before
disconnecting the battery. If the
windows do not operate normal-
ly following reconnection of the
battery, they must be reinitialised
(see sections "Reinitialisation of
the electric windows" and "Reini-
tialisation of the automatic partial
opening of the door windows").
After every reconnection of the
battery, switch on the ignition
and wait 1 minute before starting
to allow the electronic systems to
be initialised. If slight difi culties
are experienced after this, please
contact a PEUGEOT dealer.
Following disconnection of the
battery, the remote control key
and the GPS satellite naviga-
tion system must be reinitialised
(see corresponding section).

10
!
110
PRACTICAL INFORMATION
Special front windscreen
wiper position

 Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
Changing a wiper blade

 Lift the wiper arm, then unclip the
blade and remove it.

 Fit the new blade and push back
the arm.

Note: the shortest blade is i tted on
the vehicle's right-hand windscreen
wiper arm.

To return the windscreen wipers to
their normal position, switch on the
ignition and operate the wiper stalk.
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery starting
with the negative (-) terminal,
- Follow the instructions for use given by the battery charger manu-
facturer,
- Check that the terminals and connectors are clean; if they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them,
- Reconnect the battery starting with the negative (-) terminal.

It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
To start the vehicle from
another battery:
- Connect the red cable to the posi-
tive (+) terminals of the two batter-
ies,
- Connect one end of the green or
black cable to the negative (-) ter-
minal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery,
-
Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables.
WIPER BLADE
Before disconnecting the bat-
tery, you must wait for 2 minutes
after switching off the ignition.
Never disconnect a terminal
when the engine is running.
Never charge a battery without
i rst disconnecting the terminals.
Close the windows, the retract-
able roof and the doors before
disconnecting the battery. If the
windows do not operate normal-
ly following reconnection of the
battery, they must be reinitialised
(see sections "Reinitialisation of
the electric windows" and "Reini-
tialisation of the automatic partial
opening of the door windows").
After every reconnection of the
battery, switch on the ignition
and wait 1 minute before starting
to allow the electronic systems to
be initialised. If slight difi culties
are experienced after this, please
contact a PEUGEOT dealer.
Following disconnection of the
battery, the remote control key
and the GPS satellite naviga-
tion system must be reinitialised
(see corresponding section).