Peugeot 307 SW 2006 Service Manual

39
MONOCHROME SCREEN CT
Presentation
This displays the following information, via the RT3 audio/telephone control keypad:
- the time,- the date,- the outside temperature (if there is a risk of ice, you are warned by a message),- the audio source displays (radio, CD, ...),- the telematic system displays (tele-phone, services, ...),- the status of the accesses (doors, boot, ...),- the warning messages (e.g.: "Fuel level low") and vehicle function status messages (e.g.: "Automatic switching on of the lights activated") displayed temporarily,- the trip computer display,- the satellite navigation system displays.
In order to enable you to use all of your system’s functions, you have two CD-Roms:
- one, "Configuration", contains the software and the various display languages and spoken information,- the other, "Navigation", contains the satellite navigation system map data.Press the "MENU" button on the RT3 audio/telephone to access the general menu and select one of the following applications:
- navigation - guidance,- audio functions,- trip computer,- directory,- telematics,- configuration.For further details regarding these functions, refer to the corresponding section.
General menu

40
The "Display configuration" menu provides access to the following parameters:
• "Brightness setting": setting of the brightness of the display,• "Sound": setting of the voice syn-thesiser (for the male/female voice parameter: insert the configura-tion CD-Rom); setting of the voice commands,• "International parameters": setting of the date and time (12 or 24 hour mode, adjustment of the minutes on GPS); selection of the units (l/100 - °C or mpg - °F),• "Selection of the language": selection of the language of the display, information and voice commands (Français, English, Italiano, Portugues, Espanol, Deutsch, Nederlands: insert the configuration CD-rom).
For safety reasons, configu-ration of the multifunction displays by the driver must take place when stationary.
This provides access to successive confirmation windows.
Example: "duration of follow-me-home lighting"
Define the vehicle parameters
This enables you to activate or deactivate certain driving and comfort functions:
- wiper linked with reverse gear,- automatic switching on of the lights,- "follow-me-home" lighting and duration,- parking assistance.
"Configuration" menuDisplay configuration

41
COLOUR SCREEN DT
Presentation
This displays the following information, via the RT3 audio/telephone control panel:
- the time,- the date,- the outside temperature (if there is a risk of ice, you are warned by a message),- the audio source displays (radio, CD, ...),- the telematic system displays (tele-phone, services, ...),- the status of the accesses (doors, boot, ...),- the warning messages (e.g.: "Fuel level low") and vehicle function status messages (e.g.: "Automatic switching on of the lights activated") displayed temporarily,- the trip computer display,- the satellite navigation system displays.
In order to enable you to use all of your system’s functions, you have two CD-Roms:
- one, "Configuration", contains the software and the various display languages and spoken information,- the other, "Navigation", contains the satellite navigation system map data.
Press the "MENU" button on the RT3 audio/telephone to access the general menu and select one of the following applications:
- navigation - guidance,- audio functions,- trip computer,- directory,- telematics,- configuration,- map,- video.For further details regarding these functions, refer to the corresponding section.
General menu

42
The "Display configuration" menu provides access to the following parameters:
• "Select the colours": selection from the palette of colours available for the display,• "Brightness and intensity": setting of the brightness and intensity of the display,• "Sound": setting of the voice synthesiser (for the male/female voice parameter: insert the configuration CD-Rom); setting of the voice commands,• "International parameters": setting of the date and time (12 or 24 hour mode, adjustment of the minutes on GPS); selection of the units (l/100 - °C or mpg - °F),• "Selection of the language": selection of the language of the display, information and voice commands (Français, English, Italiano, Portugues, Espanol, Deutsch, Nederlands: insert the configuration CD-rom).
This provides access to successive confirmation windows.
Define the vehicle parameters
This enables you to activate or deactivate certain driving and comfort functions:
- wiper linked with reverse gear,- automatic switching on of the lights,- "follow-me-home" lighting and duration,- parking assistance.
Example: "Automatic switching on of the lights"Display configuration"Configuration" menu

43
A FEW DEFINITIONS...
Superimposed display
This is a window which appears temporarily over the current application to announce a change of status of another application.
Permanent application
This is the main application currently in use, displayed as the main screen window.
Contextual menu
This is a menu, limited to the main functions of the main application currently in use, displayed as the main screen window.
You can connect video equipment (camcorder, digital camera, DVD player, ...) to the three audio/video sockets, located in the glove box.
Videos can only be displayed when stationary.
Select the "Video" menu from the general menu:
- "Activate video mode" to activate/deactivate the video,- "Video parameters" to set the display format, the brightness, the contrast and the colours.Pressing the "MODE" or "DARK"button disconnects the display from the video.
Successive presses on the "SOURCE"button permit the selection of an audio source other than that of the video.
For safety reasons, configu-ration of the multifunction displays by the driver must take place when stationary.
"Video" menu

44

45
VENTILATION
1. Windscreen de-icing or demisting vents.
2. Front window de-icing or demisting vents.
3. Side vents.
4. Centre vents.
5. Air outlet to front footwells.
6. Air outlet to rear footwells.
Advice on operation
 If, when the vehicle has been parked in the sun for a long time, the interior temperature remains very high, do not hesitate to ven-tilate the passenger compartment for a few minutes.
Place the air flow control at a level sufficient to ensure a good renew-al of air in the passenger compart-ment.
When the air flow control is in po-sition 0 (deactivation of the sys-tem), temperature related com-fort is no longer guaranteed but a slight flow of air, due to the move-ment of the vehicle, can still be felt.
 For even air distribution, take care not to obstruct the exterior air in-take grille at the base of the wind-screen, the vents, the air outlets under the front seats and the air extractor located behind the flaps in the boot.
Check that the passenger com-partment filter is in good condi-tion. Have the filters replaced regularly. If you drive in a dusty environment, change them twice as often.Switch off the rear screen and exterior mirrors demist-ing as soon as you consider this necessary as reducing the current consumption reduces the fuel consumption.

46
The air conditioning only operates when the engine is running.
2. Temperature adjustment1. Air conditioning On/Off
Turn the control from blue (cold) to red (warm) to ad-just the temperature to your requirements.
4. Air distribution adjustment
Windscreen and side windows.
Windscreen, side windows and footwells.
Footwells
(vents closed).
The air conditioning is de-signed to operate effectively in all seasons, with the win-dows closed. In summer, it enables the temperature to be lowered and in winter, above 0 °C, it increases the effectiveness of the demisting.
Press the switch, the indicator light comes on.
The air conditioning does not op-erate while the air flow adjustment control 3 is in position "0".
Centre and side vents.
3. Air flow adjustment
Turn the control from posi-tion 1 to position 4 to obtain an air flow sufficient to en-sure your comfort.
The air distribution can be adjusted by placing the control in an interme-diate position, marked "".
AIR CONDITIONING

47
6. Demisting the rear screen and the mirrors
Pressing the button once demists the rear screen and the exterior mirrors.
This switches off automati-cally to prevent an exces-sive consumption of current.
Pressing again reactivates demisting.
It is possible to stop demisting be-fore it is switched off automatically by pressing the button again.
In certain cases of particu-larly arduous use (towing the maximum load on a steep gradient in high tempera-tures), switching off the air condition-ing permits the recovery of engine power and therefore an increase in the towing capacity.
In order for the air conditioning to be fully effective, the windows must be closed.
The air conditioning system does not contain chlorine and does not present any danger to the ozone layer.
Operate the air conditioning system for 5 to 10 minutes, once or twice a month, to keep it in perfect working order.
The water produced by the air con-ditioning condensation is discharged through an opening provided for this purpose. Therefore, a puddle of wa-ter may form underneath the vehicle when stationary.
In order to ensure that the air condi-tioning system operates correctly, reg-ular checks are also recommended.
If the system does not produce cold air, do not use it and contact a PEUGEOT dealer.
5. Air intake/Air recirculation
Pressing button 5 permits recirculation of the interior air. This is indicated by il-lumination of the indicator light.
As soon as possible, press button 5again to permit the intake of outside air, to prevent deterioration of the air quality and to avoid misting of the windows. This is indicated by the switching off of the indicator light.
The interior air recirculation enables you to isolate the passenger com-partment from exterior odours and smoke.
The outside air intake enables you to prevent and eliminate misting of the windscreen and side windows.
Used simultaneously with the air con-ditioning, air recirculation enables performance to be improved.
Used in a humid climate, air recir-culation may result in misting of the windows.
Rapid demisting of the windscreen
To quickly de-ice or demist the wind-screen and side windows:
- place the air distribution control in the "windscreen and side windows" position,- place the temperature 2 and air flow 3 controls at maximum, as indicated by the "Windscreen and side windows" symbol on the con-trol panel,- close the centre vents,- switch air intake button 5 to the "Outside Air Intake" position (but-ton 5 indicator light off),- start the air conditioning by pressing button 1.

48
The air conditioning only operates when the engine is running.When the engine is cold, to prevent too great a distribution of cold air, the air flow will reach its optimum level gradually.
The driver and his front passenger can each adjust the temperature to their re-quirements.
The value indicated on the display corresponds to a level of comfort and not to a temperature in degrees Celsius or Fahrenheit.
Turn control 2 or 3 to the left or to the right respectively to decrease or increase this value.
A setting around the value 21 provides optimum comfort. However, depending on your requirements, a setting between 18 and 24 is normal.
For optimum comfort, you are advised to avoid a left/right setting difference of more than 3.
For maximum cooling or heating of the passenger compartment, it is possible to go below the value 15 by turning un-til "LO" is displayed or above the value 27 by turning until "HI" is displayed.
4. Automatic visibility programme
The automatic comfort pro-gramme may not be sufficient to quickly demist or de-ice the windscreen and side windows (humidity, several passengers, ice, etc.).
In this case, select the automatic vis-ibility programme.
The system automatically controls the air conditioning, the air flow and the air intake and provides optimum distribution of the ventilation to the windscreen and side windows.
To switch it off, press button 4 again or press the "AUTO" button, the but-ton’s indicator light switches off and "AUTO" is displayed.
Automatic operation
1. Automatic comfort programme
Press the "AUTO" button. The "AUTO" symbol is dis-played.
We recommend the use of this mode: it permits auto-matic and optimised adjustment of all of the functions, passenger com-partment temperature, air flow, air distribution and air recirculation, in accordance with the comfort value that you have chosen. This system is designed to operate effectively in all seasons, with the windows closed.
2. Driver’s side adjustment
3. Passenger side adjustment
On entering the vehicle, if the interior temperature is much colder or warmer than the comfort value, there is no need to change the value displayed in order to obtain the comfort re-quired. The system corrects the dif-ference in temperature automatically and as quickly as possible.
DUAL ZONE AUTOMATIC AIR CONDITIONING